• YAKHAK HOEJI
• /
• v.20 no.1
• /
• pp.32-36
• /
• 1976

The pH titration curves of ampicillin, amoxicillin and cephalexin in aqueous acetone, ethanol and N, N'-dimethylformamide by use of 0.02N-KOH solution showed that 80% acetone was the most effective solvent for alkali titration of them. The pH jumps of samples in 80% acetone were sharp enough to determine the contents of them by use in 80% acetone (9, 4) was coincided with each equivalent point of ampicillin, amoxicillin and cephalexin, but those of phenolphthalein, thymolphthalein, thymol blue and bgrom cresol purple were not. The color change of brom thymol blue at equivalent points was very clear except the case of amoxicillin that the determination of smaples in 80% acetone with 0.02 N-KOH solution by the aid of brom thymol blue could be available.

• Clean Technology
• /
• v.2 no.1
• /
• pp.47-52
• /
• 1996

The solvent extraction method was applied on a spent solution containing copper, which was produced in a printed circuit board process, to recover copper and to reuse the etching solution. Lix 64 N ($\alpha$-Hydroxyoxime + $\beta$-Hydroxybenzophenone Oxime) was used as a solvent. The acidic spent copper solution was mixed with and alkaline copper solution to pH=2. The solvent including 30 volume% of Lix 64 N extracted 17.1gr/l of copper from the mixed spent copper solution. In the continuous bench scale experiment, 4 stages for extraction, 2 stages for stripping and 4 stages for washing were used. Recovered copper was recycled as copper sulfate and the raffinate was reused as copper etchant. The percentage of copper recovery and the purity of copper sulfate were higher than 99.9%, respectively.

• Membrane Journal
• /
• v.32 no.2
• /
• pp.109-115
• /
• 2022

In this work, the effect of nonwoven support during fabrication of flat sheet membranes via nonsolvent-induced phase separation, was investigated in detail. It was found that dope solutions with low viscosity tend to penetrate through the nonwoven support during phase inversion, resulting in nonhomogeneous membranes. A simple soaking treatment of nonwoven support prevented such unwanted dope penetration, and resulted in membranes with higher water and solvent permeance performance. The dope penetration through nonwoven was more prominent in solutions with low viscosity, and the nonwoven soaking treatment not effective in solutions with high viscosity.

• Journal of the Korean Wood Science and Technology
• /
• v.45 no.3
• /
• pp.268-277
• /
• 2017

In this study, lignocellulose nanofibrils (LCNFs) were prepared from Pussy willow wood powder by disk-milling after pretreatment using the cosolvent of 1-ethyl-3-methylimidazolium acetate ([EMIM]Ac) and N,N-dimethylformamide (DMF) with different mixing ratios for different time. All pretreated samples showed native cellulose I polymorph and cellulose crystallinity was lowest when cosolvent of DMF with 30% [EMIM]Ac was used. Average crystallite size of raw material and the pretreated product by MDF and its cosolvent with 10% [EMIM]Ac was found to be about 3.2 nm and decreased with increasing pretreatment time at the DMF cosolvent with 30% [EMIM]Ac. Defibrillation efficiency was improved by loosening wood cell wall structure by the pretreatment using co-solvent system of [EMIM]Ac and DMF.

• Journal of Navigation and Port Research
• /
• v.28 no.5
• /
• pp.463-468
• /
• 2004

A lab-scale fundamental study to develop the solvent extraction process of ship wash wastewater containing TBT was carried out. For various solvents, including diesels for car and ship, bunker B, thinner, toluene, and ether, the extraction efficiencies of TBT from synthetic ship wash wastewater were compared The effect of extraction conditions, such as solvent amount, time and intensity of agitation, and pH, on the extraction efficiency of TBT was evaluated Diesel for ship showed better extraction efficiency of TBT than those of other tested solvents, and the proper amount of the extraction solvent for 1L of the wastewater was l0mL. When the agitation intensity was increased from 50rpm to 250rpm, the TBT remained in the wastewater after the extraction was decreased from around 120ppb to 2.8ppb. The remaining TBT in the wastewater was sharply decreased from 1hr of the extraction time, but was slightly increased again after 5hrs of the extraction time. The efficiency of TBT extraction was good in the weak acid range of pH, but was not significant as much as the others.

