• Journal of the Korean Institute of Gas
• /
• v.15 no.2
• /
• pp.69-74
• /
• 2011

As a way to propose a method for the establishment of practical damage-minimizing plan for chemical plants, the release scenario was established by using API-581 BRD and the effect zone was estimated by the KS-RBI program supporting the quantitative cause analysis. And the risk assessment was performed. As a result, we found that to minimize the damage of a chemical plant, it is effective to use four release hole diameters (small, medium, large and rupture) and release time estimated according to the classes of detection and isolation systems. In addition, it can be safely said that through appling the damage areas considering weighted average by failure frequency and worst-case simultaneously, industrial sites can come up with the effective emergency response plan.

• Journal of the Korean Institute of Gas
• /
• v.11 no.4
• /
• pp.23-28
• /
• 2007

Damage ranges of accidents of the chemical facilities were estimated by the KS-RBI(Ver.3.0) program supporting the quantitative cause analysis, and the consequences were compared with the results of K-CARM(Ver2.0) program which assesses the quantitative risk in an usual method. As a result we found that the consequences of the KS-RBI program were similar to those of the K-CARM program. Therefore, the KS-RBI program could be applied to the quantitative risk assessment. In addition, it can be safely said that through appling the damage ranges of accidents by weighted average, industrial sites can come up with the effective plans of mitigation and emergency.

• Journal of the Korean Institute of Gas
• /
• v.14 no.4
• /
• pp.37-44
• /
• 2010

To propose a cause analysis method of pressurized facilities, a likelihood of failure (LOF) for the thinning module by hydrochloric acid corrosion was analyzed through the risk-based inspection (RBI) using API-581 BRD. For this investigation, the technical module subfactor (TMSF), as a main factor of the LOF, was estimated, and the effects of parameters on the TMSF were analyzed quantitatively. As a result, we found that the TMSF increased with increasing chloride ion concentration and temperature, but it decreased with increasing thickness of the facilities, inspection number and inspection effectiveness. Also, the TMSF showed a relatively low value for the monitoring system implemented and the overdesign factor>1.5. In this condition, the TMSF changed sensitively with the inspection number, the inspection effectiveness and the overdesign factor, and its magnitude varied with the monitoring system.

• Journal of the Korean Institute of Gas
• /
• v.12 no.2
• /
• pp.110-117
• /
• 2008

The risks of the chemical facilities were estimated by the KS-RBI(Ver. 3.0) program supporting the quantitative cause analysis, and reduction method for the risks of the facilities was investigated. As a result, we could find that the risks of the facilities decrease with reducing the likelihood of failure (LOF) affected by demage mechanism, inspection number and effectiveness of inspection, and with reducing the consequence of failure (COF) affected by the ratings of the detection, isolation, and mitigation systems. Furthermore, high risks of the facilities would be decreased by reduction of the LOF and the COF simultaneously. Accordingly, the applied plant would be able to achieve the decrease of inspection and labor costs because of the decrease of consequences and inspection intervals through the reduction of risks.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.19 no.2
• /
• pp.139-152
• /
• 2009

According to the third study on the distribution of chemical substances carried out by the Department of Environment in 2006, there were a total of 900 chemical substances whose respective annual usage amount exceeded 1,000 tons and, among them, 90 substances belonged to the 168 hazardous substances requiring management(53.6%). The work-related illnesses caused by hazardous substances requiring management in Korea between $1992{\sim}2005$ can be classified into four groups depending on the type of the chemical substances. These four groups are 23 organic substances including benzene, 12 metals including lead, 3 acids and bases including hydrogen chloride, and 6 gaseous substances including carbon monoxide. These hazardous substances requiring management were again classified depending on the threshold limit values. The chemicals whose TLV was lower than or equal to 0.005 ppm included 4 organic substances including methylene bisphenyl isocyanate and toluene-2,4-diisocyanate (TDI). The chemicals whose TLV was larger than 51 ppm included 22 organic substances including diethyl ether and 1,2-dichloroethylene. When we classified these hazardous substances requiring management according to the categories of GHS health hazards, we found that isobutyl acetate and magnesium oxide didn't belong to the 13 health hazard categories. Among the substances whose TLV is set and whose annual usage amount is more than 0.1 million ton, we recommended 12 chemical species including 4,4'-Methylenedianiline as new hazardous substances requiring management. All the recommended substances were found to be hazardous when we classified their health hazards.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.28 no.1
• /
• pp.80-90
• /
• 2018

