• 한국지구물리탐사학회:학술대회논문집
• /
• 2008.10a
• /
• pp.179-184
• /
• 2008

Silt or clay alluvium fully saturated with water generally shows low resistivity. Sometimes it is believe that the low resistivity layer is considered as good aquifer but this makes problems in the development of groundwater. To overcome this problem, we adopted induced-polarization(IP) method with resistivity method. Laboratory experiments and resistivity/IP field surveys with non-polarization electrodes were conducted for the study. Laboratory experiments shows that the increase of clay contents in the sample mixed with sand and clay give low resistivity and high chargeability. We used this experiment results in the interpretation of resistivity/IP field data which were obtained in riverbank filtration. Finally, the layer which has low resistivity and chargeabilty would be regarded as a good aquifer for the development of groundwater intake.

• Journal of the Korean GEO-environmental Society
• /
• v.13 no.10
• /
• pp.25-32
• /
• 2012

The application of electrical resistivity, which is related to charge mobility, has increased in the field of geotechnical engineering for the detection of underground cavern, faults and subsurface pollution level. The purpose of this study is to investigate the variation of electrical resistivity due to temperature change. Sand-silt mixture specimens prepared in the square freezing nylon cell are frozen in the frozen chamber. Four electrodes are attached on the four side walls of the freezing cell for the measurement of electrical resistance during temperature change. Electrical resistances of sand-silt mixtures with different degrees of saturation (0%, 2.5%, 5%, 10%, 20%, 40%, 60% and 100%) are measured as the temperature of specimens decrease from $20^{\circ}C$ to $-10^{\circ}C$. The electrical resistances determined by Ohm's law are transformed into the electrical resistivity by calibration. Experimental results show that the higher degree of saturation, the lower electrical resistivity at $20^{\circ}C$. Electrical resistivity gradually increases as the temperature decrease from $20^{\circ}C$ to $0^{\circ}C$. For the specimens with the degree of saturation of 15% or higer, electrical resistivity dramatically changes near the temperature of $0^{\circ}C$. In addition, very high electrical resistivity is observed regardless of the degree of saturation if the specimens are frozen. This study provides the fundamental information of electrical resistivity according to the soil freezing and temperature change demonstrates that electrical resistivity be a practical method for frozen soil investigation.

• 한국지구물리탐사학회:학술대회논문집
• /
• 1999.08a
• /
• pp.21-36
• /
• 1999

Recently resistivity survey is widely used for site investigations in the field of civil engineering. Since such application area requires accurate interpretation tools especially in the area of complicated geology and rough terrain topography, we developed a three-dimensional (3-D) resistivity inversion code, which can reconstruct real earth structures. Furthermore, the inversion code gives resolution-enhanced images by applying the ACB(Active Constraint Balancing) method. With the help of this inversion code, 3-D resistivity survey is now used as new techniques for site investigations in civil engineering problem. By imaging the 3-D resistivity distribution, we could get useful informations such as depth distribution of basement rock, distribution of weak zone, fractures and cavities which is crucial to civil engineers.

• Geophysics and Geophysical Exploration
• /
• v.11 no.4
• /
• pp.350-360
• /
• 2008

Electrical resistivity is one of physical property of the earth and measured by electrical resistivity survey, electrical resistivity logging and laboratory test. Recently, electrical resistivity is widely used in determination of rock quality in support pattern design of road and railway tunnel construction sites. To get more reliable rock quality data from electrical resistivity, it needs a lot of test and study on correlation of resistivity and rock quality. Firstly, we did rock property test in laboratory, such as P wave velocity, Young's modulus, uniaxial compressive strength (UCS) and electrical resistivity. We correlate each test results and we found out that electrical resistivity has highly related to P wave velocity, Young's modulus and UCS. Next, we accomplished electrical resistivity survey in field site and carried out electrical resistivity logging at in-situ area. We also performed rock classification, such as RQD, RMR and Q-system and we correlate electrical resistivity to RMR data. We found out that electrical resistivity logging data are highly correlate to RMR. Also we found out that electrical resistivity survey data are lower than electrical resistivity logging data when there are faults or fractures. And it cause electrical resistivity survey data to lowly correlate to RMR.

• The Journal of Engineering Geology
• /
• v.22 no.4
• /
• pp.409-416
• /
• 2012

In this study, an electrical resistivity survey and a drilling investigation were conducted at an animal carcass disposal site. Chemical analysis of leachate collected from the site was also performed (sampling times: May 2011 and June 2012). Five lines of dipole-dipole electrical resistivity surveys were carried out, along with drilling investigations at 3 points within the disposal areas and 11 points near the disposal site. Two-dimensional inverse modeling of the collected resistivity data was performed to evaluate the properties (size, depth, and form) of the disposal site. Leachate analysis showed that pH of leachate decreased from 7.4 to 6.7, while Eh changed from -358 mV to -48 mV over time. In addition, dissolved ions increased due to the progression of carcass decomposition. Results of the electrical resistivity survey indicated that low resistivity zones (minimum value, $0.64{\Omega}m$) existed at a depth of 8 m from the surface. Considering the bedrock location and carcass disposal depth, there was no evidence of bedrock contamination by leachate. The results of the electrical resistivity survey are consistent with those of the drilling investigation, which indicates that electrical resistivity effectively depicted the properties of the disposal site. This study demonstrates that electrical resistivity survey is a suitable technique for investigation of animal carcass disposal sites.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2000.09a
• /
• pp.41-53
• /
• 2000

Electrical resistivity survey is widely applied to the dam seepage problems. Main purpose of the resistivity survey is to delineate the inhomogeneity in the dam. In this study, two- (2-D) and three-dimensional (3-D) resistivity survey methodology and corresponding interpretations of the data have been analyzed using 3-D resistivity modeling results. Since resistivity structures beneath the dam and its shape are 3-D in nature, we could get more accurate image of the dam structures using 3-D survey compared to 2-D survey even though we cannot employ the grid-shape survey layout.

