• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2007년도 춘계학술대회B
• /
• pp.2217-2221
• /
• 2007

Because of the ozone layer depletion and global warming, new alternative refrigerants are being developed. In this study, evaporation heat transfer characteristics of carbon dioxide flowing upward in a vertical tube have been investigated by experiment. Before the test section, a pre-heater is installed to adjust the inlet quality of the refrigerant to a desired value. A smooth tube with outer diameter of 5 mm and length of 1.44 m was selected as a test tube. The test was conducted at mass fluxes of 212 to 530 kg/$m^2s$, saturation temperature of -5 to 20$^{\circ}C$, and heat fluxes of 20 to 45 kW/$m^2$. As the vapor quality and mass fluxes increase, the heat transfer coefficients of carbon dioxide are decreased, and the heat transfer coefficients increase when the heat fluxes and saturation temperatures increase.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 춘계학술대회논문집E
• /
• pp.727-732
• /
• 2001

The purpose of this study is to compare the time mean velocity distribution, the time mean kinetic energy, and the time mean turbulence intensity between vertical and horizontal flow fields in a coaxial circular pipe by PIV measurement. Experiments are performed at a Reynolds number 2,000, measuring regions divided as the section regions A, B, C, D in flow fields. The angle of the high-frequency ultrasonic is selected in the direction of $45^{\circ}$ to the flow axes and it is reflected several times. In results, it is clarified that the effect of gravity is given in the vertical flow field compared with the horizontal flow field and the ultrasonic affects the turbulence enhancement. And kinetic energy and turbulence intensity with ultrasonic are shown slightly bigger than those in flow field without it.

• 대한기계학회논문집B
• /
• 제26권2호
• /
• pp.345-352
• /
• 2002

A suboptimal control law in turbulent pipe flow is derived and tested. Two sensing variables ∂p/∂$\theta$│$\_$w/ and ∂v$\_$$\theta$/∂γ│$\_$w/ are applied with two actuations ø$\_$$\theta$/ and ø$\_$γ/. To test the suboptimal control law, direct numerical simulations of turbulent pipe flow at Re$\_$$\tau$/=150 are performed. When the control law is applied, a 13∼23% drag reduction is achieved. The most effective drag reduction is made at the pair of ∂v$\_$$\theta$/∂γ│$\_$w/ and ø$\_$γ/. An impenetrable virtual wall concept is useful for analyzing the near-wall suction and blowing. The virtual wall concept is useful for analyzing the near-wall behavior of the controlled flow. Comparison of the present suboptimal control with that of turbulent channel flow reveals that the curvature effect is insignificant.

• 태양에너지
• /
• 제12권3호
• /
• pp.60-69
• /
• 1992

본 연구에서는 고-액 상변화 시의 잠열을 이용한 축열방법 중에서 고상파라핀을 충전한 수직원관의 관벽을 가열하여 축열하는 경우에 대하여 관 내에서 일어나는 열전달 특성과 축열속도를 이론적으로 해석하였다. 액상에서는 자연대류를 고려하였고 고상에서는 순수 열전도 모델을 사용하였다. 고상파라핀의 초기온도와 관벽의 가열온도 그리고 관의 형상비가 축열속도에 미치는 영향을 알아보았으며, 전체 열전달과정을 순수열전도 모델로 해석하여 자연대류가 축열에 미치는 영향을 고찰하였다. 용융초기에는 관벽과 고액경계면의 영향으로 자연대류에 의한 유동은 장애를 받으나, 40% 정도의 용융이 진행된 후 부터는 내부 액상에서의 자연대류가 활발히 일어나고, 용융중기로 갈수록 관의 상부에 뜨거운 액상층이 축적되므로 자연대류는 소멸하게 된다. 전체적인 융용속도는 순수열전도에 의한 용융속도보다 빨라지게 된다. 관벽의 가열온도와 형상비가 증가할수록 관 내에서의 자연대류가 활발하게 일어나므로 용융속도는 빨라지며, 형상비가 클수록 상하부 간에 불균등한 용융이 일어난다. 고상의 초기온도는 초기의 용융속도에 큰 영향을 미치고 용융이 진행될수록 그 효과는 줄어든다.

