• The Journal of the Acoustical Society of Korea
• /
• v.10 no.4
• /
• pp.48-55
• /
• 1991

In this study, the unbalanced rigid rotor mounted on two pedestals is balanced u. ng the dynamic balancing procedure, and the compensating masses are estimated by the seven run method. Also, the reductions of vibration level are examined, before and after balancing procedures. In the experimental results, it is shown that the vibration amplitudes measured at the two pedestals are proportional to the unbalanced mass. The seven run method which requires measurement of vibration amplitudes only and not vibration phase angle is proved markedly useful in consideration of the dynamic balancing procedure.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.12A
• /
• pp.1225-1232
• /
• 2008

In this paper, we describe a compensation method of diurnal effect which is one of the factors giving large effect on the performance when using ground-wave signals like Loran-C for a backup and substitute navigation system of global satellite navigation system such as GPS, and currently many researches of the topics are doing in USA and in Europe. In order to compensate diurnal effect, we find periodic frequency components by using the Least Square Spectral Analysis (LSSA) method at first and then compensate the effect by subtracting the estimated compensation signal, obtained by using the estimated amplitude and phase of the individual frequency component, from the original signal. In this paper, we propose a simple compensation algorithm and analysis the performance through simulations. From the results, it is observed that the amplitude and phase can be estimated with under 5 % and 0.17 % in a somewhat poor receiving situation with 0 dB Signal to Noise Ratio (SNR). Also, we analyze the obtainable performance improvement after compensation by using the measured Loran-C data. From the results, it is observed that we can get about 22 % performance improvement when a moving average with 5 minutes interval is employed.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.2
• /
• pp.235-244
• /
• 2014

This paper describes the subarray channel configuration and calibration method for airborne AESA radar antenna. AESA radar demonstrator was designed and implemented for the digital beam-forming performance test of the 12 channel subarray structure. Magnitude and phase difference can be exist between the manufactured subarray channel. In this paper, calibration method for the subarray difference error was suggested. We measured digital monopulse slope in the subarray channel and verified the channel calibration effect. To verify the subarray channel operation, digital monopulse channel was compared with analog monopulse channel performance. AESA radar demonstrator was tested in the ground far field test range. Emulated single target was generated to test the detection and tracking performance of the demonstrator with the same waveform and search pattern. We verified that the detection and tracking performance of the 12 subarray digital monopulse channel was similar with the conventional analog monopulse channel. Also, ABF(Adaptive Beam-Forming) function for the sidelobe jammer was tested and effective operation was verified.

• Investigative Magnetic Resonance Imaging
• /
• v.9 no.1
• /
• pp.36-42
• /
• 2005

Purpose : To develop a novel approach to calculate the sensitivity profiles of the phased array coil for use in non-uniform intensity correction. Materials and Methods : The proposed intensity correction method estimates the sensitivity profile of the coil to extract intensity variations that represent the scanned image. The sensitivity profile is estimated by fitting a non-linear curve to various angles of projections through the imaged object in order to eliminate the high-frequency image content. Filtered back projection is then used to compute the estimates of the sensitivity profile of each coil. The method was applied both to phantom and brain images from 8-channel phased-array coil and 4-channel phased-array coil, respectively. Results : Intensity-corrected images from the proposed method have more uniform intensity than those from the commonly used 'sum-of-squares' approach. By using the proposed correction method, the intensity variation was reduced to $6.1\%$ from $13.1\%$, acquired from the 'sum-of-squares'. Conclusion : The proposed method is more effective at correcting the intensity non-uniformity of the phased-array surface-coil images than the conventional 'sum-of-squares' method.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.33 no.8
• /
• pp.65-74
• /
• 2005

It is required for getting the ring laser gyro output purely related to the input rotation to eliminate the output of the modulated angular vibration from the ring laser signal. In this paper we discuss the dither stripping methods of compensating the ring laser signal by converting the rate signal of dither detector from voltage to frequency for a dither type ring laser gyro. We discuss the differential methods for getting rid of the offset of the V-F signal. And we develope the methods of compensating the phase differences between the ring laser signals and the V-F differential signals by using analog integrator and digital time delays. And also, we develope the gain calculation method by comparing the standard deviations of the ring laser signals with V-F differential signals. We implemented these methods and analyzed the effectiveness of these methods by comparing the dither trapping methods.

• The Journal of Engineering Geology
• /
• v.7 no.1
• /
• pp.63-79
• /
• 1997

In this study, our purpose is to develop a technique to discriminate artificial explosions from local microearthquakes on the basis of time-frequency domain. To obtain spectral features of artificial explosions and microearthquakes, we used 3-d spectrograms(frequency, time and amplitude) because this is a useful tool to study the frequency content of entire seismic waveforms observed at local and regional distances (e. g., Kim et al., 1994). P and S waves from quarry blasts show that frequency content of dominant amplitude appeared above 10 Hz and Rg phases that are observed at near distance ranges. But P and S waves from microearthquakes have more broad frequency content as well as below 10 Hz. And for discrimination, Pg/Lg spectral ratio is performed below 10 Hz. In order to select time windows we computed group velocity using multiple filter method(MFM) and removed free surface effects from all 3-components data for improving on data quality. Next step, we computed Fast-Fourier transform, and a log average spectral amplitude over seven frequency bands : 0.5 to 3, 2 to 4, 3 to 5, 4 to 6, 5 to 7, 6 to 8 and 8 to 10 Hz. The best separation is observed from 6 to 8 Hz.

