• Journal of the Korean Chemical Society
• /
• v.33 no.1
• /
• pp.46-54
• /
• 1989

The extraction method and quantitative analysis for the fat-soluble vitamins present in food stuffs and vitamin products have been investigated. The simultaneous separation and analysis of the vitamins by reverse phase high performance liquid chromatographic method was conducted using an isocratic elution with methanol : water (95 : 5) eluent on a Novapak $C_{18}$ column. The detection of vitamins was achieved by a variable wavelength UV detector. To improve the detection sensitivity detection wavelengths were set at the highest absorption bands such as 330, 265, 285, and 290nm for the respective vitamins. The analysis for the fat-soluble vitamins was finished within 40 minutes. Alkaline hydrolysis and enzymatic hydrolysis were investigated for the sample preparation; and liquid-liquid extraction and liquid-solid extraction were attempted for the extraction of vitamins. Both hydrolysis methods were turned out to be appropriate for the analysis for vitamins A, D, and E, while for the analysis of vitamin K the enzymatic hydrolysis method demonstrated better results. Diethyl ether, pentane, and n-hexane were found to give higher recovery for the liquid-liquid extraction and silica cartridge for the liquid-solid extraction.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.16 no.3
• /
• pp.347-357
• /
• 2018

The applicability of room temperature ionic liquids (RTILs), 1-alkyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide ([$C_nmim$] [$Tf_2N$]), was investigated for the extraction of Am(III) and Eu(III) from nitric acid using n-octyl(phenyl)-N,N-diisobutyl carbamoylmethyl phosphine oxide (CMPO) and tri-n-butylphosphate (TBP) as extractants. The distribution ratios of Am(III) and Eu(III) in CMPO-TBP/[$C_nmim$][$Tf_2N$] were measured as a function of various parameters such as the concentrations of nitric acid, CMPO, and TBP. The results were compared with those obtained in CMPO-TBP/n-dodecane (n-DD). With comparable concentrations of the extractants, the distribution ratios obtained with RTILs were much higher than those obtained with n-DD. It was observed that the extraction efficiency was less for Eu(III) than for Am(III). The extraction of Am(III) and Eu(III) decreased with increases in the feed acidity for all three RTILs. The results suggest that the extraction of Am(III) and Eu(III) by CMPO in RTILs from nitric acid proceeds through the cation-exchange mechanism. The distribution ratios of Am(III) and Eu(III) increased with increases in the concentration of CMPO for all three RTILs. A linear regression analysis of the extraction data resulted in a straight line with a slope of about 3, suggesting the involvement of 3 molecules of CMPO during the extraction process.

• Resources Recycling
• /
• v.28 no.1
• /
• pp.40-46
• /
• 2019

The solvent extraction of Tb(III) from hydrochloric acid solution was investigated by employing single organophosphorus (D2EHPA, PC88A and Cyanex 272), its mixture with Alamine 336 and ionic liquids with Aliquat 336. The equilibrium pH after the extraction with extractant mixtures and ionic liquids was higher than that by single extractants. Among the mixtures and ionic liquids, only the ionic liquid with Cyanex 272 and Aliquat 336 showed synergism to the extraction of Tb(III). The extraction percentage of Tb(III) by the extractant mixtures was lower than that by single extractant and the extraction order was in the following order : D2EHPA + Alamine 336 > PC88A + Alamine 336 > Cyanex 272 + Alamine 336. The extraction order of Tb(III) by the ionic liquids was Cyanex 272 + Aliqaut 336 > PC88A + Aliquat 336 > D2EHPA + Aliquat 336.

• Analytical Science and Technology
• /
• v.24 no.6
• /
• pp.477-483
• /
• 2011

This work is on the synthesis of EMI-$BF_4$ (1-ethyl-3-methylimidazolium tetrafluoroborate) and purification of spectroscopic grade using aluminium oxide method, activated charcoal method, and liquid/liquid fractional extraction method in order to make supercapacitor finally. But the aluminum oxide method and the activated charcoal method were not suitable for obtaining high-purity ionic liquids. The liquid/liquid fractional distillation method turned out that as the concentration of solvent ($H_2O$) was increased, the higher purity of EMI-$BF_4$ was obtained and the electrical capacity of this compound was increased to higher value. When the solvent was changed to from methylene chloride to 1,2-dichloroethane, the higher purity of EMI-$BF_4$ was obtained.

• Resources Recycling
• /
• v.29 no.5
• /
• pp.55-63
• /
• 2020

In order to investigate the separation of Co(II) and Ni(II) by ionic liquids from weak hydrochloric acid solutions, extraction experiments were performed by changing the type and concentration of ionic liquids and the initial pH of the aqueous phase. Two kinds of ionic liquids based on Aliquat 336 were employed in this work; one was synthesized by reacting organophosphorus acids(D2EHPA, PC88A, Cyanex 272, Cyanex 301) with Aliquat 336 and the other was prepared by exchanging the chloride ion of Aliquat 336 with SCN^-. The three types of ionic liquids (ALi-D2, ALi-PC, and ALi-CY272) showed better extraction of Co(II) than Ni(II), and the equilibrium pH was higher than the initial pH. In the case of ALi-CY301, the selectivity of Co(II) and Ni(II) depended on the extraction conditions. In addition, the effect of the addition of TBP to the ionic liquid on the extraction of two metals was also investigated. Employment of ALi-SCN as an extractant resulted in selective extraction of Co(II) and complete separation of the two metal ions was possible.

