• Resources Recycling
• /
• v.9 no.3
• /
• pp.22-28
• /
• 2000

A study on the recovery of gallium from zinc residues is carried out by alkali leaching using NaOH. The results show that in case of alkali leaching of zinc residues, Zn, K and Si are mainly leached out and Fe and other base metals are scarcely leached out, which results in that gallium is easily recovered by solvent extraction. The leaching efficiency of gallium increases with increasing alkali concentration and solid density. Especially, alkali consumption is considerably reduced by washing the zinc residues with water before leaching in order to eleminate the soluble zinc compounds. The gallium from zinc residues is found to be leached out with a recovery of 80% or higher for 2hrs leaching with 1~1.25 M/L NaOH solution and solid density 333 g/L at $25^{\circ}C$.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.18 no.1
• /
• pp.111-118
• /
• 2014

The present study concerns the leachability of alkali ions from hardened cement paste in terms of an increase in the pH together with the rate of alkali leaching. To evaluate the influence of mix design on the leaching capacity and rate of alkali, different water-cement ratios (W/C) and binders were used to manufacture paste specimens. The cement paste was made in the form of rectangular bucket where deionised water was subsequently supplied as solvent media. Then the specimen was wrapped in polythene film to avoid contact to atmospheric conditions, which may affect the water chemistry in the bucket. The pH of media was monitored until no further change in the pH value was observed, of which value then used to calculate the leaching capacity and rate. The influence of binder on the pH of solvent is more dominant than that of water to cement ratio: OPC paste produced the highest level of alkali leaching, whilst 30% PFA and 60% GGBS pastes imposed lower level of alkali leaching. After the monitoring of the pH, the inner bucket was ground with an increment of 1.0 mm to measure the leaching influence using the suspension consisting of paste powder and deionised water. It was found that the impact zone for OPC was about 7-8 mm, whilst 30% PFA and 60% GGBS had deeper impact depth of the alkali leaching.

• Resources Recycling
• /
• v.26 no.6
• /
• pp.91-96
• /
• 2017

Tungsten (W) recovery from tungsten carbide (WC) was researched by alkali melt followed by water leaching. The experiments of alkali melt were carried out with the change of the sort of alkali material, heating temperature, and the heating duration. Water leaching of W was performed in the fixed conditions ($25^{\circ}C$, 2 hr., slurry density: 10 g/L). From the mixture of WC and sodium nitrate ($NaNO_3$) in the molar ratio of 1:2, treated at $400^{\circ}C$ for 6 hours, only 63.3% of W might be leached by water leaching. With the increase of sodium hydroxide (NaOH) as a melting additive, the leachability increased. Finally it reached to 97.8 % with the melted mixture of ($WC:NaNO_3:NaOH$) in the ratio of (1:2:2). This imply that NaOH may play a role as a reaction catalyst by lowering Gibb's free energy for alkali melt reaction for WC.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.11 no.2
• /
• pp.138-144
• /
• 2023

In this study, the effect of electrochemical treatment in mitigating alkali leaching into an aquatic environment was investigated. To modify the surface of cement paste, 1000 mA/m² of the direct current was passed through anodic graphite to the external mesh for 4 weeks. Then, the cement paste specimen was exposed to still water in air-tight condition to prevent natural healing of alkali leaching in the water. For 100 days of monitoring in water, the pH value was marginally increased at the electrochemical treatment, while control specimen ranked to the even higher pH accounting for 13.2 in the pH. Moreover, after the pH monitoring, the pH profile for the paste specimen indicated that the electrochemical treatment was effective in securing the higher alkalinity of cement matrix. The water obtained from alkali leaching process, was used to ecological test for Daphnia magna. It was evident that the electrochemical treatment had minimal adverse effect on ecological impact, while control specimen mostly immobilized the standard Daphnia magna.

• Journal of Korea Soil Environment Society
• /
• v.2 no.2
• /
• pp.73-79
• /
• 1997

Removal of the Arsenic components from the closed mine tailings has been attempted by the alkali-leaching method. Two tailings collected from the Daduck and Yuchon mine which were already closed many years ago were leached with caustic soda solutions. The Arsenic components in the leach liquor resulted from the alkali treatment of tailings could be removed fairly well in the form of insoluble calcium-Arsenic compound by the precipitation with calcium chloride. As a result, the extraction of about 60~90% Arsenic from the tailings could be obtained depending on the leaching conditions and the influence of temperature and the slurry density on the extraction of Arsenic was also found to be very small at the NaOH concentration more than 0.5N. In addition, it seemed that a caustic soda solution over 0.5N NaOH could be used repeatedly for the leaching of tailings since the consumption of NaOH was not so great in a leaching of them. As far as the precipitation of Arsenic components was concerned, more than 99% of Arsenic could be precipitated within 10 minutes by the addition of 2wt% CaC12 in to the leach liquor.

