• Korean Journal of Materials Research
• /
• v.10 no.7
• /
• pp.505-514
• /
• 2000

The carburizing behavior and fatigue properties of the plasma carburized low carbon Cr-Mo steel(0.176C-1.014Cr-0.387Mo) have been investigated. The effective case depth in plasma carburized steel increased up to 50% in comparison with that of gas carburizing, and this case depth increased with the increasing surface carbon content. With increasing time in plasma carburizing, the surface carbon content increased but its increasing rate decreased. Fatigue properties were studied in terms of microstructure, case depth, retained austenite and residual stress near the surface. The fatigue limit of the plasma carburized steel was higher than that of gas carburized one. The initiation of microcracks and initial crack propagation were retarded due to a relatively little surface and internal oxidation layer in plasma carburized steel. Fractography showed the crack initiated at the surface, and transgranular fracture at surface layer was more predominant in plasma carburized steel compared to that of gas carburized steel.

• Journal of Broadcast Engineering
• /
• v.4 no.2
• /
• pp.164-175
• /
• 1999

Based on the performance analyses for transmission channel and signal characteristics in digital satellite broadcasting system. the optimal design parameter values for system using QPSK modulation technique were proposed in this paper. The proper performance degradation were of 2.0dB for channel characteristics. O.4dB for transmission signal characteristics and 0.2dB for receiver characteristics. respectively. In this case. the design objectives for system parameters were within ${\pm}\;0.5dB$ for gain flatness in 27MHz bandwidth. and O.1nsec/MHz and $0.2sec/MHz^2$ for linear and parabolic group delay. respectively. Also. the optimal parameter values that provide the maximum availability were of OdB OBO for satellite transponder TWTA. and the optimal bandwidth for PLL circuit was of 40kHz with 0.707 damping factor. These analyses and design values can be available for high data rate transmission system via satellite.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.25 no.1
• /
• pp.20-26
• /
• 2005

Ultrasonic guided waves have been widely employed for long range inspection of structures such as plates, rods and pipes. There are numerous modes with different wave velocities, and the appropriate mode selection is one of key techniques in the application of guided waves. In the present work, phase tuning by an array transducer was applied to generate ultrasonic guided waves. For this purpose, 8-channel ultrasonic pulser/receiver and their controller which enables sequential activation of each channels with given time delay were developed. Eight transducers were fabricated in order to generate guided waves by using an array transducer. The selective tuning of wave mode can be achieved by changing the interval between elements of an array transducer.

• The Journal of the Acoustical Society of Korea
• /
• v.33 no.6
• /
• pp.392-399
• /
• 2014

The underwater acoustic communication is characterized by doubly spread channels, which are the delay spread due to multiple paths and the doppler spread due to environmental fluctuations or a moving platform. An equalizer is used to remove the inter-symbol interferences that the delay spread causes, but an equalizer doesn't use an acoustic environment such as a multipath. However, a passive time-reversal mirror is simpler than an equalizer because a matched filter is implemented numerically at the receiver structure along with one-way propagation. In this paper, a passive time-reversal mirror is applied to remove interferences due to a multipath in sea-going experimental data in East Sea in Oct. 2010 and improved communication performance is confirmed. The performance is verified by comparing the signal-to-interference plus noise ratio before/after passive time-reversal mirror. It is also performed independently of the passive time-reversal mirror and adaptive equalizer and the bit error rate is compared to verify the performance of underwater acoustic communication.

• The Journal of Information Technology
• /
• v.5 no.4
• /
• pp.1-8
• /
• 2002

This thesis is about power line communication(PLC) over the low voltage grid. The main advantage with power line communication is the use of an existing infrastructure. The PLC channel can be modeled as having multi-path propagation with frequency-selective fading, typical power lines exhibit signal attenuation increasing with length and frequency. OFDM(Orthogonal Frequency Division Multiplexing) is a modulation technique where multiple low data rate carriers are combined by a transmitter to form a composite high data rate transmission. To implement the multiple carrier scheme using a bank of parallel modulators would not be very efficient in analog hardware. Each carrier in an OFDM is a sinusoid with a frequency that is an integer multiple of a base or fundamental sinusoid frequency. Therefore, each carrier is a like a Fourier series component of the composite signal. In fact, it will be shown later that an OFDM signal is created in the frequency domain, and then transformed into the time domain via the Discrete Fourier Transform(DFT).