• 한국자동차공학회논문집
• /
• 제11권6호
• /
• pp.44-50
• /
• 2003

Cooled EGR is an effective method for the reduction of NOx from a diesel engine and an EGR Cooler is the key component of the system. High efficiency, low pressure loss and compactness are required for the EGR Cooler. To meet these requirements, new geometric tube must be developed. In this paper, a full size EGR cooler test bench has been developed to validate the CFD flow and heat transfer models. Fluid temperature and pressure drop measurements are provided. fillet temperature is $200^{\circ}C$ and $300^{\circ}C$, and flow rates vary from 0.008 kg/sec to 0.019 kg/sec. The gas flow and heat transfer in a single tube cooler have been studied using computational fluid dynamics(CFD). Analysis has been carried out in a single tube with a plain tube and six spirally enhanced tubes of varying pitch to depth ratio(p/e).

• 설비공학논문집
• /
• 제14권3호
• /
• pp.254-260
• /
• 2002

There have been many studies for the flow through internally finned tube, since the heat exchangers with fin device derive much attention in heat transfer enhance cent. In this study, analysis of laminar flow through the circular tube with longitudinal fins are investigated. The height and the number of fins are arbitrary. The flow field is assumed to be laminar and conformal mapping is used to obtain analytic solution. From the analytic solution, equi-velocity lines are shown, and the flow rate through the finned tube is calculated for various fin heights and numbers of fins. Darcy friction factor for this finned tube and shear stress distributions on the wall and fin are also considered.

• 한국가시화정보학회:학술대회논문집
• /
• 한국가시화정보학회 2004년도 추계학술대회 논문집
• /
• pp.98-101
• /
• 2004

Experimental studies were reported on the characteristics of flows in a circular pipe in which ice slurry is flowing. This was mainly due to deficiency of conventional measurement techniques. In this report, the flow characteristics are quantitatively investigated by the use of PIV technique concerning the Ice Packing Factor(IPF) and the power changes of pump motor. It was experimentally verified that the power loss does not increase any more at a certain IPF value.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2002년도 학술대회지
• /
• pp.75-78
• /
• 2002

In this paper, flow on the rear region of a butterfly valve was analysed by using numerical and experimental methods. The butterfly-valve disk angle is changed as 0-60 degree and the uniform flow velocity was fixed In this experiment. It was shown that the numerical results are similar to the experimental results. General discussions are given to the flow-pattern change upon the disk angle of the valve.

• 대한기계학회논문집
• /
• 제5권4호
• /
• pp.284-292
• /
• 1981

The flow of fluid with low prandtl number in the entrance region of a circular pipe has been considered, where the wall temperature is maintained to be constant. A finite difference method is used for the integral form of the governing equations in order that they satisfy the conservative properties of the numerical solutions. It is confirmed that the hydrodynamic entrance length and be divided into growing boundary layer region and fully viscous region, which is compared with existing results obtained by using boundary layer approximations. By assuning the developing velocity profile in the entrance region, the thermal entrance length is estimated and the local Nusselt number is obtained at various locations along the axial dirction.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2011년 춘계학술대회논문집
• /
• pp.75-77
• /
• 2011

Thermofluid flow analysis is major subject in most computational fluid dynamics applications. Accompanying convective and conductive heat transport phenomena, radiation plays an important role in high temperature operating systems. Cares in which the radiation dominates are found in such systems as boilers, furnaces, rocket engines, etc. In this paper the finite-volume method (FVM) are employed to simulate two-dimensional radiation problems in concentric and eccentric horizontal cylindrical annuli with general body-fitted coordinates. In that case the simplest and intuitive remedies are proposed for mitigation of ray effect.