• Journal of the Korea Concrete Institute
• /
• v.13 no.5
• /
• pp.484-490
• /
• 2001

This study focused on the investigation of durability of latex modified concrete in the points of chloride ion permeability and freeze-thaw resistance as latex content variated such as 5%, 10%, 15% and 20%. When latex was mixed in concrete and cured, the concrete consisted of hydrated cement and aggregate interconnected by a film of latex particles. An increasing the amount of latex produced concrete with increased flexural strength, but with slightly lower compressive strength. The increase in flexural strength might be attributed to the latex films between the hydrated cement and aggregates, and the decrease in compressive strength to the flexibility of the latex component named by Butadiene. The rapid chloride permeability test was used to evaluate the relative permeability of latex-modified concretes and conventional concretes. The results showed that the permeability of latex-modified concretes was considerably lower than conventional concretes tested, which might be due to the latex filled in voids and interconnections of hydrated cement and aggregates by a film of latex particles. The freeze-thaw resistance of LMC was quite good comparing to conventional concrete. Air entraining agent has been used in conventional concrete to improve the freeze/thaw resistance, but latex modified concrete does not need additional air entraining agent for freeze-thaw resistance provided adequate cure occurs.

• Journal of the Korea Concrete Institute
• /
• v.25 no.6
• /
• pp.675-682
• /
• 2013

In this study, to enhance the quality of concrete surface by removing the surplus water, permeable liner attached the euroform was applied for manufacturing concrete specimens. Various kinds of concrete mixtures with different water to binder ratios were applied and the strength properties of the hardened concrete surfaces were evaluated at different heights. Experimental results showed that the rebound values by schmidt hammer test and the compressive strengths on the surfaces of concrete specimens were increased as proportion to the amount of mixture water which is dependent on the water to binder ratio of each concrete mixture, and more enhancements were observed on the middle and lower specimen surfaces than the upper region. SEM analysis also showed that much denser hydrate structures were observed on the specimen surfaces by the application of the permeable liner while similar hydrate formations were occurred regardless of surface treatment conditions. From the MIP test results of the concrete surfaces, it was observed that, by the application of permeable liner, the pore volume below $0.01{\mu}m$ was decreased with a maximum of 50% resulting in the densification of pore structures.

• Korean Journal of Agricultural Science
• /
• v.25 no.1
• /
• pp.89-96
• /
• 1998

This study was performed to evaluate the engineering properties of permeable polymer concrete with rice-husk ash. The following conclusions were drawn; 1. The highest sterngth was achieved by 50% filled rice husk-ash permeable polymer concrete, it was increased 24% by compresseve, 123% by tensile and 90% by bending strength than that of the normal cement concrete, respectively. 2. The static modulus of elasticity was in the range of $1.27{\times}10^5{\sim}1.75{\times}10^5kgf/cm^2$, which was approximately 58~70% of the normal cement concrete. The higher elastic modulus was showed by 50% filled rice-husk ash permeable polymer concrete, relatively. The poisson's number of permeable polymer concrete was less than that of the normal cement concrete. 3. The ultrasonic pulse velocity was in the range of 2,503~3,083m/sec, which was showed about the same compared to that of the normal cement concrete. The higher pulse velocity was showed by 50% filled rice-husk ash permeable polymer concrete. 4. The water permeability was in the range of $4.612{\sim}5.913{\ell}/cm^2/hr$, and it was largely dependent upon the mix design. These concrete can be used to the structures which need water permeability.

• Journal of the Korea Concrete Institute
• /
• v.20 no.3
• /
• pp.291-298
• /
• 2008

Cracks in concrete generally interconnect flow paths and increase concrete permeability. The increase in concrete permeability due to the progression of cracks allows more water or aggressive chemical ions to penetrate into concrete, facilitating deterioration. The goal of this research is to study the relationship between crack width and water permeability of cracked concrete. Tests have been carried out as a function of hydraulic pressure (0.1 $\sim$ 2 bar) and crack width (30 $\sim$ 100 ${\mu}m$). Splitting and reuniting method was used to manufacture cracked concrete specimens with controlled crack width. Crack widths are checked by using a microscope($\times$100). The results show a considerable increase of water transport with crack width and hydraulic pressure. When the crack width is smaller than 50${\mu}m$, the crack width has little effect on concrete permeability. Due to the autogenous healing, the water flow through the crack gradually reduces with time. When crack width is 100 ${\mu}m$ and hydraulic pressure increase from 0.1 bar to 0.25 bar, concrete permeability increases rapidly about 190 times according to the test results.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2016.05a
• /
• pp.171-171
• /
• 2016

