• Journal of the Korean Society of Propulsion Engineers
• /
• v.22 no.3
• /
• pp.53-64
• /
• 2018

In this study, computational simulation was performed to investigate the characteristics of air/fuel mixing according to the shape of the injector exit when the transverse jet was injected into a supersonic flow. Non-reacting flow simulation was conducted with fixed mass flow rate and the same cross-sectional area. To validate the results, free stream Mach number and jet-to-crossflow memetum ratio are set to 3.38 and 1.4, respectively, which is same as the experimental condition. Further, separation region, structure of the under-expended jet, jet penetration height, and flammable region of hydrogen for five different injectors compared.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2005.05a
• /
• pp.158-163
• /
• 2005

In this paper the aeroacoustic characteristics of a tilt-rotor system is measured by using a sealed model tilt-rotor. With a microphone array system and the do-dopplerization algorithm, the location and the characteristics of rotor noise are successfully measured. The most of high frequency noise (4kHz) is found to be located at rotor blade tips, but the low frequency tonal noise is dominant on the middle of the rotor blades. The measured tonal noise characteristics are compared to the results of theoretical calculation. At 0.5m distance from the rotor plane, measured and calculated data are relatively well matched regardless of rotating speed and collective pitch angie for the azimuthal angles between $0^{\circ}\;and\;60^{\circ}$. However, the data on the azimuthal angles between $70^{\circ}\;and\;90^{\circ}$ are not quite comparable. In addition, the compared data for far-field case (1.5m) are quite different. This is probably due to the unsteady effect which if not included in the theoretical calculation.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2005.05a
• /
• pp.821-825
• /
• 2005

Tilt rotor aircraft was developed for satisfying VSTOL (vertical short take off and landing) capability and cruise performance. However the noise generated by tilt rotor system causes one of the most serious problems. In this paper, noise characteristics of tilt rotor system in hovering flight are predicted by using free wake method and Lowson's formula. The flow field of the tilt rotor is simulated by using time marching free wake method, and the free field acoustic pressure is calculated through Lowson's formula. The predicted results are compared with experimental data at various observing positions. In the near field, they show good agreement with experimental data regardless of rotating speed and collective pitch angles of 6, 8 and 10 degree, although there are some discrepancies between prediction and experiment in the far field and at the rotating axis in the near field. It seems that the reason of these discrepancies is difference of unsteady force fluctuation between experiment and calculation.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.45 no.3
• /
• pp.212-216
• /
• 2017

Aerodynamic analysis for the airfoil, KARI-11-180 having 18% thickness ratio, was performed with CFD techniques. The boundary layer grid was generated by projecting the wall grid normally and fine grid was placed behind the trailing edge to capture the wake accurately. The distance to the far boundary is 100 chords and the flow condition is same as the wind tunnel test condition. Transition SST and DES turbulence models were utilized for accurate prediction of the transiton point. The predicted lift is higher but the drag is predicted lower than the wind tunnel test. 3-dimensional results with airfoil models of which aspect ratio were 2 and 5 were compared with 2-dimensional results.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.16 no.4
• /
• pp.803-810
• /
• 1992

With increases in the rotational speed of hydraulic machine, studies on the hydrodynamic characteristics of supercavitating cascade are important on the view of flow analysis and design of fluid machinery. In the present paper, the complex functions of nonlinear theory corresponding to the flow of supercavitating cascade can be obtained by distributing singulary singulary points such as sources, vortexes and doublets on hydrofoil and free streamline. The numerical calculations on the closed wake model and semi-closed wake model are carried out in order to show the flow characteristics around the supecavitating cascade with finite with finite cavity length. As the result of this study, the flow characteristics such as lift, drag and cavitation coefficients are predicted by the flow conditions of supercavitating cascade in the fluid machinery.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.36 no.7
• /
• pp.621-627
• /
• 2008

Aerodynamic data measured in a wind tunnel has inevitable errors due to the presence of the wind tunnel walls. These unwanted interference effects must be corrected for the wall interference free aerodynamic data. Streamline curvature effects are caused by straightening of streamlines due to wind tunnel walls. Classical Glauert's correction method that is a standard method for fixed wing aircraft is not suitable for rotary wing aircraft. In this paper, Heyson's correction method of which wake model is compatible with rotors is used to correct the rotor shaft angle as well as the dynamic pressure. The results of Heyson's method are compared with Glauert's correction method.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.36 no.2
• /
• pp.137-145
• /
• 2008

An experimental study was performed in order to investigate the influence of Reynolds number on the drag coefficient variations of an oscillating airfoil. A NACA 0012 airfoil was sinusoidally pitched at the quarter chord point with an oscillating amplitude of ${\pm}6^{\circ}$. The free-stream velocities were 1.98, 2.83 and 4.03 m/s and the corresponding chord Reynolds numbers were $2.3{\times}10^4$, $3.3{\times}10^4$ and $4.8{\times}10^4$, respectively. The drag coefficient was calculated from the ensemble average velocity measured by an X-type hot-wire probe(X-type, 55R51) in the near-wakes region. In the case of Re=$2.3{\times}10^4$, variation of drag coefficient shows a negative damping (counter-clockwise variation), which implies an unstable state which could be excited by aerodynamic force, whereas the drag coefficient represents the positive damping (clockwise variation) as the Reynolds number increases from Re=$3.3{\times}10^4$ to $4.8{\times}10^4$. Hence, the drag coefficient variations show significant differences between Re=$2.3{\times}10^4$ and $4.8{\times}10^4$이다.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 1998.10a
• /
• pp.3-3
• /
• 1998

