• Journal of Life Science
• /
• v.16 no.2 s.75
• /
• pp.323-327
• /
• 2006

The Formation of acrylamide was studied in Maillard model reaction systems based on asparagine-glucose. The mixture of asparagine and glucose in equal molar ratio, and then heated at 125, 150, 175 and $200^{\circ}C$ for 10, 20 and 30 minute, respectively. The reaction products were extracted with ethyl acetate and methanol, and then isolated and detected on FFAP capillary column and HP-5MS 5% phenyl methyl siloxane column by using GC/MS. Acrylamide was detected only from methanol extracts and on FFAP capillary column, at retention time 23.53 min., and the detection limit was 4.6 ng. Acrylamide content mainly increased with increasing temperature and processing time till $175^{\circ}C$, therefore, maximal acrylamide formation occurred at $175^{\circ}C$ for 10 minute ($116{\mu}g/g$), while, above $175^{\circ}C$, higher temperatures or prolonged processing times caused a decrease of acrylamide levels, finally disappeared at $200^{\circ}C$ for 30 minute. Three major compounds were identified as 1,3-dihydroxypropanone, 2,3-dihydro-3,5-dihydroxy-6-methyl-4H-pyrane-4-one and 5-hydroxymethylfurfural, and three minor compounds also as 5-methylfurfural, 2-acetylpyrrole and N,N-dimethylcyclohexamine, from ethyl acetate or methanol extracts on FFAP or HP-5MS capillary column.

• Clean Technology
• /
• v.17 no.4
• /
• pp.314-324
• /
• 2011

Several amide derivatives have been used as additives for base oil of metal working fluids and pressure working oils. In this paper, a series of succinic acid alkyl half-amide derivatives were synthesized as over 97% yields by ring-opening reaction of succinic anhydride and several amines and were soluble in 100 N base oil within 1 wt% concentration. The structures of the synthesized amides were confirmed by $^1H$-NMR, FT-IR spectrum and GC analysis. Anti-corrosion properties of the amides in sea water were evaluated through ASTM D665 method and weight loss method. As the results of anti-corrosion properties, the properties of the amides with shorter alkyl chain and high concentration showed better performance than those with longer alkyl chain and low concentration. Also, the dialkyl amides showed better anti-corrosion properties than those of the monoalkyl amides. Inhibition efficiency% (IE%) was over 93% in the concentration of 40 ppm and corrosion rate (CR) was below 0.5 mm/year in the same concentration.

• Applied Chemistry for Engineering
• /
• v.26 no.2
• /
• pp.234-238
• /
• 2015

The separation of nitrogen heterocyclic compound (NHC) contained in a model coal tar fraction was compared by the methanol and formamide extraction. The model coal tar fraction comprising four kinds of NHC (NHCs : quinoline, iso-quinoline, indole, quinaldine) and three kinds of bicyclic aromatic compound (BACs : 1-methylnaphthalene, 2-methylnaphthalene, dimethylnaphthalene), biphenyl and phenyl ether was used as a raw material. The aqueous solution of methanol and formamide were used as solvents. A batch-stirred tank was used as the raw material - a solvent contact unit of this work. Independent of the solvent used, the distribution coefficient of NHCs sharply increased by decreasing the initial volume ratio of water to the solvent and increasing the equilibrium operation temperature, whereas, the selectivity of NHCs in reference to BACs decreased. Decreasing the initial volume ratio of solvent to feed resulted in deteriorating distribution coefficients, but the selectivity of NHCs in reference to BAC was almost the constant. The distribution coefficient of NHCs by the methanol extraction was 3~5 times higher than that of NHCs by the formamide extraction, inversely, the selectivity of NHCs based on BACs by the formamide extraction was 3~7 times higher than that of NHCs by the methanol extraction. Furthermore, two different solvent extraction methods by adding the extraction processing speed to the balance between solvency and selectivity of NHCs were compared.

• The Magazine for Energy Service Companies
• /
• s.53
• /
• pp.30-31
• /
• 2008

우리에게 익숙한 폴리에스터나 나일론(폴리아마이드)은 2개 이상의 단위체를 결합하여 만든 고분화 화합물이며 이들을 만드는 과정을 중합반응이라고 한다. 예를 들면 폴리에스터의 경우, PTA(Purified Telephtal Acid)와 Ethylene Glycol을 약 $280^\circC$의 고온과 0.4torr 정도의 진공에서 합성해 만들어 진다. 이 반응에 필요한 진공 조건을 유도하기 위해 Ejector가 필요한데 우리나라의 화학 섬유 공장에서는 주로 증기를 이용한 Ejector를 사용하고 있다.

