• Journal of Broadcast Engineering
• /
• v.4 no.2
• /
• pp.164-175
• /
• 1999

Based on the performance analyses for transmission channel and signal characteristics in digital satellite broadcasting system. the optimal design parameter values for system using QPSK modulation technique were proposed in this paper. The proper performance degradation were of 2.0dB for channel characteristics. O.4dB for transmission signal characteristics and 0.2dB for receiver characteristics. respectively. In this case. the design objectives for system parameters were within ${\pm}\;0.5dB$ for gain flatness in 27MHz bandwidth. and O.1nsec/MHz and $0.2sec/MHz^2$ for linear and parabolic group delay. respectively. Also. the optimal parameter values that provide the maximum availability were of OdB OBO for satellite transponder TWTA. and the optimal bandwidth for PLL circuit was of 40kHz with 0.707 damping factor. These analyses and design values can be available for high data rate transmission system via satellite.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2012.05a
• /
• pp.635-635
• /
• 2012

최근 공공분야 및 민간분야에서 고해상도 위성영상의 활용이 높아짐에 따라 이를 이용하여 수자원 분야의 치수계획 및 안전도 평가, 유역 홍수대응기술 분야에서의 다양한 활용이 비약적으로 증대되고 있는 실정이다. 고해상도 위성영상의 활용은 국지적 규모의 토지이용 변화 및 대기 상태의 모니터링을 위한 효과적인 기술로 인식되어 왔다. 우리나라의 KOMPSAT-2 위성은 GSD(Ground Sample Distance) 1m급의 전정색 영상과 4m급의 다중분광 영상을 동시에 제공하는 고해상도 위성이다. 그러나 다중분광센서의 복잡성과 보안성에 의해 영상이 제한적으로 제공되고 있어 KOMPSAT-2 위성영상을 이용한 다양한 연구가 미흡한 실정이다. 한편, 토지이용도의 제작은 다중분광 영상을 제공하는 위성영상을 이용하여 제작된다. 다중분광 영상이 제공하는 분광정보 및 공간정보 등으로 토지이용분류를 수행하거나 멀티센서 자료의 통합을 통한 토지이용분류 기법을 개발하여 제작하였다. 그러나 대부분 GSD 10m급 이상의 중 저해상도 위성영상을 이용하여 제작이 이루어져 수평위치 정확도 및 세부정보의 제공이 낮으며, 정보의 최신성이 결여되어 있다. 특히, 유역 치수안전도 평가를 위한 토지이용도 작성은 매우 중요한 부분을 차지하고 있으므로 이에 대한 연구가 필요하다. 이에 본 연구에서는 섬강유역을 대상으로 KOMPSAT-2 영상을 이용하여 유역 치수안전도 평가 및 치수계획 수립기술을 위한 토지이용도를 작성하고자 한다. 토지이용 분류방법은 감독분류와 무감독분류 방법을 조합하여 분류정확도를 개선시키는 하이브리드분류(hybrid classification) 방법을 이용하였으며, 분류기준의 선정은 환경부 토지이용분류 기준을 참고하여 1단위와 2단위 분류체계를 혼용하였다. 또한, 분류 후 후처리를 통하여 잡음을 제거하고 환경부의 토지이용도를 참조하여 육안판독으로 오분류된 지역을 보정하였다. 새롭게 작성된 토지이용도는 기존의 토지이용도와 비교 분석하여 토지이용변화 상황을 파악하고, 이를 통하여 KOMPSAT-2 영상의 토지이용도 개선 가능성을 검토하였다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.18 no.7
• /
• pp.944-950
• /
• 1993

Diodes and GaAs have been commonly used in a mixer design until recently. However, diodes are not preferred to use at the front-end of DBS receiver due to the conversion loss large noise. HEMT has larger conversion gain and better noise characteristics comparing with GaAs MESFET. This paper describes the design procedure, structure, and performance of a mixer, utilizaing HEMT designed by OKI Co. . A mixer configuration in which the local oscillator(LO) signal is applied to the gate is used. When the LO power is 0.01 dBm, the conversion gain of 3.7dB is obtained at IF and the 3 dB bandwidth is 400MMz.

• The KIPS Transactions:PartB
• /
• v.13B no.4 s.107
• /
• pp.369-376
• /
• 2006

The degradation and its inverse modeling can achieve restoration of corrupted image, caused by scaled digitization and electronic transmission. De-speckle process on the noisy document(or SAR) images is one of the basic examples. Non-linearity of the speckle noise model may hinder the inverse process. In this paper, our study is focused on investigation of the restoration methods for bi-level document image degraded by the impulse noise model. Our study shows that, on bi-level document images, the weighted-median filter and the Lee filter methods are very effective among other spatial filtering methods, but wavelet filter method is ineffective in aspect of processing speed: approximately 100 times slower. Optimal values of the weight to be used in the weighted median filter are investigated and presented in this paper.

• Journal of Advanced Navigation Technology
• /
• v.2 no.2
• /
• pp.75-83
• /
• 1998

This paper presents a low cost and high accuracy integrated Global Positioning System (GPS)/dead reckoning (DR) system. The integrated GPS/DR system is capable of providing highly accurate position data in real-time or in post processing. Based on the analysis of the main error source affecting the DR measurements, an eight-state mathematical model for the integrated system has been developed to represent these errors. This eight-state model has been used to build a nonlinear filter for the estimation of the state vector at every epoch when DR measurements are available. The accuracy of the system has been evaluated using 1Hz DR measurements and 3Hz continuous GPS position estimates. Through numerical simulation the system performance during periods with GPS outage has been investigated by comparing two different noise models. While one model is the position estimation filter containing a single noise model, the other filter includes two-level noise model. The simulation results have shown that the estimation filter containing two-level noise model for computing the position error of the integrated GPS/DR system yields better performance than that the filter including the single-level noise model does.

