• Journal of KIISE:Software and Applications
• /
• v.31 no.10
• /
• pp.1345-1355
• /
• 2004

In a sender-initiated load redistribution algorithm, a sender(overloaded processor) continues to send unnecessary request messages for load transfer until a receiver(underloaded processor) is found while the system load is heavy. In a receiver-initiated load redistribution algorithm, a receiver continues to send unnecessary request messages for load acquisition until a sender is found while the system load is light. Therefore, it yields many problems such as low CPU utilization and system throughput because of inefficient inter-processor communications in this environment. This paper presents an approach based on genetic algorithm(GA) for adaptive load sharing in distributed systems. In this scheme, the processors to which the requests are sent off are determined by the proposed GA to decrease unnecessary request messages.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.39 no.6
• /
• pp.672-686
• /
• 2002

현재 단대단(End-to-End) 비디오 서비스의 질을 높이기 위해 많은 연구가 각 계층별로 진행되고 있다. 전송계층에서의 오류 제어(Error Control), 네트워크계층에서의 QoS (Quality of Service)모델, 표현 및 응용계층에서의 오류 강인성(Error resilience)/오류 은닉(Error concealment) 등이 연구 개발되고 있다. 그러나 계층 간의 연관성이 높은 부분에서의 통합을 통한 성능향상에 관한 연구는 그 필요성과 효율에 비해 아직도 미흡하다. 본 논문은 QoS 서비스 모델하에서의 적응적 FEC(Forward Error Correction) 적용 및 우선순위에 따른 비디오패킷(VP ,VideoPacket)을 통하여 효율적인 계층화 비디오 스트리밍을 단대단 QoS성능의 향상에 관점을 맞추어 제안한다. 제안하는 방식은 최소 화질 보장과 같은 효율에서 보다 적은 가격에서의 서비스를 제공할 수 있다. 이를 위하여 통합형 서비스(IntServ, IS, Integrated Service) 의 자원예약을 사용하는 방법과 높은 가격의 자원 예약을 사용하지 않는 차별화 서비스(DiffServ, DS, Differentiated Service)를 적용했으며 이에 보장형 서비스의 특징을 공통을 가지기 위해 계층화 FEC를 적용하였으며 적절한 가격의 조절을 위하여 비디오패킷을 통한 데이터 분할을 적용하였다. 본 논문은 또한 최종 사용자의 만족도를 PSNR(Picture Signal to Noise Ration)과 PSNR에서 표현하지 못하는 부분의 평가를 위해 손상프레임율(DFR, Damaged Frame Ratio)과 오류프레임율(EFR,Error Frame Ratio)을 제안 이를 통해 평가하고자 한다. 제안하는 방식의 실험 결과는 비디오 코딩계층과 전송 계층, 네트워크 계층의 결합된 성능이며 이는 또한 화질의 개선뿐만 아니라 사용자의 가격문제에 대하여서도 비교 분석하였다.

• The KIPS Transactions:PartC
• /
• v.14C no.2
• /
• pp.191-198
• /
• 2007

A mobile ad-hoc network (MANET) is an autonomous, infrastructure-less system that consists of mobile nodes. In MANET, on demand routing protocols are usually used because network topology changes frequently. AODV, which is a representative on demand routing protocol, operates using the routing table of each node that includes next hop of a route for forwarding packets. It maintains the established route if there is not an expiration of route or any link break. In the paper, we propose a partially adaptive route maintenance scheme (AODV-PA) based on AODV, which provides dynamic route modification of initial route for selecting the effective route using not only next hop but also next-hop of next-hop (i.e. 2-hop next node) acquired through route discovery process. In addition, the proposed scheme additionally manages the routing table for preventing exceptional link breaks by route modification using HELLO messages. We use NS 2 for the computer simulation and validate that the proposed scheme is better than general AODV in terms of packet delivery ratio, latency, routing overhead.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.12A
• /
• pp.1136-1144
• /
• 2010

In this paper, the effects of HARQ feedback error are evaluated in IEEE 802.16m system when the HARQ and ARQ interactions that utilize the HARQ feedback information is used. Also, the HARQ and ARQ interaction scheme considering HARQ feedback errors are proposed. The HARQ and ARQ interaction scheme improve the system throughput by using the HARQ feedback information instead of the ARQ feedback message, which reduce retransmission time. However, errors in the HARQ feedback information generate severe performance degradation. Especially, the local NAK errors between HARQ feedback error critically degrade the performance, because the local NAK errors lead the loss of ARQ blocks. We propose a channel state-based schemes for HARQ and ARQ interactions to mitigate the throughput degradation due to HARQ feedback errors. Simulation results show that the proposed scheme improves the throughput and the delay performance.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.9B
• /
• pp.876-882
• /
• 2009

