• Proceedings of the Korean Environmental Sciences Society Conference
• /
• 2002.05b
• /
• pp.273-274
• /
• 2002

본 연구는, 생활 하수 슬러지가 대부분인 충남 지역에서 발생되는 하수 슬러지의 물리ㆍ화학적인 성질을 기초로 하여 소각재의 안정적인 처분과 재활용을 위한 가능성을 확인하여 하수 슬러지 소각회의 적절한 처분방안과 제반 문제점 등을 제시하고, 그 문제점들의 해결방안을 모색하였다. 그 결과 하수 슬러지의 함수율은 약 80 % 정도 되며, 유기물이 고형물의 50% 정도로 관찰되었다. 그리고 비휘발성 고형물인 무기물은 $SiO_2$-$Al_2$$O_3$가 주성분으로 관찰되었으며, 주요 광물은 하수 슬러지가 소각 온도 및 소성 온도에 따라 변화하는 것으로 나타났다. 그리고, 이러한 변화는 소각재의 최종 처분시 고려되어야 하는 중요한 요인로 작용한다. 또한 하수 슬러지 소각재에 시멘트 및 첨가제의 종류, 그리고 양생 조건 등에 따라 약 100 ～ 200 kgㆍf/$\textrm{cm}^2$의 압축 강도를 가지는 것으로 조사되어, 소각에 따른 최종 부산물인 소각재의 재활용 가능성이 매우 높다는 것을 확인할 수 있었다.

• Journal of the Korean GEO-environmental Society
• /
• v.4 no.4
• /
• pp.25-34
• /
• 2003

This paper is focused on an experimental study in order to investigate the utilization of sewage sludge ash as the cover and liner materials for the waste disposal landfill or as construction materials. A series of tests were performed to evaluate the basic properties, compaction, compressive strength, consolidation, permeability, and CBR of sewage ash. Specially, clay bricks were made as increasing replacement ratio of sewage ash (such as 5, 10, 15, 20, 25, 30%). And tests were fulfilled for its quality. Bentonite and lime were used as the additives to improve permeability properties of sewage sludge ash. As a result of tests, it was shown that the permeability coefficient decreases as increasing bentonite content and the percentage of bentonite was roughly needed 20% to keep the permeability coefficient below $1{\times}10^{-7}cm/sec$. The results of unconfined compression tests show that sewage ash meets the criteria of the unconfined compression strength for cover material. It was shown that the compressive strength decreases as increasing the replacement ratio of sewage sludge ash and the maximum replacement ratio of sewage sludge ash to satisfy the quality standards of the third degree bricks was about 15%.

• Journal of the Korean GEO-environmental Society
• /
• v.4 no.4
• /
• pp.35-43
• /
• 2003

In this study, the physical and chemical characteristics of incinerated pulp and sewage sludge ashes for recycling and reuse were examined. Then we studied the application to the cement admixture by pozzolanic reaction. The particle size of incinerated pulp and sewage sludge ashes was distributed around $10{\sim}100{\mu}$, and the contents of $SiO_2$ and $Al_2O_3$ were 45.8~51.0%, respectively. Compressive strengths of the solidified ashes were relatively higher, when the content of substituted incineration ashes was 10% and the porosity was also lower except for the case of sewage sludge ash. As results, it is shown that it may be possible to recycle incinerated pulp sludge ashes as cement admixtures.

• Resources Recycling
• /
• v.17 no.3
• /
• pp.3-9
• /
• 2008

The measurement of physicochemical properties and chemical composition of SSA(sewage sludge ash) has been carried out and the preparation of lightweight material has also been performed using SSA for reuse as building or construction materials. For this aim, lightweight material has been prepared by forming the mixture of SSA, lightweight filler and inorganic binder followed by calcination at elevated temperature and characterized in terms of density and compressive strength. The pH of fly ash was found to be slightly alkaline, pH 8.69, due to the addition of caustic soda in order to neutralize the acidic gas while the pH of bottom ash was 6.48 Heavy metal leachability based on the standard leach test was also found to be below the detection limit for Cd, Cu, Pb, As and Cr of SSA. As far as the compressive strength of lightweight material was concerned, the compressive strength of lightweight material using fly ash was higher than that of lightweight material using bottom ash.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.29 no.1
• /
• pp.5-17
• /
• 2021

This study is a literature review on the recovering phosphorus from Incinerated Sewage Sludge Ash(ISSA), which has relatively high content of phosphorus. Experimental conditions and influencing factors related to the recovery of P and removal of heavy metals by wet and thermochemical methods were discussed. For the practical application of the recovery of P from ISSA, an integrated process linked to incineration facilities is required in terms of economy from the perspective of the entire system including disposal of wastewater and residues generated during the recovery process, and minimizing added chemicals and energy consumption.

