• Journal of Sericultural and Entomological Science
• /
• v.13 no.2
• /
• pp.141-143
• /
• 1971

By means of thin-layer electrophoresis in agarose gel, hemolymph protein of healthy silkworm larvae and of the nuclear polygedrosis virus infected larvae were studied. 1. In the 4th instar, 4 fractions moving toward anode were separated. Dye-binding Capacity of the fraction was increased according to the stage. 2. After 5th day in the 5th instar, 7 fractions moving toward anode were separated, and one fraction toward cathode was separated. 3. On the first day in the 5th instar, 5 fractions were separated, and on the 4th day of the same instar 5 fractions were separated. 4. As for the hemolymph protein fractions of the polyhedrosis virus infected larvae, on the 6th and 7th day, three fractions(D.E.F) were inclined to increase, whereas on the 8th day 4 fractions(A.B.D.E) were disappeared but F fraction was inclined to decrease.

• Journal of Advanced Marine Engineering and Technology
• /
• v.35 no.4
• /
• pp.414-420
• /
• 2011

Thermal stress analysis of a planar anode-supported SOFC considering electrochemical reactions has been performed under operating conditions where average current density varies from 0 to 2000 $A/m^2$. For the case of the 2000 $A/m^2$ operating condition, Structural stress analysis based on the temperature distributions obtained from the CFD analysis of the unit cell has also been done. From this one way Fluid-Structure Interaction(FSI) analysis, Maximum Von-Mises stress under negligible temperature gradient fields occurs when cell components are perfectly bonded. The maximum stress of the electrolyte, cathode and anode in a unit cell SOFC is 262.58MPa, 28.55MPa and 15.1MPa respectively. The maximum thermal stress is critically dependent on static friction coefficient.

• Journal of the Korean Chemical Society
• /
• v.39 no.3
• /
• pp.186-190
• /
• 1995

A simple procedure, readily available at low cost with a sensitivity sufficient to determine trace levels of iron in seawater is proposed, which utilizes adsorptive accumulation of the iron/catechol complex on the mercury drop electrode in a borate medium of pH 8.0. Optimal conditions include a solution concentration of 2 mM catechol, 2.5 mM borate and a pH of 8.0, an accumulation potential of - 0.25 V is applied for 1∼3 min, and the potential scan is in the differential pulse mode. The limit of detection is 1.5 nM Fe using a preconcentration time of 3 min. The interference from copper can be eliminated and baseline slope is greatly improved, because its peak is well separated from that of iron in the proposed medium.

• Journal of the Korean Ceramic Society
• /
• v.44 no.12
• /
• pp.710-714
• /
• 2007

LSGM$(La_{0.8}Sr_{0.2}Ga_{0.8}Mg_{0.2}O_{3-{\delta}})$ is the very promising electrolyte material for lower-temperature operation of SOFCs, especially when realized in anode-supported cells. But it is notorious for reacting with other cell components and resulting in the highly resistive reaction phases detrimental to cell performance. LDC$(La_{0.4}Ce_{0.6}O_{1.8})$, which is known to keep the interfacial stability between LSGM electrolyte and anode, was adopted in the anode-supported cell, and its effect on the interfacial reactivity and electrochemical performance of the cell was investigated. No severe interfacial reaction and corresponding resistive secondary phase was found in the cell with LDC buffer layer, and this is due to its ability to sustain the La chemical potential in LSGM. The cell exhibited the open circuit voltage of 0.64V, the maximum power density of 223 $mW/cm^2$, and the ohmic resistance of $0.17{\Omega}cm^2$ at $700^{\circ}C$. These values were much improved compared with those from the cell without any buffer layer, which implies that formation of the resistive reaction phases in LSGM and then deterioration of the cell performance is resulted mainly from the La diffusion from LSGM electrolyte to anode.

• Journal of the Korean Electrochemical Society
• /
• v.15 no.3
• /
• pp.198-205
• /
• 2012

Carbon-supported manganese oxide composite were fabricated as an air cathode material for Li-air batteries by hydrothermal method. The composite materials of carbon and manganese oxide were investigated by the implementation of X-ray diffraction, FE-SEM and BET surface area measurer. The manganese oxide synthesized at $170^{\circ}C$ for 12 h has a rod like shape morphology with 40-50 nm long in size. A Lithium-air battery with coin type, of which electrodes are composed of cathode composite materials synthesized $170^{\circ}C$-12 h and lithium metal anode, reveals its first discharge capacity of 3,852 mAh/g and four discharge-charge cycles.