액체추진제 로켓엔진 연소실에는 고유모드에 대응하는 음향파동이 내재되며 이러한 음향파동은 연소와의 상호작용을 통하여 불안정한 음향에너지를 공급받아 증폭되며 결국에는 연소불안정 상태에까지 이르게 된다. 이와 같은 불안정한 상태에 이르기 위해서는 연소로부터 되먹임되는 불안정 에너지의 양이 충분히 크고 구동 음향파동에 근접한 위상을 가져야 한다. 이와 같은 구동 메커니즘을 구성하는 상세한 물리적 현상들을 규명하고 예측하기 위한 많은 연구들이 보고되었으며, 이들 중 이론적인 시간 지연 모델을 사용하는 음향적인 방법은 매우 경제적인 반면 연소 현상에 대한 상세한 모사가 생략되어 연소 불안정의 구체적인 원인을 규명하는데 어려움이 있고, 파동 방정식에 의하여 연소실 내부의 파동 에너지 증가를 예측하는 방법은 연소기 내에서의 연소 메커니즘에 대한 고려 없이 연소에 의해 발생하는 에너지만을 포함하는 단점과 선형적인 연소 불안정에만 제한된다는 제한이 있다. 음향장과 커플된 기화반응 모델은 분무액적의 기화 과정이 추진제 연소의 지배과정이라는 가정 하에 연소응답을 기화반응으로 대체하는 방법으로, 역시 단시간 내에 결과를 얻을 수 있다는 장점이 있으나 기화반응으로부터 음향파동으로의 에너지 되먹임 과정이 배제되어 있어 정확한 결과를 구하기는 어렵다. 이에 대하여 최근에는 전산 모사적인 방법을 사용하는 대규모의 연소장 해석이 가능하여 짐으로써 음향파동에 의한 외란과 에너지 되먹임과정을 모두 포하마여 수치적인 방법을 사용하여 계산하는 액체추진제 로켓엔진의 고주파 연소불안정 해석방법들이 제시되고 있다.안정성 모드가 있음을 보였다. 밀도 변화가 있는 경우나 밀도 변화가 없는 경우 모두 sinuous 모드의 가장 불안정한 모드가 varicose 모드의 가장 불안정한 모드보다 더 불안정함을 보여주어 후류 유동은 자유 유동에 가까운 위상 속도를 가지는 sinuous 모드에 의해 지배될 것임을 예측할 수 있다. 연소반응이 완전연소에 가까울수록 그리고 압축성 효과가 클수록 유동내부의 온도가 증가하고 점성 또한 증가하여 후류유동은 안정됨을 알 수 있었다 유동변수들의 contour로부터 유동의 특성을 예측한 결과 baroclinic 항이 dilatational 항보다 상대적으로 크며, 중심선 상하에 생기는 vortex를 더욱 성장시킬 것으로 생각된다.냉각 홀의 막임, 연소 입자의 점착 부위 등을 예측하여 보완책을 준비할 수 있도록 하였다.$mm^2$sec였으며, 이는 다른 graphite/epixy 복합재의 확산계수와 유사한 값을 나타내고 있다. 또한 추진제가 충전된 연소관을 절단하여 밀폐한 후 95%RH 습도 조건에 보관함으로써 연소관 내부의 추진제 기계적 특성에 미치는 침투된 습기의 영향도 함께 고찰하였다. 추진제에 따라 차이는 있겠으나 추진제가 충전된 연소관은 순수 복합재 연소관에 비해 습기의 투과 정도가 작으며, 본 연소관에 충전된 RDX/AP계 추진제의 경우 추진제의 습기투과에 의한 추진제 물성 변화는 미미한 것으로 나타났다.의 향상으로, 음성개선에 효과적이라고 사료되었으며, 이 방법이 편측 성대마비 환자의 효과적인 음성개선의 치료방법의 하나로 응용될 수 있으리라 생각된다..

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.46 no.5
• /
• pp.368-375
• /
• 2018

In the present study, aerodynamic load analysis for a floating off-shore wind turbine was conducted to examine the effect of periodic platform motion in the direction of 6-DOF on rotor aerodynamic performance. Blade-element momentum method(BEM) was used for a numerical simulation, the unsteady airload effects due to the flow separation and the shed wake were considered by adopting a dynamic stall model based on the indicial response method. Rotor induced downwash was estimated using the momentum theory, coupled with empirical corrections for the turbulent wake states. The periodic platform motions including the translational motion in the heave, sway and surge directions and the rotational motion in the roll, pitch and yaw directions were considered, and each platform motion was applied as a sinusoidal function. For the numerical simulation, NREL 5MW reference wind turbine was used as the target wind turbine. The results showed that among the translation modes, the surge motion has the largest influence on changing the rotor airloads, while the effect of pitch motion is predominant for the rotations.

• Journal of the Society of Naval Architects of Korea
• /
• v.37 no.1
• /
• pp.82-90
• /
• 2000

An experimental study has been carried out at circulating water channel to investigate the non-breaking and breaking waves generated by a submerged circular cylinder steadily moving under the free surface. Free surface profiles and pressure distributions on cylinder surface were measured at various submerged depths of cylinder. They were complemented by the measurements of velocities, head losses and turbulence intensities in the wakes of body and "breaker". Part 1 of this three-part paper describes the experimental arrangement and the patterns of wave profile and pressure distribution at various depths of submergence. These databank contributions are of special interest in traditional ship hydrodynamics. In Part 2, special focuses are made to elucidate the viscous and turbulent aspects of flow field. Finally Part 3 will deal with the visualization of instantaneous vortical flow to study the mutual interaction between vorticies shedded from the free-surface and the cylinder using a Particle Image Velocimetry.