• Journal of the Korean Chemical Society
• /
• v.52 no.5
• /
• pp.583-587
• /
• 2008

• Polymer(Korea)
• /
• v.28 no.2
• /
• pp.143-148
• /
• 2004

${\alpha}$,$\omega$-Hydrogen polyorganosiloxane(HPMDMS) prepolymer was prepared from equilibrium polymerization ofoctamethylcyclotetrasiloxane, 1,3,5-trimethylcyclotrisiloxane, 1,3,5,7-tetravinyl-1,3,5,7-tetramethyl-cyclotetrasiloxane, and 1,1,3,3-tetramethyl disiloxane as an end-blocker in the presence of tetramethylammonium siloxanolate as a catalyst. Polyorganosiloxane modified with dimethylacrylamide(APMDMS) was prepared by hydrosilylation of HPMDMS with dimethylacrylamide in the presence of Pt catalyst, and followed by coordination of metal oxide (APMDMS-MO), such as NiO and FeO, to the amide moieties of the resulting polymer. The chemical structures of HPMDMS and APMDMS were confirmed by FT-IR and $^1$H-NMR analysis. Liquid silicone rubber containing metal oxide composite (LSRMO) was prepared by compounding APMDMS-MO, ${\alpha}$,$\omega$-vinylpolydimethylsiloxane, and a catalyst in a high speed dissolver. The thermal conductivity of LSRMO composite was determined to be 0.29 W/mK, and the volume resistivity exhibited a lower value than that of LSR composite. The mechanical and thermal properties of LSRMO and LSR composite were measured by UTM and TGA.

• Polymer(Korea)
• /
• v.38 no.1
• /
• pp.74-79
• /
• 2014

Microfibrillated cellulose (MFC) was chemically modified with two different silane coupling agents (3-aminopropyltriethoxysilane and 3-mercaptopropyltriethoxysilane) and lauroyl chloride. The surface modification of MFC was confirmed by infrared spectroscopy (FTIR), energy dispersive X-ray spectroscopy (EDX), and contact angle measurements. Composite paper was successfully prepared with surface modified MFC and polyamide (PA) fiber. The surface modification of MFC not only prevented aggregation of MFC but also improved adhesive property between PA fiber and surface modified MFC. It was impossible to prepare papers of only PA fiber because there is no binder to connect PA fibers. That is, surface modified MFC as a binder in PA fiber played a crucial role in making composite paper. Composite paper with silane modified MFC showed higher tensile strength and modulus than composite paper with lauroyl moiety modified MFC. The structure, morphology, and mechanical properties of composite paper were analyzed by scanning electron microscope (SEM) and universal testing machine (UTM).

• Korean Journal of Food Science and Technology
• /
• v.50 no.2
• /
• pp.152-164
• /
• 2018

Fermented seasoning pastes were prepared by Aspergillus oryzae and Bacillus subtilis using three edible insects, Tenebrio molitor larvae (TMP), Gryllus bimaculatus (GBP), and Bombyx mori pupa (SPP), with soybean (SBP) as a negative control. Volatile compounds were extracted by the headspace solid-phase microextraction (HS-SPME) method and confirmed by gas chromatograph-mass spectrometry (GC-MS). In total, 121 volatiles from four samples were identified and sub-grouped as 11 esters, 18 alcohols, 23 aldehydes, 5 acids, 10 pyrazines, 2 pyridines, 7 aromatic hydrocarbons, 10 ketones, 19 alkanes, 9 amides, 4 furans and 3 miscellaneous. TMP, GBP, SPP and SBP had 48, 54, 36, and 55 volatile compounds, respectively. Overall, 2,6-dimethylpyrazine and trimethylpyrazine were found by a high proportion in all samples. Tetramethylpyrazine, a main flavor of doenjang, a Korean fermented seasoning soybean paste, was identified as one of the major compounds in TMP, SPP, and SBP. SBP had benzaldehyde, hexanal, n-pentanal, and aldehydes and SPP with pyrazines.

• Korean Chemical Engineering Research
• /
• v.46 no.5
• /
• pp.965-970
• /
• 2008

The separation of sulfone components using light cycle oil(LCO) after oxidation was carried out by solvent extraction method using various polar solvents such as water, n-methyl-2-pyrrolidone(NMP), dimethyl sulfoxide, ethyl acetate, acetonitrile, dimethyl formamide, and methyl alcohol. It was found that phase separation between LCO layer and solvent occurred under mixed solvent adding a proper amount of water. The mixture solvent of NMP and water was a promising extraction solvent due to the selective removal and high distribution coefficient of sulfone component in LCO. 99.5% over of sulfur contents in LCO can be removed by 4 stages equilibrium extraction.

• Journal of the Korean Chemical Society
• /
• v.48 no.4
• /
• pp.358-366
• /
• 2004

The bridged disulphato complex $[Cr_2(NH_2)_2(H_2O)_2(SO_4)_2]{\cdot}2H_2O$, terminal triisocyanato $[Cr(NCO)_3(H_2O)]{\cdot}3H_2O$ complex and limonite, $[FeO(OH)]{\cdot}0.2H_2O$ compound were prepared by the reaction of $Cr_2(SO_4)_3{\cdot}xH_2O, Cr(CH_3COO)_3$ and $Fe_2(SO_4)_3$, respectively, with urea in aqueous media at $80^{\circ}C$. The infrared spectra of the products indicate that the absence of the bands of urea, but shows the characteristic bands of coordinated amide, water, bridged sulphato and isocyanato groups. Thermogravimetric (TG) and differential thermal analysis (DTA) measurements on the complexes are also recorded. The data obtained agree quite well with the expected structures. A general mechanisms describing the formation and its thermal decomposition of the complexes are suggested.