• Analytical Science and Technology
• /
• v.11 no.5
• /
• pp.321-331
• /
• 1998

The separation and sample extraction methods of 19 polycyclic aromatic hydrocarbons (PAHs) in water samples were investigated by gas chromatography/mass spectrometry (GC/MS) and some extraction methods involved liquid-liquid extraction, disk extraction and solid-phase extraction methods. The separation of 19 PAHs was possible by partial variation of oven temperature of GC/MS in temperature range $80{\sim}310^{\circ}C$. Extraction procedures of PAHs in water samples were somewhat modified and compared as extraction recoveries and the simplicity of methods. Extraction recoveries of PAHs were 71.3~109.5% by liquid-liquid extraction method. By using disk extraction, good extraction recoveries (80.7~94.9%) were obtained in case of $C_{18}$ disk extraction method by filtration. And extraction recoveries of PAHs by $C_{18}$ solid-phase were in the range of 51.8~77.9%. Method detection limits (S/N=5) of 19 PAHs were in the range of 0.25~6.25 ppb by liquid-liquid extraction and solid-phase extraction and 0.05~1.25 ppb by disk extraction methods.

• Korean Chemical Engineering Research
• /
• v.54 no.1
• /
• pp.52-56
• /
• 2016

As an effective method for extraction of succinic acid, aqueous two-phase systems based on piperidinium ionic liquids were used in this study. Effects of the alkyl chain length of cation in piperinidium ionic liquids on phase diagram and extraction efficiencies were investigated. Experimental results show that aqueous two phase systems can be formed by adding appropriate amount of piperidinium ionic liquids to aqueous $K_2HPO_4$ solutions. It can be found that the ability of piperidinium ionic liquids for phase separation followed the order [OMPip][Br]>[HMPip][Br]>[BMPip][Br]>[EMPip][Br]. The biphase-forming ability of piperidinium ionic liquids was higher than that of imidazolium and pyrrolidinium ionic liquids in the presence of $K_2HPO_4$. 75~95% of the succinic acid could be extracted into the ionic liquid-rich phase in a single-step extraction. There was little difference in the extraction efficiency of succinic acid by piperidinium ionic liquids comparing to other ionic liquids such as imidazolium and pyrrolonidium ionic liquids. This aqueous two phase system by piperidinium ionic liquid is suggested to have effective application for the separation of succinic acid.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.463-463
• /
• 2011

집속이온빔장치(Foucused Ion Beam)에서 사용하는 액체금속이온원(Liquid Metal Ion Source)은 고 전류밀도, 고 휘도, 낮은 에너지퍼짐 등 많은 장점이 있다. 대부분의 집속이온빔 장치에서 플라즈마 이온소스에 비해 빔의 직경이 작고 GFIS 보다 다루기 쉬워 액체금속이온원을 많이 사용하고 있다. 기존에 사용하던 액체금속이온원에 서프레셔라는 새로운 전극을 추가시켜 팁과 갈륨저장소, 서프레셔, 추출극 구조로 만들었다. 이 연구를 위해 RPA(Retarding Potential Analyser)를 제작 하였다. RPA는 두 개의 메쉬와 하나의 컬렉터로 이루어져 있으며, 액체금속이온과 플로팅 되어있는 RPA에 전압의 차이를 주기위해 베터리로 제작한 파워로 액체금속이온에 인가되는 전압에 + 90V, -90V까지 제어가 가능하게 만들었다. 본 연구에서는 서프레셔의 유무에 따른 액체금속이온원의 에너지 퍼짐에 대해 연구하였다. 추출극에 전압 변화를 주어 방출되는 전류를 5uA, 10uA, 15uA, 20uA로 변화시켜가며 RPA에서 측정되는 전류를 가지고 전류-전압의 관계를 보았고, 에너지 퍼짐정도를 알았다. 마찬가지로 서프레셔에 전압 변화를 주어 전류-전압 관계, 에너지 퍼짐정도를 알았다.

• Korean Chemical Engineering Research
• /
• v.52 no.5
• /
• pp.627-631
• /
• 2014

As an effective method for extraction of acrylic acid, aqueous two-phase systems based on morpholinium ionic liquids were used in this study. Effects of the alkyl chain length of cation in morpholinium ionic liquids on phase diagram and extraction efficiencies were investigated. Experimental results show that aqueous two phase systems can be formed by adding appropriate amount of morpholinium ionic liquids to aqueous $K_2HPO_4$ solutions. It can be found that the ability of morpholinium ionic liquids for phase separation followed the order [HMMor][Br]>[OMMor][Br]>[BMMor][Br]>[EMMor][Br]. There was little difference between binodal curves of imidazolium ionic liquids and those of morpholinium ionic liquids. 50~90% of the extraction efficiency was observed for acrylic acid by aqueous two phase extraction of acrylic acid with morpholinium ionic liquids. It can be concluded that morpholinium ionic liquids/$K_2HPO_4$ were effective for aqueous two phases extraction of acrylic acid comparing to imidazolium ionic liquids/$K_2HPO_4$ systems because of their lower cost.

• Journal of the Korean Chemical Society
• /
• v.30 no.5
• /
• pp.465-474
• /
• 1986

The solvent extraction and cleanup processes for the simultaneous gas-liquid chromatographic determination of 11 kinds of organophosphorous pesticide residues in crops were investigated. The extracts dissolved with acetone were partitioned with petroleum ether after adding saturated NaCl solution. Evaporated the partitioning solvent, the residue was dissolved in methylene chloride and eluted through mixed adsorbent (1 : 2 : 4 of activated carbon, magnesia and diatomaceous earth) with methylene chloride as an eluent. The pesticides recovered were 82∼105% and the impurities were effectively removed.