• Journal of the Korean Chemical Society
• /
• v.15 no.6
• /
• pp.352-358
• /
• 1971

The interaction between dimethylsulfoxide molecules and some organic molecules, i.e.nitrobenzene, m-dinitrobenzene, o-dinitrobenzene, 1,3,5-trinitrobenzene, m-xylene, mesitylene, bibenzyl, biphenyl, o-phenanthrene, naphthalene, has been studied. The organic molecules exhibit negative deviation from Raoult's law due to the formation of the charge transfer complexes with dimethylsulfoxide. The stability constants of the complexes were determined spectrophotometrically, and also some thermodynamic functions were calculated. The binding energies of the complexes appear in the range of -1 ∼ -4 kcal/mole. The stability depends on the polarity and basicity of the solvent used.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.24 no.1
• /
• pp.7-24
• /
• 1998

게 껍질로부터 얻은 키틴을 탈아세틸화하여 키토산을 얻었으며, 얻어진 키토산의 유기용매에 대한 용해성을 향상시키기 위해 알칼리 조건에서 고압반응ㅇ기를 사용하여 프로필렌옥사이드와 반응시켜 치환율 3.5의 히드록시프로필 키토산을 합성하였다. 합성된 히드록시프로필 키토산은 고체상 CP/MAS 13C-NMR, 1H-NMR, FT-IR을 통해 반응이 키토산의 6번 탄소의 수산기와 2번 탄소의 아민기에 주로 일어났음을 알 수 있었다. 또한 X-선 회절분석을 통해 키토산의 결정성이 프로필렌옥사이드와의 반응에 의해 크게 감소하였음을 알 수 있었고, 그 결과 유기 용매에 대한 용해성이 현저히 증가되는 현상을 나타내었다. 한편, 히드록시프로필 키토산을 수상에 녹인 후 W/O 에멀젼상에 서 알칼리 촉매를 사용항 에피클로로히드린과 가교반응을 실시한 결과 내부가 비어있는 중공 마이크로비드를 얻을 수 있었다. 전자현미경을 통한 분석결과 중공 마이크로비드의 껍질의 내부에는 스킨층이 형성되어 있었으며, 외부 표면은 다공성이 높은 비대칭 막으로 되어 있음을 확인할 수 있었다.

• Applied Biological Chemistry
• /
• v.33 no.3
• /
• pp.239-246
• /
• 1990

Monascus anka strains with higher pigment production were developed using UV mutation and natural selection. To obtain organic solvent soluble pigments from Monascus anka, the following culture conditions were compared : standing and shaking culture with Nishikawa's medium, and shaking culture with Lin's medium. Shaking culture in Lin's medium exhibited decrease in solvent-soluble intracellular pigments after initial increase. The decrease was accompanied by the increase in water-soluble extracellular pigments. Monascus anka preferred sucrose and ethanol among 7 carbon sources tested. Treatment of sterol biosynthesis inhibitors, $({\pm})$-miconazole and chlorocholine chloride(CCC) , directed carbon pool to the biosynthetic pathway leading to the pigments with CCC's more pronounced effect. Two dimensional TLC revealed at least 7 yellow pigments suggesting existence of hereto unreported pigment. One of the most abundant yellow pigments was isolated and found to be ankaflavin by NMR and MS analysis.

• Applied Biological Chemistry
• /
• v.31 no.4
• /
• pp.376-381
• /
• 1988

The optimal reaction conditions were investigated to produce L-phenylalanine from transcinnamic acid and ammonia by Rhodotorula glutinis IFO 0559. The highest amount of L-phenylalanine was produced when the reaction mixture containing 200mM of traps-cinnamic acid, 4M of $NH_4OH$, 250mM of $(NH_4)_2SO_4$, 0.005% of cetylpyridinium chloride (pH 10.5) and 50mg/ml of dry cell was used. Among the nonaqueous organic solvents, petroleum ether was the most effective on the production of L-phenylalanine. The optimal concentration of petroleum ether in the reaction mixture was 50%. Under the optimal conditions, 21.1g/l of L-phenylalanine was produced in 12hr, and the yield was 63.9% based on transcinnamic acid.

• Journal of the Korean Electrochemical Society
• /
• v.8 no.1
• /
• pp.1-5
• /
• 2005

Electric double layer capacitors(EDLCS) based on the charge stored at the interface between a hi팀 surface area carbon electrode and an organic electrolyte solution are widely used as a maintenance-free power source for IC memories and microcomputers. The achievement of the excellent performance of the capacitor requires an electrolyte solution which provides high conductivities over a wide temperature range and good electrochemical stabilities to allow the capacitor to be operated at high voltage. The electrochemical capacitor using a carbon material as electrodes and using an organic electrolyte with $1M-LiPF_6$ in PC-GBL-DEC(volume ratio 1:1:2) has specific capacitance of 64F/g.