• Journal of Korean Society of Environmental Engineers
• /
• v.27 no.5
• /
• pp.468-475
• /
• 2005

Biofilters packed with various materials have emerged as a sustainable technology for the treatment of volatile organic compounds (VOCs); however, problems including low performance and clogging are commonly encountered. Recently, a bioactive foam reactor (BFR) using surfactants has been suggested to ensure efficient and stable VOCs removal performance. This study was mainly conducted to investigate the feasibility of BFRs using toluene as a model compound. Prior to bioreactor studies, a series of bottle tests were used to select a suitable surfactant for the BFR application. Experimental results of the batch bottle tests indicated that TritonX-100 was the most appropriate one among the surfactants tested, since it showed a minimal effect on the toluene biodegradation rate while the other surfactants lowered the toluene biodegradation rate significantly. Using the selected surfactant, the BFR performance was determined by changing operating parameters including gas residence time and toluene loading. As the gas residence time increased from 0.5 minutes to 2 minutes, the toluene removal efficiency increased from approximately 50% to 80%. In addition, an increase of the toluene loading from $38\;g/m^3/hr$ to $454\;g/m^3/hr$ resulted in a decrease of toluene removal efficiency from approximately 70% to 20%. The BFR had a maximum elimination capacity of $108\;g/m^3/hr$ for toluene, which was much higher than those generally reported in the literature. The high toluene-elimination performance indicates that the BFR be a potential alternative to the conventional, packed-type biofilters. However, the limitation of toluene solubilization and foam stability at either high or low gas flow rate are still problems to be challenged.

• Journal of Korean Association for Spatial Structures
• /
• v.17 no.2
• /
• pp.33-41
• /
• 2017

Composite Floor system infilled with PCM(Phase Change Material) between upper and lower steel plates was developed to apply the steel frame. When steel frames were applied this system, it can absolutely reduce the duration of construction due to dry construction method. However to apply this system as a structural floor member without fire resistance covering, it must have 2 hours fire resistance performance. Because PCM consisted of three quarters of section with thermal insulation performance, fire resistance performance of this floor system was expected to easily have 2 hours fire resistance performance. This paper was to investigate behavior characteristics of PCM infilled floor system at elevated temperature using FEM analysis to develop the fire resistance performance of it.

• Journal of the Mineralogical Society of Korea
• /
• v.25 no.1
• /
• pp.41-50
• /
• 2012

페루 남동부 지역에 위치한 꾸스코 동-금을 포함한 다중금속 광상 지역의 지질은 고생대 페름기-중생대 삼첩기 변성퇴적암인 미투(Mitu)층군과 이를 관입한 동시기 관입암으로 구성되어 있다. 조사지역은 페름기-삼첩기 관입암과 관련된 U-W-Sn-Mo, Au-Cu-Pb-Zn, REE 광화작용과 관련된 금속광화 대로 알려져 있다. 특히 해당 관입암은 대자율 측정 결과 S-type, 티탄철석계열과 관련이 있는 것으로 보인다. 꾸스코 지역은 깔까 북쪽과 시꾸아니 부근에 주요 광화대가 발달하고 있다. 조사대상 광상은 아줄 동, 올미오 동, 빅토리아 금, 빠딴자 동, 나우챠피-초차까나 동, 체카 금광상이다. 아줄 광상의 모암은 안산암질암이며 광석광물로는 반동석 및 황동석이 산출하며, 동은 7.81~15.3%의 범위를 가지고 평균 10.7%이다. 올미오 광상의 모암은 흑색편암이며 엽리를 따라 산화동이 충진되어 있고, 동은 0.61~2.60%의 범위를 가지고 평균 1.74%이다. 빅토리아 광상의 모암은 변성퇴적암이며, 석영맥 충진형 광상으로 금함량은 < 0.1 g/t, 은함량은 < 0.1~< 0.3 g/t이다. 빠딴자 광상에서는 이암 또는 실트암의 층리를 따라 충진하고 있는 산화동이 산출하며, 동은 3.74~9.21%의 범위를 보이며 평균 6.21%이다. 나우챠피-초차까나 광상은 적색사암의 층리를 교대충진하고 있는 산화동 광체이며, 동은 1.62~10.5%의 범위를 가지며 평균 6.39%이다. 체카 광상은 모암인 규암이 각력화작용을 받은 부분에서 금이 산출되고 있는 것으로 보고되어있으나 분석결과 금이 탐지되지는 않았다.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.6 no.1
• /
• pp.31-42
• /
• 1998