• Journal of the Korean earth science society
• /
• v.29 no.6
• /
• pp.447-453
• /
• 2008

Recently, the electrical DC survey has frequently been performed to assess the safety of embankment. This study showed that the damaged section of embankment could be appropriately detected by the survey only when the three dimensional effect was correctly considered. The shape of the three dimensional embankment was numerically implemented, and a proper modeling was performed to confirm the effect by analyzing the apparent and inverted true resistivity. Then, the field work was carried out. The three dimensional interpretation distinguished the erroneous weak zones from the geometrical artifact, and the embankment was ensured as safe both by the additional survey performed in rainy season and the partial excavation for direct observation.

• Proceedings of the KSEG Conference
• /
• 2002.04a
• /
• pp.285-290
• /
• 2002

조사지역은 전라남도 함평군 함평읍으로부터 남쪽으로 엄다면 화양리, 학야리, 성천리 일대에 발달한 충적층으로서. 이 지역에는 남서-북동방향으로 광주단층이 통과하고 있는 것으로 추정된다. 충적층 하부에 발달한 단층을 포함한 대규모 파쇄대 파악에는 지표지질조사로서 한계가 있다. 따라서 이 연구에서는 물리탐사방법을 적용하여 충적층 하부의 대규모 파쇄대의 방향과 연장성을 파악하고자 하였으며, 사용된 물리탐사법은 전기비저항 2차원탐사, 전자탐사 그리고 자력탐사이다. 전기비저항 탐사결과 충적층 내에서 남북방향의 연장성을 갖는 전기비저항 이상대가 파악되었으나, 자력탐사와 전자탐사의 측정자료에는 이 이상대에대한 반응을 관찰할 수 없었다. 이는 전자탐사의 경우, 가탐심도가 매우 작은 EM31을 사용하였고, 또한 자력탐사는 주변 지질매체 간의 대자율 차이가 없는 것에 기인한 것으로 판단된다. 따라서 향후 지하심부의 탐사를 위해 전자탐사법중 TEM 탐사를 실시할 계획이며, 또한 낮은 전기비저항 이상대의 연장성을 정확히 파악하기 위하여 기 측정된 전기비저항 탐사 측선 사이를 탐사할 예정이다.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2001.09a
• /
• pp.212-215
• /
• 2001

남악지역에 분포하는 조간대 퇴적층의 층서구조와 퇴적심도 및 기반암의 단열구조를 파악하기 위한 전기비저항탐사를 실시하였다. 조간대 퇴적물에서 비저항은 하부로 갈수록 증가하며 대부분 3.0 Ohm-m이하의 비저항으로 고비저항의 기반암의 기반암과 뚜렷한 경계를 보여준다. 퇴적층의 층후는 퇴적지 중앙부에서 30m를 최대로 북쪽 (고해안선)과 남쪽 (영산강)으로 갈수록 감소하는 경향을 보여주는데 선행 조사된 시추결과와 일치한다. 일부 지역의 전기비저항 해석단면과 시추단면에서 견고한 점토질 (stiff)의 지층이 분포하는데 이 지층은 북서-남동 방향의 고해안선과 나란하게 분포한다. 이것은 퇴적물을 공급한 흐름의 방향과 조간대의 확장방향이 북서-남동 방향임을 지시한다. 기반암의 단열구조로 판단되는 저비저항대는 조사지역의 동부에 집중되어 있으며 단열대의 연장방향은 북서-남동 방향이 우세하다.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2003.09a
• /
• pp.528-531
• /
• 2003

안산시 단원구 대부동, 보령시 청소면 장곡리와 서천군 비인면 선도리의 해안가 4곳에서 전기비저항 탐사를 이용하여 해수침투 조사용 관측정 주변의 대수층구조와 해수침투여부를 파악하고자 하였다. 공내수의 심도별 전기전도도를 확인 해본 결과, 4개의 조사공에서 180-48,000$\mu$S/cm의 각기 다른 값을 보였으며, 전기비저항 검층의 결과에서는 16인치 Short-Normal 검층 0.5-19.28$\Omega$m, 64인치 Long-Normal 검층 1.36-47.45$\Omega$m 그리고 Lateral 검층에서는 0.16-6.69$\Omega$m의 값의 분포를 보였다. 이를 통해 해수에 의해 지하수 및 주변 지질이 완전히 오염된 관측정과 우려되거나 아직 해수침투가 일어나지 않은 관측정을 구분할 수가 있었다. 또한 시추공-지표간 토모그래피를 통해 관측정 주변의 개략적인 수리지질 구조도 파악할 수 있었다.