• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.9 no.2
• /
• pp.360-369
• /
• 2008

The solar cells should be operated at the maximum power point because its output characteristics were greatly fluctuated on the variation of insolation, temperature and load. It is necessary to install an inverter among electric power converts by means of the output power of solar cell is DC. The inverter is operated supply a sinusoidal current and voltage to the load and the interactive utility line. In this paper, the proposes a photovoltaic system is designed with a step up chopper and single phase PWM voltage source inverter. Synchronous signal and control signal was processed by one-chip microprocessor for stable modulation. The step up chopper is operated in continuous mode by adjusting the duty ratio so that the photovoltaic system tracks the maximum power point of solar cell without any influence on the variation of insolation and temperature for solar cell has typical dropping character. The single phase PWM voltage source inverter is consists of complex type of electric power converter to compensate for the defect, that is, solar cell cannot be develop continuously by connecting with the source of electric power for ordinary using. It can be cause the efect of saving electric power, from 10 to 20%. The single phase PWM voltage source inverter operates in situation, that its output voltage is in same phase with the utility voltage. The inverter are supplies an ac power with high factor and low level of harmonics to the load and the utility power system.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.21 no.4
• /
• pp.358-365
• /
• 2019

An agrivoltaic systems (AVS) is mixed systems associating photovoltaic panels (PVPs) and crop cultivation at the same time on the given land area. It is receiving attention to improve rural economy. However, it is likely that, the crop yield should be decreased due to the reduced absorption of solar radiation by leaves. Thus, before popularizing the AVS, it is necessary to comprehend the degree of shading by PVPs in AVS. In this study, the change of radiation condition under AVS mimic shading net was investigated. The minimum and maximum of difference of photosynthetically active radiation (PAR) between under and outside shading net were 3.03 mol/㎡/day on a cloudy day and 17.08 mol/㎡/day on a sunny day. This difference decreased when the ratio of diffuse irradiance to global irradiance increased. Such a shading effect resulted in the increase of rice height and decrease of rice tillering.

• Journal of the Korean Solar Energy Society
• /
• v.39 no.6
• /
• pp.113-125
• /
• 2019

With the opening of the small power brokerage business market in December 2018, the small power trading market has started in Korea. Operators must submit the day-ahead estimates of power output and receive incentives based on its accuracy. Therefore, the accuracy of power generation forecasts is directly affects profits of the operators. The forecasting process for power generation can be divided into two procedure. The first is to forecast solar irradiation and the second is to transform forecasted solar irradiation into power generation. There are two methods for transformation. One is to simulate with physical model, and another is to use regression model. In this study, we found the best-fit regression model by analyzing hourly data of PV output and solar irradiation data during three years for 242 PV plants in Korea. The best model was not a linear model, but a sigmoidal model and specifically a Gompertz model. The combined linear regression and Gompertz curve was proposed because a the curve has non-zero y-intercept. As the result, R² and RMSE between observed data and the curve was significantly reduced.

• Journal of the Korean Solar Energy Society
• /
• v.39 no.3
• /
• pp.47-57
• /
• 2019

Clear sky indices were estimated by various ways based on in-situ observation and satellite-derived solar irradiance. In principle, clear sky index defined by clear sky solar irradiance indicates the impacts of cloud on the incoming solar irradiance. However, clear sky index widely used in energy sciences is formulated by extraterrestrial irradiance, which implies the extinction of solar irradiance due to mainly aerosol, water vapor and clouds drops. This study examined the relative difference of clear sky indices and then major characteristics of clear sky irradiance when sky is clear are investigated. Clear sky is defined when clear sky index based on clear sky irradiance is higher than 0.9. In contrast, clear sky index defined by extraterrestrial irradiance is distributed between 0.4 and 0.8. When aerosol optical depth and air mass coefficient are relative larger, solar irradiance is lower due to enhanced extinction, which leads to the lower value of clear sky index defined by extraterrestrial irradiance.

• 한국신재생에너지학회:학술대회논문집
• /
• 2011.05a
• /
• pp.67.1-67.1
• /
• 2011

Knowledge of the solar radiation components and classified wavelength are essential for modeling many solar energy systems. This is particularly the case for applications that concentrate the incident energy to attain high photo-dynamic efficiency achievable only at the higher intensities. In order to estimate the performance of concentrating solar systems, it is necessary to know the intensity of the beam radiation, as only this components can be concentrated, and The new solar system can generate electricity from ultraviolet and infrared light as well as visible light. The Korea Institute of Energy Research(KIER) has began collecting solar radiation components data since January, 1988, and solar radiation classified wavelength data since November, 2008. KIER's solar radiation components and classified wavelength data will be extensively used by concentrating solar system users or designers as well as by research institutes.

• Journal of Ocean Engineering and Technology
• /
• v.14 no.2
• /
• pp.13-18
• /
• 2000

Recently due to the environmental pollution and the requirement for the substitute energy the interest for development of the solar energy system has been highly escalated It has been approved that the solar energy is a very useful on e because of purity and low cost. Some studies about the evaluation of solar radiation on the land has been carried out but few studies on the sea. This paper deals with a study on the evaluation of solar radiation on the sea. The experiments were carried out on the training vessel on the adjacent water of Korea Japan and China for twenty days. The distributions of solar radiation from the sea were changed into nonlinear in from according to the temperature. The solar radiation on the sea has a great influence on the velocity of wind as well as the temperature The distribuition of solar radiation has higher values on the track of the coastal sea than the open sea at same conditions.

