• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.6B
• /
• pp.1156-1164
• /
• 1999

In this paper, we have studied the 8 YSB (8 Vestigial Side Band) method which is decided as the standard of modulators for next generation digital TV System. In developing digital TV System, one of the difficult problems is how digital signal can be transmitted to the receiver without any phase distortion. But, phase error is liable to occur by imperfect design, circumstance variation and device degradation. These characteristics result in distortion of 1,0 signal of modulator and interference in adjacent channels. In particular, the interference in modulator of a high power amplifier result in serious problems in adjacent channels. Here we analyzed problems of phase error which are occurred when 8 levels digital signals are modulated to If signal. And we suggested phase error compensation algorithm and discussed the results for adaptation of the algorithm

• Journal of Aerospace System Engineering
• /
• v.10 no.4
• /
• pp.35-40
• /
• 2016

Mid-course correction maneuvers (MCCMs) are necessary to correct the launch-vehicle dispersion to go to the Moon. There were 3 or 4 MCCMs needed for a direct transfer trajectory. But the strategy for MCCMs of the phasing-loop trajectory is different, because it has a longer trans-lunar trajectory than direct transfer does. An orbiter using a phasing-loop trajectory has several rotations of the Earth, so the orbiter has several good places, such as perigee and apogee, to correct the launch-vehicle dispersion. Although launch dispersion is relatively high, the launch vehicle is not as accurate as we expected. A good MCCM strategy can overcome the high dispersion by using small-magnitude correction maneuvers. This paper describes the phasing-loops sequence and strategy to correct high launch-vehicle dispersions.

• Journal of Broadcast Engineering
• /
• v.16 no.1
• /
• pp.85-95
• /
• 2011

In this paper, we propose an alternative carrier phase independent timing recovery method for VSB receivers. The Gardner algorithm may not estimate a timing offset in VSB systems when the residual carrier phase offset is contained in the signal. We use the conjugate multiplication of received signals for cancelling out the carrier phase offset. Then Gardner algorithm is employed for extracting the spectral line. The proposed method generates a consistent timing error even in the presence of the carrier phase offset.

• Journal of IKEEE
• /
• v.8 no.1 s.14
• /
• pp.128-135
• /
• 2004

This paper proposes a phase measurement algorithm which is based on the recursive implementation of sliding-DFT. The algorithm is designed to have a robust behavior against the erroneous factors of frequency drift, additive noise, and twiddle factor approximation. The size of phase error caused by the finite wordlength implementation of DFT twiddle factors is shown significantly lower than that of magnitude error. The drastic reduction of the phase error is achieved by the exploitation of the quadruplet symmetry characteristics of the approximated twiddle factors in the complex plane. Four channel power-line phase measurement system is also designed and implemented based on the time-multiplexed sharing architecture of the proposed algorithm. The operation of the developed system is also verified by the experiment performed under the test environment implemented with the multi-channel function generator and the on-line interfaced host processor system. The proposed algorithm's features of phase measurement accuracy and its robustness against the finite wordlength effects can provide a significant impact especially for the ASIC or microprocessor based embedded system applications where the enhanced processing speed and implementation simplicity are crucial design considerations.

• Proceedings of the Korean Information Science Society Conference
• /
• 1998.10c
• /
• pp.650-652
• /
• 1998

본 논문은 mesh 간략화를 위한 새로운 Gaussian 곡률 오차 추정 방법을 제안한다. Gaussian 곡률은 임의의 형상을 갖는 삼각화 된 단면체 표면에 대하여 위상과 기하학적 정보를 angle 과 face 의 관계로 정형화하여, vertex에 관한 곡률로 근사하여 표현한다. 간략화 방법은 지역적 형상으로부터 전체적인 형상을 추정한 후, 적절한 curvature criteria 로 간략화가 될 vertex를 선택하고 제거한다. 제거된 vertex에 의해 생성된 hole은 곡률에 기반하여 삼각화하고 곡률이 변화되는 vertex들의 Gaussian 곡률 오차를 계산한다. 각 간략화 level마다 최대 Gaussian 곡률 오차를 계산하므로, 사용자는 Gaussian 곡률 오차 추정으로 원하는 간략화 level을 지정할 수 있다. 또한 주어진 오차 안에서 vertex뿐만 아니라 edge나 face의 제거로, 간략화 되는 영역을 확산시켜 필요한 위상과 기하학적 정보를 유지하는 간략화를 할 수 있다.