• Journal of the Korean Ceramic Society
• /
• v.43 no.12 s.295
• /
• pp.768-774
• /
• 2006

The microstructure of Ni-YSZ cermets was controlled with fine and coarse starting powders (NiO and YSZ) to obtain a optimum strong and conductive tubular anode support for SOFCs. Three types of cermets with different microstructures, i.e., coarse Ni-fine YSZ, fine Ni-coarse YSZ, and fine Ni-fine YSZ, were fabricated to investigate their electrical and mechanical properties. The cermets from fine NiO powder showed high electrical conductivity due to the enhanced percolation of Ni particles. The cermet by foe Ni and coarse YSZ showed excellent electrical conductivity (>1000 S/cm) despite its high porosity $(\sim40%)$ but it showed poor mechanical strength due to the lack of percolation by YSZ particles and due to large pores. Thus fine NiO and YSZ powders were used to make strong and conductive Ni-YSZ support tube by extrusion. The microstructure of the anode tube was modified by the amount of polymeric additives and carbon black, a pore former. Ni-YSZ tube (porosity $\sim34%$) with the finer microstructure showed better performance both in electrical conductivity (>1000 S/cm) and fracture strength $(\sim140\;MPa)$. Either flat or circular NiO-YSZ tubes with the length from 20 to 40cm were successfully fabricated with the optimized composition of materials and polymeric additives.

• Korean Chemical Engineering Research
• /
• v.49 no.6
• /
• pp.781-785
• /
• 2011

In this work, a nano-sized samaria-doped ceria(SDC) was prepared by a urea-based hydrothermal method and characterized by XRD, FESEM and TEM. It was observed that the increase in synthesis time and temperature gave rise to crystallity and particles size. Moreover, the synthesised powders had a excellent ion-conductivity(0.1 S/cm at 600~$800^{\circ}C$) which is suitable for electrolyte of intermediate temperature-solid oxide fuel cell(IT-SOFC). Subsequently for use as electrolyte for anode-supported IT-SOFC, we tried to deposit the SDC powder on a porous NiO-SDC substrate by electrophoretic deposition(EPD) method. From the FESEM observation, a compact

• Journal of the Korean Chemical Society
• /
• v.18 no.2
• /
• pp.110-116
• /
• 1974

Reduction of chromate ion at the Pt-electrode was investigated in neutral unbuffered solutions, in buffered solutions of pH between 8 and 10, and in strongly alkaline medium. In buffered solutions of pH between 8 and 10, the number of electrons transfered in the reduction of chromate ion increased progressively with increasing pH. When chromate ion was reduced in 0.2 N sodium hydroxide medium the following mechanism was suggested: $CrO_4^=+H_2O+2e{\rightarrow}CrO_3^=+2OH^-,\;CrO_3^=3H_2O+e{\rightarrow}Cr(OH)_3+3OH^-$ When tetramethylammonium hydroxide (pH=13.5) was used as the supporting electrolyte, a second wave indicated strong adsorption. In unbuffered solutions of 0.1 N potassium chloride the linear sweep voltammogram consists of three or four distinct waves depending on the initial voltage and the voltage sweep rates, but the first wave was difficult to explain as a diffusion controlled wave.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.41 no.2
• /
• pp.109-115
• /
• 2017

Using the computational fluid dynamics (CFD) technique, we performed a numerical simulation in anodesupported solid oxide fuel cell (SOFC). The effect of gas channel/rib width on the cell performance and temperature uniformity was investigated in planar type SOFC. The open source CFD toolbox, OpenFOAM, was used as a numerical analysis tool. As a result, the effect of gas channel/rib width on the cell performance and temperature uniformity was not significant if the oxygen depletion is not occurring. On the other hand, the usage of a wide rib and operation at high current density may lead to performance degradation due to oxygen depletion.

• Composites Research
• /
• v.30 no.1
• /
• pp.46-51
• /
• 2017

Structural battery has been researched extensively to combine the functions of the battery and structure without gravimetric or volumetric increments compared to their individual components. The main idea is to employ carbon fabric as the reinforcement and electrode, glass fabric as the separator, and solid-state electrolyte which can transfer load. However, state-of-the-art solid-state electrolytes do not have sufficient load carrying functionality and exhibiting appropriate ion conductivity simultaneously. Therefore, in this research, a system which has both battery and load carrying capabilities using glass fabric separator and liquid electrolyte was devised and tested to investigate the potential and feasibility of this structural battery system and observe electric properties. It was observed that elongating separator decreased electrical behavior stability. A possible cause of this phenomenon was the elongated glass fabric separator inadequately preventing the penetration of small particles of the cathode material into the anode. This problem was verified additionally by using a commercial separator. The characteristic of the glass fabric and the interface between the electrode and glass fabric needed to be further studied for the realization of such a load carrying structural battery system.