• Applied Chemistry for Engineering
• /
• v.7 no.4
• /
• pp.670-678
• /
• 1996

The characterization of catalysts for the selective catalytic reduction(SCR) was investigated to remove NOx discharge from radioactive waste incinerator. The catalyst was prepared by impregnating $V_2O_5$, $MoO_3$, and $SnO_2$ on honeycomb shaped $TiO_2$. The effects of the type of catalysts, reaction temperature, feed composition, and mole ratio of $NH_3/NO$ on the reaction characteristics were evaluated in a laboratory scale reactor. The 10% $V_2O_5/TiO_2$ catalyst showed the highest NO to $N_2$ conversion of 94.4% at $350^{\circ}C$ and the temperature range for higher conversion was broadened by adding thermally stable promoters, $MoO_3$.

• Journal of Adhesion and Interface
• /
• v.12 no.4
• /
• pp.133-137
• /
• 2011

Exfoliated graphite oxide (EGO) was prepared by graphite oxide in an aqueous solution of TMAOH. The hybrid graphene/Zn-Al LDH material was fabricated by the hydrothermal reduction of the solution of EGO, $Zn(NO_3)_2{\cdot}6H_2O$, $Al(NO_3)_3{\cdot}9H_2O$, urea, and trisodium citrate. That is, metal ions were absorbed on the surface of EGO, and Zn-Al LDH material was randomly dispersed on the surface of graphene along with a reduction process of EGO to graphene by hydrothermal treatment. The composition, morphology, and thermal property of the obtained graphene-based hybrid material were studied by FE-SEM, EDX, TEM, FT-IR, XRD, TGA, and DSC.

• The korean journal of orthodontics
• /
• v.26 no.2 s.55
• /
• pp.175-186
• /
• 1996

The purpose of this study was to examine the effects of mechanical and thermal fatigue on the shear bond strength(SBS) of stainless steel mesh brackets bonded to human premolar teeth with 3 no-mix adhesives. The stainless steel mesh bracket was Ormesh(Ormco, .022 slot) and three types of no-mix adhesives were Ortho-one(Bisco), $Monolok^2$(RMO), $System\;1^+$(Ormco). The $10^6$ loadcycles of $17.4{\times}10^2sin2{\pi}ftlg{\cdot}cm$ and the 1,000 thermocycles of 15 second dwell time in each bath of $5^{\circ}C\;and\;55^{\circ}C$ were acturated as mechanical and thermal fatigue stress, and SBS were measured after each fatigue test. The fracture sites were analyzed by stereoscope and scanning electron microscope. The results obtained were summarized as follows; 1. Before thermocycles, $Monolok^2$ showed the highest Knoop hardness number(KHN, $64.03kg/mm^2$) and $System\;1^+$ showed the lowest value($31.60kg/mm^2$). After thermocycling, $Monolok^2$ also showed the highest KHN($38.03kg/mm^2$) and $system\;1^+$ showed the minimum($20.87kg/mm^2$). The KHN of Ortho-one, $Monolok^2,\;System\;1^+$ significantly decreased after thermocycling (P<0.01). 2. In static shear bond test, three adhesives had no significant differences in the SBS(P>0.01). 3. After thermocycling test, $Monolok^2$ showed the maximum SBS($19.34{\pm}2.75MPa$) and Ortho-one showed the minimum SBS($13.66{\pm}2.23MPa$). The SBS of Ortho-one(P<0.01) and $System\;1^+$(P<0.05) significantly decreased after $10^3$ thermocycles. 4. The SBS of three adhesives after $10^6$ loadcycles were similar and were not significantly decreased compared with static group(P>0.01). 5. The failure sites were usually bracket/resin interface in all groups irrespective of experimental conditions.

