• Journal of the Korean Geotechnical Society
• /
• v.16 no.5
• /
• pp.37-43
• /
• 2000

보통으로 다져진 실트질 모래(Dr=50%)에 대한 액상화 전후 상태에서의 반복하중에 의한 동적거동을 연구하기 위하여 몇가지의 압밀응력비로서 압밀시킨공시체에 대해서 일련의 일련의 반복삼축시험을 수행하였다. 연구결과로서 압밀응력비가 액상화거동에 미치는 영향을 나타내었으며 또한 액상화 전후의 동적거동을 비교하였다. 그리고 액상화 후의 거동은 선행액상화시의 응력반전여부에 의해서 절대적으로 좌우된다는 사실을 보여주고 있다. 결론적으로 액상화를 경험한 공시체의 액상화저항은 액상화를 경험하지 않은 공시체에 비해서 이방압밀의 경우에는 높고 등방압밀의 경우에는 낮다.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1997.10a
• /
• pp.285-290
• /
• 1997

• Journal of the Korean Geotechnical Society
• /
• v.15 no.4
• /
• pp.133-152
• /
• 1999

The cyclic triaxial test was carried out to research liquefaction characteristics and sample disturbance effects of silty sand soils at the west coast in Korea. First, liquefaction in silty sand was generated when axial strain approached to $\pm10%$ of strain and behavior of pore pressure was similar to the formula suggested by Seed, Martin, and Lysmer(1975). Also, it was found that dilatancy was generated at failure. Secondly, the liquefaction evaluation methods suggested by many researchers were carried out and the results were compared. In these methods the weak depth in liquefaction was similar and the method carried out by cyclic triaxial test on remolded sample showed the least safety factor. Thirdly the stress ratio by cyclic triaxial test was compared with that obtained from SPT N-value as a kind of empirical methods. It was found that the effect of sample disturbance was relatively small when SPT N-value was less than 20, but there were large differences in safety factor and resistance of liquefaction in soil by the effects of disturbance and remolding when SPT N-value was more than 20.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.4 no.1
• /
• pp.26-33
• /
• 1992

Physical experiments were conducted to investigate the suspension properties of silty mud in combined wave-current flow. Suspension mass when there was opposing current was much higher than that when there was following current. It is due to the fact which strong turbulent flow in the bottom is developed in the opposing current but oscillatory flow effect decreases in the following current. Critical bed shear stress for suspension of silty mud in combined wave-current flow was deduced to be $\tau$$_{c}$～0.045 N/$m^2$. Formulas expressing the relation with initial suspension rate with bed shear stress, and the relation between the former and measured significant wave height were deduced. The relationship of initial suspension rate with bed shear stress was significantly scattered, but the relationship with measured significant wave height was reasonably good. When there is wave only, vertical diffusion coefficients of sediment were calculated from the vertical concentration gradients of suspended sediment when the concentration of suspended sediment approached to nearly equilibrium state. The diffusion coefficient increased exponentially with height from the bottom in the lower half of the flow depth but were nearly constant in the upper half of the flow depth.h.

• 한국해양학회지
• /
• v.26 no.4
• /
• pp.332-339
• /
• 1991

The sedimentation pattern in Namhaepo Bay, a macrotidal coastal embayment of western Korea, was investigated by means of analysing high-resolution seismic profiles, sediment samples, and tidal currents. Recent sediments up to 20 m which overlie the irregular surface of the acoustic basement. The sediments consist mainly of sandy silt and silt; the mean grain size of these sediments ranges from 4 to 5.5 phi, showing a shoreward-fining distribution pattern. This distribution pattern agrees are largely reversed during ebb, with a maximum velocity of 39 cm/sec. The calculated shear velocity of the tidal currents at sea bed ranges from 0.5 to 3.3 cm/sec during flood and from 0.7 to 2.5 cm/sec during ebb. The mean values of these velocities exceed the critical shear velocity for the silt particles. The data suggest that the tidal currents play an important role in the transportation and deposition of sediments in the bay and the surface topography of the sea floor is largely deter-mined by tidal sedimentation.

