• Proceedings of the KSEEG Conference
• /
• 2007.04a
• /
• pp.283-285
• /
• 2007

• The Journal of Engineering Geology
• /
• v.17 no.3
• /
• pp.471-481
• /
• 2007

The Landslide in natural slope is occurred mostly by a heavy rain of the summer. This landslide is influenced in soil property of the surface than the rock mass. Soils in natural slope are created by weathering phenomena of the bedrock. These soils differed to the geological conditions such as sedimentary rock, metamorphic rock and volcanic rock. Therefore, estimation of landslide in natural slope is the most important analysis of the bedrock distributions and soil characteristics. This study analyzed the soil property to the natural slopes of Busan area where is distributed to volcanic rock, granite and sedimentary rock. Soil sample conducted various soil tests for estimate the soil physical property and soil engineering characteristics, and analysis of the correlation of geological conditions. In the experiment result, soils were mainly classified by a clayey sand. It is also established that $1.07{\sim}1.99kg/cm^3$ for wet density, $28.2{\sim}39.6^{\circ}$ for angle of shearing resistance, and $8.10{\times}10^{-5}{\sim}8.38{\times}10^{-2}cm/sec$ for coefficient of permeability. From the physical parameter, the soils are estimated to the permeable ground with good shear strength, and soil properties are showed a differential tendency for each geological condition.

• 지반과기술
• /
• v.5 no.2
• /
• pp.16-27
• /
• 2008

• Journal of Korea Soil Environment Society
• /
• v.3 no.2
• /
• pp.127-145
• /
• 1998

Unlike water or air quality standards that have been established by legislation using potential human health impact as the primary criterion, soil quality depends on the soils primary function and its relevant environmental factors, which is much more site- and soil specific. A properly characterized soil quality assessment system should serve as an indicator of the soil capacity to produce safe and nutritious food, to enhance human and animal health, and to overcome degrative processes. For our proposed example, a high quality soil with regard to maintaining an adequate soil productivity as a food production resources must accommodate soil and water properties, food chain, sustainability and utilization, environment, and profitability, that (i) facilitate water transfer and absorption, (ii) sustain plant growth, (iii) resist physical degradation of soil, (iv) produce a safe food resources, (v) cost-effective agricultural management. Possible soil quality indicators are identified at several levels within the framework for each of these functions. Each indicator is assigned a priority or weight that reflects its relative importance using a multi-objective approach based on principles of systems to be considered. To do this, individual scoring system is differentiated by the several levels from low to very high category or point scoring ranging from 0 to 10, And then weights are multiplied and products are summed to provide an overall soil quality rating based on several physical and chemical indicators. Tlne framework and procedure in developing the soil quality assessment are determined by using information collected from an alternative and conventional farm practices in the regions. The use of an expanded framework for assessing effects of other processes, management practices, or policy issues on soil quality is also considered. To develop one possible form for a soil quality index, we should permit coupling the soil characteristics with assessment system based on soil properties and incoming and resident chemicals. The purpose of this paper is to discuss approaches to defining and assessing soil quality and to suggest the factors to be considered.

• Journal of the Korean Geosynthetics Society
• /
• v.12 no.3
• /
• pp.31-41
• /
• 2013

In this study, the properties of mudstone weathered soils related to landslides were analyzed at the area of landslide induced by heavy rainfall in Pohang. The soil tests were carried out to the soils obtained from landslide and non landslide sites, and the soil properties were investigated. The correlation between soil properties and landslides were analyzed using statistical technique, and then the soil factors were extracted from the correlation analysis. The correlation equation which can calculate the coefficient of permeability influenced on landslides was proposed using the soil factors. As the result of analysis, the porosity and unit weight of soils from the landslide area is smaller than those of soils from the non landslide area. The soils with poor grain size distribution and loose unit weight are prone to landslides because the soils have a large void ratio and a low unit weight. The permeability of soils from the landslide area is larger than that of soils from the non landslide area. According to the result of correlation analysis, the effective grain size, the saturated unit weight and silt and clay contents are evaluated as the influence factors. These factors were considered to estimate the coefficient of permeability of mudstone weathered soils.