• Proceedings of the Optical Society of Korea Conference
• /
• 2003.07a
• /
• pp.260-261
• /
• 2003

위상 부호 다중화 시스템에서 cross talk 잡음은 기준빔 성분들간의 180$^{\circ}$와 다른 위상 천이 오차, 기준빔 성분들의 Bragg 격자로부터 불균일한 회절 세기들, 혹은 non-Bragg-matched 격자로부터 회절 때문에 발생하는 것으로 알려져 있다. 본 논문에서는 cross talk의 다른 원인들이 최소화된 시스템에서 위상 천이 오차만이 존재할 때 이전 연구들과 달리 유한한 contrast ratio를 갖는 이진 랜덤 이차원 이미지들을 광굴절 결정체에 위상 부호 다중화하고 복원할 때 얻어지는 신호대 잡음비(SNR)을 계산하고 이를 실험 측정 결과와 비교한다. (중략)

• Korean Journal of Optics and Photonics
• /
• v.12 no.5
• /
• pp.362-370
• /
• 2001

We prove that 3-D profile mapping using white light interferometry has systematic errors caused by aberrations of the optimal system. The tilt of an object invokes an offset between the object and the reference ray, which eventually makes the aberration cancel incompletely. The fringe peak of a white light interferogram is mainly affected by the aberration effect while the envelope peak remains stable. By the difference between the two peaks, it is easily confirmed how much the error existed in the fringe peak. Experimental results prove that the error caused by aberration is varied by object tilt, microscope NA, optics alignment within the range of $\pm$50nm.

• The Journal of the Acoustical Society of Korea
• /
• v.27 no.4
• /
• pp.178-182
• /
• 2008

In measurements of the vibration of structures underwater with a laser Doppler vibrometer, the surface vibration is measured by means of detecting the phase change of the laser beam due to the structural vibration. The laser beam passes through the sound field radiated from the vibrating structures underwater. It experiences an additional phase change due to the change in refractive index in the radiated sound field. This phase change due to the sound field may cause the error in surface vibration measurements. In this paper, this phase change due to the radiated sound filed has been analyzed. The numerical simulation has been peformed to evaluate the phase change in sound field radiated from an infinite cylindrical structure vibrating underwater.

• Journal of Convergence for Information Technology
• /
• v.11 no.8
• /
• pp.23-28
• /
• 2021

In this paper, we analyze the tracking errors of monopulse radar according to the JSR of retrodirective cross-eye and radar skin return signals. The cross-eye jammer gain(G_c) is used to calculate the radar tracking errors, and the relationship between the jammer gain and the JSR is represented mathematically. We analyze the radar tracking errors by varying the tracking angle and JSR. Analysis results of the phase difference(ϕ) and amplitude ratio(a) between the two jammer signals and the changing JSR show that the closer the phase difference of the two jammer signals is to 180, the greater the tracking error and it shows that if the JSR is above 20dB, the tracking errors no longer increase. This work presents an effective utilization of retrodirective cross-eye jammers through various tracking error analyses based on the JSR, tracking angles, two-jammer phase differences and amplitude ratios of two-jammer signals.

• Proceedings of the KIEE Conference
• /
• 2008.09a
• /
• pp.64-66
• /
• 2008

현재 전압변성기는 기존의 철심형 전압변성기에서 전자식전압변성기로 변화하고 있으며, 전자식 전압변성기의 비오차와 위상각 오차를 정확하게 평가하는 것은 전자식 전압변성기의 보급에 중요하다. 표준전압변성기 두 대와 전압변성기 비교기를 이용하여 22 kV급 전자식 전압변성기의 비오차와 위상각 오차를 평가할 수 있는 시스템을 구축하였으며, 시스템의 불확도를 분석하였다.