• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.1
• /
• pp.39-44
• /
• 2006

An OWC-type Wave Energy Conversion passes through 3 steps energy conversion process. This paper deal with the internal oscillating flow and effect of shape of air chamber and duct at setting place of turbine by numerical analysis using commercial CFD code, FLUENT. Air chamber and duct in OWC-type wave energy conversion are adopting sudden expanded and contracted form for high-efficiency. So, whole oscillating flow from OWC-type chamber to outlet duct through duct was solved by steady and unsteady analysis in order that flow efficiency of air chamber and duct was made better.

• Journal of Navigation and Port Research
• /
• v.31 no.1 s.117
• /
• pp.29-33
• /
• 2007

An OWC-type Wave Energy Conversion passes through 3 steps energy conversion process. This paper deal with the internal oscillating flow and effect of shape of air chamber and duct at setting place of turbine by numerical analysis using commercial CFD code, FLUENT. Air chamber and duct in OWC-type wave energy conversion are adopting sudden expanded and contracted form for high-efficiency. So, whole oscillating flow from OWC-type chamber to outlet duct through duct was solved by steady and unsteady analysis in order that flow efficiency of air chamber and duct was made better.

• Journal of rehabilitation welfare engineering & assistive technology
• /
• v.7 no.2
• /
• pp.13-18
• /
• 2013

In this paper design a 8 bit Current Steering D/A Converter for stimulating neuron signal. Proposed circuit in paper shows the conversion rate of 10KS/s and the power supply of 3.3V with 0.35um Magna chip CMOS process using full custom layout design. It employes segmented structure which consists of 3bit thermometer decoders and 5bit binary decoder for decreasing glitch noise and increasing resolution. So glitch energy is down by $10nV{\bullet}sec$ rather than binary weighted type DAC. And it makes use of low power current stimulator because of low LSB current. And it can make biphasic signal by connecting with Micro Controller Unit which controls period and amplitude of signal. As result of measurement INL is +0.56/-0.38 LSB and DNL is +0.3/-0.4 LSB. It shows great linearity. Power dissipation is 6mW.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.19 no.4
• /
• pp.106-117
• /
• 2016

Recently, solar power plants have spread widely as part of the transition to greater environmental protection and renewable energy. Therefore, regular solar plant inspection is necessary to efficiently manage solar-light modules. This study implemented a test that can detect solar-light module faults using an UAV based thermal infrared camera and GIS spatial analysis. First, images were taken using fixed UAV and an RGB camera, then orthomosaic images were created using Pix4D SW. We constructed solar-light module layers from the orthomosaic images and inputted the module layer code. Rubber covers were installed in the solar-light module to detect solar-light module faults. The mean temperature of each solar-light module can be calculated using the Zonalmean function based on temperature information from the UAV thermal camera and solar-light module layer. Finally, locations of solar-light modules of more than $37^{\circ}C$ and those with rubber covers can be extracted automatically using GIS spatial analysis and analyzed specifically using the solar-light module's identifying code.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.190.2-190.2
• /
• 2016

메탄은 변환을 통해 아세틸렌 및 수소와 같은 에너지 생산에 보다 유용한 기체를 얻을 수 있다. 메탄의 열분해 온도는 약 1,200 K로 알려져 있으며, 그 이상의 고온 환경 및 첨가물을 제공한 경우 효과적인 변환을 기대할 수 있다. 이러한 고온 환경 및 화학반응을 제공할 수 있는 시스템으로 열플라즈마 반응로가 있다. 일반적인 열플라즈마는 아크 방전이나 고주파 유도결합 방전으로 플라즈마 발생기에서 발생시킨 이온화된 열유체로 10,000 K 이상의 초고온과 최대 수천 m/s의 특성을 가지고 있다. 본 연구에서는 효율적인 메탄 변환을 위한 저전력 아크 플라즈마 발생기 및 반응로 내부의 온도 및 속도장을 전산모사하여 열유동 특성을 분석하였다. 아크 플라즈마 토치 영역의 전산해석은 전자기적 현상과 고온 열유동의 유체역학적 현상이 함께 작용하므로 기존에 사용되고 있는 전산유체 역학적인 방법론에 전자기적 현상에 대한 보존 방정식이 결합된 자기유체역학(Magnetohydrodynamic, MHD)방법을 이용하였고, 반응기 내부의 복잡한 열유동은 안정적인 계산이 가능한 상용 전산 유체역학(Computational Fluids Dynamics, CFD) 코드를 MHD 코드를 이용한 전산해석 결과 및 고온 물성치와 결합하여 해석하였다. 전산해석에 사용된 운전 변수로는 방전기체인 아르곤과 수소의 전체 유량을 45 L/min 으로 고정하고 수소의 비율을 0%, 6%, 12.5%, 20%로 하였으며, 각 유량 조건에서 입력 전력을 0.7 ~ 2.5 KW로 변화시켜 전체 15종의 운전조건에 따른 전산해석을 수행하여 각각의 운전변수에 따라 입력전력 기준 오차 1 ~ 28%에 해당하는 결과를 도출하였다. 본 연구를 통해 개발된 전산해석 방법을 이용하여 다양한 조건에서 아크 플라즈마 반응로 내부의 온도 및 속도장에 대한 전산해석 결과를 제시하였고, 효율적인 메탄 변환 공정을 개발하기 위한 아크 플라즈마 반응로의 설계조건 및 운전 조건을 제시할 수 있는 기반을 확보하였다.