In this paper, we propose a sub-cell coverage control algorithm for enhancement of the cell throughput in OFDMA based relay systems. Relay station (RS) is exploited for improved quality of the received signal in cellular communication systems, especially in shadow areas. However, since a RS requires additional radio resource consumption for the link between the base station (BS) and the RS, we have to carefully control the coverage areas if a mobile station (MS) is serviced via the BS or the RS considering the cell throughput. We consider radio resource reuse as well for the sub-cell coverage configuration by applying various reuse patterns between RSs. We also consider a time varying system by adaptively changing the threshold for coverage depending on the MSs' traffic in the cell. We initially determine the sub-cell coverage of the system depending on the ratio of received signal-interference-noise-ratio (SINR) of the MS from the BS and RSs, respectively. Then, the "sub-cell coverage threshold" varies based on the "effective transmitted bits per sub-channel" with time. Simulation result shows that the proposed "time varying coverage control algorithm" leads to throughput improvement compared to the fixed sub-cell coverage configuration.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.23 no.4
• /
• pp.431-437
• /
• 2019

PLC(Power Line Communication) is being used in various ways in smart grid system because of the advantages of low cost and high data throughput. However, power line channel has many problems due to impulse noise and various studies have been conducted to solve the problem. Recently, ACDL(Adaptive Cannonical Differential Limiter) which is based on an adaptive clipping with analog nonlinear filter, has been proposed and performs better than the others. In this paper, we show that ACDL is similar to the detection of slew rate with oversampled digital signal by simplification and analysis. Through the simulation under the PRIME standard it is shown that the proposed performs equal to or better than that of ACDL, but significantly reduce the complexity to implement. The BER performance is equal but the complexity is reduced to less than 10%.

• Journal of Convergence for Information Technology
• /
• v.12 no.2
• /
• pp.30-36
• /
• 2022

In this paper, when the lighting and communication functions of the visible light communication system are used at the same time, we propose a technique to reduce the dimming level and flicker of the lighting. Visible light communication must satisfy both communication and lighting performance. However, the existing data code method results in reducing the brightness of the entire lighting. This causes deterioration of lighting performance and flicker phenomenon. To solve this problem, in this paper, we propose an adaptive learning code allocation technique that allocates binary codes to transmitted characters and optimizes and matches the binary codes allocated according to the frequency of occurrence of alphabets in character strings. Through this, we studied a technique that can faithfully play the role of lighting as well as communication function by allocating codes so that the 'OFF' pattern does not occur continuously while maintaining the maximum dimming level of each character string. As a result of the performance evaluation, the frequency of occurrence of '1' increased significantly without significantly affecting the overall communication performance, and on the contrary, the frequency of consecutive '0' decreased, indicating that the lighting performance of the system was greatly improved.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.1
• /
• pp.42-52
• /
• 2017

DASH (Dynamic Adaptive Streaming over HTTP) is an adaptive streaming technique that enables transmission of multimedia content when clients request the multimedia contents to server. In this system, to ensure the best quality of the content to satisfy users, it is necessary to precisely measure the residual bandwidth. However, the measured residual bandwidth by the DASH, which is not considering the transmission features of TCP, varies by the size of previous media segment, which makes it hard to ensure QoE to users. In this paper, we excluded the TCP Slow start range from measurement of residual bandwidth and suggested the new DASH bandwidth measuring method to decrease the error. Then, we realized the method in DASH system based on open source, and compared the existing measuring method. The new method showed that the accuracy of result has increased by 20%. Also, it could improve the QoE of users in terms of service quality and number of changes of segment quality.

• Journal of Internet Computing and Services
• /
• v.11 no.4
• /
• pp.1-10
• /
• 2010

As recent fusion industry and ubiquitous technology have grown fast, network contents, which require high load, are provided in various infrastructures and facilities such as u-city and smart phones. Therefore, it is anticipated that the playback quality of multimedia compared to network loads degrades dramatically due to the drastic increment of real-time reference of conventional high load contents (eg. multimedia data). In this paper, we improved the method of the traffic assignment based on MPP which elevated the playback quality of multimedia by assigning discriminately the possible traffic of MMS with TP coefficients. When the TP coefficient which combines content preference with media preference was applied to a real-time traffic assignment scheduler, the simulation results showed that the multimedia playback stream was assigned within the possible traffic of a server. The real-time scheduling algorithm was improved by using the TP coefficient that combines the time-dependent image contents and the weighted value of media preference. It was observed from the experiment that the loss of the possible traffic decreases to 3.91% and 3.88% for three and four clients respectively.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.23 no.10
• /
• pp.90-99
• /
• 2009

In this paper, we proposed the new class-E frequency multiplier design that include the highest efficient characteristics. The proposed frequency multiplier is designed for 5.8[GHz] output using the frequency multiplier about 2.9[GHz] input signal. And studying in this paper is for the design and the implementation of the class E frequency multiplier. For the result, the maximum highest efficient characteristics 32[%] which is with output power 24.5[dBm] and 8.5[dB], is shown with frequency multiplier for the 2.9/5.8[GHz] class E. And we applied the linear method to the implemented class E frequency multiplier. As a result, the output spectrum for the linear is upgrade to 12[dB], 12[dB], 13[dB] of the ACPR characteristics on the +11[MHz], +20[MHz], +30[MHz] offset frequency in the center frequency. The result is satisfied with the 3.83[%] of the lineared EVM for the 64-QAM modulated method with the 54[Mbps] transmission velocity. In this paper, we show that the good compensation result of the linearity and the efficiency through the digital pre-linear method of the distortion with the frequency multiplier. Therefore, we suggested the frequency multiplier method are applying to WLAN, cellular, PCS, WCDMA, and etc.