• Transactions of the Korean Society of Mechanical Engineers
• /
• v.16 no.11
• /
• pp.2159-2168
• /
• 1992

Coal-water slurry is considered to have the potential for displacing petroleum used in the existing oil-fired industrial and utility boilers. The combustion of coal-water slurry(CWS) is a complex process and little is known about the detailed mechanism. In this paper the combustion behavior of a single suspended droplet of CWS in hot gas stream was investigated. The effect of coal particle size, water content in droplet, initial droplet size, ambient temperature and oxygen fraction in ambient gas were studied. The results are as follows; (1) Increasing the oxygen fraction in ambient gas considerably reduced the char combustion time. (2) The variation of water content and coal particle size in droplet showed little effect on the combustion behavior. (3) In the relatively high temperature ambient gas, the water evaporation time became shorter and the combustion process was stable.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2006.06a
• /
• pp.131-135
• /
• 2006

A seismic waveform inversion for prestack seismic data based on the Gauss-Newton method is presented. The Gauss-Newton method for seismic waveform inversion was proposed in the 80s but has rarely been studied. Extensive computational and memory requirements have been principal difficulties. To overcome this, we used different sizes of grids in the inversion stage from those of grids in the wave propagation simulation, temporal windowing of the simulation and approximation of virtual sources for calculating partial derivatives, and implemented this algorithm on parallel supercomputers. We show that the Gauss-Newton method has high resolving power and convergence rate, and demonstrate potential applications to real seismic data.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.13 no.6
• /
• pp.1269-1274
• /
• 2018

In this paper, it covers technical aspect of drone by introducing the drone hovering. Arduino Uno and 3-axis attitude and azimuth sensor are the two main components of the drone. Arduino Uno is used as a main controller and 3-axis attitude and azimuth sensor are used to collect axial (X,Y,Z) data, which is massaged to determine the pitch (fore and aft tilt) and the bank (side to side tilt). Furthermore, drone stabilizes horizontal attitude by correcting these tilted angle through PID control.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2013.11a
• /
• pp.1382-1385
• /
• 2013

본 논문에서는 로봇의 움직임 특성을 추출하여 로봇 시스템의 신뢰성을 평가하는 방법을 제안한다. 원자력 발전소 증기 발생기 전열관의 비파괴 검사에 사용되는 ECT 검사용 Probe 가이드 로봇 (이하 증기발생기 로봇으로 기술)을 대상으로 하였다. 증기발생기 로봇의 동작 상태를 감시하기 위해 관측 카메라가 설치된다. 증기발생기 수실은 로봇 설치 및 해체를 위한 원형의 출입구 (Man Way)를 제외하고는 밀폐된 공간이다. 증기 발생기 전열관의 비파괴 검사 중에는 로봇과 로봇의 동작을 감시하는 관측 카메라만 설치된다. 관측 카메라가 고정되어 있다면, 배경의 변화를 야기하는 외란은 없다고 가정할 수 있다. 시간적으로 이웃하는 2 개의 관측 영상을 미분 (차 영상) 처리하면, 로봇 시스템의 이동 성분만 추출된다. 이러한 이동성분의 크기를 계산하여 로봇의 전체 행정거리 (ECT Probe를 검사위치에 안내하기 위해 로봇 기구부가 움직이는 범위)에 대해 영상 프레임 단위로 전개하면 특정의 고유 궤적이 나타난다. 이러한 고유 궤적과 다른 패턴을 보이는 로봇의 움직임 궤적은 에러로 간주한다. Burn-in 시험 (원자력 발전소 현장에 투입하기 전에 실험실에서 현장 적용의 타당성을 검증하기 위해 수행하는 시험) 중에 있는 증기발생기 로봇에 대해 본 논문에서 제안한 방법으로 신뢰성 평가를 수행하였으며, 그 결과 및 문제점 등에 대해 기술한다.

• Annual Conference on Human and Language Technology
• /
• 2020.10a
• /
• pp.205-210
• /
• 2020

한국어 자연어처리 분야가 발달하면서 동형이의어 분별을 한 단계 넘어선 다의어 분별의 중요성이 점점 상승하고 있다. 최근에 다의어가 태깅된 "모두의 말뭉치"가 발표되었고, 이 말뭉치는 다의어가 태깅된 최초의 공개 말뭉치로써 다의어 연구가 본격적으로 진행될 수 있음을 의미한다. 본 논문에서는 이 말뭉치를 학습하여 작동하는 다의어 분별의 초기 모델을 제시하며, 이 모델의 실험 결과는 차후 연구를 위한 비교 기준점이 될 수 있다. 이 모델은 딥러닝을 사용하지 않은 통계형으로 개발되었고, 형태소분석과 동형이의어 분별은 기존의 UTagger로 해결하고 말뭉치 자원 외에도 UWordMap을 사용하여 다의어 분별을 보조하였다. 이 모델의 정확률은 약 87%이며, 다의어 분별 전에 형태소분석 또는 동형이의어 분별 단계에서 오류가 난 것을 포함한다. 현재까지 공개된 이 말뭉치는 오직 명사만 다의어 주석이 있기 때문에 명사만 정확률 측정 대상이 되었다. 이 연구를 통하여 다의어 분별의 어려움과, 다의어 분별에는 동형이의어 분별과는 다른 방법이 필요하다는 것을 확인할 수 있었다.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2008.11a
• /
• pp.112-113
• /
• 2008