• Korean Journal of Optics and Photonics
• /
• v.24 no.2
• /
• pp.77-85
• /
• 2013

The precision of retardation measurement has been improved upto $3{\sigma}$ <0.005 nm after improvements are made to the conventional transmission ellipsometer. Improvements are made such that, i) the polarizer module instead of the sample stage is rotated, ii) the light source is replaced, iii) the starting points of two rotating modules are accurately synchronized, and iv) the fine background retardation is compensated. Together with the newly introduced RVD (Retardation Vector Difference) method, the improved instrument is successfully applied to characterize the ultra small optical birefringence of the rubbed polyimide alignment layer, after the residual retardation due to glass substrate whose magnitude is about 1.0 nm is properly subtracted. It is verified that the net retardation of the alignment layer ranges from 0.05 nm to 0.15 nm.

• Bulletin of the Korean Space Science Society
• /
• 2003.10a
• /
• pp.43-43
• /
• 2003

본 연구에서는 정지궤도 위성을 이용한 표준시각 동기 서비스에 실시간 궤도결정 기술을 적용하는 방안을 고려하였다. 정지궤도 위성을 이용하여 표준시각 동기신호를 전파하는 연구는 여러 나라에서 진행되고 있는데 3지역에서의 측정(Trilateration)과 미분 보정(Differential Correction) 방식이 일반적인 방법으로 채택되고 있다. 본 논고에서는 한국 항공우주연구원에서 진행 중인 표준시각 동기 서비스 연구와 이를 위해 제작중인 실시간 궤도결정 기술을 적용한 실험 소프트웨어에 대해 소개하고자 한다. 실시간 궤도결정 방법을 적용하게 되면 동기신호 전파에 있어서 가장 큰 오차의 원인이 되는 위성궤도 예측 오차를 크게 줄일 수 있을 것으로 판단된다. 본 연구에서는 기존에 궤도 결정을 위해 사용하는 톤 레인징에 의한 위상차 신호와 안테나 각도 대신에 동기신호 자체만을 사용하고 있으며 1개의 수신 데이터만으로 궤도 결정을 수행하는 방안을 강구하였다. 본 논고에서는 실시간 궤도 결정에 의한 시뮬레이션 결과와 한국항공우주연구원에서 준비 중인 실험에 대해서 간략히 소개한다. 그리고 본 연구에서 개발된 기술은 2004년 4월에 무궁화위성 2호를 이용하여 실험을 수행할 예정이다.

• Proceedings of the KIEE Conference
• /
• 2002.07d
• /
• pp.2746-2748
• /
• 2002

MRI 스캔중 촬상 대상물의 화상평면내에서의 회전은 MRI 신호에 위상오차와 불균일 표본화를 일으킨다. 따라서, 아티팩트가 포함된 MR 화상의 화질열화를 개선하기 위하여 다음과 같은 방법들을 제안한다. 우선, 미리 주어진 회전파라메타로서 쌍일차 보간과 중첩특성을 이용해서 k공간 불균일 표본화 데이터를 수정하는 알고리즘과, 2차원 회전운동의 회전각은 이미 알려져 있고, 회전중심 위치가 미지인 경우에 대해 아티팩트를 보정하는 알고리즘을 제안한다. 이 때, 미지운동 파라메타를 예측하기 위해 촬상대상물의 경계바깥쪽에서 이상적인 MR 화상의 에너지는 최소가 되고, 촬상 대상물의 회전이 존재할 때 측정된 에너지가 증가한다는 성질을 이용했다. 이러한 성질을 이용해서 시뮬레이션 화상에 적용한 결과 제안한 방법에 대한 유효성을 확인하였다.

• Magazine of the Korean Society of Hazard Mitigation
• /
• v.3 no.3 s.10
• /
• pp.23-27
• /
• 2003

수문학자들의 주요 관심사 중 하나인 정확한 면적 강우량을 파악하는데 있어서 강우레이더는 아주 우수한 첨단 장비이다. 그러나 S 밴드나 C 밴드 레이더를 고지대에서 운영하는 것은 많은 시설비와 운영비가 필요하다. 따라서 연구 및 대도시 소유역에 대한 강우 관찰 목적으로는 차량 탑재가 가능한 소형 X 밴드 레이더가 유용할 수 있다. X 밴드 전파는 강우 도래시 전파특성상 감쇠(減衰:attenuation)가 크며, 감쇠도는 강우강도에 영향을 받는다. 이를 극복하기 위한 이중-편파 이론이 1970년대에 제시되었으나, 기술적인 어려움으로 20여년이 지난 1990년대에 실무적용이 가능하게 되었다. 현재 이중-편파 레이더의 도입으로 감쇠보정 알고리듬이 성공적으로 개발되고 있으며, 그와 같은 발상의 전환은 차등위상(differential phase)에 의한 강우 측정방법 개발로 전파 감쇠에 영향을 받지 않는 강우 관측이 가능하게 하였다. 본 기사에서는 소형 X밴드 이중-편파(偏波) 레이더의 강우량 산정방법에 대하여 간략히 검토하고자 한다.