• The Magazine for Energy Service Companies
• /
• s.31
• /
• pp.34-37
• /
• 2004

• KOREAN POULTRY JOURNAL
• /
• v.34 no.12 s.398
• /
• pp.91-94
• /
• 2002

• The Magazine for Energy Service Companies
• /
• s.83
• /
• pp.36-45
• /
• 2013

• The Safety technology
• /
• no.195
• /
• pp.54-54
• /
• 2014

• Journal of radiological science and technology
• /
• v.40 no.4
• /
• pp.605-611
• /
• 2017

The structure of the actual detector was computed using the code of the PENELOPE. Using the standard mixed sources (450, 1,000 ml), compare the effectiveness of each energy according to various densities and height of the PENELOPE computer simulation, and calculate the effectiveness of the various environmental specimens and apply them to various environmental specimens to determine the lower limit. The values obtained by the obtained value were obtained by applying the obtained efficiency to the actual environmental specimens and obtaining the lower limit values. The density correction factor is 1.155 g of the density correction factor of $0.4g/cm^3$ (59.54keV), 1.153 (661 keV), $1.06g/cm^3$ 1.064 (1,836.04keV), 1.03, and 1.033. It was confirmed that the radioactivity concentration of environmental samples decreased as the amount of specimen was measured increases, and the MDA value decreased as time measured increases.

• Clean Technology
• /
• v.14 no.2
• /
• pp.95-102
• /
• 2008

In order to choose alternative environmental-friendly cleaning agents, it is very important in the present point that the systematic selection procedures should be introduced and applied to the industry through the evaluation of their cleaning ability, environmental characteristics, and economical factors, and that the objective and effective evaluation methods of cleanliness should be established for the industry. Thus, a novel cleaning evaluation method utilizing optically stimulated electron emission (OSEE) among various methods of cleaning ability was studied in this study. The contaminants used in this cleaning experiments were flux, solder, grease, cutting oil, and mixed soil of 35% grease and 65% cutting oil. The cleaning agents developed or prepared in our laboratory were employed and their cleaning ability were comparatively evaluated by the OSEE, gravimetry and contact angle methods. The experimental results in this work showed that flux cleaning efficiency measured by the OSEE method was similar to that of the gravimetric method, but that the OSEE method could not be compared with gravimetric method for the case of solder or grease cleaning because the contaminants radiate or absorb ultra-violet light. In case of cutting oil cleaning, the gravimetric method indicated its limitation of cleaning efficiency of cutting oil since it showed cleaning efficiency of 100%, even though residual soil remaining on the substrate surface a little after its cleaning. The comparative experimental results of cleaning ability evaluated by the OSEE- and contact angle measurement methods showed that they were similar in case of cleaning of flux, mixed soil and cutting oil. It was judged that the contact angle measurement method could evaluate the cleaning ability more precisely than the OSEE method for cleaning solder and grease.

• Analytical Science and Technology
• /
• v.25 no.2
• /
• pp.146-151
• /
• 2012

An analytical method was developed for the measurement of uranium isotope in ground water using the liquid scintillation counting technique. A LKB Wallac Quantulus 1220 liquid scintillation counter (LSC) equipped with pulse shape analyzer (PSA) and a solvent extraction method were used for the measurement of uranium isotope in ground water samples. The effect of solution volume on the extraction efficiency was evaluated for 100 to 1000 mL solutions using a NIST standard reference material (NIST SRM 4321C). The effect of groundwater pH on the extraction efficiency was also investigated for pH ranging from 0.5 to 10. It was found that the extraction efficiency had a strong dependence on pH showing a maximum at pH 2. In contrast, the effect of groundwater volume on the extraction efficiency was negligible in the range investigated. According to the method, the extraction efficiency of uranium isotopes was near 96% and the lower detection limit for uranium was 0.018 Bq/L with the counting time of 300 min. The result of this study was also verified by the conventional ICP-MS measurement. It is demonstrated that the suggested method is valuable to the determination of the optimum extraction and measurement conditions for uranium in ground water. The method was successfully applied to the ground water at four locations near the Daejeon province. It was found that the uranium content and the isotopic ratio of $^{234}U/^{238}U$ at the locations ranged 0.59~6.69 Bq/L and 0.72~1.40, respectively.

• Proceedings of the Korean Institute Of Construction Engineering and Management
• /
• 2004.11a
• /
• pp.608-611
• /
• 2004

Efficiency of the construction process is one of the most important factors to project success. However efficiency is not well defined or measured in construction projects in general. More importantly, efficiency of the construction should be viewed through the life-cycle of the whole production system not in a single phase of the construction process. Therefore, this study defines the concept of efficiency and suggests the efficiency measurement model in construction. As a case study, the suggested model was applied to the curtain wall construction process of the high rise buildings as well.

• Environmental and Resource Economics Review
• /
• v.23 no.3
• /
• pp.365-408
• /
• 2014

The purpose of this paper is to compare efficiencies, two stage efficiencies, and the reduction of economic growth due to the restraint of $CO_2$ and fossil fuel in two efficiency approach by pointing out the limit of traditional efficiency approach and introducing material balance approach. The efficiencies under the traditional approach and the material balance approach report significant gaps when they are analyzed in detail. Especially, in case not including fossil fuels, the low income countries show the bad performance of production efficiencies, but OECD and high-middle income countries reveal the better performance than that of the low countries. It fails to reflect the reality justly. Based on the material balance approach, the low income countries report the higher performance and the alleviated effect of environmental components for economic growth than OECD's.

• Environmental and Resource Economics Review
• /
• v.18 no.2
• /
• pp.191-215
• /
• 2009

In the real world, there exist various products in terms of price and quality, and it can be expected that a product with lower price and higher quality than others is better. Hence efficiency of consumption behaviour can be measured by the level of goodness in terms of price and quality attributes of that product. The purpose of this research is to define consumption efficiency in terms of price and quality, and to measure consumption efficiency of IT and electronic products in South Korea. From the results, many consumers have purchased inefficient products m air-conditioner, TV, digital camera, MP3 player, computer markets. On the other hand, consumers have purchase efficient products in refrigerator and washing machine markets relatively. In addition, we analyze the relationship of consumption efficiency, information channel, and electric power consumption. This research may provide meaningful information for consumer's behaviour by measuring consumption efficiency quantitatively.