유방암은 유럽과 미국을 비롯해 전 세계적으로 증가하고 있으며 최근 우리나라에서도 가장 급속하게 늘고 있는 여성암중에 하나이다. 본 연구에서는 먼저 grey level co-occurrence matrix(GLCM)을 적용하여 유방영역을 분할한 후, median filter 를 적용하여 잡음을 제거하였다. 전처리 수행 후, 2차미분 행렬을 이용할여 미소석회화 부분을 강조한 후, 가우시안 정규분포도를 적용하여 미소석회화 후보군을 검출하였다. 검출된 후보군은 8 개의 feature 들을 적용하여 미소석회화를 최종 결정하였다. 본 연구를 통해서 조기 유방암 진단을 위한 발전된 미소석회화 검출 방법을 제안하였다.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.6 no.3
• /
• pp.102-109
• /
• 2011

In this study, in order to develop ultra rapid hardening mortar(URHM) for tunnel repairs using bottom ash of low recycle ratio and Admixture as Eco concept, watertightness and durability properties of URHM on temperature condition of construction field were performed. Test result, seepage quantity and water absorption coefficient regarding watertightness of URHM were as in the following : series II > series I. Seepage quantity for the standard condition were smaller than low temperatures. all specimens were satisfied below 20g as standards of seepage quantity on KS F 4042. Because of the decrease of unit cement content by to replacement of blast furnace slag, the neutrlization resistance for durability properties was reduced. The result of alkali resistance and acide resistance, compressive strengths for specimens soaked in calcium hydroxide solution of seriesI were lower than compressive strengths for specimens not soaked. On the other hand, the case of series II show that the deterioration of compressive strengths for specimens was not almost showed. Compressive strengths of specimens soaked were similar with specimens not soaked except series II-C in $5^{\circ}C$. Therefore, specimens using both blast furnace slag and bottom ash were good in alkali resistance and acide resistance.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.31 no.3
• /
• pp.386-392
• /
• 1998

An objective index for quality estimation of anchovy sauce, our traditional seafood, has been required because inadequate standard causes dispute about quality estimation. Qualities of anchovy sauce made by traditional method and commercial anchor sauce products were compared by investigating their proximate compositions, total nitrogen contents, amino acid contents, development and level of a specific peptide on SDS-polyacrylamde gel electrophoresis (SDS-PAGE) and isoelectric point (pI) of the specific peptide. Also, pIs of IEF were attemped to identify fish species of salt-fermented sauces. The 55,600 and 46,900 dalton of peptide band were identified in all experimental samples. Especially, the area of 55,600 dalton was closely correlated with total nitrogen contents. Also, specific pIs in accordance with fish species were identified. The results suggest that correlation between area of 55,600 dalton and total nitrogen contents are used of index for quality estimation, and specific pIs are used of fish species identification.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.4
• /
• pp.122-128
• /
• 2016

This paper, proposes a new analysis method for the event detection of an OTDR signal. An OTDR signal was passed through the Hamming filter to remove the high frequency noise included in the signal. The signal was then passed consecutively through a differential filter to detect the events of interest. The terminal position was determined using the fact that there is a large gap between the signal and the trailing noise power beyond the terminal. This study examined the local maxima of the signal up to the terminal position and determined the peak regions. The real events were determined from the peak regions using noise information and peak threshold. Finally, the user events were found by inspecting the user peaks beyond the terminal position. The events of the OTDR signal without users are located at less than 17m compared to the optical fiber link setup. The events of the JDSU device are located less than 25m and their users are less than 5m. For the RadianTech device, the events are detected at less than 19m and the users are found in 5m. The results suggest that the proposed method is sufficiently applicable to an optical fiber link monitoring system.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.9 no.4
• /
• pp.451-459
• /
• 2021

The purpose of this study is to evaluate the performance of a solidifying agent for recycling the fine powder separated from the nuclear power plant decommissioned concrete as a solidifying agent(SA) for radioactive waste. In order to evaluate the performance of the solidifying agent, a powder simulating the fine powder of waste concrete separated from the dismantled concrete of a nuclear power plant was produced, and the main variables were the type of binder and the replacement ratio of zeolite. The solidifying agent was evaluated for fluidity performance, compressive strength, and leaching resistance to non-radioactive cesium. The compressive strength of SA increased as the zeolite replacement ratio increased, and the SA containing 5% or more of zeolite showed a compressive strength that was 1.4 to 1.7 times higher than the acceptance criteria. The cesium leaching index of all specimens was 6 or higher, satisfying the acceptance criteria, and the leaching index of SA was 1.47~1.63 times higher than that of OPC. In particular, the average leaching index after 28 days of the 5% zeolite-substituted solidifying agent was 9.15, which was improved by about 6.4% compared to OPC, and it was confirmed that the zeolite was effective in improving the leaching resistance to cesium ions by showing stable performance over the entire period.