• Land and Housing Review
• /
• v.2 no.2
• /
• pp.163-170
• /
• 2011

Individual Vacuum Pressure Method (IVPM) is a soft ground improvement technique, in which a vacuum pressure can be directly applied to the vertical drain board to promote consolidation and to strengthen the soft ground. This method does not require surcharge loads, different to embankment or pre-loading method. In this study, the ground improvement efficiency of Individual Vacuum Pressure Method was estimated when suction pressure increases step by step(-20, -40, -60, -80kPa) with different periods. During Individual Vacuum Pressure Method process, surface settlement and pore pressure were monitored, and cone resistance as well as water content were also measured after the completion of Individual Vacuum Pressure Method treatment. From the results, optimum duration of each step of vacuum pressure was determined, and the settlement was calculated using FEM numerical analysis.

• Journal of the Korean GEO-environmental Society
• /
• v.8 no.1
• /
• pp.33-40
• /
• 2007

Engineering behaviour of uplift-resisting ground anchors constructed in weathered rocks has been investigated by carrying out a series of full scale pull-out tests. The anchor was to resist uplift forces (buoyancy) associated with high groundwater table acting on the basement of a rail way station. The study has included the ultimate pull-out capacity of the anchors and shear stress transfer mechanism at the anchor-ground interface. The pull-out tests were conducted by changing bonded lengths of the anchor (2~7 m) and diameter of drilled borehole (108~165 mm) to investigate their effects on the behaviour of the anchor. The measured results showed that the ultimate capacity of the anchors was increased with an increase in the bonded length, diameter of drilled borehole as expected. The ultimate capacity of the anchors deduced from the pull-out tests ranged from 392 to 1,569 kN, depending on the above-mentioned factors. This corresponds to the interface shear strength of about 227~505 kPa. Interface shear stresses deduced from the pull-out test showed that the larger the pull-out force, the larger the mobilisation of the interface shear strength. The failure mode of the anchors heavily depended on the bonded lengths of the anchors. When the bonded length was short (2~3 m), a cone-type failure was observed, whereas when the bonded length increased (5~7 m), failure developed at the grout-ground interface.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.23 no.4
• /
• pp.86-95
• /
• 2019

Recently, the applications of carbon fiber have been broader than ever when it comes to such industrials as automobiles, ships, aerospace, civil engineering and architecture because of their lightweight-ness and high mechanical properties. This study analyzed mechanical properties and flexural behavior of carbon fiber reinforced cement composites(CFRC) with different fiber contents and fiber lengths, and also impact resistance by natural drop test on mortar specimens was compared and examined. In addition, contents of carbon fiber(CF) were varied by 0.5%, 1.0%, 2.0% and 3.0%. Fiber lengths was used for 6 mm and 12 mm, respectively. As a result of the test, the flow value was very disadvantageous in terms of fluidity due to the carbon fiber ball phenomenon, and the unit weight was slightly reduced. In particular, the compressive strength was decreased with increasing carbon fiber contents. On the other hand, the flexural strength was the highest with 12 mm fiber length and 2% fiber content. As the results of the impact resistance test, the specimens of plain mortar takes about 2~3 times to final fracture, while the specimens of CFRC is somewhat different depending on the increase of the fiber contents. However, when the fiber length is 12 mm and the fiber content is 2%, the impact resistance was the highest.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.41 no.1
• /
• pp.1-11
• /
• 2021

In order to reuse existing onshore turbine foundations, it is important to redesign and reinforce the existing foundations according to the upgraded tower diameter and turbine load. In the present study, a slab extension reinforcement method and structure details of an anchorage part were examined in consideration of the reuse of spread footings, which are the most widely used foundation type in onshore wind turbine foundations. Experiments were conducted to evaluate the load resistance performance of a reinforced spread footing according to structure details of an anchorage part. The results showed that (1) the strength of an anchorage part could be increased by more than 30 % by adding reinforcement bars in the anchorage part, (2) pile-sleeves attached to an anchor ring contributed to an increase in rotational stiffness by preventing shear slip behavior between the anchor ring and the concrete, and (3) slab connectors contributed to an increase in the strength and deformation capacity by preventing the separation of new and old concrete slabs.

• Journal of the Korean Geotechnical Society
• /
• v.23 no.7
• /
• pp.17-25
• /
• 2007

Various geotechnical problems due to insufficient bearing capacity or excessive settlement are likely to occur when constructing roads or large complexes on soft ground. Accurate predictions of the magnitude of settlement and the consolidation time provide numerous options of ground improvement methods and, thus, enable to save time and expense of the whole project. Asaoka's method is probably the most frequently used one for settlement prediction and the empirical formulae such as Hyperbolic method and Hoshino's method are also often used. To find an elaborate method of predicting the embankment settlement, two recurrent type neural network models, such as Jordan model and Elman-Jordan model, are adopted. The data sets of settlement measured at several domestic sites are analyzed to obtain the most suitable model structures. It was shown from the comparison between predicted and measured settlements that Jordan model provides better predictions than Elman-Jordan model does and that the predictions using CPT results are more accurate than those using SPT results. It is believed that RNN using cone penetration test results can be a highly efficient tool in predicting settlements if enough field data can be obtained.

• Journal of Aquaculture
• /
• v.21 no.2
• /
• pp.82-88
• /
• 2008

A 12-week feeding trial was conducted to investigate the effects of dietary supplementation of probiotics as a feed additive for juvenile Korean rockfish Sebastes schlegeli. Four experimental diets supplemented with no probiotic(Control), Bacillus polyfermenticus(BP), Bacillus licheniformis(BL) or Bacillus polyfermenticus plus Saccharomyces cerevisiae(BP+SC) at $1.0{\times}10^7$ CFU/kg diet as a dry-mater(DM) basis were prepared by mixing with a basal diet. After 12 weeks of the feeding trial, fish fed BP+SC diet showed significantly higher weight gain(WG), feed efficiency(FE), specific growth rate(SGR) and protein efficiency ratio(PER) than those of fish fed control diet(P<0.05), however there were no significant differences in WG, FE, SGR and PER among fish fed the BP, BL and BP+SC diets. Fish fed BP and BP+SC diets showed significantly higher condition factor(CF) than that of fish fed control and BL diets. Fish fed BP, BL, BP+SC diets showed significantly higher hepatosomatic index(HSI) than that of fish fed control diet, however there was no significant difference in HSI among fish fed BP, BL and BP+SC diets. Fish fed BP+SC diet showed significantly lower serum glucose than that of fish fed control diet, however there was no significant difference in serum glucose among fish fed BP, BL and BP+SC diets. Fish fed BP+SC diet showed significantly higher respiratory burst activity(NBT assay) than that of the fish fed control and BL diets, however there was no significant difference in NBT assay between fish fed BP and BP+SC diets. Fish fed BP and BL diets showed significantly higher lysozyme activity than that of the fish fed control diet, however there was no significant difference in lysozyme activity among fish fed BP, BL and BP+SC diets. Fish fed BP and BP+SC diets showed significantly lower cumulative mortality than that of the fish fed control diet, however there was no significant difference in cumulative mortality among fish fed BP, BL and BP+SC diets after the challenge test. From these results, dietary B. polyfermenticus, B. licheniformis and B. polyfermenticus plus S. cerevisiae supplementation in juvenile Korean rockfish diet could enhance growth performances, non-speicific immunities and a higher resistance against the specific pathogen.