• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.14 no.3
• /
• pp.38-42
• /
• 2000

Plasma polymerized thin films were manufactured inter-electrode coupled plasma polymerization apparatus. The deposition rate reached its maximum between 40[W] and 100[W]. In the ESCA analysis, peaks revealing -CH2, -CH, -C- were present at 285.4 and 285.5[eV] respectively. The C=O peak at 532.8[eV] and the C-O peak at 533.8[eV], which were grouped with an unignorable amount of oxygen were conformed. In ESR analysis, the curve revealing strong amplification was in saturation, which was affected by weak power. This is considered as a -CH-Ch=Ch- structure containing the Allyl group. The relative permittivity of the plasma polymerized thin films was about 3.5 at a frequency of 100[Hz]∼200[kHz]. The dissipation factor showed allow value of 0.008.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.54 no.4
• /
• pp.93-103
• /
• 2012

A suction-saturation control technique based on flow pump system was developed to investigate hydraulic properties in unsaturated soils. The flow pump system is designed based on the principle of the axis-translation technique and triaxial equipment, and gives the suction-time and suction-saturation curves, the primary relationship needed for interpreting the response of unsaturated soils and link between theory and the material properties in unsaturated soil mechanics. Using the suction-saturation control technique, suction-time relationship and soil-water retention curve (SWRC) during hydraulic hysteresis were investigated with different net confining pressures and porosities. Three types of soils-two sands and a silt were used in this paper. This paper showed the effect of the hysteresis on the SWRC due to different net confining pressures and porosities. This means that a careful decision must be made as to which condition is to be modeled, since the delicate difference of the conditions in physical modeling can cause the different experimental output.

• Electrical & Electronic Materials
• /
• v.1 no.4
• /
• pp.319-332
• /
• 1988

높은 포화자속밀도와 낮은 철손을 갖는 Fe/aub 80/B$_{12}$Si$_{8}$ 비정질합금을 일반열처리, 자장열처리시켜 그의 자기적특성과 자구구조와의 관계를 조사하였다. 이를 위하여 Fe$_{80}$B$_{12}$Si$_{8}$ 비정질리본을 단롤법으로 제작하여 결정화온도를 측정하였으며 측정된 결정화온도 이하의 여러 온도에서 30분간 Ar-gas 분위기하에서 일반열처리, 자장열처리를 행하였다. 이와같이 하여 준비된 시료의 자기적특성을 조사하기 위하여 D.C., A.C. Recorking Fluxmeter를 이용하였으며 자구구조는 Bitter method로 관찰하였다. as-cast 상태의 시료를 일반열처리함에 따라 내부응력이 완화되면서 maze자구가 점차 사라지고 wave형태의 180.deg.자구가 관찰되었다. 동시에 자화과정에 있어서 자기이력곡선은 Barkhausen jump가 없어 smooth하였다. 그리고 자장열처리시에는 as-cast 상태나 일반열처리에 비해 자기적특성이 현저하게 향상되었으며 이는 열처리를 행함에 따라 내부응력이 완화되면서 maze 자구가 없어지고 일축자기 이방성으로 리본길이방향에 평행하게 형성된 180.deg.자구에 기인하는 것이라 사료된다. 그리고 자장열처리의 경우, 폭방향으로 열처리한 리본의 자구폭은 길이방향으로 열처리한 리본의 폭보다 미세하였으며 전자의 이력손실이 후자의 것보다 더 컸다.다.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.46 no.6
• /
• pp.61-69
• /
• 2004

The aim of the work described in this paper was to confirm the application of the equation of the soil-water characteristic curves on an unsaturated soil. A series of suction test for unsaturated soils was conducted on the selected 4 kinds of soil using modified pressure extractor apparatus. And it was carried out to analyse The experimental parameters which can be describe the soil-water characteristics, were determined by using the data obtained from the experiment. From the results, it was found that The matric suction varied according to the grain size distribution, amount of fine grain particles and void ratio. Also it was found that the residual degree of saturation was decreased with in crease of the void ratio, but the pore size distribution index and air entry value were increased with in crease of the void ratio. And The application of the soil-water characteristic curve equation was confirmed for the various conditions and the various state by the comparison between the measured degree of saturation and the predicted degree of saturation.

• Korean Journal of Optics and Photonics
• /
• v.4 no.4
• /
• pp.474-479
• /
• 1993

An interferometric fiber-optic magnetic field sensor is constructed by bonding a Co-Fe-B metallic glass transducer developed here by the melt-spun method to a single mode fiber arm in the fiber Mach-Zehnder interferometer and is tested. The bias field for the peak ac-sensitivity was observed near 0.97 Oe and the minimum detectable magnetic field was 3.9${\times}10^{-5}$ Oe(rms)/${\sqrt{Hz}}$ a 3 kHz. The output of the ac field sensor becomes saturated near the input signal level of 1 Oe(rms). The Co- Fe-B transducer exhibits peak response near 500 Hz.

