• Journal of Drive and Control
• /
• v.15 no.4
• /
• pp.67-73
• /
• 2018

The paper deals with an approach to time domain simulation for closed end at the downstream of pipe, hydraulic lines terminating into a tank and series lines with change of cross sectional area. Time domain simulation of a fluid power systems containing hydraulic lines is very complex and difficult if the transfer functions consist of hyperbolic Bessel functions which is the case for the distributed parameter dissipative model. In this paper, the magnitudes and phases of the complex transfer functions of hydraulic lines are calculated, and the MATLAB Toolbox is used to formulate a rational polynomial approximation for these transfer functions in the frequency domain. The approximated transfer functions are accurate over a designated frequency range, and used to analyze the time domain response. This approach is usefully to simulate fluid power systems with hydraulic lines without to approximate the frequency dependent viscous friction.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.4
• /
• pp.895-902
• /
• 2015

This paper presents a high-speed sensing and noise cancellation technique for large touch screens, which is called FDCS (Frequency Division Concurrent Sensing). Most conventional touch screen detection methods apply excitation pulses sequentially and analyze the sensing signals sequentially, and so are often unacceptably slow for large touch screens. The proposed technique applies sinusoidal signals of orthogonal frequencies simultaneously to all drive lines, and analyzes the signals from each sense line in frequency domain. Its parallel driving allows high speed detection even for a very large touch screens. It enhances the sensing SNR (Signal to Noise Ratio) by introducing a frequency domain noise filtering scheme. We also propose a pre-distortion equalizer, which compensates the drive signals using the inverse transfer function of touch screen panel to further enhance the sensing SNR. Experimental results with a 23" large touch screen show that the proposed technique enhances the frame scan rate by 273% and an SNR by 43dB compared with a conventional scheme.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.20 no.1
• /
• pp.39-50
• /
• 2007

This paper presents 3D infinite elements for the elastodynamic problem with multi-layered half-space. Five different types of infinite elements are formulated by using approximate expressions of multiple wave components for the wave function in multi-layered soil media. They are horizontal, horizontal-corner, vortical, vertical-corner and vertical-horizontal-comer infinite elements. The elements can effectively be used for simulating wane radiation problems with multiple wave components. Numerical example analyses are presented for rigid disk, square footings and embedded footing on homogeneous and layered half-space. The numerical results show the effectiveness of the proposed infinite elements.

• Proceedings of the Korea Multimedia Society Conference
• /
• 2002.11b
• /
• pp.421-424
• /
• 2002

본 연구에서는 ARM720T core를 사용한 보드에서 머리 전달 함수(HRTF)를 이용한 입체음향 시스템을 구현하였다. ARM720T core를 탑재한 EP7312칩은 저전력 고성능 프로세서로서의 이점을 갖고 있기 때문에 HRTF의 특성을 이용한 입체음향 실시간 구현이 가능하다. 또한 ARM 프로세서를 사용함으로, DAC제어부 부분을 제외한 메인 프로세싱 부분은 ARM 계열의 다른 프로세서에서도 쉽게 사용 가능하단 이점이 있다. HRTF를 이용하여 2채널의 입체음향을 구현하는 방식은 콘볼루션에서 많은 계산량이 소요된다. 본 연구에서는 실시간 구현 시 계산량을 줄이기 위해 시간영역의 콘볼루션을 사용하지 않고 주파수 영역에서의 가중 중복 합산방식을 이용하여 계산하였다. 본 연구의 연구 결과는 가상현실이나 방송음향장비 뿐만 아니라 저전력을 요구하는 휴대용 멀티미디어 기기에서 MP3/AAC/WMA와 같은 오디오 압축 장치부분에 활용되어 질 수 있다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.4A
• /
• pp.310-315
• /
• 2002

The Bark Coherence Function (BCF) defies a coherence function within perceptual domain as a new cognition module, robust to linear distortions due to the analog interface of digital mobile system. Our previous experiments have shown the superiority of BCF over current measures. In this paper, a new BCF suitable for VoIP is developed. The unproved BCF is based on the wavelet series expansion that provides good frequency resolution while keeping good time locality. The proposed Wavelet based Bark Coherence function (WBCF) is robust to variable delay often observed in packet-based telephony such as Voice over Internet Protocol (VoIP). We also show that the refinement of time synchronization after signal decomposition can improve the performance of the WBCF. The regression analysis was performed with VoIP speech data. The correlation coefficients and the standard error of estimates computed using the WBCF showed noticeable improvement over the Perceptual Speech Quality Measure (PSQM) that is recommended by ITU-T.

