• Journal of Environmental Health Sciences
• /
• v.19 no.4
• /
• pp.33-37
• /
• 1993

The problem for the removal of phosphorus increased due to reasons like eutrophication control. However its removal and operating criteria were not well developed. This study was made for enhanced removal of P by iron contactor by intermittent aeration activated sludge process. Experiment was conducted to find the effects of organic substance load and HRT, nutrient removal efficiency. When applied organic substance load and HRT, II &III reactor were good treatment efficient while come from Fe of iron contactor. Release of phophorus from II &III reactor sludge under anaerobic condition was low. As the process developed, the content of released ionized Fe from iron contactor increased. In addition, the rate of phosphorus removal became accelerating, and the removed sludge was stabilized in the existence of insoluble status.

• Journal of Biosystems Engineering
• /
• v.20 no.1
• /
• pp.66-72
• /
• 1995

A numerical study for a two dimensional multi-impingement jet with crossflow of the spent fluid has been carried out. To study the flow characteristics especially in the jet flow region, three different distributions of mass flow rate at 5-jet exits were assumed. For each distribution, various Reynolds numbers ranging from laminar to turbulent flows were considered. Calculations drew the following items as conclusion. 1) A periodical fully developed flow was observed from the third protrusion. This was also observed from previous experimentally by Whidden at al. The Nessult number at the protrusion surface increased mildly as going downstream. 2) The low Reynolds number turbulence model of Launder and Sharma was found to be adequate for the prediction of fluid flow and heat transfer characteristics of two dimensional multi-jet configuration. 3) The Nusselt number at the protrusion surface was nearly proportional to the square root of the Reynolds number.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.26 no.10
• /
• pp.2067-2072
• /
• 2002

The closed-loop state and input observer is a pole-placement type observer and estimates unknown state and input variables simultaneously. Pole-placement type observers may have poor performances with respect to modeling error and sensing bias error. The effects of these ill-conditioning factors must be minimized for the robust performance in designing observers. In this paper, the steady-state performance of the closed-loop state and input observer is investigated quantitatively and is represented as the estimation error bounds. The performance indices are selected from these error bounds and are related to the robustness with respect to modeling errors and sensing bias. By considering both transient and steady-state performance, the main performance index is determined as the condition number of the eigenvector matrix based on $L_2$-norm.

• Journal of the KSME
• /
• v.29 no.2
• /
• pp.162-168
• /
• 1989

철이나 동은 BC5000~3000년부터 도구류, 장식품 등으로 인류의 역사에 등장하고 있는데 반해 알루미늄 재료는 공업용 재료로써의 기초가 확립된 후 아직 100년이 채 못되고 있지만 건종 성 질이 우수하기 때문에 이러한 특성을 이용해서 항공기용 재료, 전선, 기물, 일반프레스 가공품, 제메이스류, 일반 기계부품, 콘덴서용 및 포장용 상자, 도료 및 잉크 원료 화포 재료, 환원재용 분말, 차량, 건축용 재료 등에 사용되고 있고 이용도는 제 2차대전후에 건축, 차량, 조선, 채광, 교량, 화학, 섬유식품 공예 등과 같은 공업분야에 널리 새로운 용도로 개척이 되어 응용이 되고 있다. 이와 같이 그 용도 분야가 다양화되고 적으로도 철, 다음가는 금속재료로 성장하고 있기 때문에 "알루미늄 재료 기술"이라는 이름으로 각종 자료들을 정리 하다보니 너무나도 그 범위가 광범위하여 본 글에서 제외된 알루미늄 재료의 성분, 선정, 지침, 물리. 화학. 기계성질, 형상과 그의 제작범위, 구조설계, 절삭가공, 접합, 표면처리, 단조 등에 대한 여러 가지 자료는 지면관 계로 별도로 정리를 해서 다음 기회에 소개하고자 한다. 소개하고자 한다.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.06a
• /
• pp.197.2-197.2
• /
• 2010

The study on the operation characteristics of solar space and water heating system with ground source heat pump (GSHP) as a back-up device was carried out. This system, called solar thermal and geothermal hybrid system (ST/G), was installed at Zero Energy Solar House II (KIER ZeSH-II) in Korea Institute of Energy Research. This ST/G hybrid system was developed to supply all thermal load in a house by renewable energy. The purpose of this study is to find out that this system is optimized and operated normally for the heating load of ZeSH-II. Experiment was continued for seven months, from October to April. The analysis was conducted as followings ; - the contribution of solar thermal system. - the appropriateness of GSHP as a back-up device. - the performance of solar thermal and ground source heat pump system respectively. - the adaptation of thermal peak load - the operation characteristics of hybrid system under different weather conditions. Finally the complementary measures for the system simplification was referred for the commercialization of this hybrid system.