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.10B
• /
• pp.1200-1209
• /
• 2011

In this paper, we propose a novel energy efficient MAC protocol which is based on orthogonal frequency division multiple access (OFDMA) and exploits the physical characteristic that propagation loss of acoustic wave depends on the distance. In the proposed scheme, sensor nodes are grouped according to the distance to sink node. Then, each group uses a different frequency band. The proposed scheme not only enables all sensor nodes to maintain the signal-to-noise ratio above a certain required level (Accepted Minimum SNR, AMS), but also reduces overall transmission power consumption. In addition, the dynamic sub-channel allocation is employed in order to improve data transmission rate. Simulations show that proposed MAC protocol has better performance in a delay-tolerant underwater acoustic sensor networks.

• Journal of Digital Convergence
• /
• v.11 no.10
• /
• pp.379-385
• /
• 2013

MANET is not suitable to be applied to vehicle environments because of frequent path loss and path re-routing. To solve these problem, It is known that location-based routing protocol VANET is efficient. But, the VANET algorithm does not consider urban environments due to frequent vehicle movement and jamming by tall building. In this paper, we propose an efficient routing protocol to improve transfer efficiency and reduce transfer hop count. in urban networks.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.2
• /
• pp.321-327
• /
• 2006

This paper presents low power and high frequency design of instructions using ad-hoc techniques at transistor level for full custom and semi-custom ASIC(Application Specific Integrated Circuit) designs. The proposed design has been verified at high level using Verilog-HDL and simulated using ModelSim for the logical correctness. It is then observed at the layout level using LASI using $0.25{\mu}m$ technology and analyzed for timing characteristic under Win-spice simulation environment. The result shows the significant reduction up to $35\%$ in the power consumption by any general purpose processor like RISC or CISC. A significant reduction in the propagation delay is also observed. increasing the frequency for the fetch and execute cycle for the CPU, thus increasing the overall frequency of operation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.1
• /
• pp.58-65
• /
• 2016

Satellite communication is a wide area network (WAN) which provides communication service worldwide. However, the performance of TCP can be seriously degraded in the satellite networks due to limited bandwidth, long round-trip time (RTT) and high bit error rate (BER) over satellite links. In order to improve the performance of TCP, this paper proposes cross-layer Performance Enhancing Proxy (PEP) in digital video broadcasting-return channel via satellite (DVB-RCS) networks. The proposed protocol sets TCP Congestion Window (CWND) size by using satellite resource allocation information exchanged between TCP and the link-layer. we implement PEP testbed based on Linux to evaluate the performance of the proposed protocol. The simulation results show that the proposed protocol performs better than standard TCP both in single and multiple sessions in variant BER, because the proposed protocol sets TCP CWND size by using satellite resource allocation.

• Journal of Satellite, Information and Communications
• /
• v.9 no.4
• /
• pp.127-133
• /
• 2014

In this paper, we present the design, functions and performance analysis of the virtual machine (VM) based on the Lua interpreter for On-Board Control Procedure Execution Environment (OEE). The development of the OEE has been required in order to operate the lunar explorer mission autonomously which is planned by Korea Aerospace Research Institute (KARI) autonomously. The concept of On-Board Control Procedure (OBCP) is already being applied to the deep space missions with a long propagation delay and a limited data transmission capacity since it ensure he autonomy of the mission without the ground intervention. The interpreter is the execution engine in the VM and it interpreters high-level programming codes line by line and executes the VM instructions. So the execution speed is very more slower than that of natively compiled codes. In order to overcome it, we design and implement OEE using register-based Lua interpreter for execution engine in OEE. We present experimental results on a range of additional hardware configurations such as usages of cache and floating point unit. We expect those to utilized to the OBCP scheduling policy and the system with Lua interpreter.