• Proceedings of the KSEEG Conference
• /
• 2007.04a
• /
• pp.618-620
• /
• 2007

• The Journal of Engineering Geology
• /
• v.7 no.3
• /
• pp.217-227
• /
• 1997

The purpose of this study is to analyze the correlation of soil properties in coastal soft ground. For the purpose of this study, several coastal soft ground areas were selected. Many large scale construction works are being executed and will increase continuously in these soft ground areas. So, soil property in these areas is very important. The grounds forming coastal areas are affected by seawater movement. So, most of these areas consist of alluvium stratum. Therefore, soil properties of eastern and southern coastal areas are very complex. Many laboratory tests were executed with disturbed and undisturbed soil samples. Undisturbed samples were taken by using thin walled tubes and transported into the laboratory with caution, so as not to disturb the sample. The consistent rate of fine-grained content in these areas is over 90%. Also, these areas contain higher water content and clay content. Therefore, knowing these soil properties, it is possible to safely design fabrics and constructions.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.1C
• /
• pp.11-17
• /
• 2011

This study was performed a series of the isotropic compression-expansion tests and the drained triaxial tests with various the relative densities 25%, 50%, 80% and 100% for Baekma river sand. Using the tests results the characteristic of the parameters of Lade's single hardening constitutive model were investigated. The soil parameters Kur and n representing elastic behavior are not much affected by the change of the relative density. The other parameters such as failure criterion (m, ${\eta}_1$), hardening function (C, p) and plastic potential (${\Psi}_2$, ${\mu}$) are in a positive linear relationship with the relative density. Since the soil parameters h and $\alpha$ representing yield function do not change much to the change of relative density and also closely related to failure criterion, they can be replaced by failure criterion ${\eta}_1$. We also observed that predicted values from the Lade's single hardening constitutive model were well consistent with the observed data.

• The Journal of Engineering Geology
• /
• v.33 no.3
• /
• pp.475-487
• /
• 2023

We surveyed the distribution of soil layers on Dongdo and Seodo of Dokdo and measured the physical properties of the soils. To investigate the distribution of soil layers, the soil depth was measured directly in accessible locations, and visual observations of inaccessible locations were carried out using drones and boats. Soil depths ranged from 3 to 50 cm, and most soil layers had depths of 10~20 cm. Based on these results, a map of the soil layer was drawn using 5 cm intervals for soil depth. To analyze the soil characteristics of Dokdo, soil samples were collected from 13 locations on Dongdo and 13 locations on Seodo, in consideration of various geological settings. According to the results of grain size distribution tests, sand contents were >75%, and soil from Seodo contained more gravel-sized particles than that from Dongdo. Using the unified soil classification system (USCS) and textural classification chart of the United States Department of Agriculture (USDA), most of the soil samples from Dokdo are classified as sand, and some are classified as loamy or clayey sand. In addition, well-graded loamy or clayey sands are more common in Dongdo, and poorly graded sands with gravel are more common in Seodo. These results are expected to be important for studying soil characteristics on Dokdo.

• The Journal of Engineering Geology
• /
• v.19 no.1
• /
• pp.33-41
• /
• 2009

In this study, some changes of soil characteristics in a field were analyzed to investigate the effect of heavy rainfall during rainy season. The heavy rainfalls were often induced geohazards like landslides. To do this, the reaching rainfall in the ground surface was investigated according to a condition of vegetation, and the change of soil characteristics induced by infiltrating rainfall was analyzed. The study site is a natural terrain located in Daedeok Science Complex. This site has same geology and soil condition whereas it has different vegetable condition. The rainfall records during the rainy season of 2006 and 2007 were selected. The rainfall records are based on the measuring date from Daejeon Regional Meteorological Administration adjacent to the study site. Also, the rainfall records according to the condition of vegetation were measured using rainfall measuring device made by ourselves. The soil tests were carried out about soil specimen sampled before and after rainfall, and then the change of soil characteristics related to rainfall and vegetation were analyzed. As the result, the density of vegetation was influenced by reaching rainfall quantity in the ground surface, and its influence intensity was decreased with rainfall intensity and rainfall duration. Also, it shows that degree of saturations, water contents, liquidities and shear resistances are directly influenced by heavy rainfalls.