• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.10 no.3
• /
• pp.252-257
• /
• 2000

To investigate the thermal preheating effect of the GaAs substrate exerted on the ZnS epilayers for the first time, ZnS epilayers were grown on the GaAs (100) substrate by hot wall epitaxy. The thermal preheating temperature was $450^{\circ}C$~$660^{\circ}C$. The full width at half maximum values of double crystal rocking curve were the smallest for the ZnS epilayers grown on the GaAs thermally preheated at around both $500^{\circ}C$ and $600^{\circ}C$. However, photoluminescence characteristics of ZnS epilayers were better at $600^{\circ}C$ than at $500^{\circ}C$. Therefore, it was shown that the optimum preheating temperature of the GaAs substrate for the growth of high quality ZnS epilayer was around $600^{\circ}C$. From these experimental results, it was shown that the crystal quality and the PL properties of ZnS epilayers were enhanced for the GaAs substrates thermally preheated at $600^{\circ}C$.

• Journal of the Korean Vacuum Society
• /
• v.9 no.4
• /
• pp.400-405
• /
• 2000

We investigated the effect of TMIn (trimethly-indium) source depletion on InGaAs, InGaAsP and 1.55 $\mu\textrm{m}$ InGaAs/InGaAsP SMQW by using EPISON ultrasonic monitor for measuring the concentration of metalorganic/carrier gas mixtures. And the problems for the growth reproducibility in MOCVD was solved by using an EPISON ultrasonic monitor with closed-loop mode under the condition of TMIn source depletion. The saturation pressure of TMIn was dramatically decreased over consumption of 80%. In the case of bulk epilayer, Up-shifting of 300 arcsec to Ga-rich direction and FWHM broadening by a factor of two in DCXRD spectrum were observed due to the TMIn source depletion. In the case of SMQW, Up-shifting of 300 arcsec to Ga-rich direction in DCXRD spectrum and blue-shift of 40 nm in PL spectrum were observed due to the TMIn source depletion. However, good reproducibility ($\Delta\theta$<$\pm$100 arcsec) was achieved even the condition of 95% of TMIn consumption, when we used the EPISON with closed-loop mode.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.1 no.1
• /
• pp.82-91
• /
• 1991

Molecular beam epitaxial growth of GaAs on Si substrate and the results on its analysis are reported. Epitaxy was performed on two different types of the substrate under various grwth conditions, and was analyzed by scanning and transmission electron microscopes, X-ray diffractometer, photoluminescence and Hall measurements. GaAs epitaxial layer has better crystalline quality when it was grown on a tilt-cut substrate. The stress seems to be releaxed more easily when multi-quantum well was introduced in the buffer layer. The epilayer was doped unintentionally with Si during growth due to the diffusion of the substrate. Also observed is that the quantum efficiency of excitonic radiative recombination of the heteroepitaxy is not as good as that of the homoepitaxy in the same doping level.

• 한국전자현미경학회:학술대회논문집
• /
• 1998.05a
• /
• pp.48-52
• /
• 1998

본 연구에서는 저온에서 InP 기판 위에 성장한 InAlAs 에피층에 존재하는 상분리와 규칙 현상을 투과전자현미경 관찰을 통해 관찰하였다. 저온에서 성장한 에피층에서 상분리의 거동이 크게 나타났으나 규칙 현상은 특정한 온도에서 최대를 나타낸다. $800^{\circ}C$ 이상에서 3분간의 열처리로 규칙 현상이 사라졌으나 상분리 현상은 변화를 보이지 않는다. 그러나 Zn가 포함된 장시간, 저온에서 열처리로 상분리 현상이 완전히 사라졌다.

• Electrical & Electronic Materials
• /
• v.6 no.6
• /
• pp.565-572
• /
• 1993

LPE(liquid phase epiraxy)법으로 성장시킨 $Al_{x}$ Ga$_{1-x}$As (0.15.leq.x.leq.0.67) 에피층의 구조적 특성을 이중결정 X-선 회절장치를 사용하여 조사하였다. GaAs기판과 $Al_{x}$ Ga$_{1-x}$As 에피층의 격자상수 차이로 인해 피이크가 분리되었고 이는 조성비가 증가함에 따라 선형적으로 증가하였다. 그리고 조성비는 Vegard의 법칙으로 구한 값과 기판 및 에피층 피이크 사이 각도분리(.DELTA..theta.)를 측정함으로써 구한 값이 일치하였으며 이때 관계식은 .DELTA..theta.=354.x을 얻었다. 또한 성장된 에피층은 compressive stress를 받고 있으며 조성비(x)가 0.15에서 0.67로 증가함에 따라 응력은 증가하였으며 그리고 피이크의 반치폭으로 부터 계산된 전위밀도가 역시 증가하였다.