• Journal of Biomedical Engineering Research
• /
• v.19 no.1
• /
• pp.81-90
• /
• 1998

Electromagnetic waves may induce various effects on nervous tissues either by thermal or non-thermal mechanisms. This paper intoduces a method to evalute the non-thermal effect to central nervous system by measuring the EEGs of the rabbits treated by nimodipine before exposed to weak microwave field. 20 rabbits were divided into 2 groups and their EEGs were measured after their head section were exposed to 2,450 MHz microwave with the power density of 10 dBm and 20 dBm respectively for 10 minutes and compared with those of the 3rd group of 10 rabbits which were not exposed. The 4th group of 10 rabbits were intravenously given with nimodipine before exposed to 20 dBm field to determine whether this drug would reverse the EEGs changes induced by weak microwave irradiation. As field poser exceeded 20 dBm although no significant physiological changes were observed, total induced EEGs power was remarkably decreased suggesting the presence of CNS activation. Using Fourier analysis on the EEGs signal it was found that remarkable decrease in delta band and increase in the alpha and beta bands in a significant manner(P<0.05) compared to control group. The changes were, however, not reversed by nimodipine-treatment. The effects may be pure thermal in nature because no significant change has been observed in nimodipine treated rabbits.

• Clean Technology
• /
• v.23 no.4
• /
• pp.378-387
• /
• 2017

To obtain epoxy resin with permanently attached flame-retardant groups, phosphorus compound containing di-hydroxyl group [10-(2,5-dihydroxyphenyl)-9,10-dihydro-9-oxa-10-phospha phenanthrene-10-oxide, DOPO-HQ] and silicone compound containing di-hydroxyl group (polydimethylsiloxane, hydroxyl terminated, PDMS) were reacted with uncured epoxy prepolymer (diglycidyl ether of bisphenol A, DGEBA) and then cured using 4,4-diaminodiphenylmethane (DDM) as a crosslinking agent. The properties of the resulting epoxy materials were characterized using Fourier transform infrared (FTIR) spectrometer, differential scanning calorimetry (DSC), thermogravimetric analysis (TGA), limiting oxygen index (LOI) test/vertical burning test (UL 94-V test), tensile properties test and impact test. This study examined the effect of phosphorus/silicone compound contents on the thermal/mechanical properties and flame retardancy of cured epoxy resins containing phosphorus and silicone compounds. It was found that the thermal/mechanical properties of epoxy resins containing phosphorus and silicone components were higher than those of simple epoxy resin. The flame-retardancy (LOI: 29.9 ~ 31.8% and UL 94-V: V-0) of all samples containing phosphorus compound and phosphrous compound/silicone compound was found to be passed the flame-retardant requirements (LOI: > 30%, UL 94-V: V-0) of LOI and vertical burning tests. However, the flame-retardancy (LOI: 21.4% and UL 94-V: no rating) of simple epoxy resin was found to be failed the flame-retardant requirements.

• Korean Journal of Environmental Agriculture
• /
• v.26 no.1
• /
• pp.1-6
• /
• 2007

In view of energy supply, biogas can be seen as alternative fuel by substituting considerable amount of fossil fuel and may be utilized for heat and power production or for transport fuel production ($CH_4-enriched$ biogas). The aim of this research is to analyse the emission of $NO_x$ and CO from biogas fired combustion engine for electric power production. The result indicate a significant effect of biogas composition ($CH_4-CO_2$ ratio) and biogas flow rate on the air pollutants emission. The emission factors from this study were compared with those of U.S. EPA. Low $CH_4-CO_2$ ratio condition typically shows the lower $NO_x$ and CO emission than higher $CH_4-CO_2$ ratio condition. At normal $CH_4-CO_2$ ratio (7:3) emission factors of $NO_x$ and CO were 1.29 and 30.43 g/MMBtu, respectively. At low $CH_4-CO_2$, ratio (6:4) emission factors of $NO_x$ and CO were 0.646 and 60.86 g/MMBtu, respectively, It should be emphasized that the actual emission may vary considerably from these results due to operating conditions including torque load and engine speed.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2017.05a
• /
• pp.513-516
• /
• 2017

When stored for long periods in a powder-based device (PMD), the explosive power in the device is aged and the explosive power is changed. Thus, The gunpowder used in the PMD must be chemically and physically stable for both internal and external factors. Since $BKNO_3$ and THPP are used as representative gunpowder, thermodynamic and kinetic analyzes were performed based on these gunpowders. Differential scanning calorimeter (DSC) was used to analyze the calorific value and reaction rate. As a result, there was no significant change in caloric value and reaction rate in THPP. In addition, XPS and TEM-EDS analyzes were performed to confirm the formation of oxide films directly related to aging, and no oxide films were observed as a result of thermal analysis. In addition, XPS and TEM-EDS analyzes were performed to confirm the formation of oxide films directly related to aging. As a results, no oxide films were observed. It can be concluded that THPP is the most famous gunpowder in terms of long-term stability.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.46 no.2
• /
• pp.52-61
• /
• 2018

