• Journal of Korean Society of Water and Wastewater
• /
• v.21 no.6
• /
• pp.679-687
• /
• 2007

Nanoscale zero valent ion (nZVI) technology is emerging as an innovative method to treat contaminated groundwater. The activity of nZVI is very high due to their high specific surface area, and supporting this material can help to preserve its chemical nature by inhibiting oxidation. In this study, nZVI particles were attached to granular ion-exchange resin through borohydride reduction of ferrous ions, and chemical reduction of nitrate by this material was investigated as a potential technology to remove nitrate from groundwater. The pore structure and physical characteristics were measured and the change by the adsorption of nZVI was discussed. Batch tests were conducted to characterize the activity of the supported nZVI and the results indicated that the degradation of nitrate appeared to be a pseudo first-order reaction with the observed reaction rate constant of $0.425h^{-1}$ without pH control. The reduction process continued but at a much lower rate with a rate constant of $0.044h^{-1}$, which is likely limited by mass transfer. To assess the effects of other ions commonly found in groundwater, the same experiments were conducted in simulated groundwater with the same level of nitrate. In simulated groundwater, the rate constant was $0.078h^{-1}$ and it also reduced to $0.0021h^{-1}$ in later phase. The major limitation in application of ZVI for nitrate reduction is ammonium production. By using a support material with ion exchange capacity, the problem of ammonium release can be solved. The ammonium was not detected in the batch test, even when other competitive ions such as calcium and potassium existed.

• Analytical Science and Technology
• /
• v.5 no.3
• /
• pp.277-283
• /
• 1992

Acid effects on the ICP-AES signals are studied as the concentrations of nitric acid, hydrochloric acid, sulfuric acid, and 1:1 mixture of nitric acid and hydrochloric acid are changed. Almost all analyte signals are depressed. The extent of the depression due to the pressence of the acids became to be pecular when the acid concentration was over 1%. Among the acids used, the suppression due to sulfuric acid is most severe and unexpectable. The ratios of the analyte signal to Ar signal and the Mg II signal to Mg I signal are measured as the concentration of the acids changed. In this study, it is proved that the main reason of the signal reduction is the change in the nebulization efficiency, for example, droplet size distribution, viscosity and surface tension variation, not the alteration of plasma excitation characteristics. There was no relationship found between ionization potential and analyte signal reduction in ICP-MS.

• Journal of the Korean Electrochemical Society
• /
• v.22 no.1
• /
• pp.36-42
• /
• 2019

A macroporous Sn thick film as a high capacity negative electrode for a lithium ion secondary battery was prepared by using a chemical etching method using nitric acid for a Sn film having a thickness of $52{\mu}m$. The porous Sn thick film greatly reduced the over-voltage for the alloying reaction with lithium by the increased reaction area. At the same time. The porous structure of active Sn film plays a part in the buffer and reduces the damage by the volume change during cycles. Since the porous Sn thick film electrode does not require the use of the binder and the conductive carbon black, it has substantially larger energy density. As the concentration of nitric acid in etching solution increased, the degree of the etching increased. The etching of the Sn film effectively proceeded with nitric acid of 3 M concentration or more. The porous Sn film could not be recovered because the most of Sn was eluted within 60 seconds by the rapid etching rate in the 5 M nitric acid. In the case of etching with 4 M nitric acid for 60 seconds, the appropriate porous Sn film was formed with 48.9% of weight loss and 40.3% of thickness change during chemical acid etching process. As the degree of etching of Sn film increased, the electrochemical activity and the reversible capacity for the lithium storage of the Sn film electrode were increased. The highest reversible specific capacity of 650 mAh/g was achieved at the etching condition with 4 M nitric acid. The porous Sn film electrode showed better cycle performance than the conventional electrode using a Sn powder.

