• The Journal of the Acoustical Society of Korea
• /
• v.27 no.3
• /
• pp.129-139
• /
• 2008

The purpose of the present work is to derive the reflection and transmission coefficients of $S_0\;and\;A_0$ mode Lamb waves in relation to the geometry of a rectangular notch when the waves propagate across the notch in an elastic plate. Firstly, the excitable modes of the Lamb wave were analyzed with respect to the plate thickness. The scattering phenomena were divided into three independent processes according to the boundary shape of the notch and the direction of the wave propagation. Linear equations for each process were derived with corresponding free or continuous boundary conditions to analyze the scattered waves. By the rule of linear superposition, the waves scattered at each process were summed for each mode. Then the steady-state reflection and transmission coefficients of the scattered waves were determined so that the difference of energy flux between the incident and the scattered waves would remain within 4%.

• Journal of the Korean Geotechnical Society
• /
• v.29 no.9
• /
• pp.17-29
• /
• 2013

The geophysical methods have an advantage for investigating the wide area with low cost, and thus the application of these methods has been increased. The objective of this paper estimates the characteristics of alluvium through the geophysical methods including elastic wave, electrical resistivity and ground penetration radar. And the standard penetration test is also carried out for verifying the geophysical data with comparison. The sources of elastic wave method are divided into hammer and sissy and the electrical resistivity method is applied with different sizes, shapes and arrays of electrode for deciding the effective way. The center frequency is determined to be 270 MHz for considering the characteristics of soil. The results of ground penetration radar are also compared with those of standard penetration test. The high resolution shows when the source is a sissy in elastic wave method, however, the water level is not identified. In the electrical resistivity method, the non-polarizable electrode and schlumberger array show highly reliable data and the resolution of ground penetration radar is low. Thus, the results of this study are widely applied for determining the appropriate method when investigating the characteristics of alluvium.

• Geophysics and Geophysical Exploration
• /
• v.12 no.2
• /
• pp.183-191
• /
• 2009

Finite difference method using not general SSG (standard staggered grid) but RSG (rotated staggered grid) was applied to simulation of elastic wave propagation. Special free surface boundary condition such as imaging method is needed in finite difference method using SSG in elastic wave propagation. But free surface boundary condition in finite difference method using RSG is easily solved with adding air layer or vacuum layer. Recently PML (Perfectly Matched layer) is widely used to eliminate artificial reflection waves from finite boundary because of its' greate efficiency. Absorbing ability of CPML (convolutional Perfectly Matched Layer) that is more efficient than that of PML and CPML that don't use splitting of wave equation that should be adapted to PML was applied to FDM using RSG in this study. Frequency absorbing characteristic and energy absorbing ability in CPML layer were investigated and CPML eliminated artificial boundary waves very effectively in FDM using RSG in being compared with that of Cerjan's absorbing method. CPML method also diminished amplitude of waves in boundary layer of solid-liquid model very well.

• Geophysics and Geophysical Exploration
• /
• v.26 no.2
• /
• pp.52-61
• /
• 2023

The use of ultra-high-resolution (UHR) seismic surveys to preceisly characterize coastal and shallow structures have increased recently. UHR surveys derive a spatial resolution of 3.125 m using a high-frequency source (80 Hz to 1 kHz). A digital streamer system is an essential module for acquiring high-quality UHR seismic data. Localization studies have focused on reducing purchase costs and decreasing maintenance periods. Basic performance verification and application tests of the developed streamer have been successfully carried out; however, a comparative analysis with the existing benchmark model was not conducted. In this study, we characterized data obtained by using a developed streamer and a benchmark model simultaneously. Tamhae 2 and auxiliary equipment of the Korea Institute of Geoscience and Mineral Resources were used to acquire 2D seismic data, which were analyzed from different perspectives. The data obtained using the developed streamer differed in sensitivity from that obtained using benchmark model by frequency band.However, both type of data had a very high level of similarity in the range corresponding to the central frequency band of the seismic source. However, in the low frequency band below 60 Hz, data obtained using the developed streamer showed a lower signal-to-noise ratio than that obtained using the benchmark model.This lower ratio can hinder the quality in data acquisition using low-frequency sound sources such as cluster air guns. Three causes for this difference were, and streamers developed in future will attempt to reflect on these improvements.

