• Transactions of the Korean Society of Mechanical Engineers
• /
• v.11 no.3
• /
• pp.386-394
• /
• 1987

The method of methanol using in diesel engines hasn't been established yet because of it's low ignition characters. But many studies about it with many methods have been doing recently. If alcohol can be used in diesel engines, smoke and NO$\sub$x/, which is a big problem in diesel engines, can be reduced large. The purpose of this study is to establish using method of alcohol, as a substitute fuel. In this study, Combustion characters, engine performance and exhaust gas emissions are checked by using gasfication diesel method. Concluding remarks of this study are as follows. (1) Methanol can be used within 30% of total inducing energy, if above that rate, it can't be used because of knocking and bad operating condition. (2) Under the low load, the effect of methanol inducing of fuel consumption is somewhat bad, but under the high load, the effect is very good. (3) Under the high load, smoke limit is a marked improvement with methanol inducing.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.9
• /
• pp.4111-4116
• /
• 2013

The progressive die producing continuously while transferring in order a multiple process is processing law that it is efficient and quality is excellent. In this study the position of precision secured that it occurred when be welded exhaust efficiency of gas boiler combustion exhaust pipe and the exhaust pipe which is cause of incomplete combustion for the purpose of productivity increase. it add burring to a product form and progressive die make die don't disassemble and it be able to exchange burring punch the position of precision and productivity by progressive die is able to improve.

• Proceedings of the Korean Institute of Industrial Safety Conference
• /
• 1997.11a
• /
• pp.267-270
• /
• 1997

악취 물질은 주로 정유공장, 분뇨 처리장, 축산$\cdot$수산 가공업, 화학공장 등에서 발생하며 작업장 내의 직원 뿐만 아니라 인근 지역주민들에게 정신적인 불쾌감을 주는 동시에 인체에 매우 유해한 물질들이다. 이들 악취의 주성분은 메틸머켑탄, 황화수소, 암모니아, 트리메틸아민 등의 물질이다. 이들 물질의 제거 방법에는 약액세정법, 직접연소법, 활성탄흡착법 등이 있다. 이중 활성탄 홉착법은 설비비와 운영경비상의 잇점으로 오랫동안 사용되어져 왔고, 현재도 악취가 많이 발생하는 사업장의 악취 제거 방법으로 널리 사용되고 있다. 그러나 기존의 활성탄을 이용한 흡착제거는 처리효율이 낮고, 이에 따른 흡착제의 충진량이 많아지고 시설용량이 커지는 등의 결점이 있다. 이러한 문제점을 해결하기 위해 활성탄의 성질의 개선과 ACF와 같은 흡착제의 활용등에 대한 연구들이 진행되고 있다. (중략)

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.15 no.3
• /
• pp.970-981
• /
• 1991

본 연구에서는 총괄 열 흡수율법과 분할법이 지니고 있는 전열 해석상의 한계 를 보완하고 슬래브 가열로의 전열해석에 실질적으로 적용하기 위하여, 분할법으로 내 내 분위기 온도를 계산하고 이로부터 슬래브의 노내 온도이력을 예측하는 계산모델을 제시하였다. 계산모델의 유용성 확인을 위하여는, Fig.1에 보인 바와 같은 최대 슬 래브 처리량이 235ton/hr인 후판 가열로를 대상으로 하여, 노내 분위기 가스 온도 및 슬래브의 온도이력을 측정하고 이를 계산 결과와 비교하였다. 이와 아울러 연료유량, 슬래브 재로시간(residence time) 및 장입 온도등의 조업조건 변화가 분위기 가스온도 와 슬래브의 온도이력에 미치는 영향을 검토하여 가열로의 효율적 조업을 위한 자료를 제시하였다.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.34 no.4
• /
• pp.409-416
• /
• 2010

The use of oxy-fuel combustion and flue gas recirculation (FGR) for $CO_2$ reduction has been studied by many researchers. This study focused on the characteristics of oxy-fuel combustion and the effects of $CO_2$ addition from the point of view of oxygen feeding ratio (OFR) and the position of $CO_2$ addition in order to reproduce an FGR system with a triple concentric multi-jet burner. Oxy-fuel combustion was stable at all OFRs at a fuel flow-rate of 15 lpm, which corresponds to an equivalence ratio of 0.93; however, the structure and length of the flame varied at different OFRs. When $CO_2$ was added in oxy-fuel combustion, various stability modes such as stable, transient, quasistable, unstable, and blow-out were observed. The temperature in the combustion chamber decreased upon $CO_2$ addition in all conditions, and the maximum reduction in temperature was below 1800 K. $CO_2$ concentration with respect to height varied with the volume percent of $CO_2$ at the nozzle tip.

