• Resources Recycling
• /
• v.19 no.6
• /
• pp.43-50
• /
• 2010

The crisis of energy gives rise to the growing concerns over continuing uncertainty in the energy market. Under these circumstances, there are also increasing interests on coals. In particular, Low Rank Coal (LRC) is receiving gradual attentions from green industry. But due to is high moisture content range from 30 - 60%, drying process has to be preceded before being utilized as power plant. In this study drying kinetics of LRC is induced by using a fixed-bed reactor. The drying kinetics was evaluated in from of the particle size, the inlet gas temperature, the drying time, the gas velocity, and the LID ratio. The consideration of the reynold's number was taken for correction of gas velocity, particle size and LID was taken for correction of reactor diameter, packing height of coal. As being seen as characteristic of drying coal, it can be found that fixed-bed reactor can contributed to active drying of free water. In this sense, it could be considered that phase boundary reaction is appropriate mechanism.

• Applied Chemistry for Engineering
• /
• v.28 no.3
• /
• pp.313-317
• /
• 2017

With the continuous increase of energy demand, low-grade coal is regarded as one of new energy sources. However, due to the high water content, the utilization efficiency of low-grade coal is not good to be used in recent conversion plants. Therefore, it requires a drying process to lower the water content in low-grade coals. Although a variety of drying experiments were conducted, drying characteristics in accordance with the pressure change has not been progressed. In this study, the flash drying characteristics of low grade coal with high moisture content (21.5 wt%) were determined in a pressurized micro-riser. The effect of operation conditions such as pressure (1-40 bar), dryer temperature ($200-600^{\circ}C$), and tube length (2-6 m) on drying ratios were investigated.

• Korean Chemical Engineering Research
• /
• v.53 no.2
• /
• pp.231-235
• /
• 2015

The characteristics of binderless briquettes for dried low-rank coal was studied in this work. Two kinds of Indonesian coals were used to briquette after drying them in electric oven. The characteristics of briquettes have been examined by moisture contents, particle size, hydraulic force, and storing period. The optimum moisture contents of briquettes were observed at between 10 wt% and 15 wt%. The strength of coal briquette was stronger as particle size became smaller. The strength of coal briquette was proportional to the hydraulic force under 300 kN, whereas there was little difference among the briquettes made at more than 300 kN of hydraulic force. The strength of briquettes sharply decreased for a week after produced, and then showed the tendency of converging. The results from this work can be a useful guideline of manufacturing and managing upgraded coal briquettes.

• Korean Chemical Engineering Research
• /
• v.46 no.3
• /
• pp.443-450
• /
• 2008

Efficient use of low rank coals (LRC) have been investigated as a method to cope with recent high oil price. Among the coals used in industry, lignite and sub-bituminous coals are belong to the LRC, and have abundant deposit and are distributed worldwide, but high moisture contents and self ignition properties inhibits their utilization. In this paper, chemical coal cleaning to produce ash-free coal from LRC has been investigated. Two technologies, that is, UCC(Ultra Clean Coal) process removing ash from coal and Hyper Coal process extracting combustibles from coal were compared with. UCC process has merits of simple and reliable when it compared with Hyper Coal process, but the remaining ash contents werehigher than Hyper Coal. Hyper Coal has ash contents under the 200ppm when raw coal is treated with appropriate solvent and ion exchange materials to remove alkali materials in extracted solution. The ash-free coal which is similar grade with oil can be used as alternate oil in the industry, and also used as a high grade fuel for IGCC, IGFC and other advanced combustion technology.

• Clean Technology
• /
• v.19 no.4
• /
• pp.469-475
• /
• 2013

In this research, the stabilization characteristics of upgraded coal using palm oil residues were investigated. The Eco coal, which is the Indonesian low-rank coal, was used as a raw material. The low-rank coal was mixed with palm fatty acid distillate (PFAD), and then dried in a nitrogen atmosphere at $107^{\circ}C$. The trend of spontaneous combustion of upgraded coal was studied by measuring of crossing-point temperature (CPT), low temperature oxidation and moisture readsorption. The results of the CPT measuring and low temperature oxidation showed that the propensity of spontaneous combustion of the upgraded coal was improved compared to the dried coal. The moisture readsorption characteristics of the upgraded coal was also improved. The upgraded coal was stabilized through the surface coating with PFAD, and stability of upgraded coal was proportional to the content of PFAD.

• Clean Technology
• /
• v.20 no.3
• /
• pp.321-329
• /
• 2014

In this study, Indonesia low rank coal, which has moisture content of around 26%, is dried less than 5% by using a laboratory-scale (batch type) steam fluidized-bed dryer in order to produce the low-moisture, high rank coal. Normally, CCS (carbon capture and storage) process discharges $CO_2$ and steam mixture gas around $100-150^{\circ}C$ of temperature after regeneration reactor. The final purpose of this research is to dry low rank coal by using the outlet gas of CCS process. At this stage, steam is used as heat source for drying through the heat exchanger and $CO_2$ is used as fluidizing gas to the dryer. The experimental variables were the steam flow rate ranging from 0.3 to 1.1 kg/hr, steam temperature ranging from 100 to $130^{\circ}C$, and bed height ranging from 9 to 25 cm. The characteristics of the coal, before and after drying, were analyzed by a proximate analysis, the heating value analysis and particle size analysis. In summary, the drying rate of low rank coal was increased as steam flow rate and steam temperature increased and increased as bed height decreased.

