• The KIPS Transactions:PartC
• /
• v.11C no.7 s.96
• /
• pp.889-894
• /
• 2004

Most ad-hoc routing protocols such as AODV(Ad Hoc On-Demand Distance Vector) and DSR(Dynamic Source Routing) do not try to search for new routes if the network topology does not change. Hence, with low node mobility, traffic may be concentrated on several nodes, which results in long end-to-end delay due to congestion at the nodes. Furthermore, since some specific nodes are continuously used for long duration, their battery power may be rapidly exhausted. Expiration of nodes causes connections traversing the nodes to be disrupted and makes many routing requests be generated at the same time. Therefore, we propose a load balancing approach called Simple Load-balancing Approach (SLA), which resolves the traffic concentration problem by allowing each node to drop RREQ (Route Request Packet) or to give up packet forwarding depending on its own traffic load. Meanwhile, mobile nodes nay deliberately give up forwarding packets to save their own energy. To make nodes volunteer in packet forwarding. we also suggest a payment scheme called Protocol-Independent Fairness Algorithm (PIEA) for packet forwarding. To evaluate the performance of SLA, we compare two cases where AODV employs SLA or not. Simulation results show that SLA can distribute traffic load well and improve performance of entire ad-hoc networks.

• Journal of Korean Society of Environmental Engineers
• /
• v.30 no.10
• /
• pp.1028-1033
• /
• 2008

Sequential quick crushing and alkali hydrolysis(SeCAH), as a pretreatment for foodwaste, incorporating mechanical crushing and alkali hydrolysis was proposed and investigated in this study. Focuses were placed on the improvement of biodegradability of foodwaste and the estimation of potential inhibitors for anaerobic digestion. The solubility of the pretreated foodwaste by SeCAH was increased 2.5 times rather than mechanical crushing. Considering solubility improvement and energy consumption, 2,000 rpm of crushing strength and 5$\sim$10 sec of crushing time are recommended. After SeCAH, the fraction of large organic particles(>2.36 mm) of foodwaste was sharply decreased from 88.0% to 29.0%, otherwise the fraction of small particles(<75 $\mu$m) was greatly increased from 10.5% to 40.7%. Ammouinum, potassium and sulfate were estimated as potential inhibitors for anaerobic digestion and their concentrations in pig slurry were 3331.3 mg/L, 4256.5 mg/L and 1017.5 mg/L, respectively.

• Journal of Preventive Medicine and Public Health
• /
• v.26 no.3 s.43
• /
• pp.332-346
• /
• 1993

This study was attempted to observe leisure time physical activity pattern and its relationship to coronary risk factors (BMI, systolic blood pressure, diastolic blood pressure, serum total cholesterol, triglycerides, fasting blood sugar). Subjects participated in this study were 277 adult male workers of an industry in Kyungpook province, Korea. Energy expenditure were measured using modified Physical Activity History questionnaire of CARDIA study by interviewing. Serum total cholesterol, triglycerides and blood sugar level were tested with 5 ml fasting blood and height, weight and blood pressure were masured. Data on smoking and drinking habits and others were obtained. Geometric mean of leisure time physical energy expenditure were estimated as 212.80 kcal per week for study subjects and only 22.4% of them expended 2,000 kcal or more per week in leisure time physical activity. Taking walks or hikes and jogging or running were more frequent leisure time physical activities in study subjects. Statistically significant mean differences in total weekly leisure time physical activity for all coronary risk factors were not found among three groups. Because energy expenditure of leisure time was generally low in this subjects and most of them were healthy men, we did not found that leisure time physical activity was significantly associated with coronary risk factors.