• Membrane Journal
• /
• v.14 no.2
• /
• pp.142-148
• /
• 2004

This paper presents the enhancement of oxygen transfer efficiency using vibrating intravascular lung assist device (VIVLAD) for patients having chronic respiratory problems. The flow rate was controlled by the pump and monitored by a built-in flow meter. The vibration apparatus was composed of a piezo-actuator, a function generator, and a power amplifier. Gas flow rates of up to 6 L/min through the 120-cm-long hollow fibers have been achieved by exciting a piezo-actuator. The output PVDF sensor and FRF (frequency response function) were investigated by various frequency in VIVLAD. As a result, the maximum oxygen transfer rate was found to occur with maximum amplitude and the transfer of vibration to the hollow fiber membranes. It was excited by the frequency band of 35 Hz at various distilled water flow rates, and various module types.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.35C no.6
• /
• pp.39-47
• /
• 1998

A fourth-order $\Sigma$-$\Delta$ modulator is designed and implemented in 0.6 $\mu\textrm{m}$ CMOS technology. The modulator is verified by introducing nonlinear factors such as DC gain and slew rate in system model that determines the transfer function in S-domain and in time-domain. Dynamic range is more than 110 dB and the peak SM is 102.6 dB at a clock rate of 2.8224 MHz for voiceband signal. The structure of a ∑-$\Delta$ modulator is a modified fourth-order ∑-$\Delta$ modulator using direct feedback loop method, which improves performance and consumes less power. The transmission zero for noise is located in the first-second integrator loop, which reduces entire size of capacitors, reduces the active area of the chip, improves the performance, and reduces power dissipation. The system is stable because the output variation with respect to unit time is small compared with that of the third integrator. It is easy to implement because the size of the capacitor in the first integrator, and the size of the third integrator is small because we use the noise reduction technique. This paper represents a new design method by modeling that conceptually decides transfer function in S-domain and in Z-domain, determines the cutoff frequency of signal, maximizes signal power in each integrator, and decides optimal transmission-zero frequency for noise. The active area of the prototype chip is 5.25$\textrm{mm}^2$, and it dissipates 10 mW of power from a 5V supply.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.16 no.6
• /
• pp.16-21
• /
• 1979

Two dimensional kernels which reconstruct a tomographic image from a blurred one formed by simple back-projection are investigated in the frequency domain and their performances are compared. The kernels are derived from a point spread function of the tomographic system and have the form of a ramp filter modified by several window functions to suppress ringings or artifacts in the reconstruction. Computer simulation using computer-generated phantom image data with different filter functions has been carried out. In this simulation, it is found that the computation time for 2-D reconstruction is much less than that of 1-D convolution method by a factor of ten or more whereas the reconstructed image quality of the former is far poorer than the latter. In 2-D reconstruction heavy windowing results in less noisy reconstruction but details smear out in this case. The trade-offs between these points are considered.

• Journal of the Society of Naval Architects of Korea
• /
• v.31 no.2
• /
• pp.65-77
• /
• 1994

This paper presents a derailed application procedure of the linear quadratic(LQ) theory for a SWATH heave and pitch control. A time domain model of coupled, linear time-invariant second order differential equations is derived from the frequency response model with the frequency dependent added mass and damping approximated as constant values at the heave natural frequency. Wave exciting forces are modeled as a sum of sinusoids. A systematic selection procedure of state and control weighting matrices is presented to obtain good transient behavior and acceptable fin movement. The validity of this controller design process is throughly investigated by simulations both in time domain and frequency domain and singular value plots of transfer function matrices. The finally designed control system shows good overall performances revealing that the applicability of the present study is proved successful.

• The Journal of the Acoustical Society of Korea
• /
• v.29 no.5
• /
• pp.339-346
• /
• 2010

For the implementation of the crosstalk canceller, the filters with large length are needed, which is because that the length of the filters greatly depends on the length of the head-related impulse responses. In order to reduce the length of the crosstalk cancellation filters, many methods such as frequency warping, common acoustical pole and zero (CAPZ) modeling have been researched. In this paper, we propose a new method combining these two methods. To accomplish this, we design the filters using the CAPZ modeling on the warped domain, and then, we implement the filters using the poles and zeros de-warped to the linear domain. The proposed method provides improved channel separation performance through the frequency warping and significant reduction of the complexity through the CAPZ modeling. These are confirmed through various computer simulations.