• Journal of the Korean Geotechnical Society
• /
• v.27 no.5
• /
• pp.5-15
• /
• 2011

Recent increase of large scale construction near costal area has also increased the application of soft ground treatment. As a result, solidification with cement and lime which increases stability and durability of soils, is frequently used for surface layer stabilization in soft ground site. While stabilization of very soft clay with high plasticity and compressibility has widely been studied, studies on silty clay with low plasticity and compressibility are relatively rare. In this study, after stabilizing low plasticity silty clay of Songdo area with cement and lime under various water contents, mixing ratio, and curing time, uniaxial compression test and plate load test were performed. Strength properties from both tests were considerably consistent. And trackability of construction equipment on the treated surface layer of dredged land was estimated. Finally, optimum mixing condition for Songdo silty clay was proposed.

• Journal of the Korean Geotechnical Society
• /
• v.32 no.8
• /
• pp.15-25
• /
• 2016

In order to analyze undrained shear strength for clayey silt with low plasticity from Hwaseong site, a series of laboratory and in-situ tests were performed. The Unconfined Compressive (UC) test and Simple Consolidated-Undrained Triaxial (SCU) test were examined in order to assess their applicability to the measurement of the undrained strength of this soil. In the case of clayey silt with low plasticity, although the samples were properly taken by undisturbed sampling method, the residual effective stress and the unconfined compressive strength were reduced considerably. Therefore, an effective confining pressure that corresponds to the typical marine clay should be applied to the soil specimen before shearing in order to compensate for the loss of residual effective stress. By evaluating the shear strengths of clayey silt with low plasticity as 75% of $s_{u(scu)}$, the in-situ shear strength of this kind of soil can be duplicated.

• Journal of the Korean GEO-environmental Society
• /
• v.4 no.3
• /
• pp.19-26
• /
• 2003

Recently, for the design of pile foundations on the soft ground condition, it is recognized that set-up effects are another important factor which influence the characteristics of bearing capacity of pile. In this paper, the thirteen dynamic pile loading tests were performed at the two different construction sites and the end of initial driving(EOID) were also performed and then restrike tests were performed after certain time lag. The H-pile, pipe pile, PHC pile are installed by driving into the loose silty soil and then restrike tests were performed. Nine days after pile driving, the bearing capacity of H and pipe pile were increased whereas there is not bearing capacity increasement with PHC pile. When the dense silty soil, the restrike test results showed that the bearing capacity of H and pipe pile increased up to 1.17 times. The 1-st and 2-nd restrike tests performed after 6 and 12 day, respectively. The results showed that the bearing capacity of PHC pile was decreased but the bearing capacity of piles were increased up to 1.38 times after 13 days with the third restrike test.

• Journal of the Korean Geotechnical Society
• /
• v.18 no.6
• /
• pp.25-32
• /
• 2002

The fractal dimension that was evaluated with soil components from the traditional particle-size distribution(PSD) curve was analyzed using the results of Wu et al.(1993) and Bittelli et al.(1999). In order to find the change of the variation of fractal dimension with the upper and lower limit, three limit values(200$\mu{m}$, 63$\mu{m}$, and 125$\mu{m}$) were chosen, and these results of fractal dimension analysis were compared to the result that was evaluated in the whole range of the soils. The results showed that it is possible to evaluate fractal dimension from the traditional PSD curve with the soil contents, and it showed that Bittelli et at.(1999)'s upper and lower limit value was more reasonable than Wu et al.(1993). Equations that were presented by Bittelli et at.(1999) also showed a good agreement with the analytical results in the silt domain.

• Journal of the Korean GEO-environmental Society
• /
• v.14 no.2
• /
• pp.31-41
• /
• 2013

The dredged soils of western sea of Korea have been used as the fill materials because it possess the characteristics that constitute silt, silty sand and sand mainly. However, a study on dredged soils as the fill materials is insufficient. Hence, in this present study, the application the dredged soils of western sea of Korea as the fill materials was confirmed. Primary, the composition characteristics of the ground was analyzed to confirm the application on dredged soils as the fill materials by the piezo-cone penetration test. In laboratory test, it was performed the self-weight consolidation test for mechanical characteristics of the dredged soils. The direct shear test using self-weight consolidation test sample for shear strength characteristics was performed after self-weight consolidation test. Additionally, the mechanical characteristics of the dredged soils on elapsed time using self-weight consolidation test sample, which is drained naturally, was evaluated. The dredged soils of western sea of Korea show that unit weight and shear strength is increased as natural drain time elapses.