• Korean Architects
• /
• no.9 s.37
• /
• pp.55-67
• /
• 1971

• Journal of Bio-Environment Control
• /
• v.25 no.4
• /
• pp.249-254
• /
• 2016

This study was carried out to evaluate the efficiency of white shading agent for reduction of greenhouse air temperature and to develop cost-effective cooling strategies for strawberry seedling production during hot seasons. Experiment results showed that solar radiation ($W/m^2$) was reduced by 14~17% and 33~37% for 15% and 35% white wash shading treatments, respectively, in black shading net treatment solar radiation was reduced by 39~44% compared to non-shaded treatment. Measured greenhouse air temperatures in 15% and 35% white wash shading treatments were $38.4^{\circ}C$ and $36.5^{\circ}C$, respectively, whereas in black shading net covered greenhouses air temperature was $35.1^{\circ}C$, thereby 35% and 15% shading treatments showed 3.3 and $1.9^{\circ}C$ higher air temperatures than black net shading treatment. Crown diameter of strawberry plants in black net shading treatment was 7.5mm, and in 15% and 35% white wash shading treatments were 8.6mm and 8.3mm, respectively. Strawberry transplants grown in 35% white wash shading treatment produced the highest above ground fresh weight(7.8g), followed by 15% white wash shading(6.7g) and black net shading treatments(5.8g). Also, both 15% and 35% white wash shading treatments produced higher root fresh weight(4.1g and 4.3g) compare to black net shading treatments(2.7g).

• Journal of Bio-Environment Control
• /
• v.15 no.4
• /
• pp.306-316
• /
• 2006

In this study, the effect of the shade level, water flow rate applied to the shades and the temperature of water on the greenhouse cooling was investigated depending on the shade level of 0, 35, 55, 75%, and water flow rate and water temperature by the test on the small wooden frames to find out the low cost cooling method. With increasing of the dry bulb temperature of outside air, the dry bulb temperature in the wooden frames increased. For the frames with the shade and water, inside temperatures of the frames were lower of -0.2$\sim$-1.2$^{\circ}C$ than the temperature of the outside air and higher than the water temperature. For the frames without water, inside temperatures of the frames were higher of 1.7$\sim$4$^{\circ}C$ than the outside and not affected by the shade level very much. The water flow rate and the temperature of the water were not the important factors to decrease the inside temperatures in the frames. The black globe temperature became lower with increasing of shade level. The shade frames with water curtain showed the best cooling effect because of reducing thermal radiation and cooling the plastic film cover. The surface temperatures of the plastic film cover for the water supplied modules became lower with increasing of the shade level. The relative humidity was decreased with the dry bulb temperature in the frame increasing and not affected by the dry bulb temperature of the outside air for the frames with the shade and water.

• 한국약용작물학회:학술대회논문집
• /
• 2010.10a
• /
• pp.284-285
• /
• 2010

• Journal of Bio-Environment Control
• /
• v.28 no.4
• /
• pp.429-437
• /
• 2019

This study was conducted to examine the effect of humidification and shading during cutting propagation on growth and development of strawberry (Fragaria x ananassa Duch.) 'Maehyang' plants at a propagation stage. The runner cuttings were stuck on Nov. 23, 2017 in propagation benches set in a Venlo-type glasshouse. Four shading treatments, no shading (control, C), 55% shading with white lawn (W55), 55% black shading net (B55), or 100% black plastic film (B100) with either an intermittent fog system (H) or without fog system. The shading and fog systems were removed 2 weeks after sticking of strawberry cuttings. A nutrient solution for strawberry, which was developed by Yamazaki, was supplied once a day with electrical conductivity (EC) $1.6dS{\cdot}m^{-1}$ and pH 5.8. Growth parameters such as plant height, longest root, crown diameter, leaf chlorophyll, leaf area and fresh and dry weight were measured at 7 days and 26 days after sticking. There was no significant difference in growth of above-aerial part of strawberry. The overall growth of the strawberry roots was better grew by providing fog than that not provide fog. The root fresh weight and root dry weight after 26 days after sticking of strawberry cutting was the best in the treatment that provided fog system without shading (CH). The longest root after 26 days after sticking of strawberry cutting was the best in the treatments that provided fog system with either 55% white lawn (W55H) and 55% black shading net (B55H). These results suggest that morphogenesis of these plants were affected by humidification and shading types. In a broader perspective, these results can be used to optimize studies of other crops grown from cuttings.

