• Journal of Energy Engineering
• /
• v.27 no.4
• /
• pp.20-26
• /
• 2018

As the global warming due to greenhouse effect has become serious problem, it is necessary to introduce the technology, for instance, such as diversity or saving of energy to reduce the use of fossil fuel. The purpose of this study was to investigate the characteristics on materials of absorption plate, unpowered and minimum use of power in cooling and heating combined device. As the results, it was observed that, in case of summer, since temperature of absorption device of solar heat(ADSH) was lower than that of no ADSH, cooling effect was insignificant in case of being not installed cold-reservoir. However, in case of winter, heating effect was certified even though the power was not used. At secondhand, the performance of ADSH with Cu was higher 2 times than that of ADSH with Al.

• Solar Energy
• /
• v.18 no.2
• /
• pp.69-89
• /
• 1998

The measured solar radiation incident on tilted surfaces by all directions has been widely used as important solar radiation data in installing solar collectors, hot water systems, and photovoltaic modules, and in designing solar buildings and houses. To maximize the incident beam radiation, the slope, which is the angle between the plane of the surface in question and the horizontal, and the solar azimuth angles are needed for these solar applied systems. To respond to above needs, a theoretical study with actual measurements on moving route of the sun is carried out. This study focuses on the development of an solar expert system and on the selection of slopes for solar absorber plates in Korea.

• Solar Energy
• /
• v.19 no.3
• /
• pp.85-91
• /
• 1999

This study represented experimental research on the flat-plate solar collector. The heat performances were measured the tube array surface temperature by thermal-couple. The solar collector($W{\times}H$) of $580{\times}1100$, various tilt angles of 30, 45, 60 degree and the internal tube number of 4, 6, 8, 10(ea) were utilized in the present investigation. It is found that the thermal concentration is higher as the tilt angle become larger and the solar tubes are more and more. In this stuby obtained results of following: The array of tubes in collector has the best nice in that the number of tube is eight and the tilt angle is 60 degree. The collect energy by each tube array shown high value by increase the number of tubes and tilt angles. In addition to, the collect energy depends on by the tilt angle than the number of tube.

• 보일러설비
• /
• no.12 s.143
• /
• pp.143-150
• /
• 2005

주택외간의 품격을 좌우하는 요소인 지붕에 주로 사용되는 자재는 기와이다. 과거에는 주로 재래식 한식기와가 사용되었지만 지금은 거의 사용되지 않고 양식기와인 스패니시 기와가 보편적으로 사용되고 있다. 그 이유는 외장재로 많이 사용되는 자재들과 가장 잘 어울리기 때문이지만 외벽에 돌이 사용된 경우에는 천연슬레이트가 더 적합하다. 최근에는 컬라아스팔트 슁글이 지붕재로 각광을 받고 있는데 미려한 외관을 만들 뿐만 아니라 방수효과도 뛰어나기 때문이다. 또 한 장두장 이상 겹쳐져 시공되기 때문에 내구성도 강하고, 강인한 글래스매트나 다공성 원지를 심재로 특수개질 아스팔트를 합쳐 채색된 돌입자로 표면을 처리하여 내후성 · 내변색성도 강하다. 무게도 기와의 1/5이 안돼 구조체의 하중부담을 줄여 안정성을 기할 수 있다. 이외의 지붕재로 금속제품, 유리, 태양열 주택의 집열판 등 부분적인 지붕으로 사용되는 것으로가 한때 유행했던 콘크리트 슬라이브 등을 들 수 있다.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2012.05a
• /
• pp.85-86
• /
• 2012

This application plan is hasty prepared with the actual condition in which the majority is reclaimed by the waste with the marine and the polysilicon sludge, that is the main raw material of the solar pannel support, does. In this research, by using OPC and Fly ash, the applicability as the blending material of the polysilicon sludge was analyze and it tried to contribute to the waste reduction afterward. The replacement ratio of the sludge was set to 5. 10, 15, 20(%) with the experiment based on the based test result and the air flow rate, liquidity, flexural strength, and compressive strength was measured. The liquidity was reduced in spite of as the replacement ratio of the sludge increased and the air flow rate increased.

• Journal of the Korean Solar Energy Society
• /
• v.28 no.3
• /
• pp.67-73
• /
• 2008

This study has been carried out to investigate the effect of vacuum on the thermal performance of a nonglass evacuated tube. A series of measurements are made indoors to monitor the temperature change of the absorber plate contained in the evacuated tube under different conditions of vacuum and heat fluxes. Those temperatures measured at the thermal equilibrium could be used to assess the heat losses to the ambient in link with the steady operation of non-glass evacuated tubes for solar exploitation.

• Proceedings of the KAIS Fall Conference
• /
• 2004.06a
• /
• pp.89-91
• /
• 2004

This study examines a regeneration process using hot air heated by solar radiation to recover absorption potential by evaporating moisture in liquid desiccant. More specifically, this study is aimed at finding the optimum operating condition of the regenerator by utilizing a well-established statistical tool, so-called design of experiment, and optimization techniques. It is demonstrated that an optimization model to find the optimum operating condition can be obtained using the functional relationship between regeneration rate and affecting factors which is approximated on the basis experimental results.

• Journal of the Korean Solar Energy Society
• /
• v.21 no.3
• /
• pp.61-68
• /
• 2001

This study represents numerical analysis on the thermal and fluid flow of the air layer in a solar collector. The boundary conditions was assumed that the top and bottom wall of the air layer have a heating and cooling surface, respectively, and this calculation model have a solid body with a cooling temperature of $20^{\circ}C$. As the results of simulations, the magnitudes of the velocity vectors and isotherms are increased proportionally to the tilt angles. As the tilt angle is increased, the mean Nusselt numbers are increased and the maximum value of the mean Nusselt number was appeared at tilt angle $\theta=75^{\circ}$.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2011.06a
• /
• pp.333-334
• /
• 2011

• Journal of Advanced Marine Engineering and Technology
• /
• v.34 no.4
• /
• pp.455-459
• /
• 2010

In recent years, the crisis of energy is growing seriously and also the contamination of ecology has been reverberated as international problem. The social concerns on energy crisis have been growing for the last several years and also the interests in new and renewable energy have been increased. Therefore, in order to solving these problems, this study has dealt with the solar air collector with perforated endothermic panel to increase the indoor temperature. And also, the PV panel for running indoor air circulating fan has used to increase the convective heat transfer. From this study, the inlet air temperature is increased up to 42[$^{\circ}C$]. This temperature is enough to heat the indoor air condition during winter season. And also the result revealed that the mixing effect of convection is increased with increasing in fan circulating power.