• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2005.06a
• /
• pp.663-667
• /
• 2005

Surface modified carbon nanotubes were applied into the epoxy composites to investigate its tribological property. Carbon nanotubes reinforced epoxy composites were fabricated by casting. Effects to the tribological property of loading concentrations and types of surface modification of carbon nanotubes were investigated under sliding condition using linear reciprocal sliding wear tester. The results show that the small amount of carbon nanotubes into the epoxy exhibited lower weight loss than the pure epoxy. It is concluded that the effect of an enormous aspect ratio of carbon nanotubes surface area which wider than conventional fillers that react as interface for stress transfer. As increased the contents of carbon nanotubes, the weight loss from the wear test was reduced. And the surface modified carbon nanotubes show better tribological property than as produced carbon nanotubes. It is due that a surface modification of carbon nanotubes increases the interfacial bonding between carbon nanotubes and epoxy matrix through chemical bonding. Changes in worn surface morphology are also observed by optical microscope and SEM for investigating wear behaviors. Carbon nanotubes in the epoxy matrix near the surface are exposed, because it becomes the lubricating working film on the worn surface. It reduces the friction and results in the lower surface roughness morphology in the epoxy matrix as increasing the contents of the carbon nanotubes.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.1
• /
• pp.21-26
• /
• 2013

In this paper we propose a system where we divide the group with 2 symbols. The two added symbols are separated by multiplexing and later added using the DE-multiplexing technique. In our proposed system a simple Partial Interference Cancelation (PIC) group decoding scheme is used for Double-ABBA(D-ABBA) Quasi-Orthogonal Space Time Code, which reduces the decoding complexity for the higher order Multiple Input Multiple Output (MIMO) space time block coding. Finally we compare the proposed scheme performance using the different modulation schemes.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.1
• /
• pp.27-33
• /
• 2013

In this paper, we propose a pilot based channel estimation technique in two-way relay networks. We propose to transmit a pilot symbol together with the data symbol during transmission. In absence of Channel State Information (CSI), destination uses the pilot symbol to estimate the channel. In this system, the relay amplifies the pilot and the data symbol then forward them to the destination using amplify and forward (AF) protocol. We assume that the relay gain is fixed, so the relay does not need to estimate the channel, the destination only estimate the channel. We apply well-known Least-square (LS) and minimum mean-square error (MMSE) channel estimation methods to estimate the channel.

• Journal of the Korean Society for Precision Engineering
• /
• v.22 no.11 s.176
• /
• pp.59-63
• /
• 2005

Since human listening is very sensitive when the sound hit him, the subjective index of sound quality is required. Therefore, at each situation of sound evaluation its composed with the sound quality factor. But, when substituting the level of one frequency band we could not see the tendency of substitution at whole frequency band during the sound quality evaluation. In this study a design of experiment is used. The frequency domain is divided into an equally 12 parts and each level of domain whether is given increase or decrease due to the change of frequency band based on 'sharp' and 'annoy' of the sound quality is analyzed. By using the design of experiment the number of test is reduce very effectively by the number of experiment and each band the main effect will be as a solution. The case of sound quality for 'sharp' and 'annoy' at each band, the change of band (increase or decrease of sound pressure or keep maintain) which will be the most effects on the characteristics of sound quality can be identify and this will be able to us to select the objective frequency band. Through these obtained results the physical changes of level at arbitrary frequency domain sensitivity can be adapted.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.8
• /
• pp.809-812
• /
• 2011

In this letter, in order to reduce the inter-channel interference at the transmitted side, we design the precoder based on Tomlinson-Harashima coding, which is well know for one kind of non-linear precoding schemes, for 3-user MIMO wireless systems. And its performance is also analyzed in comparison with that of the Dirty Paper Coding based precoder.

