• Journal of Korea Water Resources Association
• /
• v.46 no.1
• /
• pp.25-34
• /
• 2013

In this study, the development processes of multiple bars in the channels with erodible banks were investigated by double Fourier analysis. The initially straight channels in the experiment flume were widened with eroding the side banks, and the multiple bars were generated and grew due to stalling of the sediment on the bed. The bars migrated downstream and the size of the bars increased with time. The flow was separated around the bars, and the bed and banks near the bars were scoured due to the impinged secondary flow. The morphologic changes were accelerated by the bank erosion, which affected the fluctuations of sediment discharge downstream. The double Fourier analysis of the bed waves showed that 1-1 mode (alternate bar) was dominant at the initial stage of the channel development. As time increased, 2-3 mode (central or multiple bars) was dominant due to the increased width to depth ratio. Moreover, the number of bars in a cross section of the channel were increased due to the non linearity of alternate bars. The width to depth ratio was increased by the bank erosion, which affected the bar migration and the bar wavelength. However, the dimensionless tractive force was decreased by it.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.11
• /
• pp.2113-2120
• /
• 2015

This paper presents an integrated receiver to support multimode broadcasting standards such as DVB-T2, DVB-C2, and DVB-S2 in a single platform. The integrated receiver consists of a tuner block, a receiver engine, a frame processor, and an A/V decoder. The receiver engine includes a channel decoding engine and a demodulation engine to perform OFDM and APSK demodulations. The frame processor performs deinterleaving and BB frame decoding functions. The demodulator engine and the frame processor are implemented in two FPGA devices and DSP-based embedded software, respectively. To verify the functionality of the integrated receiver, it is tested in the laboratory. Commercial PC-based modulators are used to generate the DVB-T2, DVB-C2, and DVB-S2 modulated signals. The integrated receiver was tested under various operation modes as specified in the standards such as DVB-T2, DVB-C2, and DVB-S2 and showed successful operation in all the scenarios tested.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.03a
• /
• pp.56-56
• /
• 2003

최근 정보통신 분야의 급격한 발달로 인하여 무선통신에 사용되는 주파수 영역 또한 계속 높아짐에 따라 대역통과 필터 소자의 삽입 손실, 소비 전력, 크기, MMIC화에 대한 많은 연구가 진행되고 있다 압전 현상을 이용한 박막형 공진기가 이러한 요구를 충족시키고, 현재의 SAW filter를 대체할 소자로 떠오르고 있다. 본 실험에서는 단결정 미세 구조를 만들 수 있고, 압전 효과 또한 우수하며, Surface Micromachining보다 비교적 제조 공정이 간단하고 선택적 에칭이 가능한 Bulk Micromachining을 이용하여 Si$_3$N$_4$ Membrane을 이용한 중심주파수 5.2GHz인 두께 진동모드 Film Bulk Acoustic Wave Resonator(FBAR)를 제작하고 공진기의 고주파 특성을 평가하였다. Membrane구조 형성을 위해 Backside면인 Si$_3$N$_4$, Si은 RIE(Reactive Ion Etching)와 선택적 에칭용액인 KOH로 각각 에칭하여 Membrane을 갖는 구조로 중심주파수 5.2GHz인 두께 진동모드 FBAR를 설계 및 제조하였다. 체적 탄성파 공진 현상은 r.f Magnetron Sputtering법으로 증착한 AIN 압전박막과 Mo전극으로부터 발생 가능하였다. 본 연구에서는 0.9$\mu\textrm{m}$-Si$_3$N$_4$ Membrane을 이용해 FBAR를 제작/평가하고, RIE을 통해 Membrane을 제거해 가면서 공진기의 특성 즉, Quality factor와 유효전기기계결합계수(K$_{eff}$) 및 S parameter특성을 비교 측정해 보았다. 측정해본 결과 Membrane Free일때가 훨씬더 공진 특성이 우수함을 볼 수 있다

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.30 no.4
• /
• pp.307-313
• /
• 2019

The traveling wave tube amplifier (TWTA), which can be applied to the Ka-band millimeter-wave multi-mode seeker, consists of an high voltage power supply(HVPS), a grid modulator, a command and control, and an RF assembly. We designed a power supply that generates a -17.9 kV high voltage by synchronizing the pulse repetition frequency(PRF) and power supply switching frequency(i.e. synchronization frequency), and a high-speed grid-switching modulator for RF pulse modulation. The TWTA, which is fabricated through miniaturization with a volume of 3.18 L, has high pulse switching characteristics of up to 18.5 ns. The maximum rise/fall time of the grid on/bias signal and peak power is more than 564.9 W. Moreover, an excellent spurious performance of -68.4 dBc or less was confirmed within the range of PRF and PRF/2.