• Proceedings of the KWS Conference
• /
• 2009.11a
• /
• pp.42-42
• /
• 2009

마찰교반접합 (Friction Stir Welding)은 1991년 영국 TWI에서 개발된 접합 법으로서 회전하는 툴이 재료내부에 삽입되면 툴과 재료사이에서 발생하는 마찰열에 의하여 온도가 상승하게 되어 재료는 연화되고, 이러한 재료 내부에서 회전하는 툴이 이동하게 되면 재료 내부는 기계적 교반에 의해 소성변형이 일어남과 동시에 접합이 이루어진다. 마찰교반접합은 동적 재결정에 의한 접합부의 미세한 결정립 형성으로 인하여 기계적 특성이 향상되며 보호 가스가 필요 없어 친환경적임과 동시에 용융 용접 법에 비해 접합 시 에너지 소모가 적으며 또한 접합 후 접합부에서의 변형이 상대적으로 적다는 장점이 있다. 이러한 장점을 가진 마찰교반접합은 알루미늄 합금, 마그네슘 합금 그리고 동 합금과 같은 저 융점 비철재료에 많은 연구와 적용 사례들이 있어왔다. 하지만 최근에는 일반 탄소강, 연강, 오스테나이트계 스테인리스강, 니켈 합금, 티타늄 합금과 같은 고융점 재료에도 연구 및 적용이 진행되고 있는 추세이다. 페라이트계 스테인리스강은 가격이 비싼 Ni을 함유하지 않아 오스테나이트계 스테인리스강에 비하여 강재의 가격은 낮으면서도 고온특성 및 내식성이 우수하여 건축용, 자동차 배기계용으로 널리 사용되고 있다. 하지만 이런 장점을 가진 페라이트계 스테인리스강을 기존의 용융 용접 법으로 접합 시 용접부 및 열영향부에서의 결정립의 조대화로 인한 인성 및 연성이 저하되며, 특히 예민화된 열영향부 입계 내에 Cr 탄화물이 석출되어 입계주변에 Cr 결핍 층을 형성되어 입계부식이 발생되는 문제점이 발생된다. 본 연구에서는 마찰교반접합을 이용하여 두께 3mm의 409 스테인리스강에 대해 맞대기 접합을 실시하였다. 접합 변수를 툴의 재료 (WC-12wt%Co, $Si_3N_4$)로 하여 접합을 실시하였고 접합 후 외관상태 점검, 광학 현미경과 주사 전자 현미경을 통하여 미세조직을 관찰하였으며 황산-황산동 부식 시험을 실시하여 접합부의 부식 특성을 평가하였다.

• Korean Journal of Food Science and Technology
• /
• v.26 no.3
• /
• pp.305-309
• /
• 1994

Precooked powder of redbean porridge (RP) was prepared by the series of process extrusion, drying, milling and blending with a mixture of whole redbean flour and corn starch and others. The optimum process and quality of products for RP were investigated. After extrusion under the moisture content 24 to 26%, twin screw speed 350 rpm, extrusion temperature 150 to $155^{\circ}C$ and feed rate 60 kg/hr, the product had a higher quality with its natural redbean flavor/color. During the extrusion process, extrusion temperature and specific mechanical energy increased from 150 to $198^{\circ}C$ and from 134 to 144 kwh/ton respectively, as the amount of addition water decreased from 6 to 2 kg/hr. By the hot air drying of redbean extrudate (RE). it could be dried below to 4% moisture content, of which level considered as an optimal moisture content for anti-caking of the powdered product, at $80^{\circ}C$ for 4hrs and at $100^{\circ}C$ for 1.5 hrs respectively. In the sieve analysis of extrudate powder, when the product milled through a mesh size of 0.5 mm or 1.0 mm, about 80% or 65% of the feed was passed a 65 mesh screen respectively. Moisture absorption of final blended products was formed a cake under 100% of relative humidity after 13 hrs of storage. As the amount of RE powder reduced, the flavor score of products decreased by sensory evaluation of products prepared by the different ratio of RE powder, corn starch and sugar.

• Korean Journal of Food Science and Technology
• /
• v.23 no.2
• /
• pp.235-240
• /
• 1991

Starch phosphates were prepared from the corn starch mixed with 2% sodium tripolyphosphate by twin-screw extruder with a feed rate of 20 kg/hr and an extrusion temperature of $130^{\circ}C$, and the effects of extrusion variables on the physicochemical properties (target parameters) of starch phosphates were investigated. Interrelations of system parameters (specific mechanical energy and extrudate moisture) and rheological properities of starch was analyzed by using the response surface analysis. Degree of substitution (DS) was increased with increasing the feed moisture, and showed the maximum value at the screw of near 250 rpm, Degree of gelatinization was proportionally increased with increasing the screw speed and decreasing the feed moisture. Apparent viscosity of the paste was increased with increasing the feed moisture, but it was not significantly affected by the screw speed. It was found by scanning electron microscopy that the starch microgranules were much more degradaded, and as consequent result, the intrinsic viscosity was decreased, whereas, water solubility index was increased. The rate of retrogradation of the gels was retarded with increasing DS and decreasing viscosity.