• Journal of Korean Society of Environmental Engineers
• /
• v.38 no.2
• /
• pp.96-99
• /
• 2016

This study characterized fly ash produced from a sewage sludge incineration facility in Korea to determine if the byproducts can be utilized. All the incinerated sewage sludge was from a city in Korea. To characterize fly ash and to determine if it can be utilized, pH, water contents, elemental components, particle size, surface morphology, heavy metal compositions, and others were analyzed. In average, pH was 6.2, and water contents was about 5%. T-N and $T-P_2O_5$ were 3% and 24.5%, respectively. Particle size averaged 836 nm; surface morphology did not exhibit any significant results. X-ray diffraction (XRD) analysis results revealed that major components of the fly ash were $P_2O_5$, CaO, MgO, $K_2O$. Composition of heavy metals by the Korea Standard Methods for Waste Quality did not exceed the criteria for specified wastes in Korea.

• Proceedings of the Korean Environmental Sciences Society Conference
• /
• 2001.11a
• /
• pp.151-152
• /
• 2001

본 연구는 하수슬러지 소각재를 이용하여 건축재료로서의 응용 가능성을 조사하였다. 소각재를 주성분으로 하여 $950^{\circ}C$에서 소성한 시편과 보통 포틀랜드 시멘트 (OPC)를 첨가하여 습윤양생을 한 시편을 제작하여 압축 강도를 비교하였다. 소성 시편에서는 전반적으로 압축강도가 150 kgㆍf/$\textrm{cm}^2$ 이상의 높은 강도를 얻을 수 있었으나 변형율이 증가하는 것이 단점으로 나타났다. 또한, 습윤양생한 시편의 경우 소량의 OPC 첨가 만으로도 일정한 압축강도를 유지할수 있었으며, 시편의 변형 또한 줄일 수 있었다.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.28 no.3
• /
• pp.15-26
• /
• 2020

To recover phosphorus from incinerated sewage sludge ash(ISSA), ISSA were extracted with sulfuric acid solution, and the optimal phosphorus recovery conditions were experimented by comparing the recovered phosphorus contents and heavy metals by raising pH. Also the phosphorus recovery efficiency was compared when acid extract was reused or classified by particle size of ISSA. The optimal conditions for recovering phosphorus from ISSA were 1N sulfuric acid solution with an L/S ratio of 10, and an extraction time of 30 minutes. Considering the addition of alkali substances and the content of heavy metals in the recovered sediment, it is concluded to recover phosphorus under pH 5. Reuse of the ISSA extract increased the recovery rate of phosphorus by 14~21% depending on the reuse rate (100 and 50%), but it also increased zinc contents to 33 and 21%, and copper contents to 35 and 20%, respectively. The experiment of ISSA divided into four sections by particle size showed that there was no distinct advantage of phosphorous recovery by classification of certain particle size of ISSA. The removal of heavy metals from extracts through EDTA and cation exchange resin showed no definite effect.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.5 no.3
• /
• pp.55-62
• /
• 2010

This is an experimental research in order to judge the applicability of sewage sludge incineration ash having applied the mixing proportion needed to manufacture bricks and to do plaster work with addition of hwangtoh and slaked lime as a part of the methods for utilizing the wastes produced from sewage sludge incineration ash. Based on the results from experiment and analysis, it is judged that, in case of mixing proportion of 1:2 for the purpose of plastering and masonry work, the cement mortar produced by using a 10% addition ratio of sewage sludge incineration ash with mixture of hwangtoh covering all range of addition ratio, and also the cement mortar produced by using a 20% of sewage sludge incineration ash together with 0% and 10% addition ratio of hwangtoh, was possible to be applied to the practical use. In case of mixing proportion of 1:7 for manufacture of bricks and blocks, if such brick and block products are produced with 10% and 20% addition ratio of sewage sludge incineration ash having added aggregate fines or stone dust that has been actually used in brick and block manufacturing, it is judged that these bricks and blocks could be practically used in the job sites, although strength development is a little bit lower.

• Journal of Korean Society of Environmental Engineers
• /
• v.36 no.12
• /
• pp.843-850
• /
• 2014

This study investigated to recycle ash produced in the sewage sludge incinerator using reduction/stabilization. Nonsintering process was performed by binding cement, geobond and sand mixed with sewage sludge ash (SSA). Results showed that unconfined compressive strength could be obtained components of sewage sludge ash. it exceeded more than double score of the 22.54 Mpa ($229.7kg/cm^2$) Korean standard. chemical ingradients of the sewage sludge ash was mainly composed of $SiO_2$, $Al_2O_3$, $Fe_2O_3$, CaO and others, which were similar to those of the each binders consisting cement and geobond. microstructure of solidified speceimen for the different admixture was related to the compressive strength according to SEM analysis. optimum mixing range of the sewage sludge ash to inorganic binder was found to be 10~40% which can widly safely regulate the confined compressive strength. This study revealed the sewage sludge ash can be partial replacement of the inorganic binder for recycling.