최근 도시화가 진행되면서 지표의 불투수화가 급격하게 진행되고 강우의 지표면 유출량이 급격하게 증가하여, 강수 시 첨두유출 시간이 감소하고 단기간 집중유출이 증대되어 폭우로 인한 도시 홍수등이 발생하고 있다. 이러한 현상에 효과적으로 적응하기 위해 환경적으로 지속가능한 도시 개발을 위한 그린인프라(GI, Green Infrastructure) 및 저영향개발기법(LID, Low Impact Developpment)이 국내에 도입되고 있다. 하지만 아직까지 투수성 포장의 물순환 성능 평가 및 설계 방법에 대한 기준이 명확하지 않으며, 많은 경우 투수성 포장의 적용은 유출저감효과에 대한 정량적 해석 없이 적용되고 있는 실정이다. 이에 본 연구에서는 경남 양산시 부산대학교 제 2 캠퍼스에 있는 "한국형 GI&LID 실증실험단지"에 투수 도로형 실증실험시설을 구축하였다. 실험 시설은 불투수 아스팔트와 투수 아스팔트, 불투수 콘크리트와 투수 콘크리트 비교실험 할 수 있으며 도로표면 유출수 및 침투수에 대한 유량 및 수질 측정 모니터링을 통해 침투효과 및 특성을 분석할 수 있으며 차후 투수성 포장의 클로깅 현상으로 인한 투수성능의 감소 등 여러 가지 실험을 할 수 있을 것이다.

• Journal of the Korea Concrete Institute
• /
• v.13 no.5
• /
• pp.438-446
• /
• 2001

Recently, porous concrete has been used for the purpose of decreasing the load of earth environment. It consists solely of cement, water and uniform-sized coarse aggregate. And its fundamental properties will be considerably affected by the physical properties of aggregate because the aggregate occupies for the most part in its mix proportion. For such a reason, this study was carried out to investigate the influence of the sizes and kinds of aggregate for the fundamental properties of porous concrete. It showed that the fundamental properties of porous concrete were the similar value in all sizes of aggregate except in the case of using the 2.5∼5㎜ aggregate and were varied according to the kinds of aggregate. In particular, compressive strength of porous concrete using 2.5∼5㎜ aggregate was more higher than that using other aggregate, and its void ratio and coefficient of permeability was lower. And the maintenance capacity of permeability of porous concrete was varied by the sizes and the kinds of aggregate. In particular, it was greatly decreased in case of using the 2.5∼5㎜ aggregate. And unlike dynamic modulus of elasticity of ordinary concrete, that of porous concrete was very high value in early ages and was slowly increased after that time.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.601-604
• /
• 2008

When the concrete is placed, the water, needed for hydration of the cement, is under 30% of W/C including bound and gel water. However, as minimum water content cause bad workability, the W/C have to be higher. Therefore, fresh concrete produce 10${\sim}$20% extra water. As those water remain entrapped air in the concrete, life of the structure is reduced because of the degradation caused by entrapped air. For that reason, if extra water is eliminated, it will be great to improve the durability of the structures. Therefore, this study was performed to verity the fundamental properties through the experiment on the dewatering system using the euro form for eliminating extra water. When the dewatering form was applicated, the compressive strength was increased by 16% than those of normal form. However, the increasing rate of compressive strength got lower as the height is higher. In terms of ultrasonic pulse speed and surface roughness, the dewatering form showed better results than the normal one.

• Korean Journal of Agricultural Science
• /
• v.26 no.2
• /
• pp.56-60
• /
• 1999

This study is performed to evaluate the engineering properties of permeable polymer concrete. The following conclusions are drawn. 1. The unit weight is $1,883kgf/m^3$, which is decreased 18% than that of the normal cement concrete. 2. The strength of permeable polymer concrete is achieved that it is 170% by tensile strength and 240% by bending strength than that of the normal cement concrete, respectively. 3. The water permeability is $5.917l/cm^2/h$. This concrete can be used to the structures which need water permeability.

• Korean Journal of Agricultural Science
• /
• v.26 no.2
• /
• pp.49-55
• /
• 1999

This study is performed to evaluate the properties of permeable polymer concrete with blast furnace slag and fly ash. The following conclusions are drawn: 1. The highest strength is achieved by 50% filled blast furnace slag powder and fly ash permeable polymer concrete, it is increased 36% by compressive strength and 217% by bending strength than that of the normal cement concrete, respectively. 2. The static modulus of elasticity is in the range of $100{\times}10^3{\sim}130{\times}10^3kgf/cm^2$, which is approximately 43~51% of that of the normal cement concrete. 3. The dynamic modulus of elasticity is in the range of $102{\times}10^3{\sim}130{\times}10^3kgf/cm^2$, which is approximately less compared to that of the normal cement concrete. The highest dynamic modulus is showed by 50% filled blast furnace slag powder and fly ash permeable polymer concrete. The dynamic modulus of elasticity are increased approximately 0~4% than that of the static modulus. 4. The water permeability is in the range of $4.612{\sim}5.913l/cm^2/h$, and it is largely dependent upon the mix design.

• Journal of the Korea Concrete Institute
• /
• v.29 no.3
• /
• pp.267-273
• /
• 2017

Recently, the researches of self-healing concrete technology are being carried out actively due to the advent of importance for the maintenance of concrete structures. A water permeability test has been widely used for the evaluation of self-healing performance. However, it is difficult to compare tests results since there is no standard test method related to the self-healing. A standard method for measuring the crack width does not exist neither though the self-healing performance is significantly influenced by the initial crack width. In this study, the effect of water head and crack width on water flow was investigated using a constant water head permeability test equipment. The correlation equation between the initial crack width and water flow was suggested through the regression analysis of test data, and the predicted crack widths agree well with the real crack widths measured using microscopy.