• The Journal of Engineering Geology
• /
• v.23 no.1
• /
• pp.37-46
• /
• 2013

Leakage of leachate from animal carcass disposal is a significant issue because disease can easily spread to humans and other livestock. In this study, we analyzed the physicochemical properties of leachate and tested for the presence of aerobic bacteria in leachate using molecular biology methods, for 16 animal carcass disposals in the first stage (after burial for 5 months). Leachate physicochemical analysis revealed higher total coliforms, TOC, $NH^{4+}$, and $NO^{3-}$ concentrations compared with previously published data. In most leachate samples, the concentrations of $NH^{4+}$ and $NO^{3-}$ exceeded the Korean guideline values for drinking water. In 16S rRNA sequence analysis of the distribution of leachate under aerobic conditions, Bacillus pumilus, Lysinibacillus sphaericus, and B. sphaericus were observed with high frequency, whereas no food-poisoning-related bacteria such as B. cereus or Salmonella were detected. The present findings improve our knowledge of the transport of leachate from animal carcass disposal sites through geologic media, and are useful in risk analysis and for subsequent studies.

• The Journal of Engineering Geology
• /
• v.24 no.2
• /
• pp.237-246
• /
• 2014

Seasonal variations of major contaminants in groundwater around livestock burial areas in Gyeonggi province, Korea, were examined. Seven typical contamination indicators ($NO_3$-N, $NH_3$-N, chloride, pH, DO, ORP, and EC) were monitored in groundwater samples collected from 84 wells located within 60 m of livestock burial sites for the leachate plume emanating from the livestock burial sites. The monitoring results of pH, DO, ORP, and EC revealed minimal seasonal variations, providing no evidence for leachate plumes. The $NO_3$-N concentrations were below 30 mg/L and exhibited minimal seasonal fluctuations, even in the wells located close to (< 20 m) the burial sites; the $NH_3$-N and chloride concentrations also showed similar results. The contamination indicators examined in this study indicate that the observed groundwater contamination is primarily from preexisting pervasive contamination due to agricultural activities and livestock farming, not leachates derived from nearby livestock burial sites.

• Applied Chemistry for Engineering
• /
• v.24 no.5
• /
• pp.544-550
• /
• 2013

This work investigated the environmental application of an underwater dielectric barrier discharge plasma reactor consisting of a porous hydrophobic ceramic tube to the decolorization of an azo dyeing wastewater. The reactive species generated by the plasma are mostly short-lived, which also need to be transferred to the wastewater right after the formation. Moreover, the gas-liquid interfacial area should be as large as possible to increase the decolorization rate. The arrangement of the present wastewater treatment system capable of immediately dispersing the plasmatic gas as tiny bubbles makes it possible to effectively decolorize the dyeing wastewater alongside consuming less amount of electrical energy. The effect of discharge power, gas flow rate, dissolved anion and initial dye concentration on the decolorization was examined with dry air for the creation of plasma and amaranth as an azo dye. At a gas flow rate of $1.5Lmin^{-1}$, the good contact between the plasmatic gas and the wastewater was achieved, resulting in rapid decolorization. For an initial dye concentration of $40.2{\mu}molL^{-1}$ (volume : 0.8 L; discharge power : 3.37 W), it took about 25 min to attain a decolorization efficiency of above 99%. Besides, the decolorization rate increased with decreasing the initial dye concentration or increasing the discharge power. The presence of chlorine anion appeared to slightly enhance the decolorization rate, whereas the effect of dissolved nitrate anion was negligible.

• Economic and Environmental Geology
• /
• v.49 no.3
• /
• pp.167-179
• /
• 2016

Water quality of Oseepchun, Dogye area, was investigated quantitatively for its origin and hydrogeochemistry in relation to the influence of groundwater. Groundwater appears to be the principal source of Oseepchun from the water-quality monitoring data including redox potentials, composition of dissolved ions and their correlations, hydrogen and oxygen stable isotopic ratios, and the distribution and occurrence of contaminants. Water-quality type of the surface water was grouped by the water-rock interactions as $Ca-HCO_3$ type originated from carbonated bed-rocks in the Joseon Supergroup, (Ca, Mg)-$SO_4$ type related with dissolution of surfide minerals in coal beds of Pyeongan Supergroup, and (Ca, Mg)-($HCO_3$, $SO_4$) type of the mixed one. Locally water pollution occurs by high $SO_4$ from mine drainage and $NO_3$ from waste-treatment facility. Intensive precipitation in summer has no effect on the water type of Oseepchun, but increases the inflow of nitrate and chloride originated from land surface. Results of this study direct that groundwater-surface water interaction is intimate, and thus surface-water resource management should begin with groundwater characterization.