• Geophysics and Geophysical Exploration
• /
• v.6 no.3
• /
• pp.134-137
• /
• 2003

A scheme for missing-trace interpolation of linear events is proposed. For a two-dimensional seismic dataset which contains linear events, a post-interpolation spectrum can be estimated from a portion of the original aliased spectrum. The restoration of missing trace data is accomplished by minimizing the energy after applying a filter which has an amplitude spectrum that is inverse to the estimated spectrum.

• Economic and Environmental Geology
• /
• v.43 no.4
• /
• pp.349-358
• /
• 2010

For imaging complex subsurface structures such as salt dome, faults, thrust belt, and folds, seismic prestack reverse-time migration in depth domain is widely used, which is performed by the cross-correlation of shot-domain wavefield extrapolation with receiver-domain wavefield extrapolation. We apply the prestack reverse-time migration, which had been developed at KIGAM, to the seismic field data set of Block 5 in Jeju basin of Korea continental shelf in order to improve subsurface syncline stratigraphy image of the deep structures under the shot point 8km at the surface. We performed basic data processing for improving S/N ratio in the shot gathers, and constructed a velocity model from stack velocity which was calculated by the iterative velocity spectrum. The syncline structure of the stack image appears as disconnected interfaces due to the diffractions, but the result of the prestack migration shows that the syncline image is improved as seismic energy is concentrated on the geological interfaces.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2007.04a
• /
• pp.353-357
• /
• 2007

We have been setting up experiments on propagation of shock waves generated by the pulsed laser ablation. One side of a thin metal foil is subjected to laser ablation as a shock wave propagates through the foil. The shock wave, which penetrates through the foil is reflected by an acoustic impedance which causes the metal foil to high-strain rate deform. This short time physics is captured on an ICCD camera. The focus of our research is applying shock wave and deformation of the thin foil from the ablation to accelerating micro-particles to a very high speed.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.20 no.3
• /
• pp.303-309
• /
• 2007

For the propagation of elastic waves in unbounded domains, absorbing boundary conditions at the fictitious numerical boundaries have been proposed. In this paper we focus on both first and second order paraxial boundary conditions(PBCs) in the framework of variational approximations which are based on paraxial approximations of the scalar and elastic wave equations. We propose a penalty function method for the treatment of PBCs and apply these into finite element analysis. The numerical verification of the efficiency is carried out through comparing PBCs with Lysmer-Kuhlemeyer's boundary conditions.

• Proceedings of the Earthquake Engineering Society of Korea Conference
• /
• 1999.04a
• /
• pp.93-99
• /
• 1999

조화진동하는 점진원에 의한 반무한 탄성체의 응답해석을 수행해 탄성체의 임의의 깊이에서의 응답을 나타내는 계산식을 유도했다 이결과는 최근 연구개발이 진행되고 있는 조화진원에 의한 정밀 지하구조탐사에 중요한 이론적 바탕이 된다. 먼저 실용상 중요한 수평가진에 의한 응답을 계산했다 표면에 큰 응답이 표면파의 형태로 발생하지만 수평진원의 에너지 방사형태는 지향성을 가지고 있어 진원아래의 원뿔형의 영역이 크게 여기된다는 사실을 밝혔다.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.14 no.2
• /
• pp.81-92
• /
• 2011

High resolution seismic profiles (chirp and sparker system) were analyzed for the interpretation of nearshore sedimentary environments of Suyeong Bay, Busan. The sedimentary sequence is classified into three seismic units (SU1a, SU1b, and SU2), overlying acoustic basement, and each units can be defined as erosional and disconformable strata. The lowermost SU1a is characterized by the acoustically parallel and prolonged inner reflections, compared with the upper SU1b displays irregular internal reflectors. The uppermost unit, SU2, is acoustically transparent. The acoustic basement is incised with channels, probably due to the active erosion during the early period of transgression. The acoustic basement deepens eastward in the study area, suggesting primary association with the Suyeong River. The upper SU1a and SU1b units constitute lowland-fill strata. SU2 is widely distributed over the study area. High resolution seismic profiles of Suyeong Bay provide significant information crucial to the interpretation of sedimentary environmental history, which is closely related to the sea level change, estuarine environment and influx of terrestrial sediments from the adjacent rivers.