• New & Renewable Energy
• /
• v.19 no.4
• /
• pp.84-97
• /
• 2023

This study aimed to investigate the feasibility and potential applications of utilizing bifacial photovoltaic (PV) panels from an architectural perspective. It also aimed to establish a foundational dataset for installation and operational guidelines for bifacial PV panels through a comparative analysis of energy production performance with single PV panels. The research encompassed several key steps, including a comprehensive literature review, calculation of solar surface radiation values, development of datasets for bifacial and single PV energy production, and a performance comparison between both approaches. The results of the study show that bifacial PV panels exhibit optimized energy production capabilities within the range of 40 to 80 degrees, contingent upon the specific installation location. Consequently, it is recommended that the installation of bifacial PV panels in Korea should primarily focus on southwest-to-west orientation. Furthermore, it was concluded that bifacial PV panels could contribute an equivalent or even superior level of energy production compared to single PV panels, even if their performance exhibited a marginally lower efficiency of 2% to 5% with an 18% power generation efficiency.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.22 no.4
• /
• pp.258-267
• /
• 2020

The agrivoltaic can produce electricity and grow crops on fields at the same time. It is necessary to analyze the cultivation environment and evaluate the crop productivity under agrivoltaic because the shading point changes according to structure of agrivoltaic and sun's position. Two types of "fixing" and "tracing" agrivoltaic were installed, and a rice cultivation experiment was conducted in the fields under each agrivoltaic and without shading (control). "Hyunpoombyeo" was transplanted on June 7, 2019, and grown with fertilization of 9.0-4.5-5.7 kg/10a (N-P-K). Fifteen weather stations were installed under each agrivoltaic to measure solar radiation and temperature, and yield and yield-related elements were investigated by points. The accumulated solar radiation during the rice growing season in fixing was no much difference between points, and that in tracing was much difference between points. However, the average solar radiations of two agrivoltaics were similar. The mean temperature, yield, and yield-related elements showed a significant difference for the shading rate, and decreased with increasing the shading rate except ripening grain rate and 1000 grain weight of fixing agrivoltaic. In the relationship between shading rate and yield, fixing and tracing were fitted to a logistic equation and a simple linear equation, respectively, and showed a high correlation (tracing: R2 = 0.62, fixing: R2 = 0.73). The shading rate variation by point for two types was large despite similar yield variation. Thus, it needs to be more closely examined the relationship of the shading rate for a specific period rather than the shading rate during the whole growing season.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.06a
• /
• pp.198.1-198.1
• /
• 2010

The goal of this study is to measure and compare the performance of solar heat pump for room and hot water heating. To accomplish the goal, solar heat pump with alumium roll bond type evaporator and indoor heat exchanger(condenser) was built and fully instrumented with thermocouples and pressure transducers etc. The test results showed that the COP(coefficient of performance) of HFC-134a($CF_3CH_2F$) were higher than those of CFC-12($CF_2Cl_2$). One "stratospherically safe" new refrigerant is 1,1,1,2-tetrafluoroethane(HFC-134a), which is thermodynamically similar to CFC-12 and considered to be a potential direct replacement for CFC-12 in air-conditioning and refrigeration applications. The solar heat pump system for room heating was designed to show the best efficiency that the room temperature make $18{\sim}20^{\circ}C$ and $23{\sim}25^{\circ}C$ in the southern part of South Korea during November, December, and January.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.08a
• /
• pp.439-439
• /
• 2012

태양광 발전은 발전 셀의 특성상 태양광의 일사량, 태양과 셀 단면이 이루는 각도에 따라서 발전량의 차이를 가져온다. 실리콘 태양전지의 전면 texturing은 입사광의 반사율을 크게 감소시키고, 태양전지 내에서 빛의 통과길이를 증가시켜 태양전지 내의 흡수하는 빛의 양을 증가 시키는 역할을 한다. 따라서 전면 texturing은 단락전류를 증대시키는 효과를 가지고 온다. 일반적으로 texturing은 alkaline etching (WET) 공정과 reactive ion etching (RIE) 공정이 사용된다. 그리고 다결정 실리콘 태양전지의 경우에는 재료의 결정방향에 따라 식각이 되어지는 WET 공정의 경우 texturing 모양을 제어할 수 없어 효과적이지 못하는 결과를 가지고 온다. 본 연구에서는 Electroluminescence을 측정하여 RIE, WET 공정을 사용하여 만든 texturing 구조의 다결정 태양전지의 Microcrack 및 Defect, Electrode Failure, Hot spot등을 검출하였으며, ${\mu}$-PCD 측정 결과와 비교 분석하여 Micro carrier life time을 유추하여 계산하였다. 또한 반사율을 측정해본 결과 WET 공정 대비 RIE의 경우 단파장영역에서 반사율이 크게 감소하여, 상대적으로 높은 External quantum efficiency (EQE)가 측정되었다. 이는 Jsc를 증가시켜, 태양전지의 효율이 증가되는 결과를 얻을 수 있었다.