• Korean Journal of Food Science and Technology
• /
• v.31 no.4
• /
• pp.1005-1010
• /
• 1999

To study the shortening of rigor mortis and changes in the morphological properties of gamma-irradiated pre-rigor bovine muscle (M). Sternomandibularis during post mortem, this experiment was performed with a test of shear force and the observation of the ultrastucture of raw muscle. The time elapsed until maximum shear force values was shortened by gamma irradiation, depending upon the dose. The release of rigor mortis started earlier than control (non-irradiated muscle). A shortening of the length of the Z-line and the maintenance of the sarcomere length by gamma irradiation was observed. The breakdown of the perimysium of muscle bundles was observed more in irradiated samples than in the control. In conclusion, it is considered that gamma irradiation on pre-rigor beef shortens aging-period, improves tenderness and enhances the beef quality.

• Korean Journal of Materials Research
• /
• v.10 no.7
• /
• pp.505-514
• /
• 2000

The carburizing behavior and fatigue properties of the plasma carburized low carbon Cr-Mo steel(0.176C-1.014Cr-0.387Mo) have been investigated. The effective case depth in plasma carburized steel increased up to 50% in comparison with that of gas carburizing, and this case depth increased with the increasing surface carbon content. With increasing time in plasma carburizing, the surface carbon content increased but its increasing rate decreased. Fatigue properties were studied in terms of microstructure, case depth, retained austenite and residual stress near the surface. The fatigue limit of the plasma carburized steel was higher than that of gas carburized one. The initiation of microcracks and initial crack propagation were retarded due to a relatively little surface and internal oxidation layer in plasma carburized steel. Fractography showed the crack initiated at the surface, and transgranular fracture at surface layer was more predominant in plasma carburized steel compared to that of gas carburized steel.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.12 no.2
• /
• pp.115-122
• /
• 2007

In this paper, a novel fault detection method for fault tolerant control is proposed when the NPC inverter has a open failure in the switching device. The open fault of switching device is detected by checking the variation of a leg-voltage in the neutral-point-clamped inverter and the two phases control method is used for continuously balance the three phases voltage to the load. It can be achieve the fault tolerant control for improving the reliability of the NPC inverter by the fault detection and reconfiguration. This method has fast detection ability and a simple realization for fault detection, compared with a conventional method. Also, this fast detection ability improved the harmful effects such as DC-link voltage unbalance and overstress to other switching devices from a delay of fault detection. The proposed method has been verified by simulation and experiment.

• Development and Reproduction
• /
• v.9 no.1
• /
• pp.43-48
• /
• 2005

Bone marrow stromal cells, a constituent of the niche for hematopoietic stem cells in bone marrow, provide various factors involved in the fate decision of the hematopoietic stem and progenitor cells. Radiation, a widely used anti-cancer therapy, provokes side effects including the damage of the blood cells. Therefore, it is necessary to recover the blood cells shortly after radiation via promoting the differentiation of hematopoietic cells. In this study, we screened genes modulated by radiation in human bone marrow stromal cells in order to understand the mechanism involved in hematopoiesis after radiation. We performed differential display method by using polymerase chain reaction(PCR) and agarose gel electrophoresis. We found plasminogen activator inhibitor-1(PAI-1) was consistently induced by radiation. The significance of the PAI-1 gene modulation is to be determined.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.22 no.8
• /
• pp.67-74
• /
• 2008

In this paper we describe discharge characteristics between needle-to-plane electrodes in water in various conditions such as different impulse voltages, polarities and water resistivities. Streamer corona is initiated at the tip of needle electrode and propagates toward plane electrode, and it experiences the final jump across the test gap. The branched channels of streamer coronas for lower water resistivities are much thicker and brighter than those for higher water resistivities at the same level of applied voltage. The negative streamer coronas not only have more branches but also widely spread out compared to the positive streamer coronas. A number of pulse-like currents ranging from some hundreds mA to a few A after streamer corona onset were produced with discharge developments. The time-lags-to breakdown for the positive polarity were remarkably shorter than those for the negative polarity. The pre-breakdown energy supplied into the test gap was inversely proportional to water resistivity.

• The KIPS Transactions:PartC
• /
• v.15C no.2
• /
• pp.119-124
• /
• 2008

The LEACH is a study method of a clustering base that was representative in many routing techniques that was suggested in sensor network environment. This is suggested technique to manage the sensor network group which consisted of many sensors in efficiency. However, it does not consider energy remaining quantity of the cluster header to manage cluster group, the problem where the cluster group is able to destroyed on the middle which transmits data. We are going to propose to solve such a problem by this paper for new clustering technique to accomplish management for a cluster group. It uses the technique which it proposes from the dissertation which it sees and are to the data transfer and the control also the connection directivity of the cluster group to improve also the lag time diminishes, test result it will lead and the possibility which it will know it was.