• Journal of the Korean Vacuum Society
• /
• v.9 no.2
• /
• pp.116-121
• /
• 2000

We measured surface photovoltage (SPV) of $Al_{0.24}Ga_{0.76}As/GaAs$ epilayer grown by molecular beam epitixy (MBE). The band gap energies of $Al_{0.24}Ga_{0.76}As/GaAs$ epilayer, GaAs substrate and buffer layer obtained from SPV signals are 1.70, 1.40 and 1.42 eV, respectively. There results are in good agreements with photoreflectance (PR) measurement. The measured SPV intensity of GaAs substrate is three times larger than $Al_{0.24}Ga_{0.76}$Asepilayer by carrier mobility difference. The parameters of Varshni equation were determined from the SPV spectra as a function of temperature.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.29 no.3
• /
• pp.83-90
• /
• 2019

In this paper, Mg-doped AlN epilayers for power semiconductor devices are grown by mixed-source hydride vapor phase epitaxy. Magnesium is used as p-type dopant material in the grown AlN epilayer. The AlN epilayers on the GaN-templated sapphire substrate and GaN-templated-patterned sapphire substrate (PSS), respectively, as the base substrates for device application, were selectively grown. The surface and the crystal structures of the AlN epilayers were investigated by field emission scanning electron microscopy (FE-SEM) and high-resolution-X-ray diffraction (HR-XRD). From the X-ray photoelectron spectroscopy (XPS) and Raman spectra results, the p-type AlN epilayers grown by using the mixed-source HVPE method could be applied to power devices.

• Journal of the Korean Vacuum Society
• /
• v.5 no.3
• /
• pp.206-212
• /
• 1996

$In_{1-x}Ga_xAs$ epitaxial layers were grown at 76 Torr by low pressure metalorganic chemical vapor deposition (LP-MOCVD). Growth rate did not change much with growth temperature. Surface morphology of $In_{1-x}Ga_xAs$ epitaxial layer was affected by lattice mismatch, growth temperature and $AsH_3/(TMIn+TMGa)$ ratio. A high quality epilayer showed a full width at half maximum of 2.8 meV by photoluminescence measurement at 5K. The composition of the $In_{1-x}Ga_xAs$ was determined by the relative gas phase diffusion of TMIn and TMGa. Lattice mismatch and growth temperature were the most important variables that determine the electrical properties of $In_{1-x}Ga_xAs$ epitaxial layers. At optimized growth condition, it was possible to obtain a high quality $In_{1-x}Ga_xAs$ epilayers with a electron concentration as low as $8{\times}10^{14}/cm^3$ and an electron mobility as high as 11,000$\textrm{cm}^2$/Vsec at room temperature.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.26 no.3
• /
• pp.89-94
• /
• 2016

In this study, the crystalline property of a-plane GaN epitaxial layer grown on r-plane sapphire by a HVPE method has been investigated according to the V/III ratio and the growth time of multi-step growth. Furthermore, these results were compared with the previous result obtained from the single-step growth of a-plane GaN on r-plane sapphire substrate. In the multi-step growth for a-plane GaN epitaxial layer on r-plane sapphire, the FWHM values of rocking curve in GaN epitaxial layer were decreased as the HCl source flow rate and the growth time were increased. The void formed in epitaxial layer was continuously decreased as the growth time in first step and second step using a higher HCl flow rate was increased. As a result, the GaN layer obtained with the longest growth time on the first step and second step exhibited the lowest FWHM values of 584 arcsec and the smallest dependence of azimuth angle.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.8 no.6
• /
• pp.105-110
• /
• 2008

We have investigated the high temperature rapid thermal annealing of GaN epilayers in nitrogen atmosphere. Annealing has been performed in a rapid thermal annealing furnace at $950^{\circ}C$. The effect of rapid thermal annealing of GaN was studied by x-ray diffraction. The Bragg peak shifts toward larger angle as the annealing time increases. The full width at half maximum (FWHM) of the peak slightly increase, followed by decreases, and increases again as the thermal treatment time increases. The improvement of structural properties of the samples was observed after rapid thermal annealing under optimum conditions. This improvement in crystal quality is due to a reduction of the spread in the lattice parameter in epilayers.