• Journal of the Korean Magnetics Society
• /
• v.19 no.4
• /
• pp.147-151
• /
• 2009

The saturation magnetization and uniaxial anisotropy constant were obtained from magnetization and torque curves measurement in high resistive CoFeHfO thin film. The measured results were used for the analysis of the microwave complex permeability based on Landau-Lifshitz-Gilbert (LLG) theory. The high resistive CoFeHfO thin films showed very low damping constants of ${\alpha}$ = 0.014. The results are interpreted in terms of various magnetic phase with very low damping constant, which were existing inside the CoFeHfO thin film, through the linewidth analysis of the ferromagnetic resonance signal with magnetic field.

• Progress in Medical Physics
• /
• v.7 no.1
• /
• pp.25-35
• /
• 1996

Optical measurements of turbid biological tissue have provided a means to study tissue metabolism, tissue blood perfusion and blood oxygenation non-invasively. We used the red light of 660nm and infrared of 880nm to measure the blood fractional volume and oxygen saturation of biological tissue. In vivo reflectance data were obtained the physiological change from the deep tissue in human subject. The data evaluation was assessed by examining the slopes of the plotter index for the changes in oxygen saturation and blood fraction volume. The index is the natural logarithm of the ratio of reflected light intensity from measured medium to reference intensity at each wavelength. According to the experimental results, oxygen index changes significantly in the muscle of calf during exercise.

• Korean Chemical Engineering Research
• /
• v.43 no.3
• /
• pp.432-437
• /
• 2005

An electric swing adsorption (ESA) process for recovering highly pure $CO_2$ from the mixed gases was tested. In this study, activated carbon fibers were used as an adsorbent. The activated carbon fibers showed fast adsorption rate and the high adsorption capacity for $CO_2$ adsorption under the condition of the ambient pressure. Activated carbon fiber with higher specific surface area was suitable to repeated adsorption-desorption cycle process, showing consistent breakthrough curve. Especially, the regeneration method by vacuum combined with ESA improved the performance of desorption process by an additional 17％ regeneration efficiency compared to a vacuum only method, and showed the high regeneration efficiency at comparatively low 7-8 Wh energy.

• Proceedings of the KAIS Fall Conference
• /
• 2001.05a
• /
• pp.220-223
• /
• 2001

Pb가 10% 과잉되고 Zr : Ti = 52 : 48 조성을 갖는 PZT sol이 Pt(3500Å)/Ti(400Å)/SiO₂(3000Å)Si(525㎛)기판 위에 스핀 코팅법으로 반복 코팅된 후, 450℃에서 10분, 650℃에서 2분간 반복 열처리되었다. 이와 같이 다양한 두께로 적층된 박막은 각 시편에 대해 최종적으로 650℃ 30분 동안 어닐링 처리되었다. 제조된 PZT 박막의 두께는 4100Å에서 1.75㎛사이의 4종이었다. 이어서 스퍼터링법으로 Pt전극이 PZT 막 위에 증착되었다. 제조된 PZT 박막의 결정 구조 조사를 위해 XRD, 그리고 미세 구조 및 전기적 특성을 알아보기 위해 FESEM과 P-E 이력 곡선이 각각 관찰되었다. 4100Å에서 1.75㎛까지 두께 증가에 따른 장비상의 포화 이력 한계로 잔류 분극(Pr)값이 25μC/㎠에서 다소 감소되었다. 측정된 X선 회절 결과에서 최초 4회 코팅시 perovskite 결정 구조로 성장한 결정립은 (111)배향이 우세하었으나, 두께가 증가됨에 따라 (111)/(110)값이 감소되었으며, 이를 통해 두께 증가에 따른 (111)배향성이 다소 감소됨을 알 수 있었다. 이상의 결과로부터 제조된 PZT 박막은 큰 힘과 높은 내전압 특성을 갖는 마이크로 압전 액츄에이터에 적용될 수 있을 것으로 생각되었다.

• Electrical & Electronic Materials
• /
• v.6 no.3
• /
• pp.241-247
• /
• 1993

본 연구에서는 투광성 0.085Ba(L $a_{1}$2/N $b_{1}$2/) $O_{3}$- 0.915Pb(Z $r_{y}$ $Ti_{1-y}$) $O_{3}$(0.45.leq.y.leq.0.70)세라믹을 2단 소성법으로 제작한 후, PbZr $O_{3}$조성 및 온도에 따른 구조적, 강유전적특성을 측정하였다. XRD측정 결과, PbZr $O_{3}$조성이 감소할수록 결자상수 및 단위격자 체적은 감소하였으며 시편의 결정구조는 입방정계에서 능면체정계, 정방정계로 변화되었다. 8.5/60/40시편의 경우 포화분극, 잔류분극 및 항전계가 각각 33.28[.mu.C/$cm^{2}$], 4.15[kV/cm]로 전형적인 메모리 특성을 나타내었으며 PbZr $O_{3}$조성이 증가함에 따라 강유전 이력곡선은 slim loop특성을 나타내었다. 잔류분극은 온도가 증가함에 따라 감소하였으며 특히 PE-FE상경계 부근에 위치한 조성의 경우, 상전이 온도 이하의 온도에서 급격히 감소하는 경향을 나타내었다.다.