Urban heat islands occur due to increases in the extent of artificial surfaces such as concrete, asphalt and high-rise buildings. In this regard, research into the use of satellite thermal infrared images for thermal environment analysis of urban areas is being carried out. However, such analysis of the characteristics of individual land cover with low-resolution satellite images suffers from limitations because land cover patterns in urban areas are complicated. Recently, UAV has been widely used, which can compensate for this limitation as it is able to acquire high-resolution images. In this paper, the accuracy of UAV infrared images is verified and the applicability of UAV in urban thermal environment analysis is examined by comparing the results with land surface temperatures from Landsat 8 thermal images. The results show a high positive correlation of temperature values at 0.95, and no statistically significant difference between the two groups. Comparisons of land surface temperature according to land cover showed that the largest difference observed was $4.63^{\circ}C$ in the Used area, and UAV images with small cell units reflected various surface temperatures. Furthermore, it was possible to analyze the surface temperatures of various green spaces such as wetlands and street tree areas, which can lower surface temperatures in urban areas, with street tree shadows reducing surface temperatures by about $4-6^{\circ}C$. UAV can easily and rapidly measure the surface temperature of urban areas and is able to analyze various types of green spaces. Thus, this is an effective tool for thermal environment analysis in urban areas to aid in the design or management of urban green spaces, as it can allow for land cover and the effects of the various green spaces.

• Proceedings of the KIEE Conference
• /
• 1999.07d
• /
• pp.1710-1712
• /
• 1999

암모니아가스에 민감한 In이 도핑된 ZnO(ZnO:In) 박막을 In 박막$(100{\AA})$ 및 ZnO박막$(3000{\AA})$의 연속적인 증착과 열처리공정을 통하여 제조하고, 이와 같은 방법으로 Al과 In이 도핑된 ZnO (ZnO:Al, In) 박막을 In 박막과 ZnO:Al 박막의 연속적인 증착과 같은 조건에서의 열처리를 통하여 제조하였다. 기판은 $1000{\AA}$의 산화막이 열적으로 성장되어 있는 Si 기판을 사용하였다. In/ZnO 및 In/ZnO:Al 박막 이중층의 열처리온도에 따른 구조적 및 전기적 특성을 x-선회절기, 주사전자현미경, 오제전자분광법 및 4점측정시스템을 통하여 조사하였다. 이들 막에 대하여 열처리온도에 따른 암모니아가스에 대한 감도, 선택성 및 시간응답특성을 구하였다. 열처리온도 $400^{\circ}C$, 동작온도 $300^{\circ}C$에서 100 ppm의 암모니아가스를 주입한 결과 140 %의 최대감도를 나타내었으며 CO, $NO_x$ 가스에 대한 감도는 아주 낮은 것으로 나타났다.

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2004.06a
• /
• pp.105-114
• /
• 2004

This study investigated the thermal behavior of the nuclear graphite waste generated from the decommissioning of the Korean nuclear research reactor, The first part study investigated the decomposition rate of the nuclear graphite waste up to $1000^{\circ}C$ under various oxygen partial pressures using a thermo-gravimetric analyzer (TGA). Tested graphite waste sample not easily destroyed in the oxygen-deficient condition. However, the gas-solid oxidation reaction was found to be very effective in the presence of oxygen. No significant amount of the product of incomplete combustion was formed even in the limited oxygen concentration of 4% $O_2$. The influence of temperature and oxygen partial pressure was evaluated by the theoretical model analysis of the thermo-gravimetric data. The activation energy and the reaction order of graphite oxidation were evaluated as 128 kJ/mole and 1.1, respectively. The second part of this study investigated the behavior of radioactive elements under graphite oxidation atmosphere using thermodynamic equilibrium model. $^{22}Na$, $^{134}Cs$ and $^{137}Cs$ were found be the semi-volatile elements. Since volatile uranium species can be formulated at high temperatures above $1050^{\circ}C$, the temperature of incinerator furnace should be minimized. Other corrosion/activation products, fission products and uranium were found to be the non-volatile species.