• Korean Journal of Food Science and Technology
• /
• v.30 no.3
• /
• pp.665-671
• /
• 1998

Protein-bound polysaccharides (PBP) were extracted from the mycellia of Lentinus edodes SR-1, and their anti-tumor activities and immunopotentiating properties were observed. The amounts of PBP needed to extend the doubling time twofold (1 unit) were found to be 1 mg for mouse leukemic cells $P_{388}\;and\;L_{1210}$; 4.4, 3.6 and 6.6 for bowel cancer cells, HCT-48, HRT-18, HT-29 respectively; and 2.6 mg for liver cancer cell, Hep G2. When $P_{388}\;and\;L_{1210}$ were treated with 4 mg of PBP, more than 90% of the cell number were reduced in 48 hours. However, 9 mg of PBP and 72 hrs of incubation time were needed to obtain the same effect for HRT-18, HT-29, and Hep G2. The significant reduction of cell size was observed as the amount of PBP and the incubation time increased. Mice spleen weight and plaque forming cell number increased when the cancer cells were treated with PBP.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.11
• /
• pp.99-107
• /
• 2013

Controller area network (CAN) was designed for multiplexing communication between electronic control units (ECUs) in vehicles and thus for decreasing the overall wire harness. The increasing number of ECUs causes the CAN bus overloaded and consequently the error probability of data transmission increases. Since the time duration for the data transmission is proportional to CAN frame length, it is desirable to reduce the frame length. In this paper, a CAN message compression method is proposed using Data Length Code (DLC) and compression area selection algorithm to reduce the CAN frame length and the error probability during the transmission of CAN messages. By the proposed method, it is not needed to predict the maximum value of the difference in successive CAN messages as opposed to other compression methods. Also, by the use of DLC, we can determine whether the received CAN message has been compressed or not without using two ID's as in conventional methods. By simulations using actual CAN data, it is shown that the CAN transmission data is reduced up to 52 % by the proposed method, compared with conventional methods. By using an embedded test board, it is shown that 64bit EMS CAN data compression can be performed within 0.16ms and consequently the proposed algorithm can be used in automobile applications without any problem.

• Journal of the Korean Geotechnical Society
• /
• v.20 no.9
• /
• pp.47-56
• /
• 2004

A new fragmentation model, called the GRS (the generation model of weathered residual soils) model, was proposed in this study, This model could identify the formation of a residual soil. This model is based on the phenomena that as the soil was weathered more highly, soil particles were smaller and pores were more expanded simultaneously. The possibility of fragmentation, $P_F,$ which was based on the fractal theory, was introduced in this model. There were some fundamental notions in the GRS model that soil particles were generated as the rock is fragmented, and the fragmentation of the rock was performed step by step. The $P_F,$ of the rock was not constant at each fragmentation steps. As a result of application on the GRS model, there were more residue where $P_{Fi}s$ were small at any particle size. There was a S-shape of PSD curve at the concave shape of $P_{Fi},$ and the PSD curve goes to a gaped graded curve at the convex shape of $P_{Fi}.$ The shape of PSD curve was concave in the case of small $P_{Fi}s.$ The value of $P_{Fi}$ increased with the coefficient of uniformity $(C_u)$ and the fragmentation fractal dimension $(D_r),$ but had no relation with the coefficient of gradation $(C_C)$.

• The KIPS Transactions:PartA
• /
• v.11A no.6
• /
• pp.459-468
• /
• 2004

Sharing XML trees on mobile devices has become more and more popular. Optimistic replication of XML trees for mobile devices raises the need for reconciliation of concurrently modified data. Especially for reconciling the modified tree structures, we have to compare trees by node mapping which takes O($n^2$) time. Also, using semantic based conflict resolving policy is often discussed in the literature. In this research, we focused on an efficient reconciliation method for mobile environments, using edit scripts of XML data sent from each device. To get a simple model for mobile devices, we use the XML list data sharing model, which allows inserting/deleting subtrees only for the repetitive parts of the tree, based on the document type. Also, we use keys for repetitive part subtrees, keys are unique between nodes with a same parent. This model not only guarantees that the edit action always results a valid tree but also allows a linear time reconciliation algorithm due to key based list reconciliation. The algorithm proposed in this paper takes linear time to the length of edit scripts, if we can assume that there is no insertion key conflict. Since the previous methods take a linear time to the size of the tree, the proposed method is expected to provide a more efficient reconciliation model in the mobile environment.