• Membrane Journal
• /
• v.30 no.3
• /
• pp.173-180
• /
• 2020

As the demand for fossil fuels continues to increase worldwide, carbon dioxide (CO₂) concentration in the air has increased over the centuries. The way to reduce CO₂ emissions to the atmosphere, carbon capture and sequestration (CCS) technology have been developed that can be applied to power plants and factories, which are primary emission sources. According to the climate change mitigation policy, direct air capture (DAC) in air, referred to as "negative emission" technology, has a low CO₂ concentration of 0.04%, so it is focused on adsorbent research, unlike conventional CCS technology. In the DAC field, chemical adsorbents using CO₂ absorption, solid absorbents, amine-functionalized materials, and ion exchange resins have been studied. Since the absorbent-based technology requires a high-temperature heat treatment process according to the absorbent regeneration, the membrane-based CO₂ capture system has a great potential Membrane-based system is also expected for indoor CO₂ ventilation systems and immediate CO₂ supply to smart farming systems. CO₂ capture efficiency should be improved through efficient process design and material performance improvement.

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2003.11a
• /
• pp.101-104
• /
• 2003

In this study based on the mass transfer theory, experiments for the evaporation rates depending on various conditions were carried out through the operation of the existing Natural Evaporation Facility in KAERI. Evaporation media were made of the cotton and polyester. Air circulation in the facility was forced by exhausting fans. The evaporation rate and the decontamination factor were calculated by the result of experiment. The evaporation rate increased as the flow rate of air supply, the feed rate of liquid waste, and the temperature of supplied air increased. As for the humidity of supplied air, the evaporation rate was getting higher as the humidity was getting lower. As the result of this study, operation conditions of the Natural Evaporation Facility are optimized as follows : The air temperature above $8^{\circ}C$, the air humidity below 70%, the air flow rate 1.14-1.47 m/sec, and the liquid waste feed rate $4.6{\ell}/hr\cdotm^2$. The decontamination factor and the radioactivity are $5.1{\times}10^3$and $4.7{\times}10^{-13}{\mu}Ci/\textrm{m}{\ell}$ respectively, at the above mentioned optimum operation conditions. The air factor in the Dalton's equation for evaporation was determined from results of experiment on the temperature, the humidity, and the flow rate of supplied air as following : $[\textit{Eh}=(0.018 + 0.0141\textitv) {\delta}textitH]$

• Journal of Internet Computing and Services
• /
• v.12 no.6
• /
• pp.43-51
• /
• 2011

The recent development of the technology for wireless mobile computing and applied technology for location-based services has made it possible to support query processing faster than that in the past. However, some technological limitations on hardware and software still exist. The most critical aspects of query processing are accuracy and speed. For improving the accuracy, it is required that detailed information on the data involved in query processing be saved. In this case, the amount of information on the data increases, which decreases the speed. On the other hand, for increasing the speed, it is necessary to reduce the broadcast cycle, which enables rapid data acquisition as desired. In this case, because of insufficient index information, the listen time for the client increases, which may cause unnecessary energy consumption. Therefore, a trade-off occurs between the accuracy and speed. This paper proposes a hierarchical bitmap-based spatial index (HBI) as a solution for the aforementioned problems. HBI describes an object with 0 and 1 on the Hilbert curve map. It reduces the broadcast cycle by decreasing the index size on the basis of bit information and tree structure. Therefore, it is able to shorten the listen time and query processing time. In addition, HBI enables the detection of the locations of all the objects so that it is possible selectively listen to a broadcast. A performance evaluation of the proposed technique demonstrates that it is excellent.

• Journal of the East Asian Society of Dietary Life
• /
• v.25 no.4
• /
• pp.667-671
• /
• 2015

This study investigated the antioxidant capacities and inhibitory activity of peeled lotus root (Nelumbo nucifera) as a food material on angiotension-converting enzyme (ACE). The antioxidant effects on total polyphenol and total flavonoid contents were not signicant. However, DPPH radical scavenging activity decreased from 85.07% to 80.70% by peeled treatment. SOD-like activity decreased from 20.84% to 17.97%, and ACE inhibitory activity decreased from 53.4% to 50.1% by peeled treatement. Thus, consumption of non-peeled lotus root should increase.