• Analytical Science and Technology
• /
• v.16 no.3
• /
• pp.191-197
• /
• 2003

Two methods, IDMS (Isotope Dilution Mass Spectrometry) and controlled potential coulometry are compared by the determination of Pu for the NBL, CRM No.122, $PuO_2$. The recovery of Pu was found to be $1.002176{\pm}0.000452$ within the relative standard deviation of 0.045% (95% conf. level) although a small size of sample ($0.9{\mu}g$-Pu) was used in IDMS. The recovery using controlled potential coulometry were obtained in the range of 0.9923~0.9960. The analytical results of IDMS and controlled potential coulometry were good agreement within 0.6~1%. Base on these experiment results, The plutonium in HANARO irradiated fuel rod that separated portion of top, middle, and bottom were determined. The measured values of Pu are 1.155 mg, 2.483 mg and 1.920 mg in one gram of sample(fuel+clad), respectively.

• Analytical Science and Technology
• /
• v.11 no.4
• /
• pp.235-242
• /
• 1998

Membrane electrode based on chitin(po1y-[$1{\rightarrow}4$]-${\beta}$-N-acetyl-D-glucosamine) was prepared by mixing uniformly grounded of chitin (100 mesh) with PVC and DOS. We investigated the potential response of chitin membrane electrode to metal ions. It was observed that the response slopes for $Cd^{2+}$(34.9 mV/decade) and $Cu^{2+}$(34.0 mV/decade) were larger than those for other ions in pH 4 acetate buffer. The potentiometric response of chitin electrode to varying pH was nearly constant in the pH range of 2~12.

• Korean Journal of Food Science and Technology
• /
• v.2 no.2
• /
• pp.34-37
• /
• 1970

The variation of acidity, pH and oxidation-reduction potentials of Dongchimi (a kind of large raddish pickle) during its fermentation was investigated. Estimation of oxidation-reduction potentials was carried out by the electric method. 1. Acidity was increased-3.5% by lactic acid and pH was decreased 3.4 during Dongchimi fermentation. 2. In Dongchimi, oxidation-reduction potentials was comparatively high (rH above 10) in the earlier stage and then decreased rapidly from rH 15 to 2.0 but slightly increased rH 5.0 in the later stage of the fermentation. 3. It is suggested that the earlier stage of fermentation was more aerobic condition than the later stage.

• Geophysics and Geophysical Exploration
• /
• v.13 no.4
• /
• pp.364-369
• /
• 2010

Resistivity data should be edited before the inversion because resistivity data are contaminated by a lot of noise. Generally, outlier or data violating pants-leg effect in dipole-dipole array were used to be rejected in the apparent resistivity pseudo-section. For more precise data editing, normalized voltage curves are used. In this study, we analyzed the behavior of normalized voltage curves for pole-pole, pole-dipole and dipole-dipole arrays in the presence of threedimensional inhomogeneities, and finally re-examined the validity of normalized voltage curves in the editing process of resistivity data.

• Composites Research
• /
• v.22 no.3
• /
• pp.9-17
• /
• 2009

Nanoindentation behaviours on the films of softer Ag film/harder Cu substrate structure were studied by the molecular dynamics method. As a result, it was shown that the stiffness and hardness of films were strongly dependent on the thickness of films. The stiffness and hardness increased with the thickness of film within a critical range as an inverse Hall-Petch relation. The stiffness and hardness of Cu substrate with Ag film less than 5 nm were observed to be lower than those of bulk silver. In particular, the flower-like dislocation loop was created on the interface by the interaction between dislocation pile-up and misfit dislocation during the indentation of Ag film/Cu substrate with film thickness less than 4 nm, which seemed to be associated with the drop of load in the indentation load versus displacement curve.

• Proceedings of the KIEE Conference
• /
• 2007.07a
• /
• pp.353-355
• /
• 2007

피접지체의 접지는 전력설비의 절연파괴,낙뢰 등으로 전압이 침입할 경우 접지전극의 접지저항이 높으면 접지전극으로 유입되는 전류와 접지저항의 곱에 해당하는 접지전극의 전위가 상승하게 되므로 설비의 파손 인축의 피해 등이 발생 할 수 있다. 따라서 접지저항은 낮은 값으로 유지하는것이 필요하고 정기적으로 측정하여 관리하도록 규정하고 있다. 대표적인 접지저항측정방법으로는 3전극법(Fall of potential method)과 Hook-on 측정법이 있다. 그러나 3전극법은 측정하고자 하는 접지전극으로부터 일정한 거리에 전류를 흘려주고 이때 대지 전위를 측정 할 수 있는 2개의 보조전극 설치가 필수적이나 접지극과 접지선의 단자와는 설치 위치가 다르므로 접지전극의 설치점을 확인하기 곤란하고 건물내부, 지하철, 터널 등에는 보조전극의 설치가 거의 불가능하므로 처음 설치한 접지극의 접지저항측정관리에 어려움이 크다. 또한 Hook-on 측정법은 다중 접지 계통에 사용하는 방법으로 접지극이 수십 또는 수백개를 병렬로 연결한 경우 측정하고저 하는 접지그의 접지저항값에 비해 나머지 접지전극 전체의 합성저항이 무시할 수 있을 만큼 적은 경우에만 측정할 수 있으므로 건물이나 변전실 등 수개의 접지극이 설치된 경우는 사용할 수 없다. 본 연구는 보조전극을 설치하지 않고 측정하고자하는 접지전극 상호간의 전류분배 비율을 저항의 역수 비율로 하여 각각의 접지 전극의 접지저항값을 운전 중인 상태에서 간단하고 정확하게 측정할 수 있는 새로운 접지저항 측정 방법에 관한 연구이다.