• Journal of Radiation Protection and Research
• /
• v.32 no.4
• /
• pp.158-167
• /
• 2007

It is required that the neutron dosimetry be present to monitor the reactor vessel throughout its plant life. The Ex-vessel Neutron Dosimetry Systems which consist of sensor sets, radiometric monitors, gradient chains, and support hardware have been installed for 3-Loop plants after a complete withdrawal of all six in-vessel surveillance capsules. The systems have been installed in the reactor cavity annulus in order to characterize the neutron energy spectrum over the beltline region of the reactor vessel. The installed dosimetry were withdrawn and evaluated after a irradiation during one cycle and then compared to the cycle specific neutron transport calculations. The reaction rates from the measurement and calculation were compared and the results show good agreements each other.

• Explosives and Blasting
• /
• v.34 no.1
• /
• pp.11-18
• /
• 2016

It is necessary to minimize ground vibration and noise due to blasting work in urban environment. The blast induced ground vibration and noise are generally generated by a portion of detonation energy, where most of the energy is utilized for rock breakage and movement of rock mass. Recently a blast method utilizing U-shaped steel charge holder was suggested to reduce the ground vibration without decreasing destructive power toward the free surface. In this study, single hole blasting utilizing U-shaped steel charge holder were simulated and the stress waves caused by the detonation of explosives were monitored using AUTODYN software. In order to examine the fragmentation efficiency of the U-shaped steel charge holder, one free face blasting models which adapt the blast induced stress waves were simulated by dynamic fracture process analysis (DFPA) code. In addition, the general blasting models were also simulated to investigate the fragmentation effectiveness of the U-shaped steel charge holder in rock blasting.

• Journal of Radiation Protection and Research
• /
• v.9 no.2
• /
• pp.97-102
• /
• 1984

Criticality analyses of the KSC-1(Korean Shipping Cask-1) spent fuel shipping cask have been performed with the help of KENO-IV Monte Carlo computer code and 19-group CSLIB 19 cross section set which was generated from AMPX modular system. The analyses followed a benchmark calculation which has been made regard to the B & W CX-10 criticality facility in order to validate the Monte Carlo code cross section set described above. The KSC-1 shipping cask seems to be safe in the criticality point of view for the transport of one PWR spent fuel assembly under the normal conditions as well as the hypothetical accident conditions.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.13 no.4
• /
• pp.295-300
• /
• 2015

The precise determination of the activity for each radionuclide in environmental samples requires the self-absorption correction factor. In this research, we derived the self-absorption correction factor for three p-type high purity germanium detectors using the Monte Carlo code MCNPX. These detectors have different characteristics such as crystal diameter, height and size of the core. We compared the calculated full-energy peak efficiency with the experimental value using a standard sample with $1g/m^3$ density and verified the modeling. We simulated the dependency of the full-energy peak efficiency on the 0.3, 0.6, 0.9, 1.0, 1.2 and $1.5g/m^3$ samples and obtained the corresponding self-absorption correction factor. The self-absorption correction factors calculated for the three detectors differ by less than 1% over most of the energy range and sample densities considered. This indicates that the self-absorption correction factors are independent of the crystal characteristics of HPGe detector.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.2
• /
• pp.191-198
• /
• 1998

The error are equation of DC-CDMA/MDPSK signal has been derived in m-distribution and Rician fading channels. Predeteception multipath MRC(Maximal Ratio Combining) diversity technique is employed for improving the bit error rate performance. The suitability of modeling a Rician fading environment by properly chosen m-distribution model is examined. Using the derived equation the error performance has been evaluated and shown in figures as a function of PN code sequence length(N), user number(U), multipath number(P), fading index(m), Rician factor(K), number of diversity branches(L) and ($E_b/N_o$). The results show that the error performance in Rician fading agrees well with that in m-distribution fading as fading becomes weak and as user number(U) increases and as multipath number(P) increases and diversity number(L) increases.