• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37C no.12
• /
• pp.1296-1302
• /
• 2012

In this research, optimization of a dual-band dipole array was performed using genetic algorithm. A non-uniform, aperture-shared linear array was configured with dipoles which resonate at 4 GHz and 9.5 GHz. The excited current distributions on dipoles were computed considering mutual coupling between dipole elements. The current distributions were also computed using method of moment (MoM). The optimization using genetic algorithm was performed to obtain the low sidelobe levels in two operating frequency band. The PSLs of the optimized array for 4 GHz and 9.5 GHz are -15.7 dB and -17 dB, respectively. Comparison between computed and simulated results are also discussed.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.13 no.2
• /
• pp.341-348
• /
• 2018

A WLAN dual band dipole antenna with parasitic elements and a reflector is presented for high gain operation. The parasitic elements are used for practical application and high gain operation of the radiation pattern at the WLAN dual band. The proposed antenna consists of three layers, and has dimensions of $74mm{\times}40 mm{\times}31.4mm$. From the experimental results, the achieved impedance bandwidths were 1035 MHz (2.031-3.066 GHz) and 1119 MHz (5.008-6.127 GHz), respectively. The measured maximum gain at each WLAN band was 6.69 dBi and 7.81 dBi, respectively.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2002.11a
• /
• pp.268-272
• /
• 2002

슬롯이 있는 직사각형 마이크로스트립 안테나의 이중주파수 동작 특성을 연구하였다. 마이크로스트립 안테나의 급전방식은 전자기적으로 결합된 단일 마이크로스트립 안테나이며, 패치구조는 직사각형 패치의 대각선 방향에 "ㄱ"형 슬롯을 대칭으로 배치시켰다. 본 논문에서 제안된 "ㄱ"형 슬롯의 장점으로는 패치의 크기를 줄이는 효과와 동시에 이중 대역의 주파수를 갖는 것으로 확인되었다. 제안된 마이크로스트립 안테나의 반사손실은 S11에서 -10 dB 기준으로 첫 번째 공진점 4.808 ㎓ 에서는 120 MHz의 대역폭을 가졌고, 두 번째 공진점 6.175 GHz 에서는 100 MHz의 대역폭을 가졌다.는 100 MHz의 대역폭을 가졌다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.12
• /
• pp.1432-1437
• /
• 2010

This paper proposes a new design method of bandpass filter with single dual-mode resonator. In the proposed method, a coupling coefficient between two resonators was obtained by considering a dual-mode resonator as two single resonators. Based on the obtained coupling coefficient, two resonant frequencies of dual-mode resonator were calculated and then arranged according to a transmission zero's location of required filter. To verify the proposed theory, two WLAN bandpass filters which have a transmission zero to a lower and an upper stopband repectively were designed and implemented.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.3
• /
• pp.376-379
• /
• 2014

In this paper, we designed more improving a dual-band power amplifier than the transceiver of RFID reader that operates at 910 MHz and 2.45 GHz. A dual-band power amplifier has two circuits. One matching circuit is composed lumped element in the band of 910 MHz. The other matching circuit using distributed element in the high band of 2.45 GHz. So, this dual-band power amplifier works as Band Rejection Filter in the band of 910 MHz but in the high band of 2.45 GHz works as Band Pass Filter. Therefore, this is composed a microstrip transmission line. A power amplifier is showed gains of 8 dB output power at 910 MHz and 1.5 dB output power at 2.45 GHz. If input power is 10 dBm, both of bands output 20 dBm.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.2
• /
• pp.93-98
• /
• 2018

This paper introduces the development of HF(NFC) and UHF band(13.56 MHz, 920 MHz) tag antennas, imbedded in a box. In dual band antennas, the HF band tag can be used to inspect the box using NFC, and the UHF band tag can be used for logistics. The dielectric constant of the box material is measured and used for simulation. The Ntag213 chip manufactured by NXP is used in HF loop antennas, since NFC is possible with Ntag213. For the UHF band, the Higgs-3 chip manufactured by Alien is used. The HF tag antenna is located at the center of the UHF tag antenna, and the location of the HF tag antenna is calculated while considering coupling effects. The designed tag can be used by both the bands for the purposes of logistics and authentication.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.8 no.2
• /
• pp.128-132
• /
• 2015

In this paper, a microstrip dual mode band pass filter with doubly fed line is proposed. The proposed filter consists of a corner truncated patch with right crossed slots and doubly fed lines. In general, the resonator with the right crossed slots simultaneously has size reduction and spurious response suppression. In order to improve the rejection performance in out of its higher stop band, the dual mode resonator is excited by using doubly fed line. Details of the filter characteristics are described, and both simulated and measured results of the designed filter are presented.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.3
• /
• pp.499-508
• /
• 2017

A new digital pre-distortion technique to linearize power amplifier (PA) is proposed for concurrent dual-band transmitters. In the conventional dual-band DPD techniques, two independent dual-feedback paths are required to compensate nonlinear cross-products between different bands as well as the nonlinear self-products of each band's own signal. However, it increases hardware complexity and expense. In this paper, we propose a new DPD method requiring only a single feedback path. In this new structure, the proposed technique first estimates the dual-band PA characteristics using the single feedback path. The DPD parameters are then extracted from the estimated PA characteristics. The DPD performance of the proposed method is validated through computer simulation. According to the results, the proposed technique can achieve comparable performance to the conventional two feedback DPD with significantly reduced hardware complexity.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.1 s.92
• /
• pp.84-91
• /
• 2005

In this papers, we study the characteristics of dual band PIFA(Planar Inverted F antenna) for handy phones using H-type silt in the antenna radiators. Slit types on the antenna radiator vary resonance mechanism of the antenna and affect reactance component of impedance for the antenna. Therefore the antennas resonate at the dual band(cellular -band, Korea-PCS band), the bandwidth, input impedance and radiation patterns of the proposed antenna is affected by the silt length on the radiators. In order to demonstrate the validity of the proposed theory, it is implementation the antenna of the 4 types. From results for the experiment of the implementation antenna, -5 dB bandwidth of return loss is content with the allocated bandwidth of Cellular and Korea-PCS system the gains of the antenna is about -8$\~$ - 1 dB, the radiation patterns for x-polarized or y-polarized are omnidirectional pattern. From above the results of this papers, it is conclude mobile phones antenna for handy phones using this papers results.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.5
• /
• pp.598-605
• /
• 2012

In this paper, a multi-layer dual-band bandpass filter using aperture-coupling is proposed. Two coupling paths are formed with the two apertures which exist between two dual-mode resonators. The coupling coefficients can be adjusted without changing the shape of resonators. The bandwidth of the second passband can be adjusted without affecting the bandwidth of the first passband using the size of an aperture between stubs of the dual-mode resonator. The aperture coupling mechanism is theoretically analysed. The dual-mode bandpass filter for the 2.4 GHz WLAN, 3.5 GHz WiMax was designed and fabricated. The fabricated filter shows centered 2.45 GHz and 3.5 GHz with 9 % and 8 % of the bandwidth.