• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.7C
• /
• pp.713-724
• /
• 2006

The purpose of this study is to design, implement and verify the pre-modulation filter with the variable -3dB cutoff frequency and linear phase response for bandlimiting the allocation of radio frequency bandwidth for PCM/FM transmission. For the design of this required filter, the digital FIR filter, DAC system and tuneable 2nd order LPF have been constructed and simulated according to the attenuation characteristic requirement of the amplitude frequency response by each stage. From these results, we have implemented the filter and verified the analog conversion hardware part which is composed of DAC system and tuneable 2nd order LPF for the interpolation of the discrete sequences. Especially this paper proposes and carries out the verification processes using the tone generator and the calibration procedures for more precise frequency response of the filter.

• Journal of Satellite, Information and Communications
• /
• v.12 no.1
• /
• pp.13-17
• /
• 2017

This paper presents an approach to enable a typical GPS receiver to be much less susceptible to intentional disruption such as jamming and change in link environment. In order for the GPS receiver to cope with jamming and to get adaptivity, a $4{\times}4$ beamforming antenna is designed using metamaterials. The design results show the antenna gain much higher than 5 dBi and the movable beam.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.36D no.1
• /
• pp.8-14
• /
• 1999

The active devices used at microwave frequency have the different phase shift according to input power. Especially, The difference of the phase shift is large in the saturation region of the amplifier. In this paper, we disigned the phase control system for fixing the different phase shift at device. With the high frequency nonlinear amplifier, we fabricated such system that the phase shift to be fixed automatically using the varible phase shifter. The variable phase shifter fixed total phase variation of the circuit using the information that was obtained from the comparison of imputsignal phase with output signal phase. Even though the input signal is 2-tone or FM type, we could estimate and also fix the phase variation on DUT Dynamic range is about 10dB. It has been experimented at 1960MHz using Teflon (H=31mil, ${\varepsilon}r$=3.2)

• Proceedings of the KIEE Conference
• /
• 2004.07c
• /
• pp.2064-2066
• /
• 2004

본 논문에서는 새로운 개념인 능동 고조파 결합을 이용한 4위상 전압제어 발진기를 설계, 제작하였다. 4위상 출력 특성을 얻기 위하여 각각의 차동 VCO의 가상 접지(Virtual Ground)면을 본 논문에 제시된 능동 고조파 결합 회로(Active super harmonic coupling)을 이용하여 결합시키는 방법을 적용하였다. 제안된 구조는 다음과 같은 장점을 가지고 있다. 결합구조를 갖는 트랜지스터에 부가적인 전류소비를 줄일 수 있으며, layout상에서 문제되었던 대칭구조를 개선할 수 있다. 또한 기존에 발표되었던 방법인 passive transformer를 이용한 고조파 결합 보다 회로 크기를 줄일 수 있다. 측정결과 출력 전력 -12dBm, -117dBc/Hz @1-MHz 이하의 위상잡음 특성, 2.66GHz${\sim}$2.91GHz의 250 MHz 주파수 가변, 25dB이하의 2차고조파 억압, 7 mA 의 전류 소모(buffer amp. 포함되지 않음)를 가졌다.

• Journal of Advanced Navigation Technology
• /
• v.14 no.2
• /
• pp.176-182
• /
• 2010

This paper proposes that an inverse class-E amplifier is used a tunable parallel resonator at output port in order to maintain a high power-added efficiency(PAE) and output power with wide frequency ranges. A tunable circuit has a constant Q factor at operating frequency ranges and because of using varactor diode, the inductor and capacitor values of resonator can be changed. Also, the inductance value for zero-current switching (ZCS) is implemented a lumped element and the capacitance value is made a distributed element for phase compensation. The inverse class E amplifier using tunable parallel resonator is obtained to deliver 25dBm output power and achieve maximum power added efficiency(PAE) of 75% at 65-120MHz frequency ranges.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.4 s.95
• /
• pp.345-350
• /
• 2005

An X-band push-push VCO for low cost applications is proposed. The designed push-push oscillator achieves a wide tuning range in the X-band by the collector bias tuning instead of extra varactor diodes. The measurement shows a wide tuning bandwidth of $900\;\cal{MHz}\;from\;10.9\;\cal{GHz}\;to\;11.8\;\cal{GHz}$ with a drain bias voltage varying from 4 to 9 V, excellent fudamental suppression of $-30\;\cal{dBc}$ and good phase noise of $-115\;\cal{dBc/Hz}\;@\;1\;\cal{MHz}$ offset.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.9B
• /
• pp.1683-1689
• /
• 1999

We have implemented Frequency bandwidth expander with frequency upconverting by VCO drift canceller and comb generator. Te output of the low frequency synthesizer which the output frequency is 220~280MHz(Resolution : 5MHz) is expanded to 1660~2140MHz by this system. The phase noise of this system only depends on the phase noise of comb generator and low frequency synthesizer. The phase noise of VCO don’t influence at the frequency expander because the drift of VCO cancel out. When we control the output of VCO, the output frequency of this system is varied by 60MHz x N as filter banker. The switching time and the spurious of the frequency expander is below 3usec, -55dBc respectively. This system easily expands bandwidth additively by expanding the output bandwidth of the VCO. We can apply the frequency expander to very wide band microwave synthesizer which has fast switching time.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.7
• /
• pp.61-67
• /
• 2009

This paper reports an Integer-N phase locked loop (PLL) frequency synthesizer which was implemented in a 250nm standard digital CMOS process for a UHF RFID wireless communication system. The main blocks of PLL have been designed including voltage controlled oscillator, phase frequency detector, and charge pump. The LC VCO has been used for a better noise property and low-power design. The source and drain juntions of PMOS transistors are used as the varactor diodes. The ADF4111 of Analog Device has been used for the external pre-scaler and N-divider to divide VCO frequency and a third order RC filter is designed for the loop filter. The measured results show that the RF output power is -13dBm with 50$\Omega$ load, the phase noise is -91.33dBc/Hz at 100KHz offset frequency, and the maximum lock-in time is less than 600us from 930MHz to 970MHz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.5
• /
• pp.521-526
• /
• 2003

This paper describes performance data and design information on a reflection-type analog phase shifter used in Ka-band. Arranging a couple of GaAs hyperabrupt junction varactor diode parallel in a circuit, and applying reactance matching method accordingly, it is possible to 831 a large the phase shift. Design equation is formulated theoretically. Since the assembly process is important in Ka-band, this paper also includes the assembly process that is essential to minimize the generation of parasitic elements during the assembly process. It is obtained variable phase shift 220$^{\circ}$${\pm}$7$^{\circ}$ and insertion loss 5 dB${\pm}$1 dB as a measured result larger than the existing figure in Ka-band.

• Journal of IKEEE
• /
• v.3 no.2 s.5
• /
• pp.259-267
• /
• 1999

In this paper, a C-band 6-bit phase shifter is designed and fabricated and design techniques for each phase bit are represented. We applied the loaded line type to $5.625^{\circ},\;11.25^{\circ},\;22.5^{\circ}\;and\;45^{\circ}$ phase bits and the hybrid coupled type to $90^{\circ}$ phase bit and the switched line type to $180^{\circ}$ phase bit, respectively on a microstrip copper substrate.