• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2005.11a
• /
• pp.445-449
• /
• 2005

The mixed acoustic-convective mode combustion instability and the possibility of combustion control using a loudspeaker to these instabilities were studied. By changing inlet velocity, combustor length and equivalence ratio, the dynamic pressure signals and the flame structures were simultaneously taken. The results showed that as the combustor length increased and the inlet velocity decreased, the instability frequency decreased and the maximum power spectral densities of the dynamic pressures generally decreased. The instability frequency could be affected by an equivalence ratio over the operating conditions. From the data of close-loop control, as the loudspeaker may work out-of-phase with the natural instability, the optimum time-delay controller was confirmed to be able to reduce the vortex shedding from the mixed acoustic-convective mode combustion instability.

• Korean Chemical Engineering Research
• /
• v.58 no.2
• /
• pp.319-324
• /
• 2020

Electroconvective instability is a non-linear transport phenomenon which can be found in ion-selective transport system such as electrodialysis, Galvanic cell and electrolytic cell. The instability is triggered by the fluctuation of space charge layer in adjacent of ion-selective surface, leading to increase of mass transport rate. Thus, in the aspect of mass transport, the instability has an important meaning. Although recent experimental techniques have opened up an avenue to direct visualize the instability, fundamental investigations have been conducted in limited area due to several experimental limitations. In this work, the electroconvective instability under potentiostatic mode was solved by numerical method in order to demonstrate correlation between current-time curve and the instability behavior. By rigorous time-resolved analysis, the transition behaviors can be divided into three stages; formation of space charge layer - growth of electroconvective instability - steady state. Furthermore, scaling laws of transition time were numerically obtained according to applied voltage as well.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1998.05a
• /
• pp.603-608
• /
• 1998

유체내의 물체 주위에서 유동박리로 인해 생성되는 와류쉐딩은 열전달이나 물질전달을 촉진시키는 이점이 있으나, 항력을 증가시키거나 유동 및 온도의 요동에 의해 구조물을 손상시키는 단점이 있다. 특히 물체와 주위 유동 사이에 공진이 일어나면 항력값이 증가하면서 항력과 양력의 진폭이 급격히 증가하여 물체에 심각한 손상을 초래할 수 있다. 본 연구에서는 레이놀즈수 200 이하의 층류유동에서 공진시 물체 주위의 유동현상과 이로 인한 양력과 항력의 변화들을 수치해석방법을 통하여 분석하였다 수치해석은 일반좌표계에서 유한체적법을 적용하여 Navier-Stokes 방정식을 차분화하였다. 이때 방정식의 종속변수로는 공변속도를 채택하였으며, 이산화된 방정식은 분리단계법을 이용하여 수치해를 구하였다. 입구유속의 강제진동에 의한 사각실린더 주위의 와류쉐딩시 공진이 발생하는 강제진동수의 범위는 원통실린더의 경우와 유사하였으나 상대적으로 폭이 더 좁았다 그리고 공진이 발생하는 강제진동수의 범위는 진폭이 증가할수록 증가하였다. 쉐딩 진동수가 일정하면서 입구유속의 진폭이 증가하면 이에 비례하여 실린더 주위의 유속이 상대적으로 증가하게 되어 와도가 강해지면서 입추유속 진폭에 비례하여 항력의 평균값 뿐 아니라 항력과 양력의 진폭도 증가하였다. 그리고 실린더 뒷면의 와류 생성영역은 진폭에 비례하여 감소하였다. 진폭의 변화에 따라 상변화가 서로 상이한 것은 실린더 뒤쪽의 와류들이 상하면의 합력차이를 변화시켰고 이것이 진폭변화에 따라 상변화를 상이하게 나타나게 한 원인으로 진폭이 클수록 실린더 뒤쪽에서 압력변화가 심하게 변하면서 실린더 앞쪽까지 더 많은 영향을 미쳤기 때문이다.선원의 사용자에게 제공되는 최종방사능을 평가하는데 유용하게 사용될 수 있다.r의 분포를 보였다.cting the effect of earthquake on structures. This paper is based on the presented paper at the Bertero Symposium held in January 31an4 February 1 at Berkeley, California, USA which was entitled "Needs to Evaluate Real Seismic Performance of Buildings-Lessons from 1995 Hyogoken-Nambu Earthquake-". The lessons for buildings from the damage due to the Hyogoken-Nambu Earthquake are necessity to develop more rational seismic design codes based upon a performance-based design concept, and to evaluate seismic performance of existing buildings. In my keynote lecture at the Korean Association for Computational Structural Engineering, the history of seismic design and use of structural analysis in Japan, the lessons for buildings from the Hyogoken-Nambu Earthquake, the