• The korean journal of orthodontics
• /
• v.30 no.4 s.81
• /
• pp.467-473
• /
• 2000

As a rectangular wire Is inserted into edgewise brackets the wire exerts a force system three-dimensionally. The force system may include bending force in first and second orders and a torsional force in third order Analytical and experimental studies on bending force have been Introduced, but information about torsion is still lack. The purpose of this study was to estimate the torsional moment in the force system of rectangular arch wires through theoretical and experimental studies. Wires most frequently used for third order control were selected as study materials. Cross sections of 0.016x0.022, 0.017x0.025, 0.019x0.025 inch rectangular wires in foot different materials such as stainless steel(Ormco), TMA(Ormco), NiTi(Ormco), and braided stainless steel (DentaFlex, Dentaurum) were used. The torque/twist rate of each test material was calculated using the torsion formula. Torque/twist rate, yield torsional moment, and ultimate torsional moment were measured with a torque gauge. The torsion formula assesses that the torque/twist rate (T/$\theta$) is proportional to the characteristics of material (G) and cross section (J), and is inversely proportional to the length of wire (L). Most experimental results corresponded with the formula. The relative stiffness was calculated for reference to a logical sequence of wire changes.

• Journal of the Korean Magnetics Society
• /
• v.14 no.4
• /
• pp.143-148
• /
• 2004

Effects of residual flux density M$_{res}$ and number of inspection on the detection voltage and flux density B of the gas pipeline were investigated in MFL inspection, which is widely used for the non-destructive inspection in a gas pipeline. A simulation equipment composed of the magnetizer and iron ring attached on an aluminum disc was constructed instead of a huge gas pipeline facility. With this system. the iron ring could be perfectly demagnetized and signals from the bolt screw stuck on the disc could be clearly detected so that the effects of M$_{res}$S and the inspection number on the detection voltage and B of iron ring were effectively investigated. With increasing the number of inspection, M$_{res}$, B of the iron ring and the detection voltage decreased and then kept at constant values while final M$_{res}$ increased with increasing initial M$_{res}$. If inspection condition were kept unchanged, the detection voltage was proportional to the last M$_{res}$ of the iron ring instead of B. This was probably due to magnetic hysteresis of the iron ring inherited from magnetic domain so that consideration on the magnetic hysteresis was inevitable in the analysis of MFL signal from defects of a gas pipeline. A new inspection scheme using the magnetizer with reversed magnetization in the subsequent inspection was proposed from the result that a high detection voltage could be obtained in the first inspection of gas pipeline with positive M$_{res}$.

• Journal of the Korean Chemical Society
• /
• v.33 no.1
• /
• pp.70-81
• /
• 1989

Reverse phase liquid chromatographic elution behaviors of salicylic acid and its derivatives were studied with classical and modern high-performance liquid chromatography(HPLC) using Amberlite XAD-4 and XAD-7 resin packed columns. Capacity factors(k') were determined in the comparatively high concentration(from 0. 010F to 0. 150F) of ferric nitrate-50% methanol solution to elucidate the elution behaviors with classical method. On the other hand, k's were measured in the various concentrations of methanol and ferric nitrate(from $2.5{\times}10^{-4}F\;to\;1.0{\times}10^{-3}F$) solution of pH 2. 25 and 293K with HPLC to explain the elution mechanism of them, and to find their optimum separation condition. As a result, it was found that log k's of salicylic acid and its derivatives were decreased with increasing the concentration of ferric ion, and the decreasing slopes of the compounds on the increasing ferric ion concentrations were related with each stability constant of ferric salicylates. Some isomers of derivatives of salicylic acid could be separated in the optimum condition.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.13 no.2
• /
• pp.87-92
• /
• 2011