A fundamental study on methane conversion for the collection organic wastes of agriculture, forestry and fishers was performed in a laboratory scale. As a result, selected Run B sample were obtained 18.41 C/N Ratio and 168.96 mg/L TCOD; Under the biochemical methane potential test, theoretical and actual methane generation was 313.6 mg/L VS added and 234.2 mg/L VS added, respectively; However, methane conversion from Run B were occurred 74% by anaerobic digestion. By the first order reaction kinetics, kinetic constant were $0.2476d^{-1}$ for Run B. Three steps fill-up filter reactor was evaluated methane content 16% up to promote than blank reactor; TCOD and SCOD have reduced 44.7% and 44.2%, respectively.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.16 no.4
• /
• pp.46-54
• /
• 2002

A dielectric pellets bedded parallel plates with a membrane centered have been proposed as an ion separation and collection system in water. and effects of the relative dielectric constant and the applied square wave pulse voltage on the characteristics of ion separation and collection in tap water and NaCl dissolved tap water have been investigated. As a result, electrolyzed water of pH 3.1 and 10.6 were obtained with only tap water at the pulse current of 1.0[A] and flow rate of 0.5[LPM]. And the higher ionized water of pH 2.8 and pH 11.7 ware obtained in 0.1[%wt] NaCl dissolved water. When the dielectric pellets of BaTiO$_3$ having the highest dielectric constant were bedded in the ion separation and collection cell, the ionized water of pH 2.7 and pH 11.7 were obtained with only tap water. And the ionized water of pH 2.4 and pH 12.0 were obtained in 0.1[wt%] NaCl dissolved tap water with the dielectrics pellets bedded ones.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.7
• /
• pp.770-775
• /
• 2006

Biofilters packed with various materials commonly show problems such as low performance and clogging in a long-term operation. Recently, a bioactive foam reactor(BFR) using surfactants has been suggested to ensure efficient and stable VOCs removal performance. This study was mainly conducted to investigate the feasibility of the BFR system using styrene as a model compound. An abiotic md a biotic tests were conducted to estimate a mass transfer coefficient($K_La$) and a specific substrate utilization coefficient(k) for the BFR, showing the rate of mass transfer was greater in the BFR than in other diffuser systems. A dynamic loading test also indicated that the performance of the BFR was stable under a shock loading condition. Furthermore, the maximum elimination capacity of the BFR was determined to be 109 $g/m^3/hr$ for styrene, which was much higher than those for biofilter systems generally reported in the literature. Overall, the experimental results suggest that the BFR be a potential alternative to the conventional packed-bed biofilters.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.32 no.1
• /
• pp.75-81
• /
• 2003

Rheological properties of micronized full-fat soyflour (MFS ) milk were determined according to solid content, heat-treatment and type of coagulants. Heat-treated MFS milk showed a pseudoplastic flow pattern. The consistency and flow index of heated MFS milk was greatly affected by increasing the concentration of MFS and/or soy protein isolate (SPI). Apparent viscosity of MFS milk was gradually decreased by heating below 6$0^{\circ}C$, but was drastically increased by raising temperature further. Addition of coagulants and SPI resulted in dropping the temperature that allows to increase apparent viscosity drastically. A coagulant for MFS tofu was formulated based on the gelling Property of a single coagulant. The textural properties of MFS tofu were improved using 7.1% total protein fortified with SPI.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.11 no.2
• /
• pp.67-73
• /
• 2011

