• Proceedings of the Korean Nuclear Society Conference
• /
• 1996.05b
• /
• pp.67-72
• /
• 1996

수격현상(Waterhammer)으로 인한 과도압력하중은 월성원자력발전소 비상노심냉각계통 (Emergency Core Cooling System : ECCS) 설계의 주요 고려사항이다. 비상노심냉각계통은 특수안전계통으로서 냉각재상실사고(Loss of Coolant Accident : LOCA)후 일차열수송계통을 다시 채워주고 핵연료 손상을 막기위해 노심으로부터 잔열 및 붕괴열을 제거한다. 일차열수송계통으로의 비상냉각수 주입은 고압주입, 중압주입, 저압주입 3 단계로 주입된다. 과도압력이 발생될 것으로 예상되는 고압주입과 중압주입에 대한 6가지 사례들이 ECCS의 배관과 지지대 설계를 위해 고려되었다. 모든 사례에 대한 비상노심냉각계통의 과도압력 현상은 PTRAN 코드에 의해 해석 되었고 해석된 최고과도압력은 설계압력보다 작음을 알게 되었다. 모든 사례의 최고압력과 최고차압은 비상노심냉각계통 배관 및 지지대 설계를 위한 응력해석 자료로서 사용될 것이다.

• Water for future
• /
• v.28 no.5
• /
• pp.141-150
• /
• 1995

An air chamber is designed to keep the pressure from exceeding a predetermined value, or to prevent low pressures and column separation. Therefore, it can be used to protect against rapid transients in a pipe system following abrupt pump stoppage. In this research, an air chamber was applied to a hypothetical pipe system to analyze attenuation effect of pressure head for different air volumes, locations, chamber areas, coefficients of orifice loss and polytropic exponents. With an increase of air volume, the maximum pressure head at pump site is decreased and the minimum pressure head is increased. For different locations and areas of the chamber, the attenuation effects do not show much difference. Also, as the orifice loss coefficient increases, the maximum pressure head is decreased. For different polytropic exponents, isothermal process shows lower maximum pressure head than that of the adiabatic process.

• Journal of the Korean Institute of Gas
• /
• v.24 no.6
• /
• pp.61-69
• /
• 2020

This paper is a study of the behavior characteristics that occur in the hydrogen storage vessel TYPE 1 according to pressure and temperature conditions by FEM(Finite element method). Von Mises stress (VMS) generated at the highest pressure was compared with Yield strength (YS) of the material for structural safety assessment of the container, and the results of plastic strain energy density (PSED) were analyzed as basic data for life expectancy. According to the analysis results, the safety of the hydrogen gas storage vessel is not ensured due to the occurrence of VMS higher than the yield strength on the bottom of the storage container at a gas pressure of 40 Mpa or higher. In addition, the results of VMS caused by temperature conditions are very low and the behavior by temperature can be ignored. The maximum pressure of VMS/YS below 1 is calculated to be about 30 Mpa, indicating that the hydrogen storage container subject to this paper should be managed with a gas charging pressure of less than 30 Mpa.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.11 no.5
• /
• pp.1-6
• /
• 2003

The torque is an important measure that represents the performance of a particular engine. Furthermore the information of engine torque can be used as a primary feedback parameter in modem engine management system. In this paper, a methodology is proposed for torque estimation of SI-engine. Since the proposed method uses cylinder pressure sensor, the torque can be estimated in a simple manner. The indicated torque is estimated from the peak pressure and its location, and the load torque is observed by the state observer based on the estimated indicated torque. The proposed method is accurate and robust against the variations that affect the torque production such as spark timing, mass air flow and others. This torque estimation method may be an alternative solution to the use of engine torque maps in a modem torque-based engine management system.

• Journal of the Korean Institute of Gas
• /
• v.14 no.2
• /
• pp.1-6
• /
• 2010

The strength safety of high pressure gas cylinder has been analyzed by using a finite element method. In this study, the internal gas pressures of a steel bombe include a service charging pressure of $9kg/cm^2$, high limit charging pressure of $18.6kg/cm^2$, high limit of safety valve operation pressure $24.5kg/cm^2$, and hydraulic testing pressure of $34.5kg/cm^2$. The computed FEM results indicate that the strength safety for a service charging pressure of $9kg/cm^2$ and high limit charging pressure of $18.6kg/cm^2$ is safe because the stress of a gas cylinder is within yield strength of steel. But the stress for a hydraulic testing pressure of $34.5kg/cm^2$ sufficiently exceeds the yield strength and remains under the tensile strength. If the hydraulic testing pressures frequently apply to the gas cylinder, the bombe may be fractured because a fatigue residual stress is accumulated on the lower round end plate due to a plastic deformation. The computed results show that the concentrated force in which is applied on a skirt zone does not affect to the lower round end plate, and the most weak zone of a bombe is a middle part of a lower round end plate between a bombe body and a skirt for a gas pressure. Thus, the FEM results show that the profile of a lower round end plate is an important design parameter of a high pressure gas cylinder.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.10 no.2
• /
• pp.215-222
• /
• 1986

This paper presents the results of investigation, the aim of which was to predict theoretically the processes of thermodynamic cycle of M-combustion chamber type diesel engine. The combustion characteristics in cylinder are evaluated from the energy equation for an thermodynamic system in engine cylinder. In order to predict the combustion pressure in cylinder, the engine is divided in various control volumes. The simulation results of combustion characteristics show that the comparison of computed and measured values brings about the good coincidence.

