• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.28 no.4
• /
• pp.441-448
• /
• 2010

This paper estimates the tree height using Airborne LiDAR that is obtained for each season to analyze its influence based on a canopyclosure and data fusion. The tree height was estimated by extracting the First Return (RF) from the tree and the Last Return (LR) from the surface of earth to assume each tree via image segmentation and to obtain the height of each tree. Each data on tree height that is collected from seasonal data and the result of tree height acquired from the data fusion were compared. A tree height measuring device was used to measure on site and its accuracy was compared. Also, its applicability on the result of fused data that is obtained through the Airborne LiDAR is examined. As a result of the experiment, the result of image segmentation for an individual tree was closer to the result of site study for 1 meter interval when compared to the 0.5 meter interval of point cloud. In case of the tree height, the application of fused data enables a closer site measurement result than the application of data for each season.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.12C
• /
• pp.1623-1632
• /
• 2004

In this paper, we analyze the performance of linear search and bit reversal search algorithms based on the single-dwell serial search for rapid UWB (Ultra Wide Band) signal acquisition in typical indoor wireless channel environments. Simulation results according to bin spacing and frame interval in IEEE 802.15 Task Group 3a UWB indoor wireless channels show that bit reversal search algorithm achieves much smaller normalized mean acquisition time than linear search algorithm. In particular, it is found that the normalized mean acquisition time of the bit reversal search according to the range of searching termination interval closely matches the ideal case. In addition, we observe that the acquisition performance of bit reversal search algorithm becomes much better as bin spacing gets finer.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.2C
• /
• pp.200-207
• /
• 2008

In this paper, a new detector is proposed for code acquisition, which employs the signs and ranks of the received signal samples, instead of their actual values, and so does not require knowledge of the non-Gaussian noise dispersion. The mean acquisition performance of the proposed detector is compared with that of the detector of $^{[1]}$. The simulation results show that the proposed scheme is not only robust to deviations from the true value of the non-Gaussian noise dispersion, but also has comparable performance to that of the scheme of $^{[1]}$ using exact knowledge of the non-Gaussian noise dispersion.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.1
• /
• pp.43-51
• /
• 1998

In this paper, the performance about the CDMA inital synchronization under the Rician fading channel, which is actively studied as a CAI for IMT2000(FPLMTS) is analyzed. Through the performance analysis with the double dwell serial search code acquisition, the minimum mean initial synchronization acquisition time vs signal detection threshold value and first dwell duration time respectively with parameters of false alarm probability, detection probability and test PN chips is presented and the results show the mean initial synchronization acquisition time is increased with lower slope than Rayleigh fading as the threshold value of the initial synchronization acquisition decision is increased.

• Journal of Satellite, Information and Communications
• /
• v.10 no.4
• /
• pp.58-63
• /
• 2015

Due to GPS signal's vulnerability of jamming attack, various enhancement techniques are needed. Among variety of techniques, we focused on GPS receiver's anti-jamming techniques. There are many anti-jamming methods at GPS receivers which include filtering methods in time domain, frequency domain and space domain. However, these methods are ineffective to signals, which include both jamming and noise. To solve the problem, this paper proposes a jamming separation scheme by using a BSS method in a jamming environment. As separated GPS signals include noise after the jamming separation method, it is difficult to receive accurate GPS signals. For this reason, this paper also proposes a wavelet de-noising method to effectively eliminate noise. Experimental results of this paper are based on a real field test data of an integrated GPS/QZSS/Wi-Fi positioning system. At the end, the simulation result demonstrates its superiority by showing improved positioning accuracy.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.35 no.5
• /
• pp.479-485
• /
• 2011

To acquire images in a thermionic-scanning electron-beam system, a scanning unit is needed to control the electron beam emitted from the tungsten filament source. In scanning the electron beam on the solid surface, the signalto-noise ratio depends on the scanning frequency. We used a digital filter to reduce noise by analyzing the real-time frequency of a secondary electron signal. The noise and the true image signal were well separated. We designed the digital filter via a DSP floating-point operation, and the noise elimination resulted in enhanced image quality in a highresolution mode.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.9
• /
• pp.1818-1825
• /
• 2017

An Acoustic Doppler Current Profiler(ADCP) measures the current velocity and analyzes the degree of turbulence using Doppler effects of ultrasonic waves. Therefore, the autocorrelation or FFT spectrum estimates are obtained for extraction of current velocity in each spatial region. However, if the correlation method does not satisfy the assumption that the return signal spectra are symmetric Gaussian, the large bias errors can occur. Also, the accurate estimation of autocorrelation or FFT spectrum is difficult due to the short acquisition interval when the rapid changes of current velocity occur. Thus, in this paper, the estimation method of the autoregressive spectrum peak is suggested for the accurate current velocity measurement of both symmetric and asymmetric spectra. It is shown that estimation quality can be improved using the suggested method comparing with the conventional methods. Many return signals under the various environment are simulated and the results are compared and analyzed for evaluation of the suggested method.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.10a
• /
• pp.834-837
• /
• 2015

In this paper, we designed the FPGA hardware-based real-time ECG simulator, which generates an analog ECG signal within the range of 0 to 5 volts and described function. The ECG signal generated by the simulator can be applied to laboratory tests, the medical device, and the calibration study in various ways. ECG signals generated by simulator are obtained with conventional 24bit quantization to generate the signal data, and they are sampled and quantized to 1kHz of the 8-bit resolution when used as actual data. The proposed simulator is implemented using xilix Spartan-3 and data are transmitted through an RS-232 between the PC and the FPGA simulator. The transmitted data are stored in the memory and the stored data are printed out with the analog ECG signal through DAC (0808). It can also control the heart rate (HR) via the two buttons level UP-DOWN. We used existing ECG input rating for the evaluation of the designed system and evaluated differential circuit for obtaining QRS waveform and the output signal. We finally could obtained proper the result.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.11A
• /
• pp.909-917
• /
• 2009

In this paper, we proposed and implemented the method to efficiently generate TDD synchronization signal and the digital circuit for the RF repeater which can eliminate the shadow region in the wireless communication field using the time division duplex (TDD) method. After detecting the TDD signal from the transmitted or received RF signal, the detected TDD signal is fed to the RF repeater for the normal operation. The proposed technique detects the envelop of the downlink signal and amplifies the detected envelop, and then restores the degraded envelop with the proposed digital filtering method. Finally the restored envelop is manipulated to the TDD synchronization signal. Our focus on the proposed algorithm is to develop it with simple feature and low cost but robust performance. The proposed scheme was implemented to the integrated system which has both RF and digital circuit and tested under the same condition with the commercial WiBro service.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.12 no.4
• /
• pp.419-424
• /
• 2019

In this paper, we proposed an algorithm to estimate the desired target in wideband jamming signal environment. In order to suppress the jamming signal, we use the spatial time adaptive algorithm and QR decomposition to obtain the optimal weight. The spatial time adaptive algorithm of adaptive array antenna system multiplies the tap delay signal by a complex weight to obtain a weight. In order to minimize the power consumption because of the inverse matrix, optimal weight is obtained by using QR decomposition. Through simulation, we compare and analyze the performance of the proposed algorithm and the existing algorithm. In the target estimation of [-40o,0o,+40o], the proposed algorithm estimated all three targets, but the existing algorithm estimated only [0o] due to of the jamming signal. We prove that the proposed algorithm improves performance by removing the jamming signal and estimating the target accurately.