• Ecology and Resilient Infrastructure
• /
• v.8 no.3
• /
• pp.143-153
• /
• 2021

The growth inhibition effects of M. aeruginosa were verified using large volume (7.2 L) of algae samples and ultrasonication (high frequency of 1.6 MHz vs. low frequency of 23 kHz) in lab-scale experiment. The chlorophyll-a (chl-a) and cell number decreased gradually after 6 hr sonication with high frequency of 1.6 MHz whereas both decreased sharply after 6 hr sonication with low frequency of 23 kHz. Additionally, the first order degradation coefficient (k) values after sonication were greater than those during sonication. These results indicate that relatively low sonication energy per volume may affect the cell membrane and internal organs of M. aeruginosa in a slow and retarded manner and resulted in gradual decrease of cell numbers of M. aeruginosa. Based on the comparison of chl-a and cell number of M. aeruginosa after sonication, low frequency of 23 kHz is superior for growth inhibition of M. aeruginosa, since low frequency of 23 kHz easily penetrates the cell membrane and ruptures the internal organs including gas vesicles. As is evident in SEM and TEM images, ruptured cell membranes were clearly observed for low frequency of 23 kHz. Finally, the microcystin-LR in water is not detected and considered to be harmless in aquaculture systems.

• Korean journal of food and cookery science
• /
• v.29 no.2
• /
• pp.137-146
• /
• 2013

Premature-green wheat is typically obtained by early harvest when culms of wheat still appear green in color, and the wheat and its food products have been considered as wellbeing foods. The pasting properties of prematured whole green wheat powder (WGWP), were analyzed with a rapid viscosity analyzer (RVA), and compared with commercial flours. The RVA values of lower peak viscosity and time, holding strength, final viscosity, as well as breakdown and setback viscosity showed that the WGWP could retard a gelatination of starch and also delay retrogradation in bakery products. WGWP with different levels of 10, 20, 30 or 50% was added into flours for preparing bakery product (bread, muffin and cookie), and their quality properties were evaluated. The addition of WGWP lead to a reduction in loaf volume of bread and muffin, and bakery products containing different levels of WGWP showed the changed internal surface structure (e.g. pore size) observed with a scanning electron microscope when compared with the control (0% WGWP). The hardness, gumminess, chewiness of bread and muffins were increased, and cohesiveness was decreased as the WGWP content increased, but the hardness of cookies was decreased. The bakery products added WGWP showed darker and more greenish and yellowish color than control (p<0.05). The sensory evaluation showed that bakeries with WGWP were scored to have more greenish taste and green color (p<0.05), and muffins and cookies with WGWP were evaluated to have more nutty and less oily taste (p<0.05).

• Journal of the Korean Geotechnical Society
• /
• v.21 no.5
• /
• pp.225-230
• /
• 2005

At present, there are several problems related with sand mat which is used as a way to accelerate consolidation settlement, to act like an underground drainage layer and to increase trafficability simultaneously. First of all, the unbalance of the demand and supply of sand is one of the biggest problems, which causes not only price rise but also delay of the term of the total construction work. Secondly, the damage of ecosystem and scenery is triggered by thoughtless sand dredging or mining. So, the need that sand mat should be replaced with a new environmentally friendly material has been increased. Fiber mat may be one of the proper materials that suits the need. Therefore, we intended to compare the drainage properties of sand mat with those of fiber mat by experimental model tests. On the basis of the test results, fiber mat took shorter period of consolidation than sand mat and the amount of settlement in the farmer showed a little bit bigger than in the latter. As a conclusion, the substitutability of sand mat with fiber mat could be placed highly in view of drainage efficiency. Furthermore, when fiber mat is used, it has an advantage that spoiled soil of the construction site or nearby site can be used for the purpose of increasing trafficability in addition to a role of drainage layer.

• Korean Journal of Agricultural Science
• /
• v.22 no.1
• /
• pp.1-10
• /
• 1995

All agricultural crops and products should be cultured, harvested, handled and processed by the proper mechanical methods in the mechanized farming systems. Agricultural crops might be injured or deformed through various working stages due to static or dynamic forces of machines. Mechanical forces had to be applied with proper degrees to the agricultural crops in incoincidence with properties of crops without any damage of crops so as to increase the work efficiency qualitatively. Knowledges of mechanical properties of agricultural materials are essential to prevent of agricultural crops in relation with mechanical farming system. This study was carried out to examine and analyze the creep behavior of the rice stalk on growing and harvesting periods by mechanical model with computer measurement system in radial directional compressive force and bending force. The creep behavior of the rice stalk could be predicted precisely and its results approached closely to the measured values. The creep behaviors were increased greatly with increase of compressive force, namely, the steady state creep behavior occurred at the force less then 25N and the logarithmic creep behavior at the force bigger than 30N. The instantaneous elastic modulus $E_o$ and the retardation time ${\tau}_K$ were increased together with increase of applied forces, meanwhile the retarded elastic modulus $E_r$ and viscosity ${\eta}_v$ were decreased with increase of applied forces in mechanical model being expected the creep behavior in relation with the level of applied forces, which was well explained that the rice stalk might be visvo-elastic material. In the creep test along the stalk portion with compressive force and bending force, the intermediate portion showed greatest values and also the lower portion showed the least values, which implied that the intermediate portions of rice stalk were very weak. The steady state creep behavior occured at the intermediate portion and the upper portion in the rice stalk at the compressive force larger than 25.0N, which showed the possibility of injury due to external forces.