• Journal of Astronomy and Space Sciences
• /
• v.26 no.1
• /
• pp.75-88
• /
• 2009

The main purpose of the current research is to introduce the alternative algorithm of the non-recursive batch filter based on the unscented transformation in which the linearization process is unnecessary. The presented algorithm is applied to the orbit determination of a low earth orbiting satellite and compared its results with those of the well-known Bayesian batch least squares estimation and the iterative UKF smoother (IUKS). The system dynamic equations consist of the Earth's geo-potential, the atmospheric drag, solar radiation pressure and the lunar/solar gravitational perturbations. The range, azimuth and elevation angles of the satellite measured from ground stations are used for orbit determination. The characteristics of the non recursive unscented batch filter are analyzed for various aspects, including accuracy of the determined orbit, sensitivity to the initial uncertainty, measurement noise and stability performance in a realistic dynamic system and measurement model. As a result, under large non-linear conditions, the presented non-recursive batch filter yields more accurate results than the other batch filters about 5% for initial uncertainty test and 12% for measurement noise test. Moreover, the presented filter exhibits better convergence reliability than the Bayesian least squares. Hence, it is concluded that the non-recursive batch filter based on the unscented transformation is effectively applicable for highly nonlinear batch estimation problems.

• Korean Journal of Remote Sensing
• /
• v.37 no.6_3
• /
• pp.1951-1963
• /
• 2021

Remote sensing data using earth observation satellites in agricultural environment monitoring has many advantages over other methods in terms of time, space, and efficiency. Since the sensor mounted on the satellite measures the energy that sunlight is reflected back to the ground, noise is generated in the process of being scattered, absorbed, and reflected by the Earth's atmosphere. Therefore, in order to accurately measure the energy reflected on the ground (radiance), atmospheric correction, which must remove noise caused by the effect of the atmosphere, should be preceded. In this study, atmospheric correction sensitivity analysis, inter-satellite cross-analysis, and comparative analysis with ground observation data were performed to evaluate the application of KOMPSAT-3 satellite's atmospheric correction for agricultural application. As a result, in all cases, the surface reflectance after atmospheric correction showed a higher mutual agreement than the TOA reflectance before atmospheric correction, and it is possible to produce the time series vegetation index of the same standard. However, additional research is needed for quantitative analysis of the sensitivity of atmospheric input parameters and the tilt angle.

• Journal of Satellite, Information and Communications
• /
• v.1 no.2
• /
• pp.56-62
• /
• 2006

This paper describes the MMIC product qualification of the Ka band satellite transponder for the COMS(Communication, Ocean and Meteorological Satellite). Ka-band active equipment for the COMS communications transponder are being developed by using 12 kinds of MMICs which include low noise amplifiers, medium power amplifiers, frequency mixers, frequency multipliers, RF switch, and HEMT attenuator MMIC, Those MMICs had been fabricated at the MMIC production foundry of northrop Grumman Space Technology (Velocium) which is qualified for space application, and experienced in various space programs during past decades. For the MMIC product qualification, Visual inspection and SEM inspection had been performed, and burn-in test for 240 hours and accelerated life-test for 1000 hours had been done on test fixtures of individual MMIC products at $125^{\circ}C$. Additionally, infrared temperature scanning and finite element simulation were performed to analyze and confirm the channel temperature of semiconductor devices on several representatives of those MMIC products that os one of the most important factors in performance degradation and life reduction.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.23 no.3
• /
• pp.283-292
• /
• 2005

After USA removed the Selective Availability (SA), Global Positioning System (GPS) has monopolized the world market and other countries have been depended on GPS, absolutely. So the other countries, Russia, European Community (EC) and Japan, which apprehend to monopolize in technical and strategic parts, are developing the next generation GNSS including GLONASS Galileo and JRANS. And the countries are planning to provide the another GNSS. This research has focused on the next generation GNSS system based on GPS and Galileo system with developing a GNSS simulation software, named as GlMS2005, which generates and analyzes satellite constellation and measurements. Based on the software, a variety of simulation tests have been carried out to recognize limits of GPS-only system and potential benefits of integrated GPS/Galileo positioning in terms of satellite geometry strength and solution accuracy.

• Journal of Space Technology and Applications
• /
• v.2 no.1
• /
• pp.41-51
• /
• 2022

CubeSat is a satellite platform that is widely used not only for earth observation but also for space exploration. CubeSat is also used in magnetic field investigation missions to observe space physics phenomena with various shape configurations of magnetometer instrument unit. In case of magnetic field measurement, the magnetometer instrument should be far away from the satellite body to minimize the magnetic disturbances from satellites. But the accommodation setting of the magnetometer instrument is limited due to the volume constraint of small satellites like a CubeSat. In this paper, we investigated that the magnetic field interference generated by the cube satellite was analyzed how much it can affect the reliability of magnetic field measurement. For this analysis, we used a reaction wheel and Torque rods which have relatively high-power consumption as major noise sources. The magnetic dipole moment of these parts was derived by the data sheet of the manufacturer. We have been confirmed that the effect of the residual moment of the magnetic torque located in the middle of the 3U cube satellite can reach 36,000 nT from the outermost end of the body of the CubeSat in a space without an external magnetic field. In the case of accurate magnetic field measurements of less than 1 nT, we found that the magnetometer should be at least 0.6 m away from the CubeSat body. We expect that this analysis method will be an important role of a magnetic cleanliness analysis when designing a CubeSat to carry out a magnetic field measurement.