• Membrane Journal
• /
• v.25 no.6
• /
• pp.496-502
• /
• 2015

Facilitated transport is one of the possible solutions to simultaneously improve permeability and selectivity, which is challenging in conventional polymer-based membranes. Olefin/paraffin separation using facilitated transport membrane has received much attention as an alternative solution to the conventional distillation process. Herein, we report olefin separation composite membranes based on the polymer blends containing $AgBF_4/Al(NO_3)_3$ mixed salts. Free radical polymerization process was used to synthesize an amphiphilic graft copolymer of poly(dimethyl siloxane)-graft- poly(ethylene glycol) methyl ether methacrylate (PDMS-g-POEM). In addition, poly(ethylene oxide) (PEO) was introduced to the PDMS-g-POEM graft copolymer to form polymer blends with various ratios. The propylene/propane mixed-gas selectivity and permeance reached up to 5.6 and 10.05 GPU, respectively, when the PEO loading was 70 wt% in polymer blend. The improvement of olefin separation performance was attributed to the olefin facilitating silver ions as well as the highly permeable blend matrix. The stabilization of silver ions in the composite membrane was achieved through the introduction of $Al(NO_3)_3$ which suppressed the reduction of silver ions to silver particles.

• Journal of Food Hygiene and Safety
• /
• v.30 no.3
• /
• pp.265-271
• /
• 2015

This study was done in order to investigate the naturally occurring levels of nitrate and nitrite in livestock products. Total samples of 458 consisting of meats (n = 223), processed meat products (n = 51), raw milks (n = 30), processed milk products (n = 142), eggs (n = 5) and processed egg products (n = 7) were analyzed for contents of nitrate and nitrite by ion chromatography (IC). That methods showed good results in terms of linearity, limit of detection (LOD), limit of quantitation (LOQ), recovery, reproducibility and uncertainty. Nitrate and nitrite were detected in 167 and 40 samples, respectively. The nitrate levels (mg/kg) were not detected (ND)~40.23 for modified milks, ND~37.97 for sauce meats, ND~32.40 for process cheeses, ND~31.50 for processed egg products, ND~27.73 for dry milks, ND~24.76 for sausages, ND~22.45 for bacons, ND~21.55 for natural cheeses, ND~20.82 for hams and fermented milks, ND~13.57 for eggs, ND~12.77 for butters, ND~9.31 for milks and ND~3.88 for meats while the nitrite levels (mg/kg) were ND~17.35 for processed egg products and ND~1.92 for meats. In conclusion, the result of this study of nitrate and nitrite in livestock products could be used as one of scientific base datum to determine whether they are naturally occurring or not, including ingredients and their percentage, manufacturing processes, other papers relating to naturally occurring levels of them, and so on.

• Journal of the Korea Concrete Institute
• /
• v.26 no.4
• /
• pp.517-524
• /
• 2014

Nitrite-Type hydrocalumite (calumite) is a material that can adsorb chloride ions ($Cl^-$) that cause corrosion of reinforce bars and liberate the nitrite ions ($NO_2{^-}$) that inhibit corrosion in reinforced concrete. In this study, polymer-modified mortars using two types of epoxy resin with calumite are prepared with various polymer binder-ratios of 0, 5, 10, 15, 20% and calumite contents of 0, 5%. The specimens are tested for chloride ion penetration, carbonation, drying shrinkage and corrosion inhibition. As a result, the chloride ion penetration and carbonation depth of PMM using epoxy resin somewhat increases with increasing calumite contents, but those remarkably decreases depending on the polymer-binder ratios. The 28-d drying shrinkage shows a tendency to decrease with increasing polymer-binder ratio and calumite content. Unmodified mortars with calumite content of 5% did not satisfy quality requirement by KS. However, it was satisfied with KS requirement by the modification of epoxy resin in cement mortar. On the whole, the carbonation and chloride ion penetration depth of epoxy-modified mortars with calumite is considerably improved with an increase in the polymer-binder ratio regardless of the calumite content, and is remarkably improved over unmodified mortar. And, the replacement of the portland cement with the calumite has a marked effect in the corrosion-inhibiting property of the epoxy-modified mortars.