• FLOWER RESEARCH JOURNAL
• /
• v.19 no.1
• /
• pp.1-7
• /
• 2011

This study was carried out to establish a production system of cut flowers and bulbs of oriental hybrid lilies in highland in summer. In study, effect of cultivation type and shading was examined. The cultivation types used in the bulb production experiments were greenhouses with no cover, greenhouses with net screen (net screen house), and greenhouses with EVA roof cover and net screen sides (rain shelter house). Net screen and rain shelter houses had either 0 or 30% shading. Cultivation type had significant effect and shading had a minor effect on bulb production. The greatest yield and quality of produced bulbs were obtained in the rain shelter house with 30% shading. From the results of this study, it is concluded that dispersed production of high quality cut lily flowers and bulbs could be achieved during the summer in highland.

• Journal of Bio-Environment Control
• /
• v.16 no.4
• /
• pp.309-313
• /
• 2007

Experiments were conducted to measure rooting and growth of rose cuttings as affected by medium composition and volume. Rosa hybrida 'Red Sandra' and 'Little Marble' were used as test plants. For medium composition test, rockwool, phenolic foam, perlite, vermiculite, peatmoss, coir and a commercial medium (Tosilee medium) were applied in single or mixed forms on the propagation bed with fog (200 sec./5 min.) installed to control the humidification time. 'Red Sandra' and 'Little Marble' cuttings were planted in 16-cell plastic pots and 72-cell plug trays, respectively. For the medium volume test, 72-cell plug trays and 16-cell or 9-cell plastic pots were used. Cuttings with an uniform node with a five-leaflet leaf was soaked in a $500mg{\cdot}L^{-1}$ IBA solution for 30 sec. A fogging system installed on the propagation bed was used for (100 sec./5 min.). Rockwool 1 : peatmoss 1 (v/v) was the most effective on growth and rooting for both cultivars and high volume of Tosilee medium and rockwool were most effective media far both cultivars.

• Horticultural Science & Technology
• /
• v.31 no.1
• /
• pp.123-127
• /
• 2013

A new spray chrysanthemum (Dendranthema grandiflorum) 'Blue Hope' was bred by the Flower Research Institute, Gyeongsangnam-do Agricultural Research & Extension Services in 2009. The cultivar 'Blue Hope' was initially derived from the cross in 2005 between 'Ford', a spray chrysanthemum cultivar, with white anemone type, and 'Chopin', a spray chrysanthemum cultivar with white anemone type. The cultivar has anemone type with white petals. After the evaluation of the characteristics under shade culture in summer and retarding culture in spring and consecutive selection from 2007 to 2009, 'Blue Hope' was selected finality. The natural flowering time of 'Blue Hope' was October 24th, and year-round flowering is possible by shading or lighting treatment. The growth of plant was very vigorous and response time 6.5 weeks. The diameter of flower was 4.9 cm. Number of flowers per stem was 19.1 in autumn. Days to flowering under the short day treatment was about 45 in spring and its vase life was 23.8 days in the autumn season. This cultivar was resistance white rust and consumer's preference of new spray is high level than the control.

• Journal of agriculture & life science
• /
• v.45 no.2
• /
• pp.29-34
• /
• 2011

This study was carried out to investigate the flower yield and quality of Lilium Oriental Hybrids as affected by planting date. In cut flower production experiments, effect of planting date and bulb source was studied in rain shelter houses with 30% shading. Four planting dates compared were May 15, June 5, June 25, and July 15. Bulbs used for cut flower production were either imported or produced domestically. The greatest cut flower yield and quality were obtained from bulbs planted either on May 15 or June 25. Bulbs planted on July 15 produced cut flowers of very poor quality and yield, due to high temperatures during the planting time. Therefore, for planting in July, means other than 30% shading have to be adapted to lower temperature during early growth stage. Although plants from imported bulbs had better growth and cut flower yield as compared to domestic bulbs, there was no significant difference.

• Journal of Bio-Environment Control
• /
• v.18 no.4
• /
• pp.332-340
• /
• 2009

In this study, the thermal insulation effectiveness of the greenhouse insulators by the installation methods was investigated to find the right installation way of the insulation materials. Physical properties of the insulators such as thickness, air transmissivity, apparent density, ultraviolet rays cutoff ratio, reflectance, thermal conductivity, moisture absorptivity were evaluated and the insulation ability of the insulators were measured by the module experiments. For the same insulator, the insulation ability of the case with the outward direction of the black colored face, i.e., with the inward direction of the white colored face, was better than that of vice versa. The case of the black colored both surfaces was better than the case of the white colored both surfaces. For aluminium reflection material, the case with the outward direction of the lustre face, i.e., with the inward direction of the non-lustre face, was better than that of vice versa. For the same material with the inner thin polyethylene foam (or polyester) and the chemical wool, the case with the outward direction of the inner thin polyethylene foam (or polyester), i.e., with the inward chemical wool, was better than that of vice versa. Addition of the inner thin polyethylene foam increased the insulation effect very much.