• Journal of the Korean Geographical Society
• /
• v.38 no.4
• /
• pp.610-629
• /
• 2003

Ecotourism has been considered as sustainable tourism since it has been believed to preserve the environment of a tourist destination as well as to satisfy the various needs of tourists. However, most of destinations recently developed for ecotourism have confronted environmental degradation. Therefore, it is necessary to challenge and reestablish the concept of ecotourism. This study seeks to provide new perspectives on the concept of ecotourism by estimating the sustainability of three ecotourism destinations in Jeju Island. The Yae-Rae Dong Ecotourism Village shows a high level of sustainability, while the Ah-Bu Oh-rum at Song-Dang Ri and the Experience Beach at Jong-Dal Ri shows a low level of sustainability. In result, the ecotourism in itself is not sustainable tourism, and further this study suggests that appropriate planning, development, and management of a destination are important factors to decide the success of sustainable tourism.

• Journal of the Korean Society for Precision Engineering
• /
• v.22 no.10 s.175
• /
• pp.80-89
• /
• 2005

In this paper, time-frequency analysis using wavelet packet transform and advanced-MDSA (Multiple Dimensional Spectral Analysis) which based on wavelet packet transform is applied fur fault source identification and diagnosis of early detection of fault non-stationary sound/vibration signals. This method is analyzing the signal in the plane of instantaneous time and instantaneous frequency. The results of ordinary coherence function, which obtained by wavelet packet analysis, showed the possibility of early fault detection by analysis at the instantaneous time. So, by checking the coherence function trend, it is possible to detect which signal contains the major fault signal and to know how much the system is damaged. Finally, It is impossible to monitor the system is damaged or undamaged by using conventional method, because crest factor is almost constant under the range of magnitude of fault signal as its approach to normal signal. However instantaneous coherence function showed that a little change of fault signal is possible to monitor the system condition. And it is possible to predict the maintenance time by condition based maintenance for any stationary or non-stationary signals.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.7
• /
• pp.48-55
• /
• 2012

Because of increasing complexity in maximum-likelihood (ML) decoding of four of higher antenna scenario, Partial Interference Cancellation (PIC) group decoding could be the perfect solution to reduce the decoding complexity occurs in ML decoding. In this paper, we separate the symbols the users in the layered basis and find the equivalent channel matrix. Based on the equivalent channel matrix we provide the grouping scheme. In our paper, we construct a block wise transmission technique which will achieve the desired code rate and reduce the complexity and provide less transmission time. Finally we show the different grouping performance.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2005.11a
• /
• pp.530-533
• /
• 2005

Recently, modern reciprocating air compressors tend to be smaller and lighter. But, as the development of performance, they have many problems for noise and vibration. For this reason, many researches are processing for the reduction of noise and vibration by arranging cylinders with V/W type. Especially, noise and vibration problems of reciprocating air compressor cause a rotating unbalance of crankshaft, so it needs a change of crankshaft parameters appropriately. Hence in this study, we changed crankshaft parameters to solve the rotating unbalance and compared results in order to verify the noise and vibration reduction between new and original air compressor. According to modify a crankshaft parameter, the improvements of noise and vibration were showed results of spectrum measured at selected points of the air compressor crankshaft housing and sound intensity contours measured at a belt left side, table that figure out characteristics of noise. Furthermore, we analyzed objective sound quality metrics with recording data of systems. The results showed that, the new design has improved the level of the first harmonic of vibration displacement, noise and objective sound quality metrics.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.4
• /
• pp.119-125
• /
• 2015

In this paper, we introduce a Hadamard matrix interstream transmission based blind channel estimation for multi-cells multiple-input and multiple-output (MIMO) networks. The proposed scheme is based on a network with mobile stations (MS) which are deployed with multi cells. We assume that the MS have the signals from both cells. The signal from near cell are considered as desired signal and the signals from the other cells are interference signal. Since the channel is blind, so that we transmit Hadamard matrix pattern pilot stream to estimate the channel; that gives easier and fast channel estimation for large scale MIMO channel. The computation of Hadamard based system takes only complex additions, and thus the complexity of which is much lower than the scheme with Fourier transform since complex multiplications are not needed. The numerical analysis will give perfection of proposed channel estimation.