• Korean Journal of Applied Biomechanics
• /
• v.18 no.4
• /
• pp.59-65
• /
• 2008

The purpose of this study was to investigate the shift of COP pathway and the plantar foot pressure among level walking and stairs and ramp climbing in young and elderly people. Plantar foot pressure was measured by MatScan system(Tekscan, USA). Statistical analysis was used One-way ANOVA to know the characteristics of peak plantar pressure during walking with different the facilities. In young adults, COP pathway during stairs climbing was slightly shorten and trended to abduct at forefoot. COP pathway during ramp climbing was also shorten but trend to adduct at forefoot. Peak plantar pressure of 2-3 metatarsal head and heel during ramp climbing was more decreased than level walking. In elderly people, COP pathway during stairs climbing was more shorten and abducted than leve walking and COP pathway during ramp climbing was more unstable than level walking. Peak plantar pressure of first metatarsal head increased at stair climbing and decreased at ramp climbing. That of second metatarsal head and heel was more decreased at ramp climbing. Conclusionally, Peak plantar pressures of each foot region generally increased and more changed during ramp climbing.

• Information Systems Review
• /
• v.15 no.1
• /
• pp.1-24
• /
• 2013

This study empirically investigated inter-relationships among the influence factors on the adoption of e-commerce, which are classified as cause factor (i.e., perceived environmental uncertainty and competition), facilitators (i.e., perceived economic benefits, inter-organizational trust, suppliers' pressure and capability and asset specificity) and support factor (i.e., top management's support and organizational resource capability). The results of regression analyses showed that competition, inter-organizational trust, suppliers' pressure and capability, top management's support, and organizational resource capability have a positive impact on the adoption of e-commerce. In the analyses of inter-relationships among the influence factors, it was found that perceived environmental uncertainty positively influences suppliers' pressure and capability and perceived economic benefits, and competition has a positive impact on asset specificity. It was also observed that perceived economic benefits, inter-organizational trust and suppliers' pressure and capability positively affect top management's support, and inter-organizational trust and suppliers' pressure and capability have a positive impact on organizational resource capability. With mediating regression analyses, it was found that competition has an indirect impact on the adoption of e-commerce through the effect on perceived economic benefits, suppliers' pressure and capability, organizational resource capability and top management's support. The results of mediating regression analyses also showed that suppliers' pressure and capability and perceived economic benefits have indirect effects on the adoption of e-commerce through the effects on top management's support and organizational resource capability. From these results, it is concluded that intense competition causes the activation of facilitators, and the facilitators contribute to both the enhancement of top management support and the creation of organizational resource capability, which are directly linked to the adoption of e-commerce.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.04a
• /
• pp.35-38
• /
• 2004

부틸알데히드로 오염된 대상 부지에 Biosparging 공법의 현장 적용을 위해 적정 공기 주입 압력 조건을 도출한 결과, 주 오염층인 자갈질 모래층에 공기주입 가능 파괴압력(Pe)는 약 300mmAq로 측정되었으며 4,500mmAq 압력 조건에서는 용존 산소농도의 영향 반경이 약 3 m로 나타났다. 위의 조건을 적용하여 약 150일간 운전한 결과, 영양물질을 투입하지 않은 초기 90일 동안 최고농도 대비 약 90%가 저감되었으며 그 이후에 영양물질을 투입하여 초기 최고 농도 대비 96%가 저감되어 복원목표치인 50ppm을 모든 지역에서 만족시켰다. 또한 생분해 반응속도가 k=0.03/day로 나타나 휘발성이 낮고 생분 해도가 뛰어난 부틸알데히드로 오염된 자갈질 모래층에 Biosparging공법이 성공적으로 적용된 사례이다.

• The Journal of the Korea Contents Association
• /
• v.10 no.8
• /
• pp.257-265
• /
• 2010

The purpose of this study was to investigate the effect of different ramp inclination on the maximum plantar foot pressure and pathway of the center of pressure. Fifteen healthy adults who had no musculoskeletal disorders were participated with this study and descended the ramp with different inclination(level, $-5^{\circ}$, $-10^{\circ}$, $-15^{\circ}$). Plantar foot pressures were recorded by the Matscan system(Tekscan, Boston, USA) during level and descending ramp with barefoot. Plantar foot surface was defined as seven regions for pressure measurement; two toe regions, three forefoot regions, one midfoot region, one heel region. Repeated ANOVA was used to compare each region data of foot according to different ramp inclination. As descending ramp inclination became increased, the pressure of hallux region was significantly increased at $-15^{\circ}$ inclination and the pressure of 2-3 metatasal head region were significantly decreased at $-5^{\circ}$, $-10^{\circ}$, $-15^{\circ}$ inclination. The pathway of COP had a tendency to be shifted inside in forefoot and prolonged to great toe as the descending ramp inclination increased. The results indicated that plantar foot pressure could be changed at hallux and forefoot regions with $-5^{\circ}$ ramp inclination and these findings demonstrated that ramp inclination could affect the structure and function of foot.