• Korean Journal of Soil Science and Fertilizer
• /
• v.26 no.3
• /
• pp.160-171
• /
• 1993

Surface charge characteristics of Ultisol(Luisiana soil from Philippines), Alfisol(Maahas soil from Philippines), and Inceptisol(Yongii soil from Korea) were studied by way of potentiometric titration, backtitration technique, and ion adsorption method(or CEC - AEC method). The PZNC(point of zero net charge) values determined by ion adsorption method were much lower than the natural pHs in all soils, indicating that all soil samples bore net negative surface charge. The PZSE (point of zero salt effect) values determined by potentiometric titration and backtitration technique were identical in Luisiana and Yongii soils but not in Maaghas soil. All soils showed higher PZSE values than PZNC values probably due to the influence of permanent negative charge. The permanent charge calculated by the theory of Uehara and Gillman (1980) occupied quite low portion of the CEC measured at pH 7 in all soils. Backtitration technique corrected errors of potentiometric titration at extreme pH. However, it still overestimate the surface charge compared with ion adsorption method. Therefore, the ion adsorption method was recommanded for the surface charge measurement of the usual soils which have high negative charge components.

• Applied Chemistry for Engineering
• /
• v.10 no.6
• /
• pp.871-875
• /
• 1999

We calculated the characteristics of a phosphoric cation exchanger and studied on an accurately computable method to determine the ion exchange capacity for type of potentiometric titration curve. The ion exchanger was prepared by phosphorylation of a styrene-divinylbenzene copolymer with 4% crosslinking. The ion exchange capacity is 5.7 meq/g. The experimental pK values versus ${\mathit{x}}$ in phosphoric cation exchanger can be expressed as a linear equation. The ${\Delta}pK$ values were obtained from the slope of linear equation. The ${\Delta}pK$ values are the differences of antilogarithms(pK) values of the apparent equilibrium constant at complete and zeroth neutralization of the ion exchanger. Also the experimental pK values at ${\mathit{x}}=0.5$ were accorded well with theoretical data. And when it is titrated with NaOH and $Ba(OH)_2$ solutions, a good agreement between experimental and theoretical pK values for various ${\mathit{x}}$ was seen in all the potentiometric titration curves. We knew that the inflection point of potentiometric titration curve in the case of divalent ions are changed much large than that for monovalent ions. If the relation between g values and ${\partial}pH/{\partial}g$ was plotted to the Lorentz distribution curve, ion exchange capacity can be accurately evaluated.

• Korean Journal of Applied Biomechanics
• /
• v.19 no.4
• /
• pp.681-688
• /
• 2009

To better delineate the changes in corticospinal excitability when older adults are asked to observe and/or imagine actions, 22 right-handed older adults without neurological abnormalities were included in this study. The amplitude and latency of motor evoked potentials (MEPs) by transcranial magnetic stimulation were recorded in the abductor pollicis brevis of the dominant hand during passive observation/imagery/active observation of slow/fast action of abduction of right thumb and also at resting state. Thus, active observation showed better changes than passive, but slow and fast action revealed no difference at all.

• Nuclear Engineering and Technology
• /
• v.8 no.1
• /
• pp.19-27
• /
• 1976

The strain ageing behaviour of Zircaloy-4 has been studied in the temperature range 175$^{\circ}C$ to 575$^{\circ}C$ for both quenched and annealed specimens. The strain ageing in quenched Zircaloy-4 was found in the temperature range 175$^{\circ}C$ to 50$0^{\circ}C$ and its Peak occured at 3$25^{\circ}C$ while the strain ageing in annealed specimens occured in the temperature range 175-575$^{\circ}C$, showing two peaks, one at 323$^{\circ}C$ and a higher one at 45$0^{\circ}C$. The peak at 3$25^{\circ}C$ in both quenched and annealed specimens is considered to be due to the segregation of interstitial oxygen atoms to cell walls during ageing. The peak at 45$0^{\circ}C$ in annealed specimens is considered to he due to the interaction of dislocations with Fe atoms. It has been found that strain ageing stress at ~30$0^{\circ}C$ in zirconium alloys is proportional to the square root of oxygen content.