• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.22 no.3
• /
• pp.251-258
• /
• 2009

At the stage conceptual design, combat vehicle is classified into three general categories of fire power, mobility and physical properties of system. The present research is restricted to fire power and its optimization. At the stage of conceptual designing of system, it is appropriate to consider major variables affecting fire power - including the weight of bullet, which exerts a direct influence on destroying effect, maximum range which takes long range firing in consideration. To estimate the maximum firing range, a simple interior ballistic and an exterior ballistic model were built by using the lumped parameter method, Le Duc method and point mass trajectory model. Design of experiment and regression analysis was used to derive simulations of fire power. Finally, response surface models were built and design variables were analyzed.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.15 no.4
• /
• pp.1831-1837
• /
• 2014

Unmanned combat vehicles is recognized as a key tool to utilize the military combat power in the area of science and technology. It can be expected to minimize the lose of human life and increase the military power. Unmanned combat systems are based on the complex operation concept and the unit system can be manufactured by combination on unmanned combat vehicles. For the unmanned combat systems, military power exists to sustain the acquisition establishment system and unmanned technology, which is considered to give the suitability such as application area.

• Journal of the Korea Society for Simulation
• /
• v.26 no.2
• /
• pp.41-49
• /
• 2017

In the acquisition program, the conceptual design is the most important step toward specifying the military objectives, establishing requirements and determining future developmental directions, of a target system. However, if both the requirements and directions are incorrectly set due to the lack of development experiences and literature backgrounds in the target systems, such as future ground combat vehicles, it may become a major risk in the future design phases and the entire acquisition program. In order to correct these errors in the future phases, time, effort and cost are required. Therefore, it is necessary to reduce the errors that occur in the initial stages to effectively acquire the future ground combat vehicles. This paper describes the initial design method for verifying the requirements and the developmental directions and estimating the system performance at the conceptual design through the system-level physical modeling and simulation (M&S) and the target system performance analysis. The system-level physical M&S use cutting-edge design tools, model-based designs and geometric-based designs. The system performance estimation is driven from the results of the system-level physical M&S and the specialized system analysis software.

• Defense and Technology
• /
• no.7 s.233
• /
• pp.28-39
• /
• 1998

• Journal of Internet Computing and Services
• /
• v.25 no.1
• /
• pp.157-166
• /
• 2024

The Army TIGER System, which is being deployed to implement a future combat system, is expected to bring innovative changes to the army's combat methods and comabt execution capability such as mobility, networking and intelligence. To this end, the Army will introduce various systems using drones, robots, unmanned vehicles, AI(Artificial Intelligence), etc. and utilize them in combat. The use of various unmanned vehicles and AI is expected to result in the introduction of equipment with new technologies into the army and an increase in various types of transmitted information, i.e. data. However, currently in the military, there is an acceleration in research and combat experimentations on warfigthing options using Army TIGER forces system for specific functions. On the other hand, the current reality is that research on cyber threats measures targeting information systems related to the increasing number of unmanned systems, data production, and transmission from unmanned systems, as well as the establishment of cloud centers and AI command and control center driven by the new force systems, is not being pursued. Accordingly this paper analyzes the structure and characteristics of the Army TIGER force integration system and makes suggestions for necessity of building, available cyber defense solutions and Army TIGER integrated cyber protections system that can respond to cyber threats in the future.

• The Journal of the Convergence on Culture Technology
• /
• v.9 no.2
• /
• pp.295-299
• /
• 2023

In Korea, the birth rate is rapidly decreasing in the 21st century. Accordingly, if the current military service and personnel system are maintained, it will be difficult to maintain even the number of the Army reduced to 365,000. Nevertheless, the Army has a mission to protect the country from external aggression as the last bastion of national defense. To fulfill this mission, there are ways to improve the military service and personnel system, but there are ways to maximize individual combat power to create one warrior that is worth a hundred and overcome the insufficient number of troops through superior mobility to the enemy. This study studied how to solve the shortage of troops as well as strengthen combat power through a combined combat system that can maximize individual combat power and mobility by applying the latter concept, and further analyzed the future battle environment and suggested the developmental direction of the army's combined combat system.

• Journal of the Korea Society for Simulation
• /
• v.27 no.2
• /
• pp.1-10
• /
• 2018

This paper presents an autonomous detection and aiming point computation of a battle tank by using RGB images. Maximally stable extremal regions algorithm was implemented to find features of the tank, which are matched with images extracted from streaming video to figure out the region of interest where the tank is present. The median filter was applied to remove noises in the region of interest and decrease camouflage effects of the tank. For the tank segmentation, k-mean clustering was used to autonomously distinguish the tank from its background. Also, both erosion and dilation algorithms of morphology techniques were applied to extract the tank shape without noises and generate the binary image with 1 for the tank and 0 for the background. After that, Sobel's edge detection was used to measure the outline of the tank by which the aiming point at the center of the tank was calculated. For performance measurement, accuracy, precision, recall, and F-measure were analyzed by confusion matrix, resulting in 91.6%, 90.4%, 85.8%, and 88.1%, respectively.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.20 no.6
• /
• pp.794-802
• /
• 2017

Unmanned Aerial Vehicles (UAVs) have been considered as valuable aerial reconnaissance systems and our army wants capability-enhanced UAVs installed in our territory, hoping that the UAVs will provide enemy information in detail. The enemy information acqcuired by UAVs would be shared by our army's legacy systems. In this article, we made a research on the interoperability between UAVs and Ground Fighting Vehicles (GFVs), laying emphasis on what kinds of tactical information could be exchanged by two different weapon systems. Also, it needs to be addressed that their upper-level commanding systems play a significant role in such operation.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.19 no.6
• /
• pp.752-761
• /
• 2016

Tactical Multiband Multirole radio(TMMR) has been developed and under some official testings now. Our army wants TMMR to be installed in Ground Fighting Vehicles(GFVs) and be incorporated with their Battlefield Management System(BMS). Also, BMS with TMMR should communicate with BMS on FM radio which is currently under use in most of GFVs. To achieve such goals, some significant changes should be made into the present BMS and in this paper, several considerations will be presented in the both sides of hardware and software point of view.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.7
• /
• pp.1735-1739
• /
• 2009

The keen global competition is expected among foreign advanced nations for source, key technologies required by unmanned combat ground vehicle. Therefore, the trend of technologies for unmanned ground combat vehicle was analyzed in this research. It was based on the submitted patents from 1988 to 2008 in Korea, U.S.A, Japan, Europe, Canada and Israel. This analysis was focused on finding the technical level, the challenge area and breakthrough technologies and the growth of technologies of each nations considering opinions of experts. This report suggested the field of key technology development