• Resources Recycling
• /
• v.27 no.4
• /
• pp.57-64
• /
• 2018

Water leaching of tungsten(W) and vanadium(V) was researched from their oxides through mechanochemical (MC) reaction with alkali compounds. Intensive grinding for the mixture of tungsten/vanadium oxide and alkali compounds (NaOH, $Na2CO_3$) was carried out with change of their mixing ratios and grinding duration. Water soluble compounds, $Na_2WO_4$ and $NaVO_3$, were synthesized through MC reaction and their solubilities increased in proportion to the mixing ratio of sodium compound and grinding times. Whereas vanadium leachability was less affected by the mixting ratio and grinding times. The leachabilities of 99.0% were accomplished by a short period of MC treatment, W (30 min.) and V (5 min.). This process enable us to extract W and V from their oxides via a water leaching, and can be applied to the selective recovery of W and V from $DeNO_x$ spent catalysts.

• Resources Recycling
• /
• v.26 no.5
• /
• pp.77-84
• /
• 2017

White and black dross are resulted from the recycling of aluminum. There are no established processes to recover valuable materials from black dross. Hydrometallurgical processes seem to be suitable for the treatment of aluminum dross. The salts in the black dross are recovered by dissolving with water. The residues are treated by either alkaline or acid leaching. Although the leaching rate of alumina by NaOH is lower than that by acid, its intermediates are more suitable to the production of alumina-based materials. The future direction for the treatment and recovery of valuable materials from aluminum dross is discussed.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.11 no.2
• /
• pp.145-152
• /
• 2023

In this study, microscopic observation was made on the surface of cement paste immersed in an aquatic environment for 100 days at electrochemical treatment to mitigate the leaching of alkali ions. To quantitatively rank the hydration products, unhydrated grains and porosity in the interfacial region, the backscattered electron(BSE) images were obtained by scanninng electron microscopy. As a result, it was found that the porosity on the surface was significantly reduced by the electrochemical treatment, while unhydrated grains were more or less increased presumably limited hydration reaction under electric charge. At electrochemical treatment, Ca²⁺ ions present in C-S-H gel could be precipitated with OH^- to form Ca(OH)₂ then to lower C-S-H gel and simultaneously to enhance Ca(OH)₂. Substantially, the risk of alkali leaching could be lowered by the limited ionized matrix under electrochemical treatment.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2005.04a
• /
• pp.433-436
• /
• 2005

국내 A군에서 운영중인 한 쓰레기 매립지에서 배출되는 침출수와 주변 지하수를 채취하여 화학분석과 동위원소 분석을 실시하였다. 그리고 생활 쓰레기가 분해되는 과정에서 생성되는 가스들을 채집하여 동위원소 분석을 실시하였다. 유기물 분해로 생성된 이산화탄소는 일차적으로 침출수의 알칼리도를 높이고 이차적으로 일어나는 이산화탄소의 환원작용에 의하여 메탄가스가 형성되었다. 이러한 과정에서 침출수내의 용존무기탄소(DIC)의 탄소 동위원소 조성이 부화되었으며, 아울러 생성된 메탄과의 수소 동위원소 교환반응에 의하여 침출수의 수소 동위원소 조성이 크게 부화되는 특징이 관찰 되었다. 쓰레기장에서 발생되는 혼합가스에서 이산화탄소를 분리하여 탄소 동위원소 조성을 분석해 본 결과 새로운 매립지 보다 오래된 매립지에서 배출되는 이산화탄소의 탄소 동위원소 조성이 부화되는 특징이 관찰되었다.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.09a
• /
• pp.455-457
• /
• 2004

환경동위원소 기법을 쓰레기 매립장의 침출수 및 주변 지하수에 적용해본 결과 미생물의 활동에 의한 유기물의 분해과정에 대한 정보를 얻을 수 있었다. 특히 유기물 분해로 생성된 이산화탄소는 일차적으로 침출수의 알칼리도를 높이고 이차적으로 일어나는 이산화탄소의 환원작용에 의하여 메탄가스가 형성되었다. 이러한 과정에서 침출수에 잔류하는 용존무기탄소(DIC)의 탄소 동위원소 조성이 크게 부화되었으며, 아울러 생성된 메탄과의 수소동위원소 교환반응에 의하여 물의 수소 동위원소 조성이 크게 부화되는 특징이 국내에서 처음 관찰되었다.