• Korean Chemical Engineering Research
• /
• v.59 no.4
• /
• pp.626-631
• /
• 2021

One of the nonlinear electrokinetic phenomena around ion exchange membrane is electroconvective instability which can be found in various electrokinetic applications such as electrodialysis, electrochemical battery, microfluidic analysis platform, etc. Such instability acts as a positive transport mechanism for the electrodialysis via amplifying mass transport rate. On the other hands, in the electrochemical battery and the microfluidic applications, the instability provokes unwanted mass transport. In this research, to control the electroconvective instability, the onset of the instability was analyzed as a function of confinement effect as well as applied voltage. As a result, we figured out that the dynamic behavior of electroconvective instability transited as a sequence of stable regime - static regime - chaotic regime depending on the applied voltage and confinement effect. Furthermore, stability curves about the dynamic transition were numerically determined as well. Conclusively, the confinement effect on electroconvective instability can be applied for effective means to control the electrokinetic chaos.

• Journal of Advanced Marine Engineering and Technology
• /
• v.33 no.8
• /
• pp.1180-1186
• /
• 2009

This experimental study is about the flow characteristics according to existence and nonexistence of the control rod and location in the flow field where it has the Inclined rear walls in the open cavity. By using the visualization of flow and particle image velocimetry (PIV), we performed about a change and speed of the Reynolds number. Our objective was what part of the control rod gives less effects to the characteristics of flow and how the shear mixing layer moves at what critical point of the Reynolds number. As a result, we differed the location of control rod. So finally, L/H=0.2 was discovered to give less effects to the cavity. The flow of backside of vortex faces the upper side. And we found that this phenomenon shows up more clear when the number of Reynolds increases. This is because of the flow of vortex causes by the condition of y/H=1.0. This phenomenon gets more clear with increasing of number of Reynolds, and critical point of the Reynolds number was $Re=1.0{\times}10^4$ around. If control rod is L/H=0.1, depending on the number of Reynolds ($Re=6.0{\times}10^3$, $Re=8.0{\times}10^3$, $Re=1.0{\times}10^4$, $Re=1.2{\times}10^4$), doubled vortex shows up. As the shear mixing layer of the upper side of cavity increases, the speed of the lower side was very stable.

• Journal of Korean Society of Environmental Engineers
• /
• v.39 no.12
• /
• pp.706-713
• /
• 2017

This study compared and analyzed the water treatment efficiency and the applicability of water treatment plant using the existing Mechanical Rapid-Mixer by introducing the Non-powered Vortex Mixer to the domestic water treatment plant. For this study, fluid flow characteristics and head loss of a Non-powered Vortex Mixer are calculated by Computational Fluid Dynamics (CFD)respectively. The head loss rate inside the mixer was 11.30% when the inflow velocity was 0.5 m/sec, 16.27% at 0.6 m/sec and 21.44% at 0.7 m/sec, the head loss rapidly increased at the optimal velocity of 0.5 m/sec. For the inflow velocity of 0.5 m/sec, the turbulent intensity at the inlet was 2.37% and at the outlet was 7.83%, so there was sufficient mixing strength for the particulate matter and the coagulant. The result of the water quality of the treatment plants with the inflow velocity of 0.38 m/sec that was operated in three years after replacing all 12 units of the existing Rapid-Mixer with the Non-powered Mixer met the standards. Hence, it is possible to reduce the energy consumption of 64,143 ~ 65,306 kWh/year since the Rapid-Mixer is replaced by the Non-powered Vortex Mixer.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.4
• /
• pp.613-618
• /
• 2019