Objectives: This study was performed to propose a domestic occupational exposure limit(OEL) following a health hazard assessment, calculation of a non-carcinogenicity reference concentration worker($RfC_{worker}$) value, and examination of international agencies' exposure limits. It also recommends legal management within the Occupational Safety and Health Act for HCFC-123, which caused an acute hepatotoxicity incident. Methods: An acute hepatotoxicity incident due to the fire extinguishing agent HCFC-123 was investigated. Toxicological hazard and health hazard classifications were examined and a non-carcinogenicity $RfC_{worker}$ value was calculated for HCFC-123. An OEL and the necessity of legal management were recommended as well. Results and Conclusions: An OEL for HCFC-123 of 10 ppm($62.5mg/m^3$), which considered the $RfC_{worker}$ value, 5.56 ppm, produced in dose-response assessment and the exposure level of 19.1-20.9 ppm measured as an eight-hour TWA(time-weighted average) in the incident place, is recommended. HCFC-123 is urged to be included as a chemical requiring legal management in the Occupational Safety and Health Regulations. In addition, it is recommended that a peak exposure of ACGIH be adopted in the Notice of the Ministry of Employment and Labor.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.28 no.1
• /
• pp.91-99
• /
• 2018

Objectives: From a policy perspective, the introduction of confidential information reviews is a vital task for expanding workers' right to know and improving hazardous materials information communication. In this study, rational methods for introducing and administering confidential information reviews were examined as a part of advancing chemical information communication. Methods: The domestic status, social demands, and control cases from other countries about confidential information in material safety data sheets(MSDSs) were all examined. Additionally, principles for introducing MSDS confidential information review, what needs to be revised prior to its introduction, and procedures and manners of reviewing confidential information were suggested. Results and Conclusions: When composition information on MSDS needs to be protected in the EU and Canada, confidential information should be claimed and then approved by competent authorities with a principle of reviewing confidential information prior to rescinding information from MSDS. Applying the same principle, certain information on an MSDS that needs to be protected should be reviewed and approved in Korea. As a result, the MSDS is communicated with approval numbers replacing composition information. MSDS confidential information review has five steps, including deciding whether chemicals claimed to be confidential are excluded from applying for a confidentiality exemption, the names and concentration ranges of ingredients are adequate, and the claimed information is valid in terms of confidentiality.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.42 no.4
• /
• pp.469-480
• /
• 2022

To design the crown wall of rubble-mound breakwaters, the horizontal wave load should be available, but determining this load remains difficult. Lee et al. proposed modification factors for Goda's formula for the horizontal wave pressures on acrown wall. The empirical formula by Lee et al. was based on a two-dimensional model test with a relatively narrow armour crest width in front of the crown wall. In this study, a series of experiments at the same facility were conducted on the horizontal wave pressures on the crown wall of a rubble-mound breakwater with a wide armour crest width. As a result, the pressures of the unprotected part of the crown wall were nearly identical to the narrow crest width. However, the pressures of the protected part tended to decrease with a change in the armour crest width. From the experimental results, the horizontal pressure modification factors of Goda's formula including the armour crest width effect are suggested here and are likely applicable to practical designs of the crown walls of rubble-mound breakwaters covered with tetrapods.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.1D
• /
• pp.93-106
• /
• 2008

Domestic construction industry that accounts for nearly 17.5 percent of GDP is one of the major industries that has been leading domestic economy development. However, accumulated negative image such as corruption, fraudulent work and 3D industries shadowing the remarkable achievement is rampant. In order to improve the image for construction industry, this research investigated various cases and activities related to the image enhancement. Cases analyzed include activities of National Center for Construction Education and Research (NCCER) and Construction Industry Training Board (CITB) such as 'Build Your Future', 'Construct My Future', 'Positive Image 2004', and so on. Based on the analysis results, a strategic framework to improve the image of Korean construction industry was proposed. It is envisioned that improved image of the industry will positively affect the growth of the construction industry by attracting more qualified human resources.

• Journal of Korea Society of Industrial Information Systems
• /
• v.29 no.3
• /
• pp.137-152
• /
• 2024

In order to derive a plan to increase the field effectiveness of the safety and health management(SHM) system, this study suggested plans for practical application of SHM system to the actual sites managed by the branch office of a public enterprise along with practical implications that should be considered. For this, in-depth interviews were conducted with employees in charge of safety and health work at the sites to analyze SHM system of the branch office, and the implementation processes and frameworks for establishing SHM system were suggested by grasping the actual conditions of the construction company performing the construction ordered by the branch office. This study shows that in order for SHM to be internalized in public enterprises, plans and performance indicators that can be applied in the field should be specifically presented in consideration of the hierarchical structure and processes of the organization performing the work, and a work environment should be created to focus on practical works related to safety and health.