In order to better understand the role of litter layer on hydrological cycle in forest, we estimated the interception storage capacity of the litter layer at Gwangneung deciduous forest. We first made a thickness map of the litter layer at the study site based on field survey and then collected representative litter samples for the laboratory experiment. We constructed a measurement device consisting of sample tray, drain collector, tipping bucket, and a data logger. Using this device, we examined the relationship between the interception storage capacity ($C_i$) and the thickness (d) of the litter layer. For the range of d from 25 to 100 mm, there was a simple linear relationship between $C_i$ and d, which changed with the intensity of the simulated rain. The results were extrapolated to d smaller than 25 mm by considering that no interception occurs without litter layer. Overall, $C_i$ increased rapidly when d was low (< 25 mm) but the rate of increase decreased as d increased due to clumping. With an average thickness of 59 mm, the estimated $C_i$ at the site was 0.94 (${\pm}0.39$) mm. Such an interception storage capacity of the litter layer is comparable to that of the forest canopy, suggesting that the litter layer can play an important role in the forest water cycle.

• Korean Journal of Medicinal Crop Science
• /
• v.8 no.4
• /
• pp.304-311
• /
• 2000

This study was conducted to investigate the ratio and number of the Rhus javanica gall formed by chinese sumac aphid, Scheleechtendalia chinensis, in several different conditions in which R. javanica lives. The density of 11 to 15-year-old R. javanica was more higher and the number of galls was also higher than 1 to 5- or over 16-year-old one at these sites. The formed gall according to four directions such as the East, West, South and North was founded the highest at the East and followed South, North, and West order. The formative rate of R. javanica gall did not differ in the mixture forest, and in the habitat having a heap of a little stone and mosses near a valley was better than in the site of road perimeter. Through an index of the gall diameter and the number of chinese sumac aphid, we evaluated the gall processing and development formed by the aphid. As the density of aphids increase, the size of the gall was also more plumped. The part of phyllotaxy of R. javanica gall in leaf and pinnate of was increased in the middle and upper part of terminal leaflet and leaflet was more occupied than wing. R. javanica which did not form a gall in natural environmental, formed gall by a artificial inoculation of S. chinensis. Some gall disappeared during a gall development from various environmental conditions.

• Korean Chemical Engineering Research
• /
• v.48 no.2
• /
• pp.218-223
• /
• 2010

The zinc oxide thin film, which can be applied as the gas sensor of a semiconductor type, was grown on the silicon substrate by CFR(continuous flow reaction) method in this study. The growth property and the electrical property of the zinc oxide thin films synthesized by CFR method were also investigated. Zinc acetate solutions of 0.005~0.02 M were used as the precursor for the preparation of zinc oxide thin films. The size of ZnO particles consisted on the zinc oxide thin film increased not only with increasing concentration of precursor, but also the thickness of thin film increased. The growth rate of zinc oxide thin film by CFR method was proportionably depend on the concentration of precursor and the uniform ZnO thin film was prepared when zinc acetate of 0.01 M is used as the precursor. The charged currents on the zinc oxide thin films were obtained as its electrical property by I-V meter, and increased agree with increasing the thickness of zinc oxide thin film. Thus, it was concluded that the charged current on the zinc oxide thin film can be controlled with changing concentration of precursor solution in CFR method. The charged currents on the zinc oxide thin films also decreased when ZnO thin film is exposed under hydrogen sulfide of 500 ppmv at $300^{\circ}C$ for 5 min. From these results, it could be confirmed that the zinc oxide thin film prepared by CFR method can be used for the detection of sulfur compounds.