• Proceedings of the KIPE Conference
• /
• 2016.07a
• /
• pp.273-274
• /
• 2016

본 논문에서는 LLC 공진형 컨버터 기반 리튬 이온 배터리 충전기의 통합형 보상기를 제안하였다. 제안한 보상기는 실효 커패시턴스의 변화를 고려할 수 있는 배터리 모델 기반으로 설계되어 전 충전 구간 동안 안정적인 동작이 가능하며 정전류-정전압 (CC-CV) 충전을 하나의 보상기로 구현하여 충전 모드 변환시의 과도 특성을 가지지 않는다. 제안한 통합형 보상기의 설계는 기본파 근사법과 확장기술함수를 활용하여 진행 하였으며, LLC 공진형 컨버터와 배터리팩을 이용한 실험결과를 통하여 그 유효성을 검증 하였다.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.5 no.3
• /
• pp.101-109
• /
• 2012

Because the installation problem of parabola antenna that is tilted to 45 degree when this antenna is installed at the area of middle latitude, the study on planar antenna in place of parabola antenna is made rapid progess. Especially, The development of the planar antenna for VSAT is needed depending on the increased Ka-band satellite communications. In this paper, in order to meet with these performances, an array antenna consisting of the vertical polarized waveguide longitudinal slots based on the leaky-wave mode of traveling wave antenna is proposed. Especially, for the lower sidelobe level, the design method of the radiation power distribution control using the different slot widths is proposed. An array antenna consisting of 32 leakywave waveguide antennas is showing 35.16 dBi of gain, 2.5 degree of beamwidth at azimuth, below than -30 dB of sidelobe level, 45.8 degree of beam tilt angle in center frequency 30.2 GHz.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.40 no.11
• /
• pp.919-925
• /
• 2016

In this study, the Lamb wave mixing technique, which is basised on advanced research on the nonlinear bulk wave mixing technique, is applied for corrosion detection. To demonstrate the validity of the Lamb wave mixing technique, an experiment was performed with normal and corroded specimens. Comparison group in an experimentation are selected to mode and frequency with dominant in-plane displacement and out-of-plane displacement of Lamb waves. The results showed that the Lamb wave mixing technique can monitor corrosion defects, and it has a trend similar to that of the conventional Lamb wave technique. It was confirmed that the dominant displacement and mode matching the theory were generated. Flaw detectability is determined depending on displacement ratio instead of using the measurement method and mode selection.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.32 no.7
• /
• pp.51-59
• /
• 2004

An experimental procedure to identify failure modes of impact damage using sensor signals and to analyze their general features is examined. A series of low-velocity impact tests from low energy to damage-induced high energy were performed on the instrumented drop weight impact tester to monitor the stress wave signals due to failure modes such as matrix cracking, delamination, and fiber breakage. The wavelet transform(WT) and Short Time Fourier Transform(STFT) are used to decompose the piezoelectric sensor signals in this study. The extent of the damage in each case was examined by means of a conventional ultrasonic C-scan. The PVDF sensor signals are shown to carry important information regarding the nature of the impact process that can be extracted from the careful signal processing and analysis.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.306-306
• /
• 2007

최근, LED 구동 인버터, DC-DC 컨버터, AC-DC 컨버터 및 형광등 ballaster 등의 고전압전원장치등에 압전변압기를 적용하고자 하는 연구가 활발히 진행되고 있다. 순수한 $PbTiO_3$는 큐리온도($490^{\circ}C$)가 높고, 기계적강도가 크며, 비유전율(약 200 정도)이 작다. 또한, 두께방향 진동의 전기기계 결합계수 ($K_t$)가 윤곽진동의 전기기계 결합계수($K_p$)보다 크므로 두께방향의 진동모드를 이용한 벌크파 진동자의 경우 윤곽진동방향으로 불요신호(spurious signal)가 적고, 작은 grain size($1\;{\mu}m$정도)로 미세가공이 가능하여 고주파 재료로 이용되고 있다. 압전변압기의 출력 전력을 향상시키기 위해서는 적층으로 제작하여야 하는데 적층 압전변압기 제작시 층간의 내부 전극이 도포된 상태에서 소결하여야 한다. 이때 소걸 온도가 높으면 Pd 함랑이 높은 전극을 사용하여야 하는데 Pd 전극의 가격이 비싸 소자의 경제성이 떨어지게 된다. 따라서 순수한 Ag 전극을 내부전극으로 사용하기 위해서는 $900^{\circ}C$ 이하에서 소결이 가능하여야 한다. 따라서 본 연구에서는 $(Pb,Ca,Sr)Ti(Mn,Sb)O_3$ 조성을 이용하여 $900^{\circ}C$ 이하의 저온소결이 가능한 두께방향진동모드 적층 압전변암기를 제작하여 그에 대한 전기적 특성을 조사하였다.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.2 no.2
• /
• pp.69-77
• /
• 2009

Small size and low profile antenna for mobile vehicular-top-mounted is needed in satellite communication services such as DBS, Satellite Internet and VSAT. In middle latitudes, the development of an array antenna which has the conformal, low profile and 45 degree beam tilted configuration, and has the high gain with sharp beamwidth, low sidelobe and low loss is required for Ka band satellite communication. In this paper, in order to meet with these performances, an array antenna consisting of the vertical polarized waveguide longitudinal slots based on the leaky-wave mode of traveling wave antenna is proposed. Especially, for the lower sidelobe level the radiation power control using a design method of the different slot width is proposed. An array antenna consisting of 32 leakywave elements is showing 34.4 dBi of gain, 3.6 degree of beamwidth, below than -25 dB of sidelobe level, 43 degree of beam tilt angle in center frequency 20.0 GHz. Feed network designed by waveguide cooperated feed shows good performance of wideband and low loss.