• Korean Chemical Engineering Research
• /
• v.49 no.5
• /
• pp.639-643
• /
• 2011

Fry-drying of coal slurry is one of the upgrading low rank coal processes. It consists of slurry mixing, slurry dewatering, solvent recovery and briquetting. Cost estimation and economic feasibility are examined for the upgrading low rank coal process based on capacity of 1 million ton/yr. In case that investment costs are $100,000,000, discount rate is 12%, and service life is 20 years, the results of economic analysis are enough to satisfy the evaluation criteria of investment such as IRR, B/C ratio, NPV and discounted payback period. According to sensitivity analysis, investment value are very sensitive to raw material cost and product price. Since the bituminous coal price is currently soaring, it is expected that the investment value will increase more and more.

• 한국연소학회:학술대회논문집
• /
• 2014.11a
• /
• pp.47-49
• /
• 2014

발전소에서 설계 규격을 벗어나는 저등급 석탄을 사용하기 시작하면서, 보일러에서의 연소특성을 예측하기 어려운 다양한 성질의 석탄이 들어오게 되어 각종 연소 문제가 증가하고 있다. 이 중 약 점결 특성을 가지는 저등급 석탄의 사용은 대형 클링커로 인한 보일러 하부의 튜브 손상 사고, 재열증기온도 상승으로 인한 출력감발 등의 문제를 발생시켰다. 또한 현재 개발 중인 무회분석탄 역시 점결 특성을 가지고 있는 것으로 알려져 있어 보일러 내부의 다양한 문제를 일으킬 것으로 예상되고 있다. 발전소에서는 강점결탄 수입 규제를 위해 CSN(Crucible Swelling Number)를 이용하여 제철용으로 사용되는 강점결 석탄의 도입을 규제해왔으나, 발전소 운영에 악 영향을 미치는 약 점결탄에 대한 규제 및 대응으로는 그 효과가 미미한 실정이다. 따라서 본 연구에서는 석탄의 점결 특성 중 팽창 특성을 분석할 수 있는 Microdilatometer와 TGA를 이용한 연소반응성 분석을 통해 석탄의 점결 특성이 연소반응성에 미치는 영향을 분석하였다.

• Journal of Energy Engineering
• /
• v.23 no.2
• /
• pp.1-6
• /
• 2014

Upgrading technology has been studied for efficient utilization of low rank coal. Spray coating of heavy oil was applied on the upgrading process in order to stabilize low rank coal against spontaneous combustion. Low rank coal, which contains more than 30wt% of moisture, was upgraded to high calorific coal and stabilized by spray coating of heavy oil. It was identified that spray coating of heavy oil after drying coal is the optimum procedure of upgrading low rank coal. The experimental results show that more than 2wt% of heavy oil should be adsorbed on the coal in order to stabilize sufficiently for spontaneous combustion.

• Applied Chemistry for Engineering
• /
• v.22 no.5
• /
• pp.532-539
• /
• 2011

The physical and chemical properties of the dried low rank coals (LRCs) before and after the surface treatment using ozone and ammonia were characterized in this study. The contents of moisture, volatiles, fixed carbon and ash consisting of dried LRCs before the surface treatment were about 2.0, 44.8, 44.9 and 8.9%, respectively. Also, it was composed of carbon of 62.66%, hydrogen of 4.33%, nitrogen of 0.94%, oxygen of 27.01% and sulfur of 0.09%. The dried LRCs was surface-treated with the various dry methods using gases such as ozone at room temperature, ammonia at $200^{\circ}C$ and then the dried LRCs before and after the surface treatment were characterized by the various analysis methods such as FT-IR, TGA, proximate and elemental analysis, caloric value, ignition test, adsorption of $H_2O$ and $NH_3-TPD$. As a result, the oxygen content increased and the calorific value, ignition temperature and the contents of carbon and hydrogen relatively decreased because the oxygen-contained functional groups were additionally generated by the surface oxidation with ozone which plays a role as an oxidant. Also, its $H_2O$ adsorption ability got higher because the hydrophilic oxygen-contained functional groups were additionally generated by the surface oxidation with ozone. On the other hand, it was confirmed that the dried LRCs after the surface treatment with $NH_3$ at $200^{\circ}C$ have the decreased oxygen content, but the increased calorific value, ignition temperature and contents of carbon and hydrogen because of the decomposition of oxygen-contained functional groups the on the surface. In addition, the $H_2O$ adsorption ability was lowered bucause the surface of the dried LRCs might be hydrophobicized by the loss of the hydrophilic oxygen-contained functional groups. It was concluded that the various physico-chemical properties of the dried LRCs can be changed by the surface treatment.