• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2013.05a
• /
• pp.775-776
• /
• 2013

• Proceedings of the Korean Society of Computer Information Conference
• /
• 2017.07a
• /
• pp.129-130
• /
• 2017

본 연구에서는 피복 손상 등으로 누전되었을 때 그 주변의 자기장을 검출하여 누전 여부를 판단할 수 있는 장치를 개발하기 위하여 표면 누전에 의한 전류의 흐름을 조사하였고, 또한 전류에 의한 자계를 검출하기 위해 센서를 제작하였다. 전선 피복 손상에 의한 도전체 표면에 누전되는 상황을 모의하여 전력을 변화시켜서 실험을 수행하였다. 한편 표면에 발생되는 자계를 검출할 수 있도록 센서는 2축으로 구성하였으며, 이를 통해 전선 주변 및 누전된 도전체 표면에서 거리 및 각도 변화에 따른 자계를 검출하였다.

• 전기의세계
• /
• v.42 no.5
• /
• pp.34-39
• /
• 1993

상온 초전도 물질의 발달과 더불어 초전도체의 응용분야 중의 하나인 MHD 추진선은 초전도체의 실용화가 이루어지면 추진기 없는 새로운 추진장치로써 큰 기대를 모으고 있다. 그러나 지금 현재까지 나타난 문제점들인 10-20 테스라급 정도의 고자장강도를 가진 초전도 코일의 제작, 선체 중량의 5% 이하로 줄일 수 있는 초전도 코일 시스템의 경량화, 강자장 발생에 따른 구조물의 지지문제, 누설자장을 최소화시킬 수 있도록 하는 자기 차폐문제, 전극문제들이 차례차례 해결된다면 꿈의 MHD 추진선은 반드시 실현될 것으로 생각된다.

• Journal of the Korean Magnetics Society
• /
• v.8 no.5
• /
• pp.261-269
• /
• 1998

Induced anisotropy with the energy of $6{\times}10^4\; J/m^3$ is obtained in amorphous Sm-Fe based thin films which are fabricated by rf magnetron sputtering under a magnetic field of 500~600 Oe. Compared with conventional thin films, the anisotropic thin films exhibit a similar "saturation" magnetostriction, but show a very large anisotropy in magnetorstiction which is of significant practical importance due to increased strain at a particular direction. It is shown from a systematic investigation over a wide composition range for binary Sm-Fe alloys that anisotropy is also induced, though small, during a normal sputtering procedure due to the stray field, and the largest anisotropy is observed in the composition range of 25~30 at.% Sm. Furthermore, induced anisotropy is also found to be formed by magnetic annealing, but the anisotropy energy is much smaller than that by magnetic sputtering. This may be because the volume diffusion by which atoms move during magnetic annealing to from induced anisotropy is much slower than the surface diffusion which is expected to be a dominant factor during magnetic sputtering.puttering.

• Journal of Satellite, Information and Communications
• /
• v.9 no.1
• /
• pp.90-96
• /
• 2014

This paper is about increasing transfer efficiency of wireless power transmission. The new method is proposed to detect the alignment of transmitter and receiver of wireless charger and so smart phone can display the position of wireless charging receiver on its LCD panel for the maximum charging efficiency. The previous method is only to show the transfer efficiency, but this method is to show not only the efficiency but also coordinates of receiver. The apparatus of the wireless charger is based on WPC(Wireless Power Consortium) standard and has planar air coil combined with magnet shield in Tx and Rx device so that the leakage flux is minimized on condition of under hundreds of kHz operating frequency. In this paper, it's showed that relation of magnet field and distance of each coils can be linearized and position information of Tx and Rx device is calculated thru trigonometry. Through the experiment, the obstacles of linearity are discovered and also showed that it can be optimized. and so the presented method is suitable for alignment detection method of Tx and Rx device in WPC wireless charger.

• Journal of the Korean Institute of Gas
• /
• v.6 no.1 s.17
• /
• pp.10-16
• /
• 2002

This paper introduces developed prototype intelligent pig which detects corrosion on pipeline by using Magnetic Flux Leakage technology. The 8 inch developed MFL(Magnetic Flux Leakage) pig is composed of 5 yokes which magnetize pipeline wall and 45 Hall sensors which detect MFL signal. The designed MFL modules are analyzed by using magnetic circuit method in order to confirm whether pipeline wall is fully saturated. A variety of artificial defects are manufactured on 8 inch diameter steel pipeline in order to acquire MFL signals. So leakage flux of the axial, radial and circumferential component was acquired as defects. The results of this paper show that design technique for 8 inch MFL pig can be applied to large diameter MFL pig and 0.5mm defect depth can be detected.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.5
• /
• pp.382-390
• /
• 2017

In this paper, we consider particular exposure scenarios to evaluate human effects for inductive commercial wireless charging device operating at low frequency. The coil used in this study is the A10 model in Qi standard proposed by WPC(Wireless Power Consortium), and input power is 5 W to the operating frequency of 155 kHz. In perfectly aligned condition, the max leakage magnetic field is $257.58{\mu}T$ which is obtained at the side of the device, and it is exceeded about 7.4 times of the ICNIRP 1998 reference level. The SAR is evaluated with homogeneous phantom which has electric constants of wet skin. The max value of the SAR is $134.47{\mu}W/kg$ which is obtained at the side of the device also, and it is much lower than the international guidelines. Especially, it showed higher SAR values in case of misalignment condition, so we will need to consider the misalignment condition importantly when we evaluate human effects for wireless power transfer system.