The flow-induced vibration in a heat exchanger may cause the damage to piping. Therefore, it is necessary to establish the flow induced vibration characteristics for the structural stability of a heat exchanger. The purpose of this study was to compare the generation, development, and separation characteristics of a vortex around a circular tube with respect to time when the flow velocity of the inlet was fluctuating constantly and periodically. The time characteristics of lift and drag and the PSD characteristics were also investigated. In the case of a constant inlet flow velocity, the well-known Kalman vorticity distribution was shown. The vortex generation, growth, and separation were also observed alternately at the upper and lower sides of the tube. In the case of periodic inlet flow velocity, the vortex occurred simultaneously in the upper and lower sides of the tube. In the case of constant inlet flow velocity, the magnitude of the lift PSD was 500 times larger than that of drag. The frequency was 31.15 Hz and that of drag was doubled at 62.3 Hz. In case of a periodic inlet flow velocity, the PSD of the drag was approximately 500 times larger than that of lift. The frequency was 15.57 Hz, which was the same as the inlet-flow velocity frequency. In addition, the frequency of lift was 31.15 Hz, which was the same Karman vortex frequency.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.1 no.1
• /
• pp.33-45
• /
• 1997

Axisymmetric shear layers around a free jet is forced by co-flowing and counter-flowing secondary jets from/to an annular tube around the jet nozzle. The jet potential core extends far downstream with co-flowing secondary jets due to inhibited vortex developing and pairing. For counter-flowing cases, the axisymmetric shear layer around the jet transits from convective instability to absolute instability for velocity ratios R＝1.3～l.65 for the uniform velocity jets. Consequently, the jet potential core length increases and the turbulence level in the jet core is reduced significantly. The jets are controlled better with extension collars attached to the outer nozzle exit because the annular secondary flow is guided well by the extension collars. For the vectoring of jet, the annular tube around the jet is divided in two parts and the only one part is used for suction. The half suction makes the different shear layer around the jet and vectoring the jet by Coanda effect. The vectoring and turbulent components are varied significantly by the suction ratio. The experiments are carried out to investigate the characteristics of forced free jets using flow visualization, velocity and turbulence measurements.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.24 no.10
• /
• pp.1343-1350
• /
• 2000

The evolutionary structure of tip vortices has been investigated with a two-dimensional LDV system for a plain and a slotted blade, respectively. To analyze the effect of slots which bypasses a part of main stream into the tip face, velocity profiles, vortex sizes, their displacements and turbulence intensities during one revolution of the rotor were measured by the phase averaging process. For the comparison of circumferential velocity components of the plain blade and the slotted blade, the peak values of the slotted blade were lower than those of the plain blade, and axial velocity components of the slotted blade were considerably larger than those of the plain blade. The slotted rotor blade enlarged the core size and made the vortex delayed compared with those of the plain blade at the same wake ages. Turbulence profiles had peaks inside the core radii and decayed gradually in the radial direction of vortex coordinate. Also, using a quasi 3-D LDV measurement technique the budget of turbulence kinetic energy was analyzed in radial direction of the vortex core.

• Journal of the Korean Society of Visualization
• /
• v.15 no.1
• /
• pp.19-24
• /
• 2017

In this study, we conduct a numerical experiment of the single 5MW NREL wind turbine and compare the performance of various vortex core identification for the wake behind the wind turbine. In the kinetic analysis of wind turbine, 20% velocity deficit at 200 s is observed, showing wake which contains tip vortex near blade tip and rotor vortex at the center of the wind turbine. Time series of velocity and turbulent intensity show numerical simulation converge to a quasi-steady state near 200 s. In the comparison between methods for vortex identification, ${\lambda}_2$-method has good performance in terms of tip vortex, rotor vortex, vortex during its cascade process compared to vorticity magnitude criteria, ${\Delta}$-method. We conclude that ${\lambda}_2$-method is suitable for vortex identification method for wake visualization.