• The Journal of Korean Obstetrics and Gynecology
• /
• v.21 no.1
• /
• pp.199-205
• /
• 2008

Purpose: This study was conducted for evaluating whether the postpartum women has lower threshold than healthy non delivered women and men. Methods: We divided the groups by three. Group I is consist of postpartum women who have delivered within 7days. Group II is nonparous women, and the Group III is consist of men. Pain threshold in 6 specific points was measured using the digital algometer from each groups. Results: Pain threshold was obviously higher in Group III than Group I, II, And group II’s threshold was significantly higher than group I’s Conclusion: This study shows the postpartum women had lower pressure pain threshold than non delivered women and men. So clinicians should consider the physiologic and psychologic aspects for the pain control if they meet postpartum women.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.35 no.12
• /
• pp.1101-1107
• /
• 2007

this paper, integrity analysis in Korean region using GPS, modernized GPS, Galileo, SBAS and GBAS is given. The simulation results show that Cat. I requirement can be met using modernized GPS and Galileo alone, however, Cat. II and III are not met even augmenting SBAS because of VPL. A more efficient augmentation such as GBAS reduces VPL to meet Cat. II and III requirements in Korean region. This result will be used to design and implement not only an augmentation system but also regional satellite navigation system.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2014.10a
• /
• pp.347-349
• /
• 2014

Model verification and validation (V&V) is a current research topic to build computational models with high predictive capability by addressing the general concepts, processes and statistical techniques. The hypothesis test for validity check is one of the model validation techniques and gives a guideline to evaluate the validity of a computational model when limited experimental data only exist due to restricted test resources (e.g., time and budget). The hypothesis test for validity check mainly employ Type I error, the risk of rejecting the valid computational model, for the validity evaluation since quantification of Type II error is not feasible for model validation. However, Type II error, the risk of accepting invalid computational model, should be importantly considered for an engineered products having high risk on predicted results. This paper proposes a technique named as the response-adaptive experimental design to reduce Type II error by adaptively designing experimental conditions for the validation experiment. A tire tread block problem and a numerical example are employed to show the effectiveness of the response-adaptive experimental design for the validity evaluation.

• Publications of The Korean Astronomical Society
• /
• v.21 no.2
• /
• pp.101-112
• /
• 2006

We developed a new program for automatic continuum normalization of Echelle spectrographic data. Using this algorithm, we have determined spectral continuum of almost BOES data. The first advantage of this algorithm is that we can save much time for continuum determination and normalization. The second advantage is that the result of this algorithm is very reliable for almost spectral type of spectrum. But this algorithm cannot be applied directly to the spectrum which has very strong and broad emission lines, for example Wolf-Rayet type spectrum. We implanted this algorithm to the program which was developed in the previous study. And we introduced more upgraded BOES data reduction program. This program has more convenient graphical user interface environment, so users can easily reduce BOES data. Lastly, we presented the result of study on line profile variation of magnetic Ap/Bp stars analyzed using this program.

• The Bulletin of The Korean Astronomical Society
• /
• v.36 no.1
• /
• pp.36.2-36.2
• /
• 2011

A cancelling magnetic feature (CMF) is believed to be a result of magnetic reconnection in the low atmosphere of the Sun. In this work, we investigate the physical properties of CMFs, focusing on the rates of flux cancellation in CMFs and the dynamics of chromospheric phenomena coupled with CMFs. First, we have determined the specific rates of flux cancellation using the magnetograms taken by the Solar Optical Telescope (SOT) aboard the Hinode satellite. The specific rates determined with the SOT turned out to be systematically higher than those based on the data taken by the Michelson Doppler Imager (MDI) aborad the SOHO. Second, we analyzed transient Ca II brightenings associated with small-scale CMFs using the SOT/Hinode. We found that in most Ca II brightenings related to CMFs, and the Ca II intensity peaks after magnetic flux cancellation proceeds. Moreover, brightenings tend to appear as pairs of bright points of similar size and similar brightness overlying magnetic bipoles. To further study the brightening and dynamics of chromospherie features associated with CMFs, we have analyzed Fast Imaging Solar Spectrograph (FISS) data. From this data the Doppler motion of chromospheric features above a CMF changed from redshift to blueshift. The duration of such dynamics is very short being less than 2 minutes. These results are unexpected one and can not be explained by any pre-existing pictures of CMFs.