This study aims to develop an economical precast hollow concrete column with high constructability which consists of only splice sleeve and general reinforcing bar without using PC tendons in order to reduce the construction period and cost. With this purpose, this study performed the finite element analysis and tension test by using some variables such as length of sleeve, diameter of rebar and curing method for suggesting a grouting type splice sleeve which is a new type joint rebar and developing an optimized splice sleeve. As a result, the analysis on the tension performance of splice sleeve did not show any destruction caused by pull-out in reinforcing bar but it only occurred destruction of tension bar or bolt shear rupture from the mechanical defect of sleeve. Therefore, the experiment showed high performance in tension of the suggested splice sleeve and verified the application of precast hollow concrete column.

• Economic and Environmental Geology
• /
• v.40 no.5
• /
• pp.517-535
• /
• 2007

Two distinctive Mesozoic hydrothermal systems occurred in South Korea: the Jurassic/Early Cretaceous(ca. $200{\sim}130$ Ma) deep-level ones during the Daebo orogeny and the Late Cretaceous/Tertiary(ca. $110{\sim}45$ Ma) shallow hydrothermal ones during the Bulgugsa event. The Mesozoic hydrothermal system and the metallic mineralization in the Korean Peninsula document a close spatial and temporal relationship with syn- to post-tectonic magmatism. The calculated ${\delta}^{18}O_{H2O}$ values of the ore-forming fluids from the Mesozoic metallic mineral deposits show limited range for the Jurassic ones but variable range for the Late Cretaceous ones. The orogenic mineral deposits were formed at relatively high temperatures and deep-crustal levels. The mineralizing fluids that were responsible for the formation of theses deposits are characterized by the reasonably homogeneous and similar ranges of ${\delta}^{18}O_{H2O}$ values. This implies that the ore-forming fluids were principally derived from spatially associated Jurassic granitoids and related pegmatite. On the contrary, the Late Cretaceous ferroalloy, base-metal and precious-metal deposits in the Taebaeksan, Okcheon and Gyeongsang basins occurred as vein, replacement, breccia-pipe, porphyry-style and skarn deposits. Diverse mineralization styles represent a spatial and temporal distinction between the proximal environment of subvolcanic activity and the distal to transitional condition derived from volcanic environments. The Cu(-Au) or Fe-Mo-W deposits are proximal to a magmatic source, whereas the polymetallic or the precious-metal deposits are more distal to transitional. On the basis of the overall ${\delta}^{18}O_{H2O}$ values of various ore deposits in these areas, it can be briefed that the ore fluids show very extensive oxygen isotope exchange with country rocks, though the ${\delta}D_{H2O}$ values are relatively homogeneous and similarly restricted.

• Economic and Environmental Geology
• /
• v.37 no.1
• /
• pp.1-19
• /
• 2004

Metallic deposits in Korea have a variety of genetic types such as hydrothermal veins, skarns, hydrothermal replacement and alaskite deposits and so on. Geological, mineralogical and geochemical features including host rock, wall-rock alteration, ore and gangue mineralogy, mineral texture and secondary mineralogy related to weathering process control the environmental signatures of mining areas. The environmental signatures of metallic deposits closed from early 1970s to late 1990s in Korea show complicate geochemistry and mineralogy due to step weathering of primary and secondary minerals such as oxidation-precipitation-remobilization. The potentiality of low pH and high heavy metal Concentration s from acid mine drainage is great in base-metal deposits associated with polymetallic mineralization, breccia-pipe type and Cretaceous hydrothermal Au veins with the amount of pyrite whereas skam, hydrothermal replacement, hydrothermal Cu and Au-Ag vein deposits are in low contamination possibility. The geoenvironmental models reflecting the various geologic features closely relate to disuibution of sulfides and carbonates and their ratios and finally effect on characteristics of environmental signatures such as heavy metal species and their concentrations in acid mine drainage.