• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.21 no.1
• /
• pp.24-30
• /
• 2011

In this work, a new active hybrid mount featuring piezostack actuator and rubber element is proposed, and its vibration control performance is evaluated by applying a robust frequency-shaped sliding mode controller. After describing the configuration of the proposed mount, vibration control performances are experimentally evaluated. A mount system with four active hybrid mounts is then constructed. To attenuate vibrations on the supported mass, a frequency-shaped sliding mode controller is designed and implemented to the system. Finally, control performances are obtained and presented in time and frequency domains via computer simulation.

• Journal of the Korean Society for Railway
• /
• v.16 no.1
• /
• pp.1-6
• /
• 2013

In this study, the natural frequency and damping ratio of a four-harness satin woven glass/epoxy composite material are evaluated by means of modal tests and a finite element analysis. To achieve this goal, glass/epoxy beam specimens with different lengths and thicknesses were manufactured via autoclave curing. In the test, the maximum damping ratio was found to occur at the lowest test frequency. As the test frequency increased, the damping ratio decreased exponentially to a critical value. After that value, the damping ratio increased gradually to the maximum test frequency.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.7 s.349
• /
• pp.132-142
• /
• 2006

In this paper, we present a candidate high data rate space time coded OFDM system for short range personal networking. The system transmits the complex space time coded signals with a hybrid orthogonal frequency division multiplexing (OFDM) based on ultra wideband (UWB) pulses. The transmitted signals are sparse pulse trains modulated by a frequency selected from a properly designed set of frequencies. Additionally, a widely linear (WL) receive filter and a space time frequency transmission are designed by using two simple parallel linear detectors. To overcome the deeply fade in the propagation system, a beamforming combined with space time block codes also 따 e briefly discussed.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2000.11a
• /
• pp.79-83
• /
• 2000

해양에서의 기름유출이 가장 빈번하고 심각한 해양 오염이다. 이러한 오염의 초기 발견을 위한 센서로서 수정진동자의 표면에 활성탄을 도포한 센서의 측정감도와 안정성을 시험하고자 한다. 분말 활성탄과 페놀 수지를 센서의 표면에 도포하고 약1시간 가열하여 성형하였다. 물과 소금용액에 아세톤을 각각 소량 용해하여 유사 오염해수를 만들고 서로 다른 농도의 용액에서 공진주파수를 측정하여 아세톤 농도를 계산하였다. 실험결과를 고려할 때 센서의 제작이 적절하였고 아세톤 농도의 측정이 안정하며 충분히 예민하여 해수의 유기물 오염 측정에 사용할 수 있음을 알 수 있었다.

• Proceedings of the Korean Fiber Society Conference
• /
• 2003.10b
• /
• pp.126-129
• /
• 2003

PEI(polyetherimide)는 고강도, 고탄성율를 가지며 20$0^{\circ}C$에서 연속사용이 가능한 고내열성, 내화학성을 가진 고성능 고분자이다. 우수한 물성과 더불어 성형성도 뛰어나 다양한 제품설계를 할 수 있으며, 특히 연소시 낮은 연기배출율(smoke emission)을 지니며, 고유의 우수한 난연성을 가지고 있다. 또한 광범위한 온도와 주파수대에서 높은 유전율과 전기 저항 특성을 유지할 수 있다. (중략)

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.32B no.11
• /
• pp.1464-1472
• /
• 1995

In this paper, we propose an error diffusion image halftoning technique based on the noise spectrum shaping. The new technique can arbitrarily control the shape of the display error spectrum whereas conventional halftoning algorithms have been known to minimize dc errors only in which case edge information cannot be properly rendered. As a method for estimating the error diffusion coefficients, a least mean square (LMS) approach is adopted.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.6B
• /
• pp.579-585
• /
• 2002

The investigation into the effect of various feedback errors on system performance can help the robust feedback channel design and transmission of exact feedback channel information as well. In this paper, we address the algorithm that determines space combining weight vector maximizing received signal power at mobile on frequency flat fading channel and investigate the performance degradation by feedback channel delay in the FDD/CDMA systems employing transmit beamforming. We observe the effect of feedback channel delay corresponding to the number of transmit antennas and the temporal/spatial correlation of channel. The results show that performance is more sensitive to feedback delay with the larger number of antennas when fadings at transmit antennas are not spatially correlated.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.32 no.4
• /
• pp.88-94
• /
• 2004

The electrical design of the Ka-band antenna for the domestic Communications and Broadcasting Satellite (CBS) is described. The antenna has the offset Gregorian structure and is installed on the Earth-facing panel of the satellite. The electrical performance specifications for the antenna were determined from the required EIRP and G/T through the payload level performance analysis. This paper utilized the reflector shaping technology for the trade-off among the major performance parameters, resulting in compliance of all the parameters. The designed antenna shows 37.95 dBi EOC (End of Coverage) gain and 28.7 dB sidelobe isolation for transmit band, and 37.49 dBi EOC gain and 31.1 dB sidelobe isolation for receive band, The electrical performances of the antenna have been verified via the electrical testing of a manufactured EQM (Engineering Qualification Model) antenna.

• Journal of Advanced Navigation Technology
• /
• v.8 no.1
• /
• pp.73-80
• /
• 2004

In the case of Non-Line-of-Sight (NLOS), common telecommunication systems typically have Rayleigh distributed amplitude characteristics. However measurement result of Ultra Wideband (UWB) Multi-Band Orthogonal Frequency Division Multiplexing (MB-OFDM) system which is proposed as one of candidate standard in IEEE 802. 15. 3a for Wireless Personal Area Network (WPAN) shows that it has independent log normal fading in each cluster as well as in each ray within the cluster. Based on this clustering phenomenon observed, MB-OFDM channel model derived from Saleh-Valenzuela model with a couple of slight modifications. In this paper, channel remodeling for RF frequency hopping in MB-OFDM system is achieved, and performances of MB-OFDM system for each channel mode and data rate are verified using modified channel model.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.37 no.1
• /
• pp.76-87
• /
• 2000

Multicarrier DS-CDAM is an effective approach to realize wideband CDMA system in a multipath fading channeal. In this paper, we propose a cinvolutionally-coded overlapped multicarrier DS-CDMA system, and show the performance improvement by comparing with conventional multicarrier DS-CDMA system. We consider the case of 50% overlapping with the adjacent subband to utilize the transmission bandwidth more efficiently. In the proposed multicarrier system, each of the rate 1/M convolutionally-encoded symbols is also 1/R repetition coded and transmitted using overlapped multicarriers and we may obtain the coding gain and frequency diversity effect, simultaneously. We also analyze the possibility of reduction in total MUI by considering a raised-cosine wave-shaping filter having a roll-off factor (0< ${\beta}{\le}1$). It will be shown that the proposed system outperforms the multicarrier DS-CDMA system in $^{[3]}$.