• Journal of the Korean Society of Propulsion Engineers
• /
• v.11 no.1
• /
• pp.57-63
• /
• 2007

The oxidizer-rich preburner is applied to the high efficiency closed cycle rocket propulsion system. This system is generally operated on oxidizer-fuel mixture ratio over than 50. The spray quality and mixing performance are very important for stable combustion of this preburner. This paper presents basic design concept and spray characteristic of the oxidizer-rich preburner injector and this result could be applied to the development of the oxidizer rich preburner system.

• The Bulletin of The Korean Astronomical Society
• /
• v.37 no.2
• /
• pp.151.2-151.2
• /
• 2012

터보펌프 구동에 사용된 가스발생기 생성가스를 연소기로 공급하여 주추력 발생에 사용하는 다단연소 사이클 로켓엔진은 고추력을 요하는 우주 발사체에 널리 사용되고 있다. 다단연소 사이클 로켓엔진에 사용되는 가스발생기를 예연소기라 부르며 케로신과 액체산소를 추진제로 하는 다단연소 사이클 로켓엔진에는 산화제 과잉 예연소기가 사용된다. 예연소기는 터보펌프 구동을 목적으로 하기 때문에 예연소기 생성가스의 횡단면 온도분포는 터빈에 의해 제한되는 온도범위 내에서 균일하여야 하며 넓은 운전영역에서 안정적인 연소가 이루어져야 한다. 산화제 과잉 예연소기는 모든 추진제가 혼합헤드를 통해 분사되는 방식과 추진제를 혼합헤드와 연소실로 나누어 공급하는 방식이 있다. 기술검증을 위해 산화제 일부와 연료를 혼합헤드를 통해 연소실에 공급하여 1차 연소시키고 나머지 산화제를 연소실 냉각채널을 거쳐 연소실 중앙의 분사공을 통해 연소실로 주입하여 기화시키는 형태로 최종적으로 연소압 20MPa, 혼합비 60에서 작동하는 산화제 과잉 예연소기를 설계하여 연소시험을 수행하였다. 혼합헤드에는 별도의 점화용 분사기 없이 전체 연료 분사기를 통해 점화용 연료인 TEA/TEB 혼합물을 분사하여 점화하였다. 추진제를 2단으로 공급할 수 있도록 고안된 가압식 연소시험 설비에서 10회, 누적 60초 이상의 연소시험이 성공적으로 수행되었다. 연소시험결과 넓은 작동영역에서 안정적 연소특성과 생성가스 온도 분포의 균일성을 확인할 수 있었다. 고온 고압의 산화제 과잉 예연소기 기술 확보를 통해 케로신/액체산소 다단연소 사이클 로켓엔진 개발을 위한 기술적 기반을 마련하였다.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2006.11a
• /
• pp.47-53
• /
• 2006

The oxidizer-rich preburner is applied to the high efficiency closed cycle rocket propulsion system. This system is generally operated on oxidizer-fuel mixture ratio over than 50. The spray quality and mixing performance are very important for safe combustion of this preburner. This paper presents basic concept and spray characteristic of the preburner injector.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.17 no.1
• /
• pp.89-96
• /
• 2013

Combustion pressures were measured to study combustion stability for an oxygen rich preburner by both of static and dynamic pressure sensors. The resolutions of each static and dynamic pressure sensor are the 1,000 Hz and 25,600 Hz, respectively. The nominal combustion pressure of the preburner was 200 bar but 80 bar was used at the several initial tests for the safety reason. Two stage ignition was applied to reduce the ignition impact for every tests including the tests with 200 bar combustion pressure. The tests lasted for 10 sec. max. and a little fluctuations of pressure was observed during the main mode. The measured pressures were studied by FFT analysis and no noticeable frequency coupling was found. Thus the preburner can be regarded as stable and it can be utilized for further study on staged combustion cycle liquid rocket engine.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2010.11a
• /
• pp.533-536
• /
• 2010

It has been manufactured the a prototype of the oxygen rich preburner which can be used for a small high performance liquid rocket engine. Based on the model designed and analyzed by KARI a series of the work was made. First, the layout was drawn and then two kinds of the test specimen were devised and manufactured for the hydraulic and pressure test respectively. It was confirmed that the details in designing and manufacturing the preburners. All of them efforts may help establish the bases to develop high performance liquid rocket engine.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.36 no.12
• /
• pp.1180-1185
• /
• 2008

In-house code which simulates the performance of pre-burner in staged-combustion liquid-fueled rocket engine was developed and demonstrated. Chemical reaction of pre-burner was modeled based on analytic algorithm of CEA (Chemical Equilibrium with Applications) and gas dynamics model was incorporated with it. Comparison results between in-house code and CEA have shown small relative errors except at very high or very low O/F ratio. Also the performance curve obtained by in-house code revealed that the calculated values follow the overall trend of real engine (RD-8) performance quite well and at steady-state operation, the deviation became very small.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.17 no.3
• /
• pp.67-75
• /
• 2013

The numerical analysis for the verification of preburner's cooling characteristics applying to kerosene-LOx rocket engine has been fulfilled. The distribution of combustion gas properties in primary combustion zone was calculated by the mixture ratio based on head injector arrangement, the properties of oxygen flowing in wall channels as coolant were applied under real-gas conditions, and multi-phase mixing model was employed to calculate the mixing process of primary combustion zone with liquid oxygen which was used for wall cooling. The results of numerical analysis were compared with the experimental results, hence thermo-physical properties in cooling channels and a combustor could be quantitatively identified.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2010.05a
• /
• pp.21-24
• /
• 2010

The cooling channel of the preburner for staged combustion engines was studied. The combustion pressure of the researched preburner is about 210 bar which is very high compared with the engines of the Korean Launch Vechicle and 30 ton class liquid rocket engines developed as a pre-research program. Also, the combustion is an oxygen rich process unlike the gas generators of open cycle kerosene engines. Thus the cooling process is very important to make the preburner stable. Many configurations for the preburner were developed and numerically analyzed. As a result, the pressure loss could be reached below the target.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2012.05a
• /
• pp.65-69
• /
• 2012

An oxygen rich preburner was tested and the responses from the pressure sensors were studied with FFT analysis. Since the limited capability of the static sensor, less than 250 Hz frequency domain was investigated and compared to the results of the dynamic sensors. As a result, 60 Hz harmonics were presented dominant in the combustion pressure and oxygen inlet pressure. While similar harmonics were shown with the dynamic sensor, it indicated that harmonics less than 60 Hz were very minor and the high frequency is more important.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.26 no.6
• /
• pp.10-20
• /
• 2022

The present study developed a design code for preburner of staged combustion cycle engines, which calculates preburnt gas at high-pressure oxidizer-rich conditions and predicts conjugate heat transfer and hydraulics of cryogenic fluid flow through cooling passages. It has been written based on the open-source library Cantera, into which this study has incorporated new source codes to predict correctly non-ideal thermodynamics and transport anomalies of the cryogenic fluid. For a preburner of 100 tonf-class booster engine currently under preliminary design, the present code demonstrated predictive capability and usability as a design code by comparing with CFD simulation.