• Journal of the Korean Wood Science and Technology
• /
• v.43 no.6
• /
• pp.768-776
• /
• 2015

This study was performed to understand combustion properties four major Indonesian wood species such as Albizia, Gmelina, Mangium and Mindi were investigated by cone-calorimeter for better utilization of theses wood species. Heat release rate (HRR), total heat release (TSR), specific mass loss rate (SMLR), effective heat of combustion (EHC), time to ignition (TTI), flame time (FT), specific extinction area (SEA), smoke production rate (SPR) and CO compound production rate were measured. HRR, THR and FT were proportional to the density of woods. Albizia showed the highest HRR, while Mindi had the lowest HRR. For SPR, Albizia showed the highest value due to its higher SEA. On the other hand, Mindi had the lowest SPR due to a lower SEA value. The highest smoke emission was for Albizia at the beginning of combustion. After 300 seconds, smoke emission of Gmleina and Mangium was increased greatly. Mangium and Mindi showed the highest total carbon dioxide emission. Expecially, Gmelina released the highest carbon monoxide during the combustion period and presented three times higher $CO/CO_2$ ratio than those of other species due to incomplete combustion.

• 한국연소학회:학술대회논문집
• /
• 2006.10a
• /
• pp.202-208
• /
• 2006

The purpose of this research is to model numerically the turbulent gas-particle flows in a rectangular chamber using Eulerian-Eulerian Method. A computer code using the ${\kappa}-{\varepsilon}-Ap$ two-phase turbulence model is developed for the numerical study. This code and the Eulerian multiphase model in FLUENT were used for the numerical simulations of the two-phase flow in a rectangular chamber. The numerical results calculated by the two different turbulent gas-particle codes have shown that the ${\kappa}-{\varepsilon}-Ap$ model results in a stronger diffusion of the flow momentum in the gas-particle turbulence interaction than the Eulerian multiphase model in FLUENT.

• 한국연소학회:학술대회논문집
• /
• 2006.10a
• /
• pp.110-116
• /
• 2006

A new measurement technique based on a two-color pyrometry and modulated LII signals to measure local soot particle temperatures has been proposed and examined experimentally. The theoretical review suggests that modulated LII signals of soot particles is suitable for a two-color pyrometry as long as the temperature increase due to laser heating remains relatively small. The modulated LII signals from ethylene and propylene diffusion flames were simultaneously measured at 550 and 750 nm by a dual measurement system that consists of optical fibers, PMT and lock-in amps. The local soot particle temperatures of diffusion flames could be obtained using a two-color pyrometry and modulated LII signal based new technique.

• 한국연소학회:학술대회논문집
• /
• 1997.06a
• /
• pp.45-50
• /
• 1997

An experimental study on LII signal images from soot particles in a flame has been carried out in order to investigate the effect of the incident laser characteristics. By changing the wavelength of the incident laser beam, the LII signal was saturated at smaller laser power with 532 nm than 1,064 nm. This implies that the larger absorption coefficient of soot particles at 532 nm would influence the LII signal characteristic. Using the deconvolution technique, the projected LII line images were coverted to reconstruct the local LII signals inside the beam. The results show that the LII images at ICCD camera result from the integration of LII signal across the laser beam.

• 한국연소학회:학술대회논문집
• /
• 1997.06a
• /
• pp.23-32
• /
• 1997

Characteristics of the lifted flame which is generated by issuing of the fuel through the miniature nozzle, d=0.164 mm, are studied using the planar laser induced fluorescence technique. OH radical is excited on the $Q_1$(8) line of the $A^2{\Sigma}\ ^+{\leftarrow}\ X^2{\prod}$ (1,0) band transition(283.55 nm) and LIF signals are captured at the bands of (0,0) and (1,1) transition(306-326 nm) using the filters and ICCD camera. Hydroxyl radical(OH) profile for nozzle attached flame shows that OH radical populations at the flame sides and flame tip are larger than those at the base. But for the lifted flame (tribrachial flame) case, those are larger at the flame base than at the flame tip and flame sides. The OH radical is more dense near the center line of flame base at the blowing out. This fact proves the Chung and Lee's